• Interaction and multiscale mechanics
• /
• 제1권2호
• /
• pp.177-190
• /
• 2008

In this paper, both experimental measurement and theoretical analysis are used to investigate the out-of-plane resonant characteristics of a cantilevered piezoceramic plate in air and three different kinds of fluid. The experimental method, amplitude-fluctuation electronic speckle pattern interferometry (AF-ESPI), is the major technique used in this study to measure the resonant characteristics of the cantilivered piezoceramic plate. Both resonant frequencies and full-field mode shapes are obtained from this experimental technique. Numerical computations based on the finite element analysis are presented for comparison with the experimental results. Good quality of mode shapes for the cantilevered piezoceramic plate in air is obtained from the AF-ESPI technique. However, the quality decreases as the viscosity of fluids increases. From the results provided from experimental measurements and numerical computations, it is indicated that the resonant frequencies of the cantilevered piezoceramic plate in fluid decrease with the increase of the viscosity of fluids. Good agreements between the experimental measured data and the numerical calculated results are found for both resonant frequencies and mode shapes of the cantilevered piezoceramic plate in fluid.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제55권6호
• /
• pp.314-324
• /
• 2006

In recent years, having the advantages of being small, low in cost and high in efficiency, Half-wave resonant type, (having only one output diode), is used in ZVS Half-Bridge DC/DC converter. This paper presents the operation mode by multi-resonant factors in the Half-wave type multi-resonant converter with direct Buck chopper circuit operated in discontinuous current mode. To study the characteristics of a multi-resonant operation in steady-state, the characteristic impedances in each mode and safe operation-region(S.O.R) are reported. Computer simulation and experimental data are also riven to verify the theoretical results.

• Journal of Power Electronics
• /
• 제6권2호
• /
• pp.95-103
• /
• 2006

In this paper, a novel prototype of auxiliary switched capacitor assisted voltage source soft switching PWM Single-Ended Push Pull (SEPP) series capacitor compensated load resonant inverter with two auxiliary edge resonant lossless inductor snubbers is proposed and discussed for small scale consumer high-frequency induction heating (IH) appliances. The operation principle of this inverter is described by using switching mode equivalent circuits. The newly developed multi resonant high-frequency inverter using trench gate IGBTs can regulate its output AC power via constant frequency edge-resonant associated soft switching commutation by using an asymmetrical PWM control or duty cycle control scheme. The brand-new consumer IH products which use the newly proposed edge-resonant soft switching PWM-SEPP type series load resonant high-frequency inverters are evaluated using power regulation characteristics, actual efficiency vs. duty cycle and input power vs. actual efficiency characteristics. Their operating performance compared with some conventional soft switching high-frequency inverters for IH appliances is discussed on the basis of simulation and experimental results. The practical effectiveness of the newly proposed soft switching PWM SEPP series load resonant inverter is verified from an application point of view as being suitable for consumer high-frequency IH appliances.

• 대한후두음성언어의학회지
• /
• 제11권2호
• /
• pp.146-160
• /
• 2000

The current study aimed to establish rationales for using three different voice therapies (resonant voice, accent method, and tongue-tip trills) by comparing the aerodynamic, and vocal fold closure characteristics under three therapies. A total of 8 male under/graduate students(tenors) participated as subjects. In order to compare aerodynamic characteristics, air flow rates and subglottal pressures were measured using Phonatory function analyzer under three therapy conditions. The characteristics of vocal fold closure patterns also were examined by comparing closed quotients(CQ) measured by Electroglottograph(EGG) under three therapy conditions. However, maximum phonation time (MPT) was measured under only resonant voice and tongue-tip trills using Aerophone II. The results are summarized as follows : 1) CQ, subglottal pressure and MPT decreased significantly under resonant voice as compared with throat voice, but the air flow rate increased significantly under resonant voice. 2) CQ decreased significantly under accent method as compared with throat voice, but both air flow rate and subglottal pressure increased significantly under accent method. 3) Both CQ and MPT decreased significantly under tongue tip trills as compared with throat voice, but air flow rate and subglottal pressure increased significantly under tongue-tip trills. Clinical implications of results were discussed in light of differential effects of three voice therapies.

• 한국군사과학기술학회지
• /
• 제21권4호
• /
• pp.413-421
• /
• 2018

The pyroshocks can cause failure of electronics devices and structures. Metal-metal impact methods are utilized to simulate mechanical pyroshock, and to adjust the knee frquency of the SRS(Shock Response Spectrum) through resonant structures. In this paper, the major parameters of pyroshock simulation device which affect the SRS were examined. Through the Hertzian contact law and the modal characteristics of the resonant bar, it was found that the SRS is affected by the length and mass of a bar and various impact conditions such as velocity and mass of impactor. The characteristics due to the geometric parameters of a resonant bar was analyzed by performing FEA and also the resonant bar was designed and fabricated. Through the pyroshock simulation test, the characteristics of SRS due to the variation of impact parameters were examined.

• 전력전자학회논문지
• /
• 제14권4호
• /
• pp.323-332
• /
• 2009

본 논문에서는 다 출력 LLC 공진 컨버터의 동작 특성 대해 서술하였고 분석하였다. 특히 다 출력 변압기의 2차 측 인덕턴스와 여러 부하조건에 따른 영향에 의해 다 출력 LLC 공진 컨버터의 전압이득특성 및 등가공진주파수가 변한다. 따라서 출력이 다 출력일 때 부하에 따른 공진 특성 변화와 이득 변화를 확인하였고, 또한 부하 동 특성을 고려한 설계와 전압이득 특성을 기본으로 하여 42인치 PDP TV용 전원에 540W 3-output LLC 공진컨버터를 적용하여 실험한 결과를 보였다.

• 한국자동차공학회논문집
• /
• 제5권5호
• /
• pp.104-113
• /
• 1997

In this paper, the effects of intake manifold systems on volumetric efficiency were investigated in the 4-cylinder 4-stroke cycle diesel engines. The effects of intake manifold system were analyzed on resonant speed and on volumetric efficiency. Resonant speed was calculated by acoustic theory and volumetric efficiency by the method of characteristics. The calculation results agreed well with rest results. It was assured that between the resonant speed and the volumetric efficiency there exists good correlation in multi-cylinder engines. As the results, the prediction of resonant speed was useful to design the optimum intake system. It was assured that the intake manifold systems for BOX-type and RAM-type have different characteristics on the trend of volumetric efficiency. Also a procedure to design the desirable intake manifold system was proposed.

• 전력전자학회논문지
• /
• 제17권4호
• /
• pp.281-290
• /
• 2012

This paper describes a Cross-regulation characteristics of a multi-output LLC resonant converter widely used in consumer electronics. The output characteristics of the multi-output LLC converter is derived from the assumption that the current and voltage in the resonant network is sinusoidal and the duty loss exists. The simulation and experimental results are provided to verify the theoretic results.

• 전기학회논문지P
• /
• 제51권4호
• /
• pp.193-197
• /
• 2002

In this paper, the ultrasonic sensor for gas flowmeter was simulated, fabricated and measured according to the assembly step and the piezoelectric vibrator layers. The simulated resonant frequency and the measured resonant frequency were similar except two layer sensor. The simulated resonant frequency of three layer sensor was 48 kHz and the measured resonant frequency of three layer sensor was 45.2 kHz. From the results, the ultrasonic sensor for gas flowmeter could be designed and expected without fabrication.

• 전기학회논문지
• /
• 제56권7호
• /
• pp.1250-1254
• /
• 2007

The multi-resonant(MR) converter has a characteristics that the parasitic components existing in the converter are absorbed into the resonant circuits. The designed MR converter could be got a high efficiency and a high power density because the switching power losses are reduced effectively due to resonant switching circuit. However, the high resonant voltage stress of switching power devices leads to the conduction loss. In this paper, it is proposed the novel alternated(AT) flyback multi-resonant converter to overcome such a drawback. The suggested converter dc input is divided by two series input filter capacitors. The resonant stress voltage is reduced to 2-3 times the input voltage without any complexity and it provides the various circuit schemes in lots of applications. The proposed flyback MR converter is verified through simulation and experiment.