• 한국전산유체공학회지
• /
• 제17권3호
• /
• pp.59-67
• /
• 2012

Large Eddy Simulation(LES) of turbulent mass transfer in fully developed turbulent pipe flow has been performed to study the effect of Reynolds number on the concentration fields at $Re_{\tau}=180$, 395, 590 based on friction velocity and pipe radius. Dynamic subgrid-scale models for the turbulent subgrid-scale stresses and mass fluxes were employed to close the governing equations. Fully developed turbulent pipe flows with constant mass flux imposed at the wall are studied for Sc=0.71. The mean concentration profiles and turbulent intensities obtained from the present LES are in good agreement with the previous numerical and experimental results currently available. The effects of Reynolds number on the turbulent mass transfer are identified in the higher-order statistics(Skewness and Flatness factor) and instantaneous concentration fields. The budgets of turbulent mass fluxes and concentration variance were computed and analyzed to elucidate the effect of Reynolds number on turbulent mass transfer. Furthermore, to understand the correlation between near-wall turbulence structure and concentration fluctuation, we present an octant analysis in the vicinity of the pipe wall.

• 대한기계학회논문집B
• /
• 제25권2호
• /
• pp.156-163
• /
• 2001

The experiment is conducted on the rapidly rotating incompressible flow within a confined cylinder using LDV(Laser Doppler Velocimetry). The configurations of interest are the flows between a rotating upper disk with a bar and a stationary lower disk enclosed within a cylinder. The flow is considered to be an axisymmetric undisturbed basic flow. The results show that the flow is strongly dependent on the radius and the shape of bar but is negligibly affected by the Reynolds number in turbulent flow. It is observed that in the lid-driven case the main forms near the wall as the Reynolds number increases. The thin bar causes the second axial flow due to the suction effect and the thick bar causes the main flow to be pulled toward the surface of the bar. The step bar shows the dual effect of the two. 1:2 tilt bar shows that the main flow distributes wider than the other cases in which interference occurs due step bar.

• 대한기계학회논문집B
• /
• 제24권6호
• /
• pp.822-833
• /
• 2000

This experimental study concerns the characteristics of a transitional flow in a concentric annulus with a diameter ratio of 0.52, whose outer cylinder is stationary and inner one rotating. The pressure drops and skin-friction coefficients have been measured for the fully developed flow of water and that of glycerine-water solution (44%) at a inner cylinder rotational speed of $0{\sim}600$ rpm, respectively. The transitional flow has been examined by the measurement of pressure drops and the visualization of flow field, to reveal the relation of the Reynolds and Rossby numbers with the skin-friction coefficients and to understand the flow instability mechanism. The present results show that the skin-friction coefficients have the significant relation with the Rossby numbers, only for laminar regime. The occurrence of transition has been checked by the gradient changes of pressure drops and skin-friction coefficients with respect to the Reynolds numbers. The increasing rate of skin-friction coefficient due to the rotation is uniform for laminar flow regime, whereas it is suddenly reduced for transitional flow regime and, then, it is gradually declined for turbulent flow regime. Consequently, the critical (axial-flow) Reynolds number decreases as the rotational speed increases. Thus, the rotation of inner cylinder promotes the early occurrence of transition due to the excitation of taylor vortices.

• Journal of Advanced Marine Engineering and Technology
• /
• 제21권4호
• /
• pp.430-436
• /
• 1997

Time-dependent Flow characteristics of a two-dimensional lid-driven square cavity flow of six high Reynolds numbers, $10^4 2{\times}lO^4., 3{\times}l0^4, 5{\times}lO^4, 7.5{\times}lO^4$ and $10^5$ were investigated. A convection conservative difference scheme based upon SOLA to maintain the nearly 2nd-order spatial accuracy was adopted on irregular grid formation. Irregular grid number is $80{\times}80$ and its minimum size is about 1/400 of the cavity height(H) and its maximum is about 1/53 H. The result shows that at Re= $10^4$, periodic migration of small eddies appearing in corner separation region and its temporal sinusoidal fluctuation are represented. And another critical Reynolds number which shows the commencement of flow randomness emerging from the periodic fluctuation is assumed to be around Re= $1.5{\times}10$. At five higher Reynolds numbers ($2{\times}lO^4., 3{\times}l0^4, 5{\times}lO^4, 7.5{\times}lO^4$ and $10^5$), an organizing structure of four consecutive vortices similar to a Moffat vortex at two lower corners is revealed from time-mean flow patterns.

• 동력기계공학회지
• /
• 제5권1호
• /
• pp.21-26
• /
• 2001

This paper represents the turbulent intensity, the turbulent kinetic energy and Reynolds shear stress in the X-Y plane of cone type swirl gas burner measured by using X-probe from the hot-wire anemometer system. The experiment is carried out at flowrate 350 and $450{\ell}/min$ respectively in the test section of subsonic wind tunnel. The turbulent intensity and the turbulent kinetic energy show that the maximum value is formed in the narrow slits distributed radially on the edge of a cone type swirl burner, hence, the combustion reaction is anticipated to occur actively near this region. And the turbulent intensities ${\upsilon}\;and\;{\omega}$ are disappeared faster than the turbulent intensity u due to the inclined flow velocity ejecting from the swirl vanes of a cone type baffle plate of burner. Moreover, the Reynolds shear stress $u{\upsilon}$ is distributed about three times as large as the Reynolds shear stress $u{\omega}$ in the outer region of the cone type gas burner.

• 대한기계학회논문집B
• /
• 제21권5호
• /
• pp.637-649
• /
• 1997

Effects of cone angle, pressure-hole orientation and Reynolds number on the five-hole probe calibration have been investigated for eight large-scale conical five-hole probes, which have either perpendicular pressure holes or forward-facing pressure holes for the cone angles of 45 deg, 60 deg, 75 deg and 90.deg. Pitch and yaw angles are changed from -40 deg to +40 deg with an interval of 5 deg, respectively, when the probe Reynolds numbers are 1.77*10$^{4}$, 3.53*10$^{4}$ and 7.06*10$^{4}$. The result shows that larger cone angle results in more sensitive changes in the calibration coefficients. In the case that the cone angle is 45 deg, the pitch-angle and yaw-angle coefficients of the five-hole probe with the perpendicular pressure holes show a very different trend compared with those of the five-hole probe with the forward-facing pressure holes. On the other hand, when the cone angle is more than 60 deg, each calibration coefficient is nearly independent of the pressure-hole orientation. Additionally, the effects of the Reynolds number on the calibration coefficients are also reported in detail.

• 설비공학논문집
• /
• 제18권11호
• /
• pp.888-895
• /
• 2006

The present study has been conducted to investigate the effects of Reynolds number on heat/mass transfer and pressure drop characteristics in a rotating smooth two-pass duct. For stationary cases, the heat/mass transfer and pressure drop Is decreased on turning region of both leading and trailing surfaces as Reynolds number increases. For rotating cases, increment of Reynolds number affects differently the heat/mass transfer and pressure drop on the leading and trailing surfaces. In the first pass, for example, the heat/mass transfer on the leading surface is greatly increased, though the heat/mass transfer on the trailing surface is almost the same. The reason is that effect of the main flow is more dominant than effect of secondary flow. In particular, it gave decrement of the heat/mass transfer and the pressure drop at turning region and upstream region of second pass for both non-rotating and rotating cases.

• 한국가스학회지
• /
• 제19권5호
• /
• pp.69-74
• /
• 2015

본 연구의 목적은 촉매가 삽입된 단일 개질관 내 가스의 주입 속도와 버너의 고온공기 주입온도에 따른 3차원 전산 유체 해석(Fluent ver. 16.1)을 수행하여, 열유동 및 화학반응 특성을 파악하는 것이다. 개질관 내부 촉매는 니크롬 재질의 다공성 영역으로 가정하였다. 메탄-수증기 개질반응은 1000 K 이상의 고온 환경에서 작동하므로 전도, 대류 및 복사를 고려한 복합열전달을 해석했다. 수소 개질량을 비교하기 위한 두 개의 레이놀즈 수는 49,000과 88,000이고, 레이놀즈 수가 88,000인 경우, 고온공기의 온도를 각각 1100 K, 1200 K 및 1300 K로 설정하였다. 수치해석 결과, 레이놀즈 수가 낮을 경우 개질관 내부의 온도가 상승하였으며, 수소 개질량도 증가하였다. 레이놀즈 수가 높을수록 상대적으로 온도가 낮은 가스의 대류 열전달량이 증가하여 개질관 내의 온도는 낮아져 수소 개질량은 감소한다. 그리고 고온 공기의 온도가 높을수록 개질관 내부의 온도가 증가하므로, 수소 개질량도 증가한다.

• 항공우주시스템공학회지
• /
• 제9권1호
• /
• pp.7-11
• /
• 2015

최근 무인기와 초소형비행체를 위한 프로펠러 연구수요가 증가하고 있다. 일반적인 프로펠러와 다른 점은 저 레이놀즈수 유동조건에서 구동된다는 점이다. 본 연구는 저 레이놀즈수 유동조건에서 비행하는 인간 동력 항공기를 위한 프로펠러 공력설계 및 성능해석에 관한 연구다. 저 레이놀즈수 유동조건에서 발생하는 공력천이현상을 고려한 3차원 공력특성 변화를 정확히 반영하지 못하는 상용 프로그램의 단점을 보완하여 프로펠러 공력설계 및 성능해석이 가능한 프로그램을 개발했다. 개발된 프로그램으로 인간 동력 항공기 설계요구조건에 충족하는 프로펠러 공력설계 및 성능해석을 수행하였다. 또한 프로펠러 회전수와 장착각도 변화에 따른 성능변화를 예측하여 비행당시 상황에 따라 비행 가능한 성능출력이 가능하도록 하였다.

• 한국전산유체공학회지
• /
• 제16권2호
• /
• pp.62-65
• /
• 2011

Characteristics of the pressure drop in an expanded bed have been compared to those in a packed bed for numerical study of the interphase drag in gas-particle flows. A numerical analysis of the pressure drop by the particle drag has been conducted according to the tube-to-particle diameter ratios and Reynolds numbers for comparison. As the tube-to-particle diameter ratios increase at the same Reynolds number, the pressure drop tends to converge. It has been confirmed that characteristics of the pressure drop in the expanded bed are similar to those in the packed bed.