• The Journal of Korean Academy of Prosthodontics
• /
• v.35 no.4
• /
• pp.706-718
• /
• 1997

Ceramometal crowns are common restorations in fixed prosthodontics because of their casting accuracy, the high strength properties of the metal, and the cosmetic appearance of porcelain. However, deterioration of the initial fit of the metal coping has been observed after the porcelain firing cycle. The distortion due to repeated firing makes it difficult to fit crown margin and elicits microleakage. The major causes of distortion are the residual stress that accumulate during wax-up, casting, cold work and the induced stress caused by the mismatch of porcelain-metal thermal contraction. This study examined the marginal fit changes of metal copings in relation to repeated firing and the effects of heat treatment that reduce the distortion resulted from residual stress. The marginal changes of the copings that were treated with conventional method and those treated with heat before repeated firing, were evaluated. The metal die which represented preparations of a maxillary central incisor was fabricated, and 45 wax patterns were cast with nonprecious metal alloys. The heat treatment of each group was performed as follows. Group 1(control) : Casting - Devesting - Cold work - Firing Group 2 : Casting - Heat treatment - Devesting - Cold work - Firing Group 3 : Casting - Devesting - Cold work - Reinvesting - Heat treatment - Devesting - Firing The copings were fired 3 times. After each firing, the marginal fit changes were measured with inverted metallurgical microscope at the 4 reference points located at labial, lingual, and both proximal surface. Measurements were compared, and statistically analyzed. The results were as follows ; 1. In all groups, the highest value of marginal fit changes of the copings studied were found after the first firing cycle. 2. When the distortion of each experimental group at the first firing cycle were compared, group 1 exhibited the greatest changes($20-27{\mu}m$), followed by group 2($9-13{\mu}m$), and group 3($8-10{\mu}m$). 3. The copings treated with heat before devesting(group 2) revealed significantly smaller marginal fit changes than the copings treated with conventional method(group 1). (p<0.01) 4. The copings treated with heat after reinvesting(group 3) revealed significantly smaller marginal fit changes than the copings treated with conventional method(group 1). (p<0.01) 5. No siginificant differences in marginal fit changes were found between the copings treated with heat before devesting(group 2) and the copings treated with heat after reinvesting(group 3). (p>0.01)

• Journal of Korean Society of Forest Science
• /
• v.104 no.1
• /
• pp.111-116
• /
• 2015

The purpose of this study was to evaluate mixed model of dbh-height relation containing random effect. Data were obtained from a survey site for Quercus variabilis in Gangwon region and remeasured the same site after three years. The mixed model were used to fixed effect in the dbh-height relation for Quercus variabilis, with random effect representing correlation of survey period were obtained. To verify the evaluation of the model for random effect, the akaike information criterion (abbreviated as, AIC) was used to calculate the variance-covariance matrix, and residual of repeated data. The estimated variance-covariance matrix, and residual were -0.0291, 0.1007, respectively. The model with random effect (AIC = -215.5) has low AIC value, comparison with model with fixed effect (AIC = -154.4). It is for this reason that random effect associated with categorical data is used in the data fitting process, the model can be calibrated to fit repeated site by obtaining measurements. Therefore, the results of this study could be useful method for developing model using repeated measurement.

• Mycobiology
• /
• v.30 no.4
• /
• pp.240-243
• /
• 2002

Embellisia allii causing bulb canker of white garlic(Allium sativum) has been observed on harvested or stored garlic bulbs. Identification of the fungus was determined based on the symptoms and morphological characteristics on in vitro potato dextrose agar(PDA) and malt extract agar(MEA). Colonies were effuse, blackish brown to black, velvety or powdery. Conidia were solitary, almost straight, most commonly ellipsoidal(or subcylindrical) to ovoid, mid to dark brown, smooth, with very dark 1 to 6 transverse(commonly $3{\sim}4$) and occasionally 1 or 2 oblique or longitudinal septa, and $30.4{\times}13.4{\mu}m$(av.). Conidiophores were simple or branched, straight or flexuous, up to 80 ${\mu}m$ long and $5.1{\sim}10.2{\mu}m$ thick. Chlamydospores were developed through enlargement and repeated cellular division of several adjacent hyphal cells to form a complex of thickwalled cells. The conidial measurements of garlic isolates closely matched the previous description of E. allii.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.32A no.1
• /
• pp.53-60
• /
• 1995

The aims of this study are to evaluate the measurement capability of the electromagnetic power and to understand the current state of standard maintanance of the eight participants among the thirteen national calibration and test organizations. The calibration factors were measured at six test frequencies, 50, 100, 500, 1000, 5000, 10000 MHz by organizations and KRISS on the basis of round robin test. The results were analyzed by calculating the standard deviation of the measured values from the standard values. The analysis shows good agreement within 1.0% for all participants at the measurement frequencies. Therefore, the measurement capability of all participants is good in the frequency range of 50 MHz to 10 GHz. For the four participants which specified standard deviations of repeated measurements in their reporst, the total uncertainties is less than 1.9% at the measurement frequencies.

• Proceedings of the KSMRM Conference
• /
• 2001.11a
• /
• pp.169-169
• /
• 2001

Purpose： To assess the clinical usefulness of Transfer Insensitive Labeling Technique (TILT) in t evaluation of ischemic cerebrovascular disease. Method： Arterial spin labeling (ASL) is a method of perfusion weighted imaging usin endogenous water as a tracer. To avoid MT-related artifacts, which is common in usual A technique, a transfer insensitive labeling technique (TILT) was used, which globall manipulate macromolecular spins in the same way by both labeling and reference preparatio while free water is labeled in one case and left unchanged in the other. Philips Interal 1.5 T system was used. 40cm FOV and 32 repeated measurements were done because of the wea perfusion signal. 5 slices of supratentorial brain were obtained in 5 patients ｛MCA infar (n=3), moyamoya disease (n=2)｝. We simultaneously obtained contrast enhanced T2＊-weighted perfusion MRI and correlate to TILT images.

• 한국가시화정보학회:학술대회논문집
• /
• 2003.11a
• /
• pp.87-90
• /
• 2003

In this paper, flow characteristics of plasma flow in a micro-tube were investigated experimentally using Micro-PIV. For comparision, the experiments were repeated for DI-water instead of plasma. Both velocity profiles of Plasma and DI-water are well agreed with the theoretical velocity distribution of newtonian fluid. We also carried out generating plasma-in-oil droplet formation at a Y-junction microchannel. In order to clarify the hydrodynamic aspects involved in plasma droplet formation. Rhodamin B were mixed with plasma only for visualization of plasma droplet.

• Archives of Pharmacal Research
• /
• v.29 no.3
• /
• pp.191-194
• /
• 2006

Twigs from llex macropoda were extracted with MeOH, and the concentrated extracts were partitioned with $CH_2Cl_2$, EtOAc, n-BuOH, and $H_2O$. Repeated column chromatography of the $CH_2Cl_2$ fraction ultimately resulted in the isolation of two compounds, via activity-guided fractionation, using ACAT inhibitory activity measurements. According to the physico-chemical data, the chemical structures of these isolated compounds were identified as lupeol (1) and betulin (2). Compounds 1 and 2 were shown to inhibit the activity of hACAT-1 and hACAT-2 in a dose-dependent manner, and compounds 1 and 2 inhibited hACAT-1 with $IC_{50}$ values of 48 and $83{\mu}M$, respectively.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.28 no.5
• /
• pp.587-593
• /
• 2004

In this paper, flow characteristics of plasma flow in a micro-tube were investigated experimentally using micro particle image velocimetry(micro-PIV). For comparison, the experiments were repeated for deionized(DI) wale. instead of plasma. Both velocity profiles of plasma and do-ionized water are well agreed with the theoretical velocity distribution of newtonian fluid. We also carried out generating plasma-in-oil droplet formation at a Y-junction microchannel. In order to clarify the hydrodynamic aspects involved in plasma droplet formation, Rhodamine-B were mixed with plasma only for visualization of plasma droplet. With oil as the continuous phase and plasma as the dispersed phase, plasma droplet can be generated in a continuous phase flow at a Y-junction. For given experimental parameters, regular-sized droplets are reproducibly formed at a uniform flow conditions.

• Proceedings of the Korean Society for Emotion and Sensibility Conference
• /
• 1998.11a
• /
• pp.230-234
• /
• 1998

This study developed a test with a high test-retest reliability consisting of 18 items by selecting from Korean adjectives describing tactile sensations. Principal components were extracted by three repeated measurements of 19 different fabrics for underwear. Adjectives such as 'smooth' 'soft' 'sexy' 'comfortable' and 'cozy' were most discriminating between preferred and non-preferred fabrics. The fabrics were analyzed by Kawabata Evaluation System in 16 mechanical properties, then these properties were analyzed by regression analyses as to their relations with human sensation and sensibility. Among the fabrics, the most preferred were made of polyester whereas the least preferred were made of gauze and cotton. Mechanical properties were identified that were related to the most discriminating adjectives such as 'smooth', 'soft', 'sexy,' and 'cozy'.

• Journal of the Korean Statistical Society
• /
• v.33 no.4
• /
• pp.367-379
• /
• 2004

This article deals with the nonparametric analysis of longitudinal data when there exist possible correlations among repeated measurements for a given subject. We consider a quasi-likelihood regression model where a transformation of the regression function through a link function is linear in time-varying coefficients. We investigate the local polynomial approach to estimate the time-varying coefficients, and derive the asymptotic distribution of the estimators in this quasi-likelihood context. A real data set is analyzed as an illustrative example.