• Journal of Powder Materials
• /
• v.19 no.6
• /
• pp.416-423
• /
• 2012

This paper introduces an effect of a preparing $ZrO_2$-Ag composite on its mechanical properties and microstructure. In present study, $ZrO_2$-Ag was prepared by reduction-deposition route and wetting dispersive milling method, respectively. Two type of Ag powders (nano Ag and micron Ag size, respectively) were dispersed into $ZrO_2$ powder during wetting dispersive milling in D.I. water. Each sample was sintered at $1450^{\circ}C$ for 2hr in atmosphere, and then several mechanical tests and analysis of microstructure were carried out by bending test, hardness, fracture toughness and fracture surface microstructure. As for microstructure, the Ag coated $ZrO_2$ showed homogeneously dispersed Ag in $ZrO_2$ in where pore defect did not appear. However, $ZrO_2$-nano Ag and $ZrO_2$-micro Ag composite appeared Ag aggregation and its pore defect, which carried out low mechanical property and wide error function value.

• Health Policy and Management
• /
• v.21 no.4
• /
• pp.541-564
• /
• 2011

This study aimed to investigate health outcome of acute myocardial infarction (AMI) patients such as mortality and length of stay in hospital and to identify factors associated with the health outcome according to the comorbidity index. Nation-wide representative samples of 3,748 adult inpatients aged between 20-85 years with acute myocardial infarction were derived from the Korea National Hospital Discharge Injury Survey, 2005-2008. Comorbidity index was measured using the Charlson Comorbidity Index (CCI). The data were analyzed using t-test, ANOVA, multiple regression, logistic regression analysis in order to investigate the effect of comorbidity on health outcome. According to the study results, the factors associated with length of hospital stay of acute myocardial infarction patients were gender, insurance type, residential area scale, admission route, PCI perform, CABG perform, and CCI. The factors associated with mortality of acute myocardial infarction patients were age, admission route, PCI perform, and CCI. CCI with a higher length of hospital stay and mortality also increased significantly. This study demonstrated comorbidity risk adjustment for health outcome and presented important data for health care policy. In the future study, more detailed and adequate comorbidity measurement tool should be developed, so patients' severity can be adjusted accurately.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.9 no.5
• /
• pp.1790-1806
• /
• 2015

Utility-based routing is a special type of routing approach using a composite utility metric when making routing decisions in ad hoc and sensor networks. Previous studies on the utility-based routing all use fixed retry limit and a very simple distance related energy model, which makes the utility maximization less efficient and the implementation separated from practice. In this paper, we refine the basic utility model by capturing the correlation of the transmit power, the retry limit, the link reliability and the energy cost. A routing algorithm based on the refined utility model with adaptive transmit power and retry limit allocation is proposed. With this algorithm, packets with different priorities will automatically receive utility-optimal delivery. The design of this algorithm is based on the observation that for a given benefit, there exists a utility-maximum route with optimal transmit power and retry limit allocated to intermediate forwarding nodes. Delivery along the utility-optimal route makes a good balance between the energy cost and the reliability according to the value of the packets. Both centralized algorithm and distributed implementations are discussed. Simulations prove the satisfying performance of the proposed algorithm.

• Journal of Korean Society for Atmospheric Environment
• /
• v.8 no.2
• /
• pp.100-104
• /
• 1992

The research in this paper centers on a comparative risk assessment for nearby air pollution by carcinogenic metal emission from municipal solid waste incinerators. If a substance is identified as a potential human carcinogen, the carcinogenicity may be related to the chemical form of a substance and the route of exposure. This type of information with regard to carcinogenic uncertainty is incorporated into hazard quantification. In addition to the dioxin emission, the metal emission from municipal solid waste incineration is found to be a major contributor to human cancer risk via the inhalation route. The magnitude of risk by metals is about 5 times greater than that of risk by dioxins. Hexavalent form of chromium and cadmium compounds are major contributors to cancer risk from metal emission. In addition, hexavalent chromium is known to be human carcinogen while 2,3,7,8-TCDD is known to be only probable human carcinogen.

• Proceedings of the KSR Conference
• /
• 2009.05a
• /
• pp.831-839
• /
• 2009

An interlocking equipment of railway signalling systems is manufactured with electrical devices and electrical interlocking equipment has been substituted for existing interlock equipment(relay sequential logic type). But interlock conditions are still generated from rail diagram and used to make Interlock Table manually. In order to make EIS(Electrical Interlock System) operate, we should write interlock data which is made from interlock table. But, as the station is larger and more complicated, handwork may becomes a very tediou work and makes more mistakes. Therefore the development of CAD system for Interlocking System is very significant, if CAD can reduce the mistakes from handwork and help the configuring the interlocking system. In this paper, we first arrange some rules which can be used to extract route information automatically from rail diagram and interlocking rules. And then we propose "Search-And-Rollback" algorithm to extract route information and individual interlocking rules. The proposed algorithm is implemented and tested through the signal design process of the Hyundai-Steel private railway to carry melted pig iron from the blast furnace to the steel-making workshop. some cases. It shows that CAD for Interlocking system is very helpful in time saving aspect and system reliability.

• Journal of the Korea Society of Computer and Information
• /
• v.11 no.1 s.39
• /
• pp.147-155
• /
• 2006

Hierarchical Prefix Delegation (HPD) protocol refers to a type of solution to problems inherent in non-optimal routing which occurs with Network Mobility (NEMO) basic solution. However, because HPD cannot improve the micro-mobility problems, problem surfaces each time Mobile Network Node (MNN) changes the attachment point; as happens also in a Mobile IPv6 (MIPv6) protocol in sending Binding Update (BU) messages to Home Agent (HA) / Correspondent Nodes(CNs). By applying Hierarchical Mobile IPv6 protocol concept to HPD, this study proposes an algorithm for effectively handling micro-mobility problems which occur with HPD in a nested NEMO environment. By sending BU only to nearby Mobility Anchor Point(MAP) during MNN location change within a MAP's domain, the proposed protocol will alleviate service disruption delays and signaling loads during the handover process, overcoming the limitations of HPD.

• Aerospace Engineering and Technology
• /
• v.12 no.1
• /
• pp.173-181
• /
• 2013

In this paper, the design result of the trajectory-based air traffic analysis software which is going to be used to assess air-traffic efficiency in case that some modification's made in dynamic airspace configuration, is described. The software has been developed to make statistical data about air-traffic in Incheon FIR based on the RPL, and to analyze the airway utilization and controller workload using the trajectory modeling data which are derived from the aircraft type, cruise speed, cruise altitude, and routes and fixes in the RPL. Since it batch-processes the long-term trajectory data with other inputs such as airspace, route information and so on, it has the advantage of quickly predicting the traffic variation when some change in airspace and route information is made.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.36 no.3
• /
• pp.71-78
• /
• 2013

An efficient vehicle routing heuristic for different vehicle moving times for forward and backward between two points is studied in this research. Symmetric distance or moving times are assumed to move back and forth between two points in general, but it is not true in reality. Also, various moving speeds along time zones are considered such as the moving time differences between rush hours or not busy daytimes. To solve this type of extremely complicated combinatorial optimization problems, delivery zones are specified and delivery orders are determined for promising results on the first stage. Then delivery orders in each zone are determined to be connected with other zones for a tentative complete delivery route. Improvement steps are followed to get an effective delivery route for unsymmetric-time-varing vehicle moving speed problems. Performance evaluations are done to show the effectiveness of the suggested heuristic using computer programs specially designed and developed using C++.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2004.04a
• /
• pp.343-350
• /
• 2004

LNGC suffers a great heat inflow during navigation and this heat inflow inevitably boils off the LNG. The boiled off gas(BOG) is normally consumed as a fuel for ship's engine. The boiled off LNG means a loss of cargo during transportation from the viewpoint of shipper. Therefore, a contract between shipper and ship operator is made on the limit of boiled off rate(BOR) under 0.15 ％／day based on laden voyage. This contract on BOR limit requires that ship's officer has a correct knowledge on BOR for his ship. But, in most cases ship is operated based on only officer's experiences. In this study, author presented a simple model to predict the boiled off gas(BOG) during navigation based on the existing precision heat exchange design technology about the heat distribution on the hull and heat inflow from outside through the hull. The BOG is calculated for ballast and laden voyage based on the actual weather conditions and verified by comparing with the measured BOG for the study ship. The study ship is a membrane type LNGC which is now servicing in Middle east route. Thus, the BOG prediction method which is presented in this study is expected to be used for an useful tool to manage the BOG in now servicing LNGC.

• Journal of the Korean Institute of Navigation
• /
• v.19 no.2
• /
• pp.23-75
• /
• 1995

A major change occuring in the workplace is the willingness of union leaders, managers, and workers to experiment with various work schedules and to work toward the improvement in the QWL(quality of work life). In this study, the writer measures the level of QWL, embodies components of QWL, testifies the difference of QWL according to the demographical traits, and develops some scales to measure QWL in merchant ships. To achieve objectives of the paper, 11 hypotheses were established and a questionnaire was used, 894 proper data was obtained from 2, 910 Korean seamen working in merchant ships. Results of analyses are as follows : 1) The components of QWL in merchant ships are job, employee satisfaction, wage, welfare, working condition, supervise, colleague relations, initiative, and organization management. 2) Seamen of merchant ships are satisfied with job, supervise, colleague relations, and organization management. They are dissatisfied employee satisfaction, wage, welfare, and working condition. 3) According to demographical traits, the number of the factors significant difference(P<0.05) among components of QWL are 9 for type of ships, 8 ages of seamen, 7 for married or single, nationality of ships, and education level respectively, 5 for seamen career, for 4 rank on board and trading route of ships respectively, 2 for whether union or not and whether union involvement or not respectively, and 1 for department on board. 4) Results which tested hypotheses are as follows : For the components of QWL, married men are more satisfactory than an unmarried men, officers are more dissatisfactory than ratings, old men are more satisfactory than young men, men in high education level are more dissatisfactory than men in low education level, those who are much careers as a seaman are more satisfactory than those who are little careers as a seaman. There are significant differences in the components of QWL according to nationality and type of ships. There are insignificant differences in the components of QWL according to the shipboard department, whether union is or not, whether union involvement is or not, and trading route of ships.