• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2000.05a
• /
• pp.747-752
• /
• 2000

Rotary shearing using of rotating and locally shear force has been studied. It is possible to be obtained in any case for requested blank diameters. In this paper, different local forming zones, that are clearances between upper roller and vertically taped low roller, were investigated. Required shearing force is calculated by undecided coefficient method for clearances and strokes of upper roller. Rotary shearing is completed undergoing some processes composed of pressing steps and standing steps. The reason for using these processes is to avoid jamming or tearing of blank by means of upper roller during shearing.

• 제어로봇시스템학회:학술대회논문집
• /
• 1987.10a
• /
• pp.759-764
• /
• 1987

The design and application of optimal control technique to the rotary shearing system is mentioned in this paper. To maximize the accuracy in both shearing length and blade speed at shearing, time-varying gain patterns for closed loop control are designed on the basis of fixed terminal time constrained optimal regulator. The performance accuracy in real application has greatly improved than the conventional way of shearing control.

• Journal of Biosystems Engineering
• /
• v.15 no.3
• /
• pp.177-185
• /
• 1990

The break of rotary blade is occured from a stress concentration of the inside of blade by the outside impulsive load. In order to examine its inside stress and stress concentration of rotary blade, a epoxy plate which is suitable to applicate by photoelastic system is used to experiment. These results are summarized as follow. 1. Refer to the existence of bolt hole and a size of its of rotary blade, a stress concentration which cause the break of rotary blade is not exposed. 2. It is expected to be break to section of hold of rotary blade and the break of this is due to that there are concentrated by shearing force, bending moment and bending stress. 3. When the crack which caused from processing are set up to any location, the stress concentration taken to the creak point. 4. Without regard to the location of the reaction points of rotary blade, the bending stress which is greated than the bending moment is occured within about 6 em toward the center line of bolt hole and it was possible to break that section.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2003.06a
• /
• pp.1824-1827
• /
• 2003

The sheet metal shearing process is normally used in the precision elements such as semi-conductor components. In precision elements, burrs usually reduce the quality of machined parts and cause interference, jamming and misalignment during assembly procedures and because of their sharpness, they can be safety hazard to personnel. Furthermore, not only burrs are hard to predict and avoid, but also deburring, the process of removing burrs, is time-consuming and costly. In order to get the burr-free parts, therefore, we developed the precise burr measuring system using the laser. The laser burr measuring system consists of the laser probe, the photo detector, the achromatic doublet lens, and the rotary ＆ the X-Y table. In previous reports, we used simple vertical measuring method. But, as we used relatively bigger laser spot diameter and had the limited reflection angle, it was difficult to obtain the precise measuring results. So called, the spot size effect makes the profile of burr measured distorted and the burr height measured smaller. By introducing the novel laser measuring method which employing the achromatic lens system and the tilting mechanism, we could make the spot size smaller and get the appropriate beam direction angle. Through the experiments, the accuracy of the developed system is proved. The burr height measured during the punching process can be used for automatic deburring and in-situ aligning.