• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제55권5호
• /
• pp.239-244
• /
• 2006

To drive the high-image quality plasma displays of XGA and/or full-HD, we must effectively improve the driving waveform, which get the reset period for the stabilized control of wall charges, the address period to select discharge or non-discharge, and sustain period for luminance in 1 TV-frame, and also the display quality. To accomplish them, the development of the technology for the fast address discharge is required. In this paper, the correlation between the sustain-electrode gap and address discharge characteristics for the high-speed addressing was analyzed using the measurements of dynamic voltage margins. Results showed that the narrower the gap between the sustain electrodes, the narrower the with of the scan pulse became and a dynamic margin of data voltage of 29.2 V was obtained at scan pulse width of $1.0{\mu}s\;and\;V_{ramp}$ of 240 V for driving 4-inch test penal, which the gap between sustain electrodes was $65{\mu}m$.

• 비만대사연구학술지
• /
• 제2권1호
• /
• pp.6-10
• /
• 2023

Compensatory changes in energy consumption and neuro-hormonal changes following weight loss make it difficult to maintain the reduced weight and may cause weight regain. Therefore, establishing a long-term weight control plan and strategy starting from the initial weight loss period is necessary. Both the patient and doctor should know that weight loss cannot occur continuously, and that maintaining weight after the weight loss period is the basic course of obesity treatment. No single dietary pattern is effective for weight maintenance, and a variety of dietary control methods - such as calorie restriction and healthy proportions of carbohydrates, proteins, fats, and meal replacements - should be used to target an integrated and healthy dietary habit. An increase in physical activity is needed for weight loss and maintenance; however, rather than recommending an excessive amount of exercise, it is better to set realistic and long-term achievable goals. It is necessary to reset the goal according to the patient's weight maintenance stage and continuously apply behavioral therapies, such as self-monitoring and stress management. In previous studies, since the degree of weight loss and changes in behavioral patterns over the course of one year were important factors in maintaining long-term weight loss, obesity therapists should closely examine patient data and behavioral patterns across a period of one year and actively intervene when needed.

• 한국산학기술학회논문지
• /
• 제22권2호
• /
• pp.113-118
• /
• 2021

무기체계는 최근 고도의 신기술과 비용이 투자되어 첨단화, 정밀화 복합 기능화 등의 특징을 가진 형태로 변화하고 있다. 유도무기체계의 경우 주어진 임무를 한번만 수행하게 되는 One-Shot 시스템으로서 전원이 인가되어 임무를 수행하기까지 오랜 시간 동안 저장 되는 것이 특징이다. 이에 따라 유도무기체계의 경우도 경제적인 운용과 사용자의 안전성을 보장하는 측면에서 신뢰성이 보장되어야 한다. 특히 유도무기체계 중 보증탄의 형태로 개발된 유도탄의 경우, 개발단계 시 장기 저장 환경을 고려한 신뢰도 유지 기준이 제시 되고 이를 유지하기 위한 최적화된 점검주기가 필요하다. 본 연구는 현재 군에서 장기간 운용 중인 OO 유도탄을 대상으로 점검주기 간 발생한 정비현황 및 사격결과를 기초로 수학적 모형에 의한 추세 검정, 적합도 검정, 분포 분석 등을 통하여 실측 신뢰도를 산출한다. 이를 통하여 개발단계 시 설정된 점검주기 모델(Martinez 기법)에 적용하여 개선된 점검주기를 활용 가능한지 여부를 판단한다. 마지막으로 이러한 연구 결과 자료를 종합하여 점검주기 연장에 따른 정책적 관리방안을 제언한다.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제48권9호
• /
• pp.467-475
• /
• 1999

This paper presents an analysis method of a forward converter, using both the finite element method considering the external circuit and a state variables equation. The converter operates at 50kHz and its one period is divided into two modes for the simplicity of the analysis. In the first mode, the switching transistor turns on and an input power is transferred into the load by the electromagnetic conversion action of a ferrite transformer. In the second mode, the switching transistor turns off and the stored energy in an inductor is delivered to the load, and the transformer core is demagnetized by the reset winding current. In this paper, time-stepping finite element method taking into account the on-state electrical circuit of the converter in used to analyze both the electrical circuit and electromagnetic field of the magnetic device during the first mode and the demagnetization period of the transformer core. Then a state variables equation for the circuit which the inductor current flows is constituted and solved during the second mode. As a result, the simulation results have been good agreement with the results obtained form experiment.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제53권8호
• /
• pp.407-414
• /
• 2004

In this paper, a new gray scale expression method that divides the scan lines into multiple blocks is suggested. The proposed method can drive 16 sub-fields per 1 TV field in the panel with XGA ($1366{\times}768$) resolution. The on and off states of even subfields depend on the condition of odd subfields. The write address mode is used in the odd subfields, while the erase address mode is used in the even subfields. Because the ramp reset pulse is applied every 2 sub-fields, both the contrast ratio and the dynamic voltage margin are sufficiently obtained in comparison with previous AWD (Address While Display) methods. In realizing 16 subfields, shortening the scan time in the erase address period was important. The X bias voltage in the erase address period affected the minimum address voltage but did not the delay time of the address discharge. The delay time of the address discharge was affected by the address voltage and the time interval between the last sustain discharge and the scanning time. We also evaluated the dynamic false contour. New method shows an improved image quality in horizontal moving, but discontinuous lines were observed at the boundaries of each block in vertical moving

• Transactions on Electrical and Electronic Materials
• /
• 제11권1호
• /
• pp.20-23
• /
• 2010

The analog front end (AFE) of a radio frequency identification transponder using the ISO 14443 type A standard with a 100% amplitude shift keying (ASK) modulation is proposed in this paper and verified by circuit simulations and measurements. This AFE circuit, using a 13.56 MHz carrier frequency, consists of a rectifier, a modulator, a demodulator, a regulator, a power on reset, and a dynamically enabled digital phase locked loop (DPLL). The DPLL, with a charge pump enable circuit, was used to recover the clock of a 100% modulated ASK signal during the pause period. A high voltage lateral double diffused metal-oxide semiconductor transistor was used to protect the rectifier and the clock recovery circuit from high voltages. The proposed AFE was fabricated using the $0.18\;{\mu}m$ standard CMOS process, with an AFE core size of $350\;{\mu}m\;{\times}\;230\;{\mu}m$. The measurement results show that the DPLL, using a demodulator output signal, generates a constant 1.695 MHz clock during the pause period of the 100% ASK signal.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2004년도 Asia Display / IMID 04
• /
• pp.153-156
• /
• 2004

A newly developed flexible active-matrix (AM-) electrophoretic display (EPD) is reported. The AM-EPD features: (1) low-temperature polycrystalline silicon (LTPS) thin film transistor (TFT) technology, (2) fully integrated scan- and data-drivers, (3) flexibility and light-weight realized by transferring the whole circuits onto a plastic substrate using $SUFTLA^{TM}$ (Surface Free Technology by Laser Annealing/Ablation) process. A large storage capacitor is formed in each pixel so that driving electric field can be kept sufficiently strong during a writing period Two-phase driving scheme, a reset-phase which erases a previous image and a writing-phase for writing a new image, was chosen to cope with EPD's high driving voltage. The flexible AM-EPD has been successfully operated with a driving voltage of 8.5 V.

• 품질경영학회지
• /
• 제26권4호
• /
• pp.51-64
• /
• 1998

Mean shifts may be found in tool wear in machining, drawing, stamping and moulding operations, which make the process quality level deteriorate over time. In such situations, it is necessary to reset or readjust the manufacturing process at regular time basis or by inspection to prevent defective items produced. Although the deterioration rate may be assumed to be linear in a production cycle, there are many cases where the rate varies after resetting due to the variation of tool characteristics or by using the resharpened tools. In such cases, the deterioration rate should not be assumed to be a deterministic constant but a random variable. This paper is to find an optimal resetting period and quality level for such production processes.

• Journal of Information Display
• /
• 제7권4호
• /
• pp.24-26
• /
• 2006

We have developed a new driving method named TROPHY(Talented Role-playing Technology with Dual Polarity sustainer in Hybrid Mono board). In this method, the sustain voltage is partially compared to the conventional method and the number of power sources is reduced by voltage level unification during the reset, address and sustain period. The hybrid mono board was especially developed to implement those technologies. Through this, we can lower the cost with the TROPHY compared to the conventional one. It is a suitable technology to improve the reliability of circuit and image sticking problem. We can also reduce the number of driving boards and the EMI problem compared with those of the conventional method.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2006년도 6th International Meeting on Information Display
• /
• pp.246-249
• /
• 2006

We have developed a new driving method named TROPHY(Talented Role-playing Technology with Dual Polarity sustainer in Hybrid Mono board). In this method, the sustain voltage is halved compared to the conventional method and the number of power sources is reduced by voltage level unification during the reset, address and sustain period. The hybrid mono board was especially developed to implement those technologies. Therefore, we can lower the cost with the TROPHY compared to the conventional one. It is suitable technology to improve the reliability of circuit and image sticking problem. We can also reduce the number of driving boards and the EMI problem comparing to those of the conventional method.