• The Journal of Korean Academy of Prosthodontics
• /
• v.39 no.1
• /
• pp.84-95
• /
• 2001

Titanium is widely used in dentistry for its low density, high strength, fatigue resistance, corrosion resistance, and biocompatibility. But it has a tendency of surface damage under circumstance of friction and impact for its low hardness of the surface. Coating is one of methods fir increasing surface hardness. Its effect is to improve surface physical characteristics without change of titanium. Diamond-like carbon and titanium nitride are known for its high hardness of the surface. So that this study was aimed at the wear test and the cytotoxicity test of the commercially pure titanium and Ti-6Al-4V alloy which were deposited by diamond-like carbon film or titanium nitride film to acertain improvement of the surface hardness and the biocompatibility. A disk (25mm diameter, 2mm thickness) was made of commercially pure titanium and Ti-6Al-4V alloy and these substrates were deposited by diamond-like carbon film or titanium nitride film. Diamond-like carbon film was deposited by the method of radiofrequency plasma assisted chemical vapor deposition and titanium nitride film was deposited by the method of reactive arc ion plating. Then these substrates were tested about wear characteristics by the pin-on-disk type wear tester in which ruby ball was used as a wear causer under the load of 32N, The fracture cycles were measured by rotating the substrates until their films were fractured. The wear volume was measured after 150 cycles and 3,000 cycles using surface profiler. The cytotoxicity test was peformed by the method of the MTT assay. The results were as follows : 1. In the results of the wear volume test, commercially pure titanium and titanium alloy which were coated by diamond-like carbon film or titanium nitride aim had higher resistance against wear than the substrates which were not coated by any films (P<0.05). 2. In the results of the fracture cycle test and the wear volume test, diamond-like carbon film had higher resistance against wear than titanium nitride film (P<0.05). 3. In both coatings of diamond-like carbon aim and titanium nitride film, Ti-6Al-4V alloy had higher resistance against wear than commercially pure titanium (P<0.05) 4. In the results of the cytotoxicity test, diamond-like carbon film and titanium nitride film had little cytotoxicity as like commercially pure titanium or Ti-6Al-4V alloy (P>0.05).

• Journal of the korean academy of Pediatric Dentistry
• /
• v.27 no.4
• /
• pp.558-563
• /
• 2000

The lasers have been used in dentistry for more than 30 years and the application of lasers for drilling dental hard tissue has been investigated since the early developement of lasers. Recently, the Er:YAG laser was invented for hard tissue ablation. The Er:YAG laser, having a wavelength of 2.94um, is highly absorbed in both water and hydroxiapatite, leading to a very effective material for hard tissue removal by bursting off the solid tissue component that is, enamel and dentin are removed by the Er :YAG laser by water vaporization and microexplosion, without any melting of inorganic tissues. Therefore, the Er:YAG laser produced round craters with well defined margins and the surrounding tissues had no cracks and no charring. When used for cavity preparation, pulpal damage should not occur if hear buildup is minimized by careful selection of exposure parameters and by use of a water spray. The present study demonstrated that the Er:YAG laser cut the tooth substance adequately for composite resin restoration, without having undesirable side effects such as harmful effects on the pulp, discoloration or cracking etc. Also, the child patients were well cooperative during laser treatment mainly because of little noise, lesser vibration and minimal pain compared to conventional means of cavity preparation.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.44 no.2
• /
• pp.161-170
• /
• 2018

Skin aging degree can be objectively measured using the instrumental analysis. The purpose of this study was to evaluate the anti-aging effects of a cream containing 8000 PPM of resveratryl triacetate (RTA) in the human skin test. Twenty female subjects were given test products twice a day for 8 weeks on the face, and wrinkles, sagging, elasticity, dermis denseness, moisture and brightness were measured every 4 weeks by instrument analysis. After 4 and 8 week-use of the test product, total wrinkle area decreased (5.12%, 4.86%), total wrinkle volume decreased (10.53%, 8.41%), sagging decreased (4.69%, 5.91%), elasticity increased (2.84%, 3.98%), dermis denseness increased (15.65%, 20.80%), water content increased (5.83%, 7.37%), lightness ($L^*$ value) increased (0.79%, 1.07%), and individual typology angle ($ITA^{\circ}$) increased (5.43%, 4.95%)compared with the baseline values before treatments, and all these changes were statistically significant (p < 0.05). No adverse skin reactions were observed in all participants during the study period. This study supports the anti-aging effects of the test product.

• The Journal of Korean Academy of Prosthodontics
• /
• v.37 no.2
• /
• pp.212-234
• /
• 1999

Dental restorative materials must have the physical properties to withstand wear and corrosion. Base metal alloys possess better mechanical properties and lower price than the gold alloys. For these reasons such alloys have largely replaced the precious metal alloys. One aspect to con-sider is the release of metal substances to oral environment. The release of elements from dental alloys is a continuing concern because the elements may have the potentially harmful biological effects on local tissues. The purpose of this study was to minimize metal release on the nonprecious metal surfaces by ion beam assisted deposition(IBAD) of titanium nitride (TiN) Ni-Cr-Be alloys with and without TiN coatings were secured in an wear test machine opposing ruby ball to determine their relative resistance to wear with loom, 200m, 300m and 400m sliding distance. And the corrosion behavior of the Ni-Cr-Be alloys with and without TiN coatings and 3 dental noble alloys have been studied. Potentiodynamic curves were used to analyse the corrosion characteristics of the alloys. The measurement of the released Ni and Cr ions was conducted by analysis of the electrolyte solution with atomic absorption spectroscopy. The results were as follows : 1. The critical sliding distance that wore down TiN coatings of $2.5{\mu}m$ thickness in this study condition was 300m. 2. Ion beam assisted deposition of TiN showed a good surface modification with respect to the properties of wear and corrosion resistance. 3. X-ray diffraction showed that the strongest peak of TiN is TiN(111) in the coatings. 4. The release of Ni and Cr ions from alloys measured by means of atomic absorption spectroscopy was reduced by ion beam assisted deposition of TiN.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.41 no.1
• /
• pp.9-20
• /
• 2015

Ultraviolet radiation (UV) is a major cause of skin photoaging, and effective UV protecting agents are needed for the skin health and beauty. This study was undertaken to examine the effects of Bambusae caulis in Taeniam extract (BCTE) on UVB-induced cell death, oxidative stress and matrix metalloproteinase 1 (MMP1) expression in cell-based assays. HaCaT human keratinocytes were exposed to UVB in the presence of BCTE at different concentrations and resulting changes in cell viability and biochemical events were determined. The results showed that BCTE enhanced the viabilities of UVB-exposed cells, and attenuated apoptotic events such as cleavage of procaspase 3 to its active form, and the increase of Bax to Bcl-2 ratios. BCTE also attenuated the reactive oxygen generation and lipid peroxidation in cells exposed to UVB. Additionally, it attenuated the expression of matrix metalloproteinase 1 and the phosphorylation of c-Jun N-terminal kinase stimulated by UVB. Conclusively, the present study demonstrated that BCTE pro tected skin cells from the UVB-induced cell death, oxidative stress and MMP1 expression, suggesting its potential use as a cosmetic ingredient mitigating some features of the skin photoaging.

• ALGAE
• /
• v.37 no.3
• /
• pp.227-237
• /
• 2022

Knowledge on the seaweeds of eastern Sorsogon in the Philippines is uneven. Not only is eastern Sorsogon among the areas of high seaweed diversity but locals there have interacted with seaweeds for ages. Despite seaweeds' assumed importance to Sorsoganon, ethnobotanical records are missing. In this study, we documented the traditional knowledge on seaweed use and determined the rate of knowledge transmission among the locals of eastern Sorsogon. Vernacular names and modes of preparation were given of the 12 identified species bearing culinary and medicinal importance. Ten species were eaten while three were used therapeutically. Based on ethnobotanical indices, Caulerpa chemnitzia ecad turbinata and Gelidiella acerosa were the most important seaweeds. The least cited was Caulerpa racemosa. Our study demonstrated that most of the seaweed resources in eastern Sorsogon remain largely untapped, as the identified ethnotaxa were only about 5% of the total seaweed species diversity reported for the area. The seaweed knowledge in eastern Sorsogon appeared to be homogenous across age groups with primary sources of knowledge biased towards female relatives (mothers and grandmothers) and to children as inheritors. Cessation of seaweed knowledge may come at a potential cost, as a significant fraction of the population did not transmit their knowledge to others. Our study furthered the interest in providing sophisticated resource management recommendations that consider the relationships of traditional and scientific knowledge of seaweed selection and use in eastern Sorsogon and beyond.

• Economic and Environmental Geology
• /
• v.45 no.6
• /
• pp.599-622
• /
• 2012

The phase I soil geochemical exploration was carried out targeting around Chau Binh area far from about 14 km with southeastern direction from Quy Chau within Nghe An province. The interval of sampling are horizontal 300 m with 14 line and longitudinal 500 m with 15 line, resulting in 194 soil samples. Based on the result of the phase I soil geochemical exploration, the phase II detailed pitting survey was carried out targeting the grid point with high TREO content, resulting in 56 soil samples within 7 pits. The geology of survey area are consisted of Ban Chieng biotite granite complex and Dai Loc gneissic granite complex intruding Bu Khang formation comprising of schist, gneiss and limestone. Main mineralization in the study area have the characteristics of occurrence with tin, ruby and REE-bearing monazite(about 300 g/t) and xenotime(about 10 g/t) to be thought as occurring at the alteration zone of granite complex. In order to elucidate the source rock of monazite and xenotime confirmed from heavy sand, soil geochemical exploration was carried out. As a analysis result with ICP-MS on the soil samples from the phase I soil geochemical exploration, total REE oxide content of background amount to about 2 times of crustal abundance, enriching the heavy rare earth(about 2 times) and light rare earth(about 1.84 times). As a analysis result with ICP-MS on the soil samples from the phase II soil detailed pit survey, we identified outcrop considering as economic ore body at the grid point 4-7 pit with N40W attitude. As a synthetic consideration on the phase I soil geochemical exploration and phase II detailed pit survey, we tentatively designated areas considering as the extension of economic ore body with REE anomaly. In the near future, we have the plan to carry out the geophysical exploration and test drilling targeting the interval anticipated to the economic ore body.

• Economic and Environmental Geology
• /
• v.47 no.2
• /
• pp.147-168
• /
• 2014

The soil geochemical exploration was carried out targeting around Tri Le area far from about 30 km with northwestern direction from Que Phong within Nghe An province. The interval of sampling are horizontal 200 m interval with 23 line and longitudinal 300 m with 10 line, resulting in 228 soil samples. Based on the result of the soil geochemical exploration, the detailed pitting survey was carried out targeting the grid point with high TREO content, resulting in 75 soil samples within 7 pits. The geology of survey area are consisted of Ban Chieng biotite granite complex and granitic gneiss intruding Ban Khang formation comprising of quartz schist and marble. Main mineralization in the study area have the characteristics of occurrence with tin, ruby and REE-bearing monazite and xenotime to be thought as occurring at the alteration zone of granite complex. In order to elucidate the source rock of monazite and xenotime confirmed from heavy sand, soil geochemical exploration was carried out. As a analysis result with ICP-MS on the soil samples from the soil geochemical exploration, total REE oxide content of background amount to about 2 times of crustal abundance, enriching the heavy rare earth(about 2 times) and light rare earth(about 1.5 times). As a analysis result with ICP-MS on the soil samples from the soil detailed pit survey, we only identified outcrop considering as economic weathered granite body at the grid point 1-10 pit among 7 pits. As a synthetic consideration on the soil geochemical exploration and detailed pit survey, we tentatively designated Tri Le area as no promising target for REE. In 2014, we have the plan to carry out the soil geochemical exploration targeting the extended economic REE ore body in Quy Chau as project area from 2011 to 2012.

• Journal of Applied Biological Chemistry
• /
• v.63 no.1
• /
• pp.43-50
• /
• 2020

In this study, the anti-oxidative, health functional, and beauty food activities of water and ethanol extracts from newly bred Ruby S apple (Malus pumila Mill.). The results of measuring the 1,1-diphenyl-2-picrylhydrazyl radical scavenging activity by treating the phenolic compound with thinning green ball apple at a concentration of 50-200 ㎍/mL showed that the water and ethanol extracts at a concentration of 200 ㎍/mL showed 94.69 and 92.24%, respectively. 2,2'-Azinobis-(3-ethylbenzothiazoline-6-sulfonic acid) radical scavenging activities showed 100.30 and 99.16%, respectively, in 200 ㎍/mL of water and ethanol extracts. The water and ethanol extracts of Green ball showed antioxidant protection factor of 1.76 PF 1.76, respectively. The water and ethanol extracts showed 101.46 and 99.64% anti-oxidative effect on thiobarbituric acid reactive substances at phenolic concentration of 200 ㎍/mL. The water and ethanol extracts showed 33.28 and 32.14% hyaluronidase inhibition, respectively, at phenolic concentration of 150 ㎍/mL. The water and ethanol extracts showed 47.33 and 40.92% elastase inhibition and 46.19 and 65.58% collagenase inhibition at phenolic concentration of 200 ㎍/mL, respectively. About these experiments, thinning Green ball apple was found to exhibit anti-oxidation activity as well as hyaluronidase, elastase and collagenase inhibitory activities. Therefore, thinning Green ball apple can be considered a potential sources for new functional materials.