• Journal of Korea Water Resources Association
• /
• v.56 no.11
• /
• pp.785-799
• /
• 2023

In this study, we proposed a new concept termed the Secondary Peak Constant (SPC) and discerned the temporal characteristics of independent rainstorm events based on unit time and SPC about 24 observation stations in Seoul. Utilizing rainfall observations from 2000 to 2022, independent rainstorm events discreted from rainfall data per unit time. The temporal characteristics of these events were derived according to unit time, and temporal characteristics of the peak rainfall were identified through the SPC. Finally, the temporal characteristics of independent rainstorm events were examined distinctively when analyzed by unit time and SPC. Independent rainstorm events with smaller unit time showed significantly larger total rainfall, rainfall duration, and rainfall intensity. The temporal characteristics of the largest peak rainfall (1^st Peak) within independent rainstorm events followed a sequence of Q4>Q2>Q3>Q1. Additionally, the 2^nd Peak rainfall predominantly occurred the location where the 1^st Peak appeared. The proportion of independent rainstorm events with multiple peak rainfalls exceeded 50.0% when the SPC was 0.7 or lower. The average number of peak rainfalls within independent rainstorm events ranged from 1.5 to 3.4. This study identified the temporal characteristics of independent rainstorm events based on unit time. Then, the peak rainfall of temporal characteristics was quantified by SPC on this study. Hence, it is evident that the temporal characteristics of independent rainstorm events for specific area can be anlayzed and quantified based on unit time and SPC.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07b
• /
• pp.857-860
• /
• 2004

Cubic CdS thin film with the strongest XRD peak (111) at diffraction angle $(\theta)$ of 26.5 was well made at substrate temperature of $150^{\circ}C$. At that time, lattice constant a of the thin film was $5.79{\AA}$, grain size of that was more over ${\mu}m$ and it's resistivity was over $10^3{\Omega}cm$. And the peak of diffraction intensityat miller index (111) of CdS:In thin film with dopant In of 1 atom% was shown higher about 20 % than undoped CdS thin film. Also, CdS:In thin film had in part hexagonal structure among cubic structure as secondary phase. Lattice constant of a and grain size of secondary phase of the film with dopant In of 1 atom% was $5.81{\AA}$ and around $1{\mu}m$ respectively The lowest resistivity of $5.1{\times}10^{-3}{\Omega}cm$ was appeared on dopant In of 1.5 atom%. Optical band gap of undoped CdS thin film was 2.43 eV and CdS:In thin film with dopant In of 0.5 atom% had the largest band gap 2.49 eV.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.19 no.7
• /
• pp.1675-1683
• /
• 1995

A numerical study of the fluid flow and heat transfer characteristics of the two-dimensional impingement jet with a confinement plate has been carried out. The fluid flow was calculated by solving the full Navier-Stokes equation. In doing that, the well known SIMPLER algorithm was used and the trouble making convection term was discretized according to QUICKER scheme. The energy equation was simply solved by using the SOR method. For the Reynolds number of 10000, two channel heights, say 1.5 and 3.0 times the jet exit width, and two thermal boundary conditions constant wall temperature and constant wall heat flux were considered. Discrete heat sources were flush mounted along the impingement plate at a distance of 0, 2, 3, 4, 5, 6, 10, 12, times the jet exit width from the stagnation point. The length of each heat source is 4 times the jet exit width long. The Nusselt number averaged over each heat source was compared with experiment. Comparison shows that both calculations and experiment have the secondary peak of Nusselt number at downstream of stagnation point, even though there is a little quantitative difference in between. The difference is believed due to abscure thermal boundary condition in experiment and also accuracy of turbulence model used. The secondary peak is shown to be caused by rigorous turbulent flow motion generated as the wall jet flow is retarded and developes into the channel flow without flow reversal.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.05c
• /
• pp.156-159
• /
• 2002

This paper presents an experimental study of the surge response characteristics for the primary winding of a pole transformer and ultimately aims at devising countermeasures against the surge in operating transformer. After applying the impulse voltage to the primary of the 30 kVA pole transformer with single bushing, the voltage waveforms were measured at each tap lead and compared with one another. As a result, the voltage peak of the surge propagating in the primary was decreased in magnitude at a constant rate and somewhat delayed compared to the peak of the applied surge as the tap leads were getting closer to the grounding terminal. The voltage measured at the secondary was not delayed in time, different from that at the primary, and it was about 1/6 according to the turn ratio.

• Journal of Korean Society of Water and Wastewater
• /
• v.18 no.3
• /
• pp.377-384
• /
• 2004

In the present study, a feasibility of an advanced oxidation process using UV/Hydrogen peroxide($H_2O_2$) system equipped with a medium pressure lamp for secondary effluent reclamation was investigated. Initial concentration of $H_2O_2$ and pH were changed to determine the optimum operation condition for the system. The removal efficiency of color was than 80% with 14.3mg/L of initial $H_2O_2$ and 5 minute of contact time in the UV/$H_2O_2$ system. The color removal was analyzed using first-order reaction equation. The dependence of rate constant (k) on initial $H_2O_2$ represented the rational relationship with maximum value. Residual $H_2O_2$ caused increase of effluent COD, since analyzing agent, dichromate, reacted with $H_2O_2$ in the sample. Therefore, excess initial concentration of $H_2O_2$ would significantly affect effluent COD measurement. At pH variation experiment, both residual $H_2O_2$ and color showed peak in the neutral pH range with the same pattern. Effect of $H_2O_2$ dose also enhanced color removal but raised residual $H_2O_2$ problem in the continuous operation UV system. In conclusion, these results indicated that medium pressure UV/$H_2O_2$ system could be used to control color in the secondary effluent for reclamation and reuse.

• Journal of Korean Society on Water Environment
• /
• v.30 no.3
• /
• pp.304-310
• /
• 2014

The conventional methods for total residual chlorine such as iodometry and DPD colorimetric can cause secondary pollution due to additional agents, also have a wide error range. As for alternative, electrochemical method can measure TRC(Total residual chlorine), and is not required as additional agents, also very suitable for using the fields of ballast water because test time is relatively fast. Therefore, this study was investigated for changing charge by agitation, salt concentration, and temperature change. Charge showed differences based on changes of reduction peak with or without agitation. In contrast, TRC and charge were well correlated in constant agitation speed. As TRC and charge were analyzed with high correlations in constant salinity and temperature of ocean, thereby conductivity was firstly measured, and charge had high correlation for TRC in spite of changing salinity and temperature Pt electrode revealed high reliability ($r^2=0.960$) because it was rarely effected by TRC, On the other hand, Au electrode appeared inadequate ($r^2=0.767$) to use sensor in less than 1.0 ppm of TRC. For high accuracy and detection of TRC, Pt and Au electrodes for test time were, respectively, 14 and 22 seconds. As a result, Pt electrode was more valuable than Au electrode in terms of response time.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.12 no.4_1
• /
• pp.9-21
• /
• 1992

The effectiveness of the isolation system installed at the base of the primary structure and at the support of the substructure mounted on the primary structure is evaluated for reducing of structural responses under different earthquakes in this paper. The structural responses are analyzed to identify its behavior due to the input motion characteristics such as various peak acceleration and frequency content. Three analytical models are used to evaluate the effectiveness of the isolation system in this study as follows: fixed-base primary structure with support-fixed substructure, base-isolated primary structure with support-fixed substructure, and fixed-base primary structure with support-isolated substruciure. A computer code (KBISAP) is used for numerical integration of equation of motion considering the interaction between the primary structure and the secondary structure. The matrix condensation technique and constant average acceleration method are utilized in this program. And also, the effective stiffness of the base-isolator on reducing the structural response are evaluated for various earthquakes through the relationship of the acceleration - displacement.

• Korean journal of applied entomology
• /
• v.37 no.2
• /
• pp.193-198
• /
• 1998

Experiments were conducted to investigate the population fluctuation, developmental periods, fecundity, hatching rate and demage of Citrus red mite (Panonychus citri M.) on Yuzu trees (citrus junos T.) from 1996 to 1997. Citrus red mite occurred from May to November and made two peaks. The first peak was in July to August and the secondary peak was in October. Density of the second peak was higher (9.5 miteslleaf) than that of the first peak. In the constitution rate of each developmental stage of citrus red mite on Yuzu leaves, egg stage occupied 85%. At the four constant temperature (15, 20, 25, 30 + 1$^{\circ}$C, RH 60 + lo%, 14L- IOD) conditions, the developmental period from egg to adult was 41 .l, 15.5, 11.0 and 9.4 days ; Mean longevity of adult was 23.3, 8.3, 6.3, and 6.1 days; Mean number of egg laid per female per day was 1.6, 3.2, 4.5, 4.0 eggs; Mean hatching rate was 66.6, 85.7, 90.7 and 94.7% at above temperature, respectively. When sprayed acaricide at different density of Citrus red mite, the growth of young Yuzu tree were better at low density. Defoliation rate during winter was 13.5, 20.6, 53.1, 72.6% at 4 control density 1 , 3, 6 mites per leaf and uncontrolled (10 ( ). When every time spray acaricide under 3 mites per leaf, defoliation rate during winter suppressed above 50% compare to uncontrol 72.6%.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.36 no.10
• /
• pp.1019-1023
• /
• 2012

In this research, a novel direct-aluminum-heating-induced crystallization method was developed for the purpose of application to solar cells. By applying a constant current of 3 A to an aluminum thin film, a 200-nm-thick amorphous silicon (a-Si) thin film with a size of $1cm{\times}1cm$ can be crystallized into a polycrystalline silicon (poly-Si) thin film within a few tens of seconds. The Raman spectrum analysis shows a peak of 520 $cm^{-1}$, which verifies the presence of poly-Si. After removing the aluminum layer, the poly-Si thin film was found to be porous. SIMS analysis showed that the porous poly-Si thin film was heavily p-doped with a doping concentration of $10^{21}cm^{-3}$. Thermal imaging shows that the crystallization from a-Si to poly-Si occurred at a temperature of around 820 K.

• Asian Pacific Journal of Cancer Prevention
• /
• v.15 no.18
• /
• pp.7929-7934
• /
• 2014

Background: The primary objective of this study was to assess the proportion of malignancies in ovarian masses during $1^{st}$ January 2002, to $31^{st}$ December 2011 at the Department of Obstetrics and Gynecology, King Chulalongkorn Memorial Hospital. A secondary objective was to evaluate associations with patients' clinical characteristics and ovarian malignancy proportion and subtypes. Materials and Methods: Retrospective descriptive study analyzed data of ovarian masses larger than 3 centimeters in maximal diameter, from the division of Gynecologic Cyto-Pathology at KCMH. SPSS software version 17 (SPSS, Inc, Chicago, IL, USA) was used. Results: A total number of 6,115 patients were included. Among the total ovarian masses studied, 13.7% were malignant. After the age of sixty, the proportion reached almost 40%. It was also above 20% in women younger than 20 years old. During premenarche period, proportion of ovarian malignancies was 50%. Only 1% of ovarian masses were found to be malignant during the pregnancy and post-partum periods. Parity decreased the probability of ovarian malignancy during postmenopausal years. Period of menopause did not have any impact on this probability. During the first two decades of life, germ cell malignancy dominated. As the age increased, the percentage of surface epithelial-stromal malignancy increased with a peak at the fifth decade. In contrast, malignant sex cord-stromal cell tumors occurred at a constant rate in each age group after the thirties. Conclusions: Proportion of ovarian cancers in each age group, menstrual and pregnancy status are similar. However there are differences in the distribution of ovarian subtypes especially for the surface epithelial-stromal category.