• 한국자기학회지
• /
• 제23권5호
• /
• pp.173-177
• /
• 2013

본 연구에서는 구형(sphere) 용기 내 작동유체로 물과 자성유체(ferrofluid)를 사용하였을 경우의 구형 용기의 병진 운동에 따른 슬로싱(sloshing) 현상에 대하여 실험적으로 고찰하였고 두 가지 작동유체에서 나타나는 특성을 비교하였다. 구형 용기의 병진운동에 따른 슬로싱 현상을 고찰하기 위하여, 자기장(magnetic field)을 0 mT에서 50 mT로 변화시키고, 가진 진폭을 5 mm에서 15 mm로 변화시켜가면서 실험을 수행하였다. 결과적으로, 구형 용기내의 자성유체는 자기장를 인가하지 않았을 때 물과 유사한 액면거동 현상을 나타내었고, 자성유체에 인가되는 자기장 세기가 증가할수록 공진점(resonance point) 발생이 이론공진주파수(theoretical resonance frequency)보다 높은 영역에서 발생함을 확인하였다. 즉 용기 내 슬로싱은 자성유체를 사용할 경우 인가 자기장의 크기에 따라 공진점이 발생하는 공진주파수를 제어할 수 있으며 액면 변위의 크기를 제어할 수 있었다.

• 소음진동
• /
• 제8권2호
• /
• pp.346-352
• /
• 1998

This paper presents actuating characteristics of an asymmetric high-speed optical pick-up fine actuator that can be installed in a small area such as a notebook personal computer. In the asymmetric actuator four points (mass center, actuation center, supporting point of wire suspension on a bobbin, and optical axis) are not coincident so that the proposed actuator suspension reveals undesirable suspension resonance in the pitch and yaw direction. Lumped parameter dynamic model in each direction is used to investigate the driving characteristics with respect to relative location of the four points. Some of desired design directions toward reducing resonance peaks are suggested by using sensitivity information. In order to avoid undesirable resonance, at least supporting point on the obbin must be located in the middle of the mass and actuation center of the asymmetric pick-up actuator.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2003년도 추계종합학술대회
• /
• pp.381-384
• /
• 2003

In this paper, cobalt (Co)-electrode FBAR devices fabricated on seven-layered Bragg Reflectors are presented along with their resonance characteristics. ZnO films are used as the resonating material in FBAR devices where the Co electrode is 3000$\AA$ thick. All processes are preformed in an RF magnetron sputtering system. As a result of characterization, the resonance characteristics are observed to depend strongly on the quality of ZnO film and Bragg Reflectors. In addition, the FBAR devices with W/SiO$_2$ reflectors show good resonance characteristics in term of return loss and quality-factor (Q-factor).

• 한국전기전자재료학회논문지
• /
• 제16권8호
• /
• pp.688-692
• /
• 2003

For high voltage operation, a new type of piezoelectric transformer using radial vibration of disk, poled with the same direction was proposed. The piezoelectric ceramics was composed to PZT-PMN-PSN. The diameter and thickness of a disk type piezoelectric transformer were 45［mm］and 4［mm］, respectively The surface ratio of driving electrode and generating electrode of the piezoelectric transformer was 2 : 1. The resonance characteristics of input admittance, step-up voltage ratio and power transmission efficiency of the piezoelectric transformer were measured by varying the load resistance(0.1∼70［kΩ］). As a result, both resonance frequency and step-up voltage ratio increased with increasing load resistance. The step-up voltage ratio was reached more than 60 times under no load resistance. The maximum efficiency of 97% at load resistance of 2kΩ was obtained.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2005년도 춘계종합학술대회
• /
• pp.371-375
• /
• 2005

In this paper, the resonance characteristics of ZnO-based FBAR devices are compared. Several FBAR device samples were fabricated by using three different annealing methods while one sample remained non-annealed as a reference for comparison. Resonance characteristics could be significantly improved by both Bragg reflector-annealing and/or post-annealing steps. Especially, the use of two-step annealings resulted in most desirable resonance characteristic improvement compared with the Bragg reflector-annealing or post-annealing step alone.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2007년도 추계종합학술대회
• /
• pp.204-207
• /
• 2007

Film bulk acoustic wave resonator (FBAR) technology has attracted a great attention as a promising technology to fabricate the next-generation RF filters mainly because the FBAR technology can be integrated with current Si processing. The RF filters are basically composed of several FBAR devices connected in parallel and in series, and their characteristics depend highly on the FBAR device characteristics. Thus, it is important to design high quality FBAR devices by device or process optimization. This kind of effort may enhance the FBAR device characteristics, eventually leading to FBAR filters of high performance. In this paper, we describe the methods to more effectively improve the resonance characteristics of the FBAR devices.

• Journal of Biosystems Engineering
• /
• 제34권4호
• /
• pp.260-268
• /
• 2009

As a basic study to develop a high sensitive biosensor using film bulk acoustic resonator, the mathematical model for analyzing the resonance characteristics of bulk acoustic resonator with acoustic Bragg reflectors was investigated. The simulation results due to the number of acoustic Bragg reflectors with low and high acoustic impedance materials were compared with the experimental results for 1, 2.25 and 5 MHz of PZT based bulk acoustic resonators with various acoustic Bragg reflectors. At the fabricated bulk acoustic resonator with an odd number of acoustic Bragg reflectors, low and high acoustic impedance materials in sequence under the bottom electrode showed better resonance characteristics than even number of acoustic Bragg reflectors. The changes of resonance frequencies due to the increase of number of acoustic Bragg reflectors by simulation and experiment, respectively showed approximately similar tendency but some differences in input impedance between the experiment and simulation were found. The derived mathematical model for describing the resonance characteristics of the bulk acoustic resonator with acoustic Bragg reflector will be available for analyzing the design parameters for development of biosensor using bulk acoustic resonator.

• 대한기계학회논문집A
• /
• 제28권2호
• /
• pp.118-124
• /
• 2004

The objective of the paper is to demonstrate the noise reduction characteristics of an air-gap resonator, which is composed of an air gap and a partition sheet. By means of installing the air-gap resonator in an enclosed cavity, acoustic resonance can be effectively suppressed using a small space. In particular, it is revealed from a simple, one-dimensional model that the air-gap resonator serves as the Helmholtz resonator that generally absorbs acoustic resonance energy at its resonance frequency. As a result, the air-8ap resonator also has a resonance frequency, which can be predicted with a simple frequency equation derived in the paper. Finally, verification experiments show that the air-gap resonator can be effectively designed by predicting a reasonable gap thickness using the simple frequency-equation.

• Transactions on Electrical and Electronic Materials
• /
• 제6권4호
• /
• pp.159-163
• /
• 2005

We analyzed the fault current limiting characteristics of a flux-lock type $high-T_c$ super­conducting fault current limiter (HTSC-FCL) using series resonance between capacitor for series resonance and magnetic field coil which was installed in coil 3. The capacitor for the series resonance in the flux-lock type HTSC-FCL was inserted in series with the magnetic field coil to apply enough magnetic field into HTSC element, which resulted in higher resistance of HTSC element. However, the impedance of the flux lock type HTSC-FCL has started to decrease since the current of coil 3 exceeded one of coil 2 after a fault accident. The decrease in the impedance of the FCL causes the line current to increase and, if continues, the capacitor for the series resonance to be destructed. To avoid this operation, the flux-lock type HTSC-FCL requires an additional device such as fault current interrupter or control circuit for magnetic field. From the experimental results, we investigated the parameter range where the operation as mentioned above for the designed flux-lock type HTSC-FCL using series resonance occurred.

• 한국음향학회지
• /
• 제16권1호
• /
• pp.76-80
• /
• 1997

Hofler 타입의 열음향 냉장시스템에 있어서 음향학적 공진특성을 해석하고, 공진특성이 냉장성능에 미치는 영향을 시스템의 제작 및 냉장 실험을 통하여 확인하였다. 열음향 냉장시스템의 공진특성을 결정하는 주요 인자는 공명구(cavity)와 가는 관, 그리고 굵은 관으로 구성되는 공명기의 특성과, 구동 스피커의 특성, 그리고 스피커 후면부의 음향학적 특성이며, 다시 스피커의 전기적 특성과 결합되어 전기적 공진특성이 정해진다. 또한 공명기에서 발생하는 벽-효과(wall effect)를 통한 감쇠로 인하여 공진특성이 둔해진다. 제작된 열음향 냉장시스템에 대한 해석 및 실험결과 전체 공진특성은 공명기에 의하여 결정되지만 후면부의 강성과 감쇠로 인하여 공진특성이 상당히 둔화되고, 냉장실험 결과 정확한 공진특성의 유지가 냉장성능에 큰 영향을 마침을 확인하였다.