• 대한의용생체공학회:의공학회지
• /
• 제24권5호
• /
• pp.453-458
• /
• 2003

압전식 쇄석기를 이용하여 충격파를 대상물에 조사할 때 들리는 소리의 발생지가 바로 충격당하는 대상물이란 사실을 실험을 통하여 확인하였다. 하이드로폰과 소리가 발생되는 음원과의 거리 및 방위각을 추정함으로써 방사음의 위치를 추정하는 방법을 이용하였으며, 센서로서는 한 개의 하이드로폰을 사용하였다. 또한, 진동 특성이 뚜렷한 금속모델을 대상물로 선정하여 그 대상물로부터의 방사음과 진동과의 관계를 조사한 결과를 제시하여, 방사음이 대상물에 관한 정보를 포함하고 있다는 사실을 보다 명백히 검증하였다.

• Clinics in Shoulder and Elbow
• /
• 제19권2호
• /
• pp.96-100
• /
• 2016

We encountered a rare condition of rice body in subacromial and subdeltoid spaces in a patient with unremarkable medical history. Although it is uncommon, there have been continued reports on its formation in certain type of infective and inflammatory arthritis. However, except for a traumatic event, evaluation yielded no known and conceivable cause for his chronic inflammatory bursitis. Relatively typical findings for rice body on magnetic resonance imaging have been described, and in our case the imaging prompted us to schedule early removal, which is generally accepted as the management of choice to prevent further progression of symptoms. The symptoms of the shoulder showed significant improvement, and a close follow-up schedule has been recommended for observation of recurrence and development of any foreseeable underlying cause.

• Journal of Magnetics
• /
• 제18권2호
• /
• pp.168-172
• /
• 2013

We have developed a high-field and high-frequency ESR system using a commercially available magnetometer equipped with the superconducting quantum interference device (SQUID). This is magnetization detection type ESR and ESR is observed as a change of the magnetization at the resonance condition under irradiation of the electromagnetic wave. The frequency range is from 70 to 315 GHz and the maximum magnetic field is 5 T. The sensitivity is estimated to be $10^{13}$ spins/G. The advantage of this system is that the high-field ESR measurements can be made very easily and quantitatively. Moreover, this high-field ESR can be applied to the measurements under pressure by using a widely used piston-cylinder pressure cell.

• 한국초전도ㆍ저온공학회논문지
• /
• 제4권2호
• /
• pp.58-62
• /
• 2002

The purpose of this study is to analyze the charging gas effect on the resonance and performance characteristics of the linear compressor for small scale FPFD Stirling refrigerator. To ensure high performance of FPFD type Stirling refrigerator, the operating frequency of the refrigerator should be around the natural frequency of compressor. The gas spring effect which is induced from Pressure change in cylinder due to motion of pistons has significant effect on the natural frequency of the compressor. The numerical results show the linear compressor has high natural frequency when the charging pressure of working fluid is high and the stroke of compressor, current, input power and efficiency of compressor were shown with different operating conditions.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1988년도 전기.전자공학 학술대회 논문집
• /
• pp.802-805
• /
• 1988

The objective of the present study was to manufacture the piezoelectric composites of Lead Zirconate Titanate (PZT) - polymer for applications such as ultrasonic medical diagnosis and hydrophone. The PZT rod-polymer composites have been prepared with 4.5 to 57 volume percent PZT using 1.5 mm rod, so the connectivity pattern of the two phase is 1-3 type. The electromechanical coupling factors of radial mode ($k_{p}$) and thickness mode ($k_{t}$) were nearly independent of the volume percent PZT, which were 0.3 and 0.65, respectively. The acoustic impedance of the piezoelectric composites was measured by the resonance technique in the frequency range 50 KHz-1.5 MHz, which was in the range of 3.8 - 60 Mrayl.

• Journal of electromagnetic engineering and science
• /
• 제2권2호
• /
• pp.105-111
• /
• 2002

New high-performance Ka-band waveguide-to-microstrip transitions for millimeter-wave transceiver applications have been developed and characterized. These transitions are probe-type, but the dielectric material completely covers the whole waveguide aperture, thus providing moisture-barrier and robustness in the probe section. The new probe transitions are also designed to be less sensitive to fabrication tolerances. Further performance enhancements have been obtained by placing vias around the waveguide aperture. Also, the resonance phenomena associated with waveguide wall-penetration have been identified. The developed probe transitions provide insertion loss less than 0.4 dB over entire Ka-band frequencies, but can be optimized for narrowband applications with insertion loss less than 0.2 dB.

• E2M - 전기 전자와 첨단 소재
• /
• 제10권8호
• /
• pp.813-818
• /
• 1997

In this study the thin film air core and magnetic core inductors consisting of planar coil and/or CoNbZr amorphous magnetic layers on a Si substrate were fabricated as spiral type by using rf magnetron sputtering and wet etching methods. The etchant solution was achieved by iron chloride solution(17.5 mol%) mixed with HF (20 mol%) during 150 sec which etched Cu films and CoNbZr/Cu/CoNbZr multi-layer films. They were about 10${\mu}{\textrm}{m}$ of thickness and 10$\times$10 mm$^2$of size. The properties of thin film magnetic core inductor were 400 nH of Q value at 10 MHz and the resonance frequency was about 300 MHz.

• 한국전기전자재료학회논문지
• /
• 제16권12S호
• /
• pp.1224-1231
• /
• 2003

This paper reports on the air-gap type thin film bulk acoustic wave resonator(FBAR) using ultra thin wafer with thickness of 50$\mu\textrm{m}$. It was fabricated to realize a small size devices and integrated objects using MEMS technology for flexible microsystems. To reduce a error of experiment, MATLAB simulation was executed using material characteristic coefficient. Fabricated thin FBAR consisted of piezoelectric film sandwiched between metal electrodes. Used piezoelectric film was the aluminum nitride(AlN) and electrode was the molybdenum(Mo). Thin wafer was fabricated by wet etching and dry etching, and then handling wafer was used to prevent damage of FBAR. The series resonance frequency and the parallel frequency measured were 2.447㎓ and 2.487㎓, respectively. Active area is 100${\times}$100$\mu\textrm{m}$$^2$.Q-factor was 996.68 and K$^2$$\_$eff/ was 3.91％.

• Journal of Korean Neurosurgical Society
• /
• 제46권3호
• /
• pp.257-260
• /
• 2009

Intraventricular hemorrhage long after successful encephaloduroarterio synangiosis (EDAS) is very rare. The effect of revascularization surgery for preventing hemorrhagic event of moyamoya disease remains controversial. We report a 17-year-old female with intracerebral hemorrhage and intraventricular hemorrahge 10 years after successful EDAS. Even though cerebral vessels angiography showed good collateral circulations without specific weak points, a cerebral hemorrhage could occur in patient with ischemic type of moyamoya disease long after successful indirect bypass operations. Good collateralization of cerebral angiography or magnetic resonance perfusion image after indirect bypass surgery would ensure against ischemic symptoms, not a hemorrhage. And, thus a life-time follow-up strategy might be necessary even if a good collateral circulation has been established.

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제4권4호
• /
• pp.437-446
• /
• 2012

An ocean buoy energy farm is considered for Green energy generation and delivery to small towns along the Korean coast. The present study presents that the floating buoy-type energy farm appears to be sufficiently feasible for trapping more energy compared to affixed cylinder duck array. It is also seen from the numerical results that the resonated waves between spaced buoys are further trapped by floating buoy motion.Our numerical study is analyzed by a plane-wave approximation, in which evanescent mode effects are included in a modified mild-slope equation based on the scattering characteristics for a single buoy.