• Journal of the Korea Furniture Society
• /
• v.17 no.1
• /
• pp.33-46
• /
• 2006

This study was carried out to investigate a radio-frequency/vacuum (RF/V) drying ability and physical properties of the green boards and the pre-kiln dried boards with 40 mm thickness, and the 70 mm-thick green board of Iroko (Milicia excelsa). The major results were summarized as follows; The drying time from initial moisture content (MC) of 110% to approximate 6% MC for a 40mm-thick green board was 192 hours, and about 200 hours for the 70 mm-thick green board, respectively and so the RF/V drying times were dramatically shortened compared to conventional kiln drying time. The case hardenings at the RF/V drying completion stage test were very negligible, thus represented almost no existence of the residual stress. The checks were very slightly formed on all of the boards during the RF/V drying test, but crook appeared quite severely. During the accelerating test, the water-resistant treated specimens had not experienced any signs of checking occurred, whereas the control boards had encountered very frequent occurrences of end checking and slight surface checking. There were no observations of warping and discoloring regardless of the treatment.

• Nuclear Engineering and Technology
• /
• v.55 no.7
• /
• pp.2516-2533
• /
• 2023

Several practical methods for accelerating the depletion calculation in a GPU-based Monte Carlo (MC) code PRAGMA are presented including the multilevel spectral collapse method and the vectorized Chebyshev rational approximation method (CRAM). Since the generation of microscopic reaction rates for each nuclide needed for the construction of the depletion matrix of the Bateman equation requires either enormous memory access or tremendous physical memory, both of which are quite burdensome on GPUs, a new method called multilevel spectral collapse is proposed which combines two types of spectra to generate microscopic reaction rates: an ultrafine spectrum for an entire fuel pin and coarser spectra for each depletion region. Errors in reaction rates introduced by this method are mitigated by a hybrid usage of direct online reaction rate tallies for several important fissile nuclides. The linear system to appear in the solution process adopting the CRAM is solved by the Gauss-Seidel method which can be easily vectorized on GPUs. With the accelerated depletion methods, only about 10% of MC calculation time is consumed for depletion, so an accurate full core cycle depletion calculation for a commercial power reactor (BEAVRS) can be done in 16 h with 24 consumer-grade GPUs.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2000.06a
• /
• pp.1816-1822
• /
• 2000

The maximum and mean indicated pressure of two stroke low speed diesel engine has been continuously increased with a view of increasing engine power and also reducing fuel consumption. As a result, axial excitation has been highed comparing to that of the previous and so in standard axial vibration damper is applied to all two stroke low speed diesel engine at the free end of crankshaft. Though many studies were carried out for marine use, few has been made for diesel power plant because there was little demand for power plant. Nowadays, diesel engine is much to be used for many benefits and so in this paper, the optimum design of axial vibration on the 65 MW diesel power plant with 9K80MC-S engine was carried out. And the axial-torsional coupled vibration of this shafting system is identified by theoretical analysis and vibration measurement.

• Architectural research
• /
• v.17 no.3
• /
• pp.101-108
• /
• 2015

So far, the Japanese exhibitions in the colonized Korea, especially the Joseon Industrial Exhibition of 1915, haven't been studied sufficiently; they have been understood mainly as political propaganda to legitimize the Japanese colonization of the Korean peninsula; many scholars have agreed that Japan highlighted material developments in Korea under the benevolent guidance of Japan by displaying strong visual contrasts between the modern and the traditional. So, they only acknowledge colonial modernity; this perspective regards Western forms as the sole expression of architectural modernity, not only in the exhibition but also in the colonial space and time. However, to be on a par with the West, Japan started to develop a series of historical narratives in searching for its historical origins in Asia, and it also carried out archaeological investigations in the Korean peninsula around the early 1900s. I argue that the developed historical narratives with traditional Korean artworks and architecture (i.e. the shared historical origins between Japan and Korea) influence the architectural conditions of the 1915 exhibition. And, the status of traditional Korean architecture in the Japanese exhibition expresses architectural modernity in terms of showing historical progress.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.12B
• /
• pp.1509-1521
• /
• 2011

WfMC, which is one of the international standardization organizations leading the business process and workflow technologies, has been officially released the BPAF1.0 that is a standard format to record process instances' event logs according as the business process intelligence mining technologies have recently issued in the business process and workflow literature. The business process mining technologies consist of two groups of algorithms and their analysis techniques; one is to rediscover flow-oriented process-intelligence, such as control-flow, data-flow, role-flow, and actor-flow intelligence, from process instances' event logs, and the other has something to do with rediscovering relation-oriented process-intelligence like process-driven social networks and process-driven affiliation networks from the event logs. The current standardized format of BPAF1.0 aims at only supporting the control-flow oriented process-intelligence mining techniques, and so it is unable to properly support the relation-oriented process-intelligence mining techniques. Therefore, this paper tries to extend the BPAF1.0 so as to reasonably support the relation-oriented process-intelligence mining techniques, and the extended BPAF is termed BPAF2.0. Particularly, we have a plan to standardize the extended BPAF2.0 as not only the national standard specifications through the e-Business project group of TTA, but also the international standard specifications of WfMC.

• Korean Chemical Engineering Research
• /
• v.56 no.3
• /
• pp.297-302
• /
• 2018

Bead type and hollow fiber type catalyst (HFC, Hollow Fiber type Catalyst) was prepared by $La_{0.1}Sr_{0.9}Co_{0.2}Fe_{0.8}O_{3-{\delta}}$ (LSCF1928) perovskite powder catalyst which showed excellent methane complete oxidation characteristics through previous studies. The HFC have a cylindrical shape with an empty interior, and pores can be formed through Phase inversion method so the specific surface area can be remarkably improved. In the case of the bead type catalyst prepared by adding Methyl Cellulose (MC), $SrCO_3$ was produced in addition to the original catalyst composition of LSCF1928 due to the reaction of $CO_2$ emitted from MC and Sr of the catalyst. In the case of the HFC, a single phase perovskite structure was obtained without impurities. The HFC calcined at $700{\sim}900^{\circ}C$ showed pore structure of finger-sponge-finger structure, and 99.9% oxygen conversion rate was achieved through complete oxidation of methane at $475^{\circ}C$. Air gap and spinning pressure condition were changed to control the HFC pore. 2 cm air gap and 7 bar spinning pressure showed the best catalytic performance and achieved oxygen conversion rates of more than 70.65%, 93.01%, and 99.99% at $425^{\circ}C$, $450^{\circ}C$ and $475^{\circ}C$, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.12 s.103
• /
• pp.1171-1178
• /
• 2005

Multi-code code division multiple access(MC-CDMA) has been proposed for providing the various service rates with different quality of service requirement by assigning multiple codes and increasing the capacity. However, it suffers from the serious problem of high peak to average power ratio(PAPR). So, it requires large input back-off, which causes poor power consumption in high power amplifier(HPA). In this paper, we propose a new method that can reduce PAPR efficiently by constraint codes based on the opposite correlation to the incoming information data in MC-CDMA. PAPR reduction depends on the length and indices of constraint codes in MC-CDMA system. There is a trade-off between PAPR reduction and the length of constraint codes. From the simulation results, we also investigate the BER improvement in AWGN channel with HPA. The simulation results show that BER performance can be similar with linear amplifier in two cases: 1) Using exact constraint codes without input back-off and 2) a few constraint codes with small input back-off.

• The Transactions of the Korea Information Processing Society
• /
• v.6 no.2
• /
• pp.485-496
• /
• 1999

Comparing with sequential programming, parallel programming has additional complexity due to the consideration of parallelism, communication and synchronization of processes. A synergism between users and compliers should be established, each assisting the other to produce high quality parallel programs. On the above underlying philosophy, we developed a parallel Object-Oriented specification language, POOSL, as preliminary works. However, it is still likely to hard for users to write parallel program because users have to consider grammar of POOSL and to write text-based parallel program. It would be more desirable to provide users wit visual environment for effective parallel programming. Therefore, we propose a visual programming environment. VEPO(Visual environment for Parallel Object-Oriented Programming), based on POOSL in order that users can develop parallel programs more easily and conveniently. It aims at supporting a programming environment in which users can represent their programs more naturally and visually I parallel manner with object-oriented concept and essential steps during parallel program development such as program specification, compilation, execution and animation of execution are integrated. VEPO has useful features for parallel processing. Especially, complicated parallel codes for synchronization and communication of processes are automatically generated in the translation phase, so users can be relieved of writing error-prone parallel codes. The system is targeted to the transputer-based parallel system, MC-3. The graphic user interface of VEPO was implemented using Visual C++. Visual programs descirbed on VEPO are translated into Inmos C and executed on MC-3.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.16 no.4
• /
• pp.33-41
• /
• 2006

RSA cryptosystem is of great use in systems such as IC card, mobile system, WPKI, electronic cash, SET, SSL and so on. RSA is performed through modular exponentiation. It is well known that the Montgomery multiplier is efficient in general. The critical path delay of the Montgomery multiplier depends on an addition of three operands, the problem that is taken over carry-propagation makes big influence at an efficiency of Montgomery Multiplier. Recently, the use of the Carry Save Adder(CSA) which has no carry propagation has worked McIvor et al. proposed a couple of Montgomery multiplication for an ideal exponentiation, the one and the other are made of 3 steps and 2 steps of CSA respectively. The latter one is more efficient than the first one in terms of the time complexity. In this paper, for faster operation than the latter one we use binary signed-digit(SD) number system which has no carry-propagation. We propose a new redundant binary adder(RBA) that performs the addition between two binary SD numbers and apply to Montgomery multiplier. Instead of the binary SD addition rule using in existing RBAs, we propose a new addition rule. And, we construct and simulate to the proposed adder using gates provided from SAMSUNG STD130 $0.18{\mu}m$ 1.8V CMOS Standard Cell Library. The result is faster by a minimum 12.46% in terms of the time complexity than McIvor's 2 method and existing RBAs.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.21 no.4
• /
• pp.61-75
• /
• 2011

Recently, there is significant increasing of massive attacks, which try to infect PCs that visit websites containing pre-implanted malicious code. When visiting the websites, these hidden malicious codes can gain monetary profit or can send various cyber attacks such as BOTNET for DDoS attacks, personal information theft and, etc. Also, this kind of malicious activities is continuously increasing, and their evasion techniques become professional and intellectual. So far, the current signature-based detection to detect websites, which contain malicious codes has a limitation to prevent internet users from being exposed to malicious codes. Since, it is impossible to detect with only blacklist when an attacker changes the string in the malicious codes proactively. In this paper, we propose a novel approach that can detect unknown malicious code, which is not well detected by a signature-based detection. Our method can detect new malicious codes even though the codes' signatures are not in the pattern database of Anti-Virus program. Moreover, our method can overcome various obfuscation techniques such as the frequent change of the included redirection URL in the malicious codes. Finally, we confirm that our proposed system shows better detection performance rather than MC-Finder, which adopts pattern matching, Google's crawling based malware site detection, and McAfee.