• Transactions on Electrical and Electronic Materials
• /
• 제12권4호
• /
• pp.156-159
• /
• 2011

SiNx:H films have been widely used for anti-reflection coatings and passivation for crystalline silicon solar cells. In this study, SiNx:H films were deposited using high frequency (13.56 MHz) direct plasma enhanced chemical vapor deposition, and the optical and passivation properties were investigated. The radio frequency power, the spacing between the showerhead and wafer, the $NH_3/SiH_4$ ratio, the total gas flow, and the $N_2$ gas flow were changed over certain ranges for the film deposition. The thickness uniformity, the refractive index, and the minority carrier lifetime were then measured in order to study the properties of the film. The optimal deposition conditions for application to crystalline Si solar cells are determined from the results of this study.

• 고려인삼학회:학술대회논문집
• /
• 고려인삼학회 1980년도 학술대회지
• /
• pp.59-69
• /
• 1980

A new HPLC-method for separation and quantitative determination of ginsenosides in Panax ginseng, Panax quinquefolium and in pharmaceutical drug preparations is elaborated. A reversed-phase-system with ${\mu}Bondapak\;C_{18}$ column (3.9 mm $I.D.{\times}30\;cm$) using acetonitrile-water (30:70) 2 ml/min and acetonitrile-water (18:82) 4 ml/min is suitable for the base-line separation of $Rb_1,\;Rb_2,\;Rc,\;Rd,\;Rf,\;Rg_2,\;respectively\;Re,\;Rg_1$ in 30 minutes. The ginsenosides are directly detected at 203 nm (without derivatization) with the LC-55 or LC-75 spectrophotometer (Perkin-Elmer) at $100\%$ transmission. Detection limit is 300 ng at a signal-to-noise ratio of 10:1. The ginsenosides-peak identification is carried out with HPTLC (high performance thin layer chromatography), with MIR-IR (multiple internal reflection-IR-spectros-copy) and with FD-MS (field desorption mass spectrometry). The calibration curve of each ginsenoside has a correlation coefficient very near to 1. Relative standard deviation for quantitative determinations depends upon the amount of ginsenosides and is approximately 1\%$ for ginsenoside contents of 1\%$. This method is adaptable for routine analysis in quality control laboratories.

• 한국진공학회지
• /
• 제19권2호
• /
• pp.121-127
• /
• 2010

소형위성의 추력시스템으로 사용되어지는 홀 추력기의 중성 기체 시뮬레이션을 수행하였다. 홀 추력기의 채널 내부에서의 난반사효과 및 초기 가스의 온도, 그리고 채널의 길이 등을 변수로 하여 계산되어진 밀도, 압력, 속도, 온도를 분석 하였다. 시뮬레이션에서 얻어진 결과를 통해 홀 추력기의 방전 시뮬레이션의 정확성을 높이는 동시에 실제 시스템의 이해에 기여할 것으로 예상되어 진다.

• Journal of electromagnetic engineering and science
• /
• 제6권1호
• /
• pp.36-46
• /
• 2006

In this paper, we present a two-element circularly-polarized antenna array for UHF-band RFID reader applications. The antenna element in the array is a comer-truncated rectangular patch placed on a thick plastic-foam dielectric. The patch is fed on one of its edges by a microstrip line printed on a separate thin substrate. The array antenna is fed by a microstrip power divider. Parametric studies on the patch are carried out, from which an optimum design of a single antenna element is derived. The element spacing and the feed network of the array are investigated. A commercial electromagnetic software is employed in the analysis and design of the antenna. The designed array is fabricated and tested. Measurements show good performance characteristics of the fabricated antenna: a 11.2-dBi gain, a reflection coefficient of - 14 dB, an axial ratio less than 3 dB over 3-dB beamwidths of 40 and 60 degrees on two principal planes.

• Journal of Electrical Engineering and Technology
• /
• 제13권5호
• /
• pp.2004-2010
• /
• 2018

We propose a small active antenna to receive Global Navigation Satellite System (GNSS) signals, i.e., Global Positioning System (GPS) L1 (1,575MHz) and Russian Global Navigation Satellite System (GLONASS) L1 (1,600 MHz) signals. A two-stage low-noise amplifier (LNA) with more than 27 dB gain is implemented in the bottom layer of a three-layer antenna package. In addition, a hybrid coupler is used to combine signals from pair of proximately coupled orthogonal feeds with $90^{\circ}$ phase difference to achieve the circular polarization (CP) characteristic. Three layers of high permittivity (${\varepsilon}_r=10$) substrates are stacked and effectively integrated to have a small dimension of $64mm{\times}64mm{\times}7.42mm$ (including both circuit and antenna). The reflection coefficient of the fabricated antenna at the target frequency is below -10 dB, the measured antenna gain is above 26 dBic and the measured noise figure is less than 1.4 dB.

• 한국해양공학회지
• /
• 제31권2호
• /
• pp.121-129
• /
• 2017

The present study numerically investigated the influence of the waveform distribution on the tsunami-vegetation interaction using a non-reflected wave generation system for various tsunami waveforms in a two-dimensional numerical wave tank. First, it was possible to determine the wave attenuation mechanism due to the tsunami-vegetation interaction from the spatial waveform, flow field, vorticity field, and wave height distribution. The combination of fluid resistance in the vegetation and a large gap and creates a vortex according to the flow velocity difference in and out of the vegetation zone. Thus, the energy of a tsunami was increasingly reduced, resulting in a gradual reduction in wave height. Compared to existing approximation theories, the double volumetric ratio of the waveform increased the reflection coefficient of the tsunami-vegetation interaction by 34%, while decreasing the transfer coefficient and energy attenuation coefficient by 25% and 13%, respectively. Therefore, the hydraulic characteristics of a tsunami is highly likely to be underestimated if the solitary wave of the approximation theory is applied for the tsunami.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2008년도 제31회 추계학술대회논문집
• /
• pp.349-352
• /
• 2008

수축-확대 초음속 노즐 내부에 분출된 이차제트에 의한 추력편향 제어에 관한 실험적, 수치적 연구가 진행되었다. 특정위치(노즐 목으로부터 12mm 떨어진 곳)에서 분출되는 이차제트 유동전압이 변화할 때 나타나는 제트유동의 추력편향 특성이 관찰되었다. 수치해석 결과는 동일한 경계조건에서 수행된 과거 연구결과 및 본 연구에서 수행된 쉴러린 유동가시화 결과와 비교되었으며, 정성적으로 좋은 일치를 나타냈다. 추력편향의 특성은 노즐 내부의 경사충격파의 반사구조, 즉, 이차제트 압력비 SPR의 크기에 관계되어 있음이 관찰되었다.

• Geomechanics and Engineering
• /
• 제11권6호
• /
• pp.821-845
• /
• 2016

Extensive researches on distribution of earthquake induced damages in different regions have shown that geological and geotechnical conditions of the local soils significantly influence behavior of alluvial areas under seismic loading. In this article, the site of Babol city which is formed up of saturated fine alluvial soils is considered as a case study. In order to reduce the uncertainties associated with earthquake resistant design of structures in this area (Babol city), the required design parameters have been evaluated with consideration of site's dynamic effects. The utilized methodology combines experimental ground ambient noise analysis, expressed in terms of horizontal to vertical (H/V) spectral ratio, with numerical one-dimensional response analysis of soil columns using DEEPSOIL software. The H/V spectral analysis was performed at 60 points, experimentally, for the region in order to estimate both the fundamental period and its corresponding amplification for the ground vibration. The investigation resulted in amplification ratios that were greater than one in all areas. A good agreement between the proposed ranges of natural periods and alluvial amplification ratios obtained through the analytical model and the experimental microtremor studies verifies the analytical model to provide a good engineering reflection of the subterraneous alluviums.

• 로봇학회논문지
• /
• 제16권2호
• /
• pp.94-102
• /
• 2021

This study addresses a method for 3D reconstruction using acoustic data with heterogeneous sonar devices: Forward-Looking Multibeam Sonar (FLMS) and Profiling Sonar (PS). The challenges in sonar image processing are perceptual ambiguity, the loss of elevation information, and low signal to noise ratio, which are caused by the ranging and intensity-based image generation mechanism of sonars. The conventional approaches utilize additional constraints such as Lambertian reflection and redundant data at various positions, but they are vulnerable to environmental conditions. Our approach is to use two sonars that have a complementary data type. Typically, the sonars provide reliable information in the horizontal but, the loss of elevation information degrades the quality of data in the vertical. To overcome the characteristic of sonar devices, we adopt the crossed installation in such a way that the PS is laid down on its side and mounted on the top of FLMS. From the installation, FLMS scans horizontal information and PS obtains a vertical profile of the front area of AUV. For the fusion of the two sonar data, we propose the probabilistic approach. A likelihood map using geometric constraints between two sonar devices is built and a monte-carlo experiment using a derived model is conducted to extract 3D points. To verify the proposed method, we conducted a simulation and field test. As a result, a consistent seabed map was obtained. This method can be utilized for 3D seabed mapping with an AUV.

• Nano
• /
• 제13권10호
• /
• pp.1850121.1-1850121.11
• /
• 2018

In this study, a series of $LaMnO_3$-diamond composites with varied $LaMnO_3$ mass contents supported on micro-diamond have been synthesized using a sol-gel method. The as-prepared composites were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), Raman spectroscopy and the Fourier transform infrared spectra (FTIR). Meanwhile, the photocatalytic performances were also tested by photoluminescence (PL) spectroscopy, ultraviolet-visible diffuse reflection spectra (UV-Vis DRS) and the degradation of weak acid red C-3GN (RC-3GN). Results show that the peak position of $LaMnO_3$ is shifted to low angle after the introduction of diamond, and perovskite particles uniformly distributed on the surface of diamond, forming a network structure, which can increase the active sites and the absorption of dye molecules. When the mass ratio of $LaMnO_3$ and diamond is 1:2 (LMO-Dia-2), the composite shows the most excellent photocatalytic activity. This result offers a sample route to enlarge the range of the application of micro-diamond and provide a new carrier for perovskite photocatalysts.