• 한국소음진동공학회논문집
• /
• 제20권5호
• /
• pp.437-443
• /
• 2010

SAW device is widely used as band pass filters, chemical or physical sensors, and actuators. In this paper, we propose the capacitive gap measurement system with high precision using SAW device. The research process is mainly composed of theoretical and experimental part. In the theoretical part, equivalent circuit model was used to predict the SAW response by the change of load impedance. In the experimental part, commercialized capacitor was used to see the SAW response by the change of load capacitance to check the feasibility as a sensor unit. After that, experimental setup to measure and adjust the gap was made and the SAW response by the change of gap which caused the capacitance change was measured. Finally, resolution and stroke was decided compared with the signal change and basic measurement noise level.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2009년도 제40회 하계학술대회
• /
• pp.1515_1516
• /
• 2009

A 440MHz wireless and passive surface acoustic wave (SAW) based micro-sensor was developed for simultaneous measurement of temperature and humidity. The developed sensor is composed of a SAW reflective delay lines structured by an IDT (Inter-Digital Transducer), four reflectors and humidity sensitive film (polyimide). Polyimide was dry-ecthed by RIE (Reactive Ion Etching) to obtain high roughness, which gives the large reaction area resulting in high sensitivity. In wireless testing using a network analyzer, sharp reflection peaks with high S/N ratio, small signal attenuation, and few spurious peaks were observed in the time domain. High sensitivity towards the temperature and humidiy were also observed in the large concentration range. The obtained sensitivity was $16.8^{\circ}/^{\circ}C$ for temperature sensor and $15.8^{\circ}$/%RH for humidity sensor.

• 한국통신학회논문지
• /
• 제15권6호
• /
• pp.494-505
• /
• 1990

본 논문에서는 한 개의 탄성표면파 콘벌버를 사용한 직접 시퀀스 대역 확산 통신시스템에서의 DPSK 복조기를 제작, 실험을 하고, 이론적인 고찰을 하였따. 제작한 DPSK 복조 시스템은 SSMA를 위하여 각 데이터 마다 다른 코드로 대역 확산시켰으며, 코드 칩은 PSK로 변조하였다. 본 논문에서 제안한 복조 시스템의 출력은 시뮬레이션 파형과 같음을 확인하였으며, 이론적인 고찰 결과 두개의 콘벌버를 사용한 CSK 복조 시스템과 같은 성능을 보였다.

• 정보저장시스템학회논문집
• /
• 제8권1호
• /
• pp.16-21
• /
• 2012

SAW device is widely used as filters, sensors, actuators in various technologies. And capacitive sensor is tremendously used to measure pressure, gap, etc. The application of SAW device as signal conditioner of capacitive sensor reduces noise level and enables high precision measurement. The response increase of SAW based capacitive sensor is produced just before the two capacitive electrode contacts by the existence of parasitic resistance of capacitive electrode. In this paper, we analyze the effects of parasitic resistance and propose the calibrating method using lumped component and execute the high precision gap measurement using calibrated system. And xx nm resolution and yy ${\mu}m$ stroke was attained.

• 한국음향학회지
• /
• 제10권1호
• /
• pp.71-82
• /
• 1991

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2007년도 추계학술대회 논문집
• /
• pp.359-360
• /
• 2007

• 한국통신학회논문지
• /
• 제31권11A호
• /
• pp.1159-1166
• /
• 2006

본 논문에서는 수동형 태그 기반 908.5~914MHz RFID 리더기의 수신 감도를 개선하고자 수신부에 서큘레이터, LNA 그리고 SAW필터를 사용하는 개선된 수신부 시스템을 설계하였다. 그리고 시뮬레이션을 통하여 동작 주파수 및 리더기와 태그 상호간 특성에 따른 수신부 성능을 분석하였다. 분석결과 상용 시스템은 24개의 캐패시턴스(C)와 6개의 인덕터(L)를 사용함으로써 감도 손실을 가져왔으나, 본 연구에서는 설계된 시스템은 서큘레이터 사용에 의해 상호 간섭을 최소화할 뿐만 아니라 LNA 사용으로 수신 감도를 크게 향상시키는 결과를 얻을 수 있었다. 또한 SAW 필터에 의해 송 수신부 간섭을 최적화시킴으로써 시스템 감도가 더욱 개선되었음을 확인하였다.

• 센서학회지
• /
• 제14권3호
• /
• pp.186-190
• /
• 2005

This paper describes the development of a surface acoustic wave gas sensor that is designed to detect volatile gas by monitering phase change of output signal as a function of time. The sensor consists of SAW oscillators with a center frequency of 100 MHz fabricated on $128^{\circ}$ Y-Z $LiNbO_{3}$ substrates. Experimental results, which show the phase change of output signal under the absorption of volatile gas onto sensors, are presented. The proposed sensor has the properties of high sensitivity compare to the conventional SAW gas sensor and chemical selectivity. Thus, it is thought these results are applicable for use in sensor array of an high performance electronic nose system.

• 한국산업정보학회논문지
• /
• 제21권1호
• /
• pp.43-50
• /
• 2016

본 논문에서 PVT 변환에 상관없이 거의 일정한 주파수 특성을 갖는 LC 수동 필터를 구현하기 위해 자동 변환 LC 캘리브레이터를 제안하다. 이를 이용하여 SAW 필터 없는 GPS 수신기 프론트엔드를 65nm CMOS 공정을 이용하여 구현하였다. 또한 자동 변환 LC 캘리브레이터에 필요한 신호를 제공하기 위한 새로운 이중 모드 저 잡음 증폭기의 구조를 제안하였다. 구현된 GPS 수신기 프론트엔드의 특성은 약 42.5 dB 전압 이득, 1.35dB 이하의 잡음 지수, 가장 최악 조건의 1710 MHz 블로커 신호에서 -24 dBm의 블로커 입력 P1dB 특성을 보이며 이 때 1.2 V 전원에 7 mA 전류를 소모한다.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2002년도 ITC-CSCC -2
• /
• pp.1196-1199
• /
• 2002

The low phase noise frequency source to be used for measurements and so on realizes by oscillator having highly output signal power against output noise power. SAW devices can be used by high power than BAW devices. So we examine on configuration of SAW oscillator circuits with the power gain. In this paper we shall discuss a configuration of oscillator circuit to obtain an extremely low phase noise and an oscillator operating at a non-reactive frequency of SAW resonator.