• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.7A
• /
• pp.440-450
• /
• 2003

The reverse link of a spectrally overlaid macrocell/microcell cellular CDMA system supporting multimedia traffic is characterized in terms of the required signal power, interference, and capacity. Several narrowband subsystems are overlaid with a wideband subsystem in macrocells, while a single wideband subsystem is operated in a microcell with the same spectrum as the macrocell wideband subsystem. Using a typical propagation model the reverse link signal power and interference are characterized as the relative user signal power and the cross-tier interference factors between the macrocell and the microcell. The reverse link capacity of the overlay system is then analyzed. Analytical results show that the dominant parameters affecting the system performance are the spectral overlay ratio and the distance between the microcell and macrocell base stations. In particular, when the distance equals a half of macrocell radius, optimum performance can be achieved by minimizing the cross-tier interference factors. These results can be applied to CDMA multimedia network planning in heavily populated traffic areas.

• Mass Spectrometry Letters
• /
• v.12 no.2
• /
• pp.47-52
• /
• 2021

Evaluating the impurity concentrations in semiconductor thin films using time of flight secondary ion mass spectrometry (ToF-SIMS) is an effective technique. The mass interference between isotopes and matrix element in data interpretation makes the process complex. In this study, we have investigated the doping concentration of phosphorus in, phosphorus doped silicon thin film on glass using ToF-SIMS in the dynamic mode of operation. To overcome the mass interference between phosphorus and silicon isotopes, the quantitative analysis of counts to concentration conversion was done following two routes, standard relative sensitivity factor (RSF) and SIMetric software estimation. Phosphorus doped silicon thin film of 180 nm was grown on glass substrate using hot wire chemical vapor deposition technique for possible applications in optoelectronic devices. Using ToF-SIMS, the phosphorus-31 isotopes were detected in the range of 10¹~10⁴ counts. The silicon isotopes matrix element was measured from p-type silicon wafer from a separate measurement to avoid mass interference. For the both procedures, the phosphorus concentration versus depth profiles were plotted which agree with a percent difference of about 3% at 100 nm depth. The concentration of phosphorus in silicon was determined in the range of 10¹⁹~10²¹ atoms/cm³. The technique will be useful for estimating distributions of various dopants in the silicon thin film grown on glass using ToF-SIMS overcoming the mass interference between isotopes.

• International journal of advanced smart convergence
• /
• v.2 no.1
• /
• pp.21-23
• /
• 2013

The antenna pattern in this case has a main beam pointed in the desired signal direction, and has a null in the direction of the interference.The conventional antenna pattern concepts of beam width, side lobes, and main beams are not used, as the antenna weights are designed to achieve a set performance criterion such as maximization of the output SNR.A new direction of arrival estimation method using effects of model errors and sensitivity analysis is proposed. Two subspaces are used to form a signal space whose phase shift between the reference signal and its effects of model error signal. Through simulation, the performance showed that the proposed method leads to increased resolution and improved accuracy of DOA estimation relative to those achieved with existing method. Since a desired signal is obtained after interference rejection through correction effects of model error, the effect of channel interference on the estimation is significantly reduced.

• International Journal of Control, Automation, and Systems
• /
• v.5 no.5
• /
• pp.601-605
• /
• 2007

In this paper, we propose a simple and relative electrode contact monitoring method. By exploiting the power line interference, which is regarded as one of the worst noise sources for bio-potential measurement, the relative difference in electrode impedance can be measured without a current or voltage source. Substantial benefits, including no extra circuit components, no degradation of the body potential driving circuit, and no electrical safety problem, can be achieved using this method. Furthermore, this method can be applied to multi-channel isolated bio-potential measurement systems and home health care devices under a steady measuring environment.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.37 no.2
• /
• pp.60-67
• /
• 2000

When the eigenvalues of the input covariance matrix of an array system spread by orders of magnitude, conventional adaptive arrays can't remove all the interference signals effectively In this paper, an Applebaum array adopting an adaptive gain controller (AGC) in the feedback loop of the array is proposed When eigenvalue spreaded interferences are incident to an array, a high power interference is removed easily in several iterations while a relative low power interference which is a cause of eigenvalue spread is still remained In the array output After some initial iterations, the proposed array increases the correlation between the low power interference and the array output by amplifying the output signal of the array As a result, the weights vector adapts to the direction of the low power interference as well as that of the high power interference Computer simulation results show that the proposed array gives high output signal to interference plus noise ratio (SINR) and a fast convergence speed.

• Journal of Communications and Networks
• /
• v.18 no.2
• /
• pp.150-161
• /
• 2016

Coordinated multi-point transmission (CoMP) techniques are being touted as enabling technologies for interference mitigation in next generation heterogeneous wireless networks (HetNets). In this paper, we present a comparative performance study of uplink (UL) CoMP algorithms for the 3GPP LTE HetNets. Focusing on a distributed and functionally-split architecture, we consider six distinct UL-CoMP algorithms: 1. Joint reception in the frequency-domain (JRFD) 2. Two-stage equalization (TSEQ) 3. Log-likelihood ratio exchange (LLR-E) 4. Symmetric TSEQ (S-TSEQ) 5. Transport block selection diversity (TBSD) 6. Coordinated scheduling with adaptive interference mitigation (CS-AIM) where JRFD, TSEQ, S-TSEQ, TBSD and CS-AIM are our main contributions in this paper, and quantify their relative performances via the post-processing signal-to-interference-plus-noise ratio distributions.We also compare the CoMP-specific front-haul rate requirements for all the schemes considered in this paper. Our results indicate that, with a linear minimum mean-square error receiver, the JRFD and TSEQ have identical performances, whereas S-TSEQ relaxes the front-haul latency requirements while approaching the performance of TSEQ. Furthermore, in a HetNet environment, we find that CS-AIM provides an attractive alternative to TBSD and LLR-E with a significantly reduced CoMP-specific front-haul rate requirement.

• Journal of the Microelectronics and Packaging Society
• /
• v.26 no.2
• /
• pp.9-14
• /
• 2019

The newly discovered properties of periodic nanoscale patterns have increasingly sparked research interests in various fields. Along this direction, it is worth mentioning that there had been rare studies conducted on interference exposure, a method of creating periodic patterns. Additionally, these few studies seemed to validate the existence of only exact quadrangle shapes and dot patterns. This study asserted the formation of wavy patterns associated to using multiple exposures of the ratio of the first exposure intensity to the second exposure intensity. Such patterns were designed and constructed herein via overlapping of two Gaussian beams relative to certain rotation angles, and with a submicron structure fabricated based on a 360-nm continuous-wave laser. Results confirmed that the proposed double exposure laser interference lithography is able to create circular, elliptical and wavy patterns with no need for complex optical components.

• Journal of Communications and Networks
• /
• v.5 no.3
• /
• pp.187-196
• /
• 2003

We consider the use of error control coding in direct sequence-code-division multiple access (OS-COMA) systems that employ multiuser detection (MUO) and space diversity. The relative performance gain between Reed-Solomon (RS) code and convolutional code (CC) is well known in [1] for the single user, additive white Gaussian noise (AWGN) channel. In this case, RS codes outperform CC's at high signal-to-noise ratios. We find that this is not the case for the multiuser interference channel mentioned above. For useful error rates, we find that soft-decision CC's to be uniformly better than RS codes when used with DS-COMA modulation in multiuser space-time channels. In our development, we use the Gaussian approximation on the interference to determine performance error bounds for systems with low number of users. Then, we check their accuracy in error rate estimation via system's simulation. These performance bounds will in turn allow us to consider a large number of users where we can estimate the gain in user-capacity due to channel coding. Lastly, the use of turbo codes is considered where it is shown that they offer a coding gain of 2.5 dB relative to soft-decision CC.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.13 no.1
• /
• pp.85-93
• /
• 1988

Installation of the digital carrier system is increased rapidly in the telecommunication network, and most of systems are operating over a twisted pair conductor. Many systems are accommodated in multipair cable for their economical installation, therefore we must consider tha crosstalk interference between digital systesm. This paper considers the calculation method which determine crosstali interference between signals in multipair. And the transmission margin at a certain error rate is analyzed considering crosstalk power. Finally, this paper estimates the crosstalk noise susceptibility of 2.048Mbps relative to 1.544Mbps PCM system and 1.544Mbps relative to 2.048Mbps PCM system, and then considers the methos which both systems can operate together in a same cable.

• Proceedings of the KIEE Conference
• /
• 2007.10a
• /
• pp.469-470
• /
• 2007

In this paper, we propose a simple and relative electrode contact monitoring method. By exploiting the power line interference, which is regarded as one of the worst noise sources for bio-potential measurement, the relative difference in electrode impedance can be measured without a current or voltage source. Substantial benefits, including no extra circuit components, no degradation of the body potential driving circuit, and no electrical safety problem, can be achieved using this method. Furthermore, this method can be applied to multi-channel isolated bio-potential measurement systems and home health care devices under a steady measuring environment.