• Bulletin of the Korean Chemical Society
• /
• v.18 no.2
• /
• pp.185-189
• /
• 1997

The effect of pH and sodium dodecyl sulfate (SDS) micelle on the quenching of Ru(bpy)32+ luminescence by N-alkyl-4,4'-bipyridinium ions (RBPY+: R=methyl, octyl, dodecyl, benzyl) were investigated. In the absence of SDS, the quenching rate at pH 2 is similar to that of the corresponding methylalkyl viologens and much greater than that in pH 8 solution due to greater reducibility of the protonated form of RBPY+ (HRBPY2+). The quenching rate at pH 2 is strongly enhanced by the presence of SDS, while that at basic pH is greatly retarded. These observations are explained by deep embedment of RBPY+ into the hydrophobic hydrocarbon region of the micelle, whereas Ru(bpy)32+ and HRBPY2+ locate in the Stern layer of the micelle.

• Corrosion Science and Technology
• /
• v.14 no.4
• /
• pp.177-183
• /
• 2015

Prestressed Concrete steel Cylinder Pipe (PCCP) is extensively used as seawater pipes for cooling in nuclear power plants. The internal surface of PCCP is exposed to seawater, while the external surface is in direct contact with underground soil. Therefore, materials and strategies that would reduce the corrosion of its cylindrical steel body and external steel wiring need to be employed. To prevent against the failure of PCCP, operators provided a cathodic protection to the pre-stressing wires. The efficiency of cathodic protection is governed by the anodic performance of the system. A mixed metal oxide (MMO) electrode was developed to meet criteria of low over potential and high corrosion resistance. Increasing coating cycles improved the performance of the anode, but cycling should be minimized due to high materials cost. In this work, the effects of $RuCl_3$ concentration on the electrochemical properties and lifespan of MMO anode were evaluated. With increasing concentration of $RuCl_3$, the oxygen evolution potential lowered and polarization resistance were also reduced but demonstrated an increase in passive current density and oxygen evolution current density. To improve the electrochemical properties of the MMO anode, $RuCl_3$ concentration was increased. As a result, the number of required coating cycles were reduced substantially and the MMO anode achieved an excellent lifespan of over 80 years. Thus, we concluded that the relationship between $RuCl_3$ concentration and coating cycles can be summarized as follows: No. of coating cycle = 0.48*[$RuCl_3$ concentration, $M]^{-0.97}$.

• Journal of the Korean Chemical Society
• /
• v.34 no.6
• /
• pp.652-657
• /
• 1990

Primary amines react with 1,6-hexanediol at 180$^{\circ}C$ for 5 h under argon atmosphere in the presence of both $RuCl_3{\cdot}3H_2$O and $PR_3$ to give N-substituted perhydroazepine derivatives in good yields. For aromatic amines such as anilines, $RuCl_3{\cdot}3H_2$O combined with $PPh_3$ showed the highest catalytic activity. On the other hand, in the reaction of aliphatic amines, $RuCl_3{\cdot}3H_2$O combined with $PBu_3$ showed the highest catalytic activity. These differences may be attributed to the difference in the basicity of these amines. Less basic aromatic amines may require less basic phosphines, while more basic aliphatic amines may require more basic phosphines as the ligands.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.08a
• /
• pp.304-304
• /
• 2010

The study on the catalytic oxidation of carbon monoxide (CO) to carbon dioxide ($CO_2$) using the noble metals has long been the interest subject and the recent progress in nanoscience provides the opportunity to develop new model systems of catalysts in this field. Of the noble metal catalysts, we selected ruthenium (Ru) as metal catalyst due to its unusual catalytic behavior. The size of colloid Ru NPs was controlled by the concentration of Ru precursor and the final reduction temperatures. For catalytic activity of CO oxidation, it was found that the trend is dependent on the size of Ru NPs. In order to explain this trend, the surface oxide layer surrounding the metal core has been suggested as the catalytically active species through several studies. In this poster, we show the influence of surface oxide on Ru NPs on the catalytic activity of CO oxidation using chemical treatments including oxidation, reduction and UV-Ozone surface treatment. The changes occurring to UV-Ozone surface treatment will be characterized with XPS and SEM. The catalytic activity before and after the chemical modification were measured. We discuss the trend of catalytic activity in light of the formation of core-shell type oxide on nanoparticles surfaces.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.63 no.1
• /
• pp.76-79
• /
• 2014

We report Zinc oxide (ZnO) nanorods synthesis and electrochemical luminescence (ECL) cell fabrication. The ECL cell was fabricated using the electrode of ZnO nanorods and Ru(II) complex ($Ru(bpy)_3{^{2+}}$) as a luminescence materials. The fabricated ECL cell is composed of F-doped $SnO_2$ (FTO) glass/ Ru(II)/ZnO nanorods/FTO glass. The highest intensity of the emitting light was obtained at the wavelength of ~620 nm which corresponds to dark-orange color. At a bias voltage of 3V, the measured ECL efficiencies were 5 $cd/m^2$ for cell without ZnO nanorod, 145 $cd/m^2$ for ZnO nanorods-$5{\mu}m$, 208 $cd/m^2$ for ZnO nanorods-$8{\mu}m$ and 275 $cd/m^2$ for ZnO nanorods-$10{\mu}m$, respectively. At a bias voltage of 3.5V, the use of ZnO nanorods increases ECL intensities by about 3 times compared to the typical ECL cell without the use of ZnO nanorods.

• Resources Recycling
• /
• v.20 no.2
• /
• pp.60-66
• /
• 2011

Solvent extraction experiments were carried out to recover and separate Ru(III) from aqueous hydrochloric acid media using TBP and Cyanex923. The efficiency of the extraction was studied under various experimental conditions, such as concentration of HCl and NaCl, concentration of extractant in the organic phase and temperature. The extraction behavior of metal impurities, such as Pt, Bi, Sn, Fe, Pb and Cu in mixed solutions was examined. From the experimental studies, it was found that the Cyanex923 resulted in higher extraction percentage of Ru than TBP. However TBP was more effective for the separation of Ru and Pt, Bi, Sn in mixed solutions than Cyanex923.

• Bulletin of the Korean Chemical Society
• /
• v.9 no.5
• /
• pp.317-322
• /
• 1988

Premicellar precipitation, resolubilization and luminescing behaviors of $RuL_3^{2+}$ (L = bpy, phen, $Me_2bpy$) in aqueous alkylsulfate and sulfonate solutions were studied. Addition of the anionic surfactants to $RuL_3\;^{2+}$ solutions caused initial precipitation which was redissolved by further addition of the surfactants. The apparent solubility products $K_{sp}$'s of the precipitates were evaluated assuming 1:2 salt formation. The values were smaller as the ligand is more hydrophobic and the length of hydrocarbon chain of the surfactant is longer. The $K_{sp}$ values for L = bpy were constant over wide surfactant concentration range. However, those for L = $Me_2bpy$ and also for phen, but to less extent, increased with the surfactant concentration. The resolubilization of 1:2 salts was followed by red-shift of emission band and extensive emission quenching above critical concentration of the surfactants. The critical concentration was lower for more hydrophobic surfactant. For L = $Me_2bpy$, the blue-shifted emission band with enhanced emission intensity was observed in intermediate surfactant concentration region. The high ionic strength of media prevented the precipitate formation, but facilitated the red-shift of the emission bands. The results support that the precipitate is dissolved by accretion of surfactant anions to the salts to form water-soluble surfactant-rich $RuL_3$-surfactant anionic species. These species appeared to aggregate cooperatively to produce large clusters which exhibited the red-shifted emission.

• Korean Journal of Metals and Materials
• /
• v.49 no.5
• /
• pp.395-399
• /
• 2011

In this study, micro gas sensors for ammonia gas were prepared by adopting MEMS technology and using a sol-gel process. Three types of sensors were prepared via different synthesis routes starting with W sol and Ru sol mixture. This mixture was deposited on a MEMS platform and the platform was subsegueny heated to a temperature of $350^{\circ}C$. The topography and crystal structure of the sensing film were studied using FE-SEM and XRD. The response of the gas sensor to $NH_3$ gas was examined at various operating temperatures and gas concentrations. The sensor response increased almost linearly with gas concentration and the best sensing response was obtained at $333^{\circ}C$ for 5.0 ppm $NH_3$ for the specimen prepared by coating $WO_3$ powders with the Ru sol mixture.

• Corrosion Science and Technology
• /
• v.21 no.5
• /
• pp.340-347
• /
• 2022

In this research, mixed metal oxide (TiO₂, RuO₂) coating was applied to grade 1 titanium as a bipolar plate for polymer electrolyte membrane fuel cell (PEMFC). Electrochemical experiments were carried out in an aqueous solution of pH 3 (H₂SO₄ + 0.1 ppm HF, 80 ℃) determined by DoE. The air was bubbled to simulate a cathode environment. Potentiodynamic polarization test revealed that corrosion current densities of the titanium substrate and MMO-coated specimen were 0.180 µA/cm² and 4.381 µA/cm², respectively. There was no active peak. After potentiostatic experiment, current densities of the titanium substrate and the MMO-coated specimen were 0.19 µA/cm² and 1.05 µA/cm², respectively. As a result of observing the surface before and after the potentiostatic experiment, cracked dried clay structures were observed without corrosion damage. Both the titanium substrate and the MMO-coated specimen could not satisfy the interfacial contact resistance suggested by the DoE. Thus, further research is needed before they could be applied as bipolar plates.

• Nuclear Engineering and Technology
• /
• v.16 no.2
• /
• pp.58-63
• /
• 1984

Paper electrophoretic separation of octahedrally bonded (Ruc $l_{6}$ )$^{3-}$ has been carried out by using the specially designed migration apparatus. The supporting electrolyte solutions are as follows: 0.1M-HCl $O_4$, 0.05 M-HCl+0.09M-KCl, 0.1M-HCl, 5$\times$10$^{-3}$ M-NTA, 0.01M-HCl, 0.01M-HCl $O_4$, 0.01M-citric acid, 0.01M-K $H_2$P $O_4$+0.01M-N $a_2$HP $O_4$, 0.05M-borax, 0.025M-N $a_2$C $O_3$+0.025M-NaHC $O_3$, 0.01M-N $a_3$P $O_4$, 0.01M-NaOH and 0.1 M-NaOH. The (Ruc $l_{6}$ )$^{3-}$ appears in 2 to 4 peaks and is found in several chemical species such as (RuCl ($H_2O$)$_{5}$ )$^{2+}$, cis and trans (RuC $l_2$($H_2O$)$_4$)$^{1+}$, (RuC $l_3$($H_2O$)$_3$)$^{0}$ , (RuC $l_4$($H_2O$)$_2$)$^{1-}$, (RuC $l_{5}$ ($H_2O$))$^{2-}$ and (RuC $l_{6}$ )$^{3-}$. The retention value has been found to be highest in the 0.025M-N $a_2$C $O_3$+0.025M-NaHC $O_3$ electrolyte solution.n.