• Journal of the Korean Geotechnical Society
• /
• v.36 no.2
• /
• pp.5-15
• /
• 2020

The liquefaction phenomenon that occurred during the Pohang earthquake (M_L=5.4) brought new awareness to the people about the risk of liquefaction caused by the earthquake. Liquefaction hazard maps with 2 km grid made in 2014 used more than 100,000 borehole data for the whole country, and regions without soil investigation data were produced using interpolation. In the mapping of macro liquefaction hazard for the whole country, the site amplification effect and the ground water level 0 m were considered. Recently, the Ministry of Public Administration and Security (2018) published a new site classification method and amplification coefficient of the common standard for seismic design. Therefore, it is necessary to rewrite the liquefaction hazard map reflecting the revised amplification coefficient. In this study, the results of site classification according to the average shear wave velocity in soils before and after revision were compared in the whole country. Also, liquefaction assessment results were compared in Gangseo-gu, Busan. At this time, two ground accelerations corresponding to the 500 and 1,000 years of return period and two ground water table, 5 m for the average condition and 0 m the extreme condition were applied. In the drawing of liquefaction hazard map, a 500 m grid was applied to secure a resolution higher than the previous 2 km grid. As a result, the ground conditions that were classified as S_C and S_D grounds based on the existing site classification standard were reclassified as S₂, S₃, and S₄ through the revised site classification standard. Also, the result of the Liquefaction assessments with a return period of 500 years and 1,000 years resulted in a relatively overestimation of the LPI applied with the ground amplification factor before revision. And the results of this study have a great influence on the liquefaction assessment, which is the basis of the creation of the regional liquefaction hazard map using the amplification factor.

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.06a
• /
• pp.246.1-246.1
• /
• 2010

본 연구는 바이오가스의 에너지효율성을 높이기 위한 연구로서 바이오가스 정제공정과 초저온액화공정을 통하여 액화바이오메탄을 생산하는 바이오가스 고질화기술개발 연구이다. 바이오가스 정제공정은 탈황, 제습, 흡착, 압축, $CO_2/CH_4$ 분리공정으로 구성하고, 초저온액화공정은 열교환기, $CO_2$ 제거설비, 질소냉매 공급공정으로 구성하여 혐기성소화조에서 발생하는 바이오가스($CH_4$ 농도: 60~65%, $H_2S$: 1,500~2,500ppm)를 $200Nm^3/hr$의 유량으로 인입시켜 액화바이오메탄을 생산하였다. 연구결과, 탈황공정에서는 가성소다 세정법을 이용하여 1,500~2,500ppm으로 인입되는 $H_2S$를 100ppm 이하로 제거한 후, 흡착법을 이용하여 $H_2S$를 완전히 제거하였다. 바이오가스에 포화된 수분은 냉각제습과 흡착제습공정을 통해 Dew point $-70{\sim}-90^{\circ}C$까지 제거하여 안정적으로 $CO_2/CH_4$ 분리공정에 인입시켰다. $CO_2/CH_4$ 분리공정은 흡착방식을 적용하여 $CH_4$ 순도가 95% 이상인 바이오메탄을 생산하였으며, 이때 메탄 회수율은 약 87%이였다. $CO_2$가 분리된 바이오메탄은 초저온액화공정을 이용하여 액화바이오메탄으로 전환시켰다. 이때 초저온액화공정은 Reverse Brayton cycle로 구성하였으며, 냉매로는 질소를 사용하였다. 액화바이오메탄의 생산은 바이오메탄을 등엔트로피과정인 단열팽창을 통하여 $-155{\sim}-159^{\circ}C$의 초저온으로 냉각되는 질소냉매와 열교환기에서 열교환시켜 이루어졌으며 그 생산량은 $3.46m^3$/day(1bar, $-161^{\circ}C$)이었다.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.4 no.1
• /
• pp.43-70
• /
• 1994

The effects of potassium chromate (500ppm/500ppm), potassium dichromate (500ppm/500ppm), cobalt chloride (100ppm/10ppm), methylmercuric chloride (100ppm/10ppm) on the biosynthesis of phospholipid and their composition of fatty acids in E.coli and B.subtilis were analyzed. The contents of phosphatidylethanolamine, phosphatidylcholine, phosphatidylinositol, phosphatidylglycerol, cardiolipin and total lipids in treatment with metal compounds were lower to compare with the control. The major fatty acid utilized for biosynthesis of phospholipid was palmitic acid in control of E.coli and B.subtilis. However, in treatment with metal compounds, changes of fatty acid composition utilized for phospholipid formation were as follows. In E.coli major fatty acids were palimitic acid (ave. 26.26%) and cis-vaccenic acid (ave. 10.94%) in treatment with potassium chromate, palmitic acid (ave. 31.41%/31.42%) and stearic acid (ave. 17.92%/19.41%) in treatment with potassium dichromate and cobalt chloride. And in treatment with raethylmercuric chloride, palmitic acid (ave. 26.66%), stearic acid (ave. 15.50%) and cis-vaccenic acid (ave. 20.59%) were used in phospholipid formation. In B.subtilis, the major fatty acid was palmitoleic acid (ave. 15.29% /10.22%) in treatment with potassium chromate and cobalt chloride, and stearic acid (ave. 16.01%) in treatment with potassium dichromate. On the other hand, cis-vaccenic acid (ave. 9.09%), palmitic acid (ave. 17.23%), stearic acid (ave. 6.66%), myristic acid (ave. 6.34%) and lauric acid (ave. 4.75%) were analyzed into major fatty acids in treatment with methylmercuric chloride. As shown in results, specific fatty acid pattern was came out in treatment with metal compounds according to bacteria and treatments.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.8 no.1
• /
• pp.25-30
• /
• 1979

A bacterial strain which showed a remarkable tolerance against cadmium was isolated from waste water and identified as a member of Staphylococcus aureus. Heavy metal ions, at the concentration of 10 ppm and other than cadmium, inhibited at least by 30 per cent of turbidometric growth of the organism. The organism exhibited a normal pattern of growth with increasing concentration of cadmium up to 50 ppm. However, they were unable to grow in the concomitant presence of cadmium higher than 500 ppm. In spite of the drastic growth inhibition of cadmium, the organism was able to grow even in the concomitant presence of 500 ppm cadmium when it was previously cultivated for 15 hours with exposing to 10 ppm cadmium or lead.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.4A
• /
• pp.439-446
• /
• 2004

This paper describes high speed and low power design techniques for an 8-bit 500MSamples/s CMOS 2-step ADC. Instead of the conventional closed-loop architecture, the newly proposed ADC adopts open-loop architecture and uses a reset-switch to reduce loading time in an environment of big parasitic-capacitances of mux-array. An analog-latch is also used to reduce power consumption. Simulation result shows that the ADC has the SNDR of 46.91㏈ with a input frequency of 103MHz at 500Msample/s and consumes 203㎽ with a 1.8V single power supply. The chip is designed with a 0.18mm 1-poly 6-metal CMOS technology and occupies active area of 760${\mu}{\textrm}{m}$*800${\mu}{\textrm}{m}$.

• Journal of Practical Agriculture & Fisheries Research
• /
• v.20 no.1
• /
• pp.97-105
• /
• 2018

We assessed the effects of population density on the growth and survival rate of sea cucumber(Stichopus japonicus) in indoor tank Growth of S. japonicus in high density breeding was slow overall, and body weight on 250, 350 and 500 individual/m² group were 31.9g, 26.8g and 21.5g, respectively. The growth rate of body weight was 3.5~5.1 times according to the density of water, and the survival rate was 44.2~50.1%. The growth and survival rate were increased as decreasing the storage density. During the breeding season, small individuals tend not to be large and constantly culled, so it is necessary to set up the sorting period (etc.), and divide S. japonicus into groups of similar size.

• International Journal of Quality Innovation
• /
• v.1 no.1
• /
• pp.106-120
• /
• 2000

The purpose of this research is to understand the effects of Quality Management Award on stock prices movement and to examine the comparative advantages of quality award system in Korea and the U.S. This study compares the performances of QM Award companies in the stock market with those of the market index in both countries. We develop Korean Quality Award Index(KQA Index) based on the Baldrige Index of NIST in the U.S. We inspect three studies. Study 1 tests if the performances of MB Award winners and S&P500 index have a difference in the stock market. Study 2 tests if the performances of KQA winners and KOSPI(Korean Composite Stock Price Index) have a difference in the stock market. Study 3 tests if the performances of KQA winners and MB Award winners have a difference in the stock market. From the empirical tests, the performances of KQA winners are superior to those of KOSPI and the performances of MB Award winners are superior to those of S&P500 and the performances of MB Award winners are superior to those of KQA winners.

• The Bulletin of The Korean Astronomical Society
• /
• v.35 no.2
• /
• pp.53.1-53.1
• /
• 2010

Earth's polar motion has been known for more than one century, and it has been monitored by astrometric observation and recently by space geodetic technique. The Chandler and the annual wobbles are two dominant parts of Earth's polar motion. But according to our recent analysis on a relevant and accurate dataset, another polar motion component, of which period is about 500 days, exists with an amplitude of 20 milliarcseconds in average. This third largest component of polar motion should be caused by resonance of unidentified oscillating mode of Earth, possibly Earth's inner core wobble.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.20 no.2
• /
• pp.105-110
• /
• 2002

For the accuracy assessment of DTM obtained by Airborne Laser Mapping Systems (ALMS), we selected 500 m spaced test points and analyze the accuracy of the DTM by various methods including GPS survey. To estimate the height at the point in between the test points of the DTM we produced a TIN, and to analyze the accuracy we use a GPS coverage map overlaid with the TIN. Compared with the existing method, DTM by ALMS is shown to be relatively accurate, and therefore, ALMS is applicable to 1/5000 digital terrain mapping.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.5
• /
• pp.738-744
• /
• 2017

Recently, the installation of energy storage systems (ESSs) has increased in parallel with the extension of renewable energy resources. However, there has been no concrete analysis ofthe performance verification and economic evaluation of ESSs,which makes it difficult to perform aneffective installation and operation of an ESS. In particular, there are no international technical standards and guidelines on electric ESS for frequency regulation applications. Therefore, acomprehensive study on the power quality, impact on grid, extent of contribution, and cost benefit study of ESS are strongly being required. Under these backgrounds, this paper proposes a performance verification algorithm on ESS for frequency regulation application based on ananalysis of the AGC(Automatic Generation Control) performance verification method of PJM in USA. In addition,this paper proposes an economic evaluation algorithm on a 500 MW installation of ESS for frequency regulation applications using the account settlement of an expensive gas-fired generation plant and coal-fired power generation plant. From the simulation with real ESS operation data and 500 MW installation case, it wasconfirmed that the ESS showssuperior performance toany other conventional generators and provides anannual benefit of 500 MW ESS are between 345~429 billon won.