• Nuclear Engineering and Technology
• /
• 제29권4호
• /
• pp.269-279
• /
• 1997

The errors associated with incorrect sampling and transport of radioactive aerosol from radwaste thermal process off-gas are analyzed and the conditions of representative sampling and correct transport of radioactive aerosol for off-gas system evaluation are discussed. An estimation method of sampling errors for individual radionuclides is proposed and applied to simulated vitrification melter aerosols. Prediction methods for particle deposition in sample transport tube under laminar as well as turbulent flow conditions are also described by example calculations with simulated incinerator off-gas From the results of example calculations and plots, instrumental and operational conditions of radioactive aerosol sampling system with minimized errors and correction methods for nonideal sampling and transport are recommended.

• 한국초전도ㆍ저온공학회논문지
• /
• 제24권2호
• /
• pp.23-26
• /
• 2022

A lossless transport of an arbitrary waveform in a frequency range of 10⁶-10⁹ Hz through a conduction channel in a cryogenic temperature is of importance for a high-speed operation of quantum device. However, it is hard to use a commercial oscilloscope to directly detect the waveform travelling in a device located in a cryogenic system. Here, we developed a cryogenic voltage sampling technique by using a Schottky barrier gate prepared on a surface of a GaAs/AlGaAs device, which revealed that an incident rectangle waveform can transport through a 1 mm long two-dimensional conduction channel without waveform deformation up to 20 MHz, while further study is needed to increase the detection frequency.

• 한국ITS학회 논문지
• /
• 제18권6호
• /
• pp.262-274
• /
• 2019

본 연구에서는 영동 고속도로 용인IC ~ 양지IC 구간을 대상으로 미시교통시뮬레이션 모형인 VISSIM을 이용하여 고속도로 교통정보 취득을 위한 프루브 차량 최소 비율을 추정하고자 한다. 실험을 위하여 일반상황과 유고상황을 고려한 7,200 가지의 시나리오를 생성하였다. 하지만, 모든 시나리오를 실험을 통해 수행하기에는 어려움이 있어 라틴 하이퍼큐브 샘플링(Latin Hypercube sampling) 방법을 사용하여 40 가지의 시나리오를 채택하였다. 이를 통해 얻은 개별차량의 1초당 데이터를 얻어 프루브 차량 비율을 세분화하여 평균통행시간 분포를 통계적으로 비교 분석 해본 결과 일반 상황에서는 고속도로 교통정보 취득을 위한 프루브 차량의 최소 비율이 1%였고 유고상황에서는 45%로 산정되었다. 또한 시나리오 분석 결과 25%의 프루브 차량 정보를 가지고 유고상황 시나리오 교통상황 중 70%를 충족시킬 수 있는 것으로 확인되었다.

• 열처리공학회지
• /
• 제35권4호
• /
• pp.193-202
• /
• 2022

Manholes and underground spaces are installed to manage the buried heat transport pipes of the district heating system, and the corrosion damage of the equipment placed in this space often occurs. The purpose of this work is to identify locations with a high risk of corrosion damage in the air vent and to establish preventive measures based on precise analysis via sampling of heat transport pipes and air vents that have been used for about 30 years. The residual thickness of the air vent decreased significantly by reaching ~1.1 mm in thickness, and locations of 60~70 mm away from a transport pipe were the most vulnerable to corrosion. The energy dispersive X-ray spectroscopy (EDS) analysis was performed in the corroded oxides, and it was found that chloride ion was contained in the corrosion products. Anodic polarization tests were carried out on the air vent materials (SPPS250, SS304) with varying the amounts of chloride ions at two different temperatures (RT, 80℃). The higher concentration of chloride ions and temperature are, the lower corrosion resistances of both alloys are.

• 한국ITS학회 논문지
• /
• 제7권3호
• /
• pp.29-37
• /
• 2008

본 논문은 RFID 시스템을 통해 수집되는 데이터를 '국가도로교통량조사'에 활용하는 것에 목적을 두고 있다. 연구 수행에 있어 RFID 전자태그 보급의 한계성을 극복하기 위해서, 먼저 RFID 시스템을 통하여 표본데이터를 수집하고 이를 전수화(표본데이터를 조사지점을 통과하는 모든 차량의 수로 만드는 과정) 하였다. 최적의 전수화 방법론을 선정하기 위하여 세가지 방법론(시간계수 모델, 퍼지 모델, 신경망 모델)을 적용하였으며 분석결과 시간계수를 이용한 모델이 최적의 전수화 방법론으로 선정되었다. RFID 시스템을 '국가도로교통량조사'에 활용할 수 있는 방안을 모색하기 위해 '제주도'를 모델로 하여 분석한 결과 인프라 구축의 한계로 인하여 상시조사를 대체할 수는 없으나, 수시조사는 활용에 대한 새로운 가능성을 확인하였다. 따라서 교통량 조사(상시조사)에 있어 RFID 시스템을 활용한다면 기존 검지기에 비해 비용저감 효과가 있을 것으로 기대된다.

• 설비공학논문집
• /
• 제6권3호
• /
• pp.237-246
• /
• 1994

Experimental data are reported for charging and collection of NaCl aerosols in the 0.03- to $0.2{\mu}m$-geometric-mean-diameter range in 2-stage parallel-plate electrostatic precipitators. The NaCl aerosols are generated with geometric standard deviation of about 1.74 and particle generation rate of about 10^9 particles/see by the constant output atomizer and injected into the air flow in the clean wind-tunnel. The 2-stage parallel-plate electrostatic precipitator installed in the test section of the wind-tunnel is operated with a positive corona discharge. The NaCl aerosols in the channel flow are sampled and transported to the aerosol particle number concentration measurement system by using the isoaxial sampling and transport system constructed based on the Okazaki and Willeke design. The aerosol particle number concentration measurement system measures the size distribution of submicrometer aerosols by an electrical mobility detection technique. It is confirmed from comparing the measured collection efficiencies in this study and the predicted ones by our previous theoretical analysis that the predicted collection efficiencies agree well with the experimental ones. It is also found from the comparison that below about $0.02{\mu}m$ all particles are not charged and the uncharged particles are not collected, and consequently 2-stage parallel-plate electrostatic precipitators are not suitable for that particle size range.

• 한국대기환경학회지
• /
• 제29권5호
• /
• pp.656-667
• /
• 2013

The non-exhaust coarse, fine, and ultrafine particles were characterized by on-road driving measurements using a mobile sampling system. The on-road driving measurements under constant speed driving revealed that mass concentrations of roadway particles (RWPs) were distributed mainly in a size range of 2~3 ${\mu}m$ and slightly increased with increasing vehicle speed. Under braking conditions, the mode diameters of the particles were generally similar with those obtained under constant speed conditions. However, the PM concentrations emitted during braking condition were significantly higher than those produced under normal driving conditions. Higher number concentrations of ultrafine particles smaller than 70 nm were observed during braking conditions, and the number concentration of particles sampled 90 mm above the pavement was 6 times higher than that obtained 40 mm above the pavement. Under cornering conditions, the number concentrations of RWPs sampled 40 mm above the pavement surface were higher than those sampled 90 mm above the pavement. This might be explained that a nucleation burst of a lot of vapor evaporated from the interaction between the tire and the road pavement under braking conditions continuously occurred by cooling during the transport to the sampling height 90 mm, while, for the case of cornering situations, the ultrafine particle formation was completed before the transport to the sampling height of 40 mm.

• 한국진공학회지
• /
• 제5권4호
• /
• pp.284-291
• /
• 1996

차세대 반도체 제조공정을 위한 고진공 클러스터 장비용 반송모듈에 대해 고속 응답이 가능한 압력제어 장치의 구현과 그 성능시험을 수행하였다. 일반적인 자동 유량조절기가 가지고 있는 저속 응답에 대한 문제점을 해결하기 위하여 압력제어 순서를 매우 효과적으로 최적화하기 위하여 새로운 실험방법이 제시되었다. 압력제어를 시작하는 시점과 Ziegler-Nichols 제어방법에 의한 조율 상수들을 조절함으로써 매우 안정되고 빠른 응답이 가능한 압력제어를 성공적으로 달성하였다. 반송압력이 $10\times 10^{-5}$ torr인 경우, 질소의 초기유량을 21 sccm으로 설정한 수 4초 시각부터 실제적인 압력제어가 시작되었다. 그 결과, 최대 압력오차가 설정값에 대해 $\pm$0.5% 이하에서 안정화 시간은 10 sec 이내로 기존 실험방법과 비교해 볼 때 70% 정도 개선된 우수한 성능을 얻을 수 있었다. 이때 rise rate는 0.02 torr/sec, the lag time는 0.15sec, the sampling period는 0.5 sec이였다. 이러한 실험결과를 설명하기 위하여 이론적인 모델이 유도되었으며, $\omega$=-1.0일 때 실험결과와 잘 일치함을 알 수 있었다.

• Nuclear Engineering and Technology
• /
• 제56권2호
• /
• pp.762-769
• /
• 2024

The TMSR-SF0 simulator is an integral effect thermal-hydraulic experimental system for the development of thorium molten salt reactor (TMSR) program in China. The simulator has two heat transport loops with liquid FLiNaK. In literature, the 95% level confidence uncertainties of the thermophysical properties of FLiNaK are recommended, and the uncertainties of density, heat capacity, thermal conductivity and viscosity are ±2%, ±10, ±10% and ±10% respectively. In order to investigate the effects of thermophysical properties uncertainties on the molten salt heat transport system, the uncertainty and sensitivity analysis of the heat transfer characteristics of the simulator system are carried out on a RELAP5 model. The uncertainties of thermophysical properties are incorporated in simulation model and the Monte Carlo sampling method is used to propagate the input uncertainties through the model. The simulation results indicate that the uncertainty propagated to core outlet temperature is about ±10 ℃ with a confidence level of 95% in a steady-state operation condition. The result should be noted in the design, operation and code validation of molten salt reactor. In addition, more experimental data is necessary for quantifying the uncertainty of thermophysical properties of molten salts.

• Journal of Pharmaceutical Investigation
• /
• 제31권4호
• /
• pp.273-279
• /
• 2001

The purpose of this study is to characterize the iontophoretic transport of growth hormone releasing peptides (GHRP-6) through hairless mouse skin from aqueous solution. The effect of various factors, such as pH, poloarity, current profile, current density, current duration, ionic strength, drug concentration, and enhancer application was studied to obtain basic knowledge on the transport. We have also studied the stability of GHRP-6 in solution with/without current. The donor chamber was filled with phosphate buffer solution containing GHRP-6 and the receptor chamber was filled with phosphate buffer solution (pH 7.4). Ag/AgCl electrode was used for their stability and reversibility. At a predetermined time interval, sampling was made and the concentration of drug was analysed using HPLC system. The results showed that, compared to passive flux, the total amount of drug transported increased markedly by the application of anodal current. Cathodal flux was similar to passive flux. Flux increased with the current density, the duration of current application and drug concentration. The effect of enhancers on the flux was studied using hydrophilic (5% N-methyl pyrrolidone) and hydrophobic (5% propylene glycol monolaurate, 5% oleic acid) enhancers. Application of enhancer also increased the flux.