• Textile Coloration and Finishing
• /
• v.16 no.4
• /
• pp.10-18
• /
• 2004

In this work, Aqueous sericin solution was prepared by degumming process with electrolytic reduction water. Then, the microfiltration and ultrafiltration systems were applied to the concentration of aqueous sericin solution. The objective of this study was to select the optimum operating condition among the different pressure. The permeate flux and rejection ratio were observed with time, pressure, flow rate and concentration. and, the wastewater and permeated water quality values such as pH, BOD, COD, and NH levels were measured. In order to see the influence of electrolytic reduction water, the flux of pure water and electrolytic reduction water by PVDF22(MF) and PS100(UF) membrane was measured. In microfiltration system, the relative flux reduction decreased rapidly to 0.02 in the 30min, as the concentration polarization and gel layer formation were increased. and then the sericin concentration rejection ratio was 40%. In ultrafiltration system, the permeate flux decreased with time and concentration, and increased with the operating pressure and flow rate. Optimal condition in PS100 membrane system for sericin concentration was operating pressure 1.464kgf/$cm^24, operating flow rate $7\ell/min at\; 40^{\circ}C$. At that time, sericin concentration rejection ratio was 83% respectably. The sericin solution was concentrated from 0.1wt% solution to 0.2 wt % solution during about 2 hrs by the UF filteration membrane system.

• Journal of Ocean Engineering and Technology
• /
• v.1 no.2
• /
• pp.123-129
• /
• 1987

Corrosion fatigue fracture of dual phase steel(SS41) and raw material steel(SS41) were investigated in 3.5% NaCl aqueous solution at PH 4,6,9 and 11. The fatigue limit of dual phase steel is increased approximately 1.8 times larger than that of raw material in air. The corrosion fatigue life of dual phase steel is about 5-10 times larger than that of raw material in 3.5% NaCl aqueous solution. The reduction of fatigue life is larger for the acidsalt solution than for the alkali salt solution. The reduction of stress level on the reduction ratio of corrosion fatigue life is large as pH 6-11. The reduction ratio of corrosion fatigue life of dual phase steel and raw material is nearly coincided at pH 2. While at pH4-2 the reduction ratio of corrosion fatigue life only depends on the corrosion effect. It has been found that the corrosion resistance effect of dual phase steel is smaller than that of raw material in corrosion fatigue crack propagation rate. As pH below 6 is changed, it can be clearly observed from raw material that the brittle intergranular fracture is characterized, and from the above result, the influence of corrosion of dual phase steel is small.

• Journal of Environmental Health Sciences
• /
• v.29 no.3
• /
• pp.28-34
• /
• 2003

This study was performed to compare the effects of chaff and sawdust as bulking materials on temperature, pH, weight and volume reduction and salinity in aerobic composting of food wastes. Volume ratios of food wastes to chaff in reactor of Control, Ch-l, Ch-2, Ch-3 and Ch-4 were 4:0, 4:1, 4:2, 4:3 and 4:4, respectively. Volume ratios of food wastes to sawdust in reactor of Control, Sd-l, Sd-2, Sd-3 and Sd-4 were 4:0, 4:1, 4:2, 4:3 and 4:4, respectively. Reactors were operated for 24 days with 1 hour stirring by 1 rpm and 2 hours aeration per day. The lowering of the volume ratio of food wastes to chaff and sawdust resulted in the reaction at higher reaction temperature and the elongation of the high temperature reaction period. The lowering of the volume ratio of food wastes to chaff and sawdust resulted in faster pH increase. In the volume ratio of 4:3 and 4:4, pH increased faster in food-chaff mixtures than in food-sawdust mixtures. The lowering of the volume ratio of food wastes to chaff and sawdust resulted in faster steady state in the weight reduction rate and the volume reduction rate. The weight reduction rates of chaff mixtures were higher than those of sawdust mixtures, but the volume reduction rates of sawdust mixtures were more higher than those of chaff mixtures. Salinity increased as composting reaction proceeded, due to reduction in mass weight. The final salinity of Control was 2.79%, and the final range of salinities of chaff and sawdust mixtures were 2.18∼2.37% and 1.86∼2.05%, respectively.

• Journal of Climate Change Research
• /
• v.9 no.4
• /
• pp.357-368
• /
• 2018

The Paris Agreement, adopted in 2015, requires global mitigation actions by all countries, whether they are developed or developing countries. All member countries prepared and communicated a greenhouse gas reduction target, formally called the Intended Nationally Determined Contribution (INDC). There has been some concern regarding whether the INDCs communicated are sufficient to achieve the emissions reduction needed to hold the increase in global temperature to $2^{\circ}C$ above pre-industrial levels. How to address this emissions gap in an equitable and fair manner remains controversial. Beginning in the year 2023, global stocktaking under the Paris Agreement will be performed by the Conference of the Parties to assess progress towards temperature goals. The present study, based on various composite indicators reflecting equity, fairness, ability and efficiency, analyzed the GHG reduction targets of eleven major countries and the ambitiousness of these targets. Employing share indicators and comparative ratio indicators (resulting in eight composite indicators), this study showed that when share indicators are applied, Korea's appropriate reduction requirement rate is relatively low at 1~2%. However, when comparative ratio indicators are applied, Korea's appropriate reduction requirement rate increases dramatically to 6~11%. In a similar vein, when share indicators are applied, Korea's 2030 target is very ambitious compared to other countries, while the opposite is seen with comparative ratio indicators. This strongly suggests that Korea needs to apply more share indicators than comparative ratio indicators when discussing the equitable and ambitious role of Korea in the climate debate.

• Resources Recycling
• /
• v.33 no.1
• /
• pp.15-21
• /
• 2024

The demand for electric vehicles powered by lithium-ion batteries is continuously increasing. Recovery of valuable metals from waste lithium-ion batteries will be necessary in the future. This research investigated the effect of reaction temperature on the lithium recovery ratio from hydrogen reduction followed by water leaching from lithium-ion battery NCM-based cathode materials. As the reaction temperature increased, the weight loss ratio observed after initiation increased rapidly owing to hydrogen reduction of NiO and CoO; at the same time, the H₂O amount generated increased. Above 602 ℃, the anode materials Ni and Co were reduced and existed in the metallic phases. As the hydrogen reduction temperature was increased, the Li recovery ratio also increased; at 704 ℃ and above, the Li recovery ratio reached a maximum of approximately 92%. Therefore, it is expected that Li can be selectively recovered by hydrogen reduction as a waste lithium-ion battery pretreatment, and the residue can be reprocessed to efficiently separate and recover valuable metals.

• Journal of Korean Society of Water and Wastewater
• /
• v.37 no.6
• /
• pp.311-324
• /
• 2023

As an advanced study on the method of calculating the target revenue water ratio of local waterworks through the leakage component analysis method proposed by Kim et al. (2022), this study developed a model to calculate the achievable revenue water ratio within the specified project cost, the required project cost to achieve the specified target revenue water ratio, and the economically appropriate target revenue water ratio level by considering the leakage reduction cost and leakage reduction benefit for each revenue water ratio improvement strategy, and conducted an applicability evaluation of the developed model using actual field data. The procedure for calculating the target revenue water ratio of local waterworks considering economics proposed in this study consists of three stages: physical data linkage model construction, leakage component analysis, and economic analysis, and the applicability was evaluated for Zone H with branch type and the Zone M network type. As a result of the application, it was calculated that approximately 32.5 billion won would be required to achieve the target revenue water ratio of 70% in the Zone H, and approximately KRW 10.5 billion would be required to achieve the target revenue water ratio of 75% in the Zone M. If the business scale of Zones H and M was corrected to 10,000 m³/day of water usage, the required project cost for a 1% improvement in the revenue water ratio of Zone H was calculated to be 0.7642 billion won and 0.4715 billion won for Zone M.

• Pediatric Gastroenterology, Hepatology & Nutrition
• /
• v.11 no.2
• /
• pp.110-115
• /
• 2008

Purpose: Intussusceptions are one of the most common causes of intestinal obstruction in infants and young children. Although it is easily treated by non-operative reduction using barium, water or air, this treatment is very stressful for young patients and may cause bowel perforation, peritonitis and shock. In this study, we identified the risk factors associated with the failure of non-operative reduction, to identify a group of children that would benefit from the procedure and those who would not. Methods: We reviewed the medical records of patients with intussusception who were treated at the Korea University Medical Center Ansan hospital from March 1998 to July 2006. Three hundred fourteen children with intussusception were identified. Among them, non-operative reductions were performed in three hundred. Clinical and radiological variables were compared according to the failure or success of the non-operative reduction. Results: Non-operative reductions were successful in 243 (81%) and failed in 57 (19%). The group that had failed procedures had a younger age (12.3${\pm}$17.2 months vs. 18.0${\pm}$15.8 months, p=0.03), longer symptom duration before reduction (33.6${\pm}$29.0 hr vs. 21.5${\pm}$20.3 hr, p<0.01), more vomiting and lethargy (p<0.01), but less abdominal pain and irritability (p<0.01), compared with the group that had a successful procedure. Logistic regression analysis showed that the factors associated with the failure of non-operative reductions were a younger age, less than 6 months of age (odds ratio: 2.5, 95% confidence interval: 1.2~5.2, p=0.01), duration of symptoms, longer than 24 hrs before reduction (odds ratio: 2.1, 95% confidence interval: 1.2~4.2, p=0.03), bloody stool (odds ratio: 4.8, 95% confidence interval: 1.9~12.2, p<0.01), lethargy (odds ratio: 3.4, 95% confidence interval: 1.1~10.4, p=0.04), and abdominal pain or irritability (odds ratio: 0.2, 95% confidence interval: 0.1~0.4, p<0.01). Conclusion: For children with intussusception, an age younger than 6 months, and duration of symptoms more than 24 hrs before reduction, as well as the presence of bloody stools, lethargy and abdominal pain or irritability were variables associated with failure of a non-operative reduction. Knowledge of these variables should be considered in making clinical decisions for therapeutic interventions.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.8 no.1
• /
• pp.71-76
• /
• 2009

In a running blower, there are various exciting forces which can generate noise. The noise of an running industrial fan or blower depends on the structure of a fan, the machining accuracy of each element, and assembled conditions. Many studies have been carried out to reduce the noise of it. In this study, 3-hole buffs are used in pipe of blower to study the influence the number and position of buffs on the noise reduction at inlet and outlet in pipe. Commercial engineering software ANSYS and SYSNOISE were employed to analyze the characteristics and reduction ratio of pressure. It is concluded that optimal position and number of buffs in pipe of blower to show the least reduction ratio of pressure.

• Korean Journal of Metals and Materials
• /
• v.50 no.6
• /
• pp.445-448
• /
• 2012

We studied the effect of temperature and reaction time by investigating the various temperatures and reaction times in the reduction of molybdenum oxide ($MoO_3$) to molybdenum (Mo) powder in hydrogen gas. We also studied the effect of the reaction of reduction according to the various hydrogen gas flow rates. We surveyed the reduction from molybdenum oxide to molybdenum powder in hydrogen gas and checked two temperature ranges, one from $400^{\circ}C$ to $600^{\circ}C$ and the other from $700^{\circ}C$ to $900^{\circ}C$. We found that the reaction ratio of molybdenum oxide increased with an increasing temperature and also increased with an increasing reaction time, but hydrogen gas did not influence the reduction ratio of molybdenum oxide. We examined molybdenum powders fabricated by ball milling for two hours, using with X-ray diffraction (XRD) and a scanning electron microscopy (SEM).

• Proceedings of the Korean Institute of Resources Recycling Conference
• /
• 2003.10a
• /
• pp.165-169
• /
• 2003

Current volume reduction methods for wasted expandable polystyrene (EPS) foam are summarized and compared each other. Wasted EPS foam has not been recycled effectively because of its large volume to weight ratio. This has prevented from its proper recycling because of high cost of transportation to recycling plant. Successful recycling of wasted EPS foam results directly from successful, i.e. economically and environmentally, volume reduction of wasted EPS foam. This paper deals with various methods for volume reduction methods of wasted EPS foam. Five typical methods of volume reduction are introduced and they are compared each other in terms of expected PS properties after volume reduction, cost effectiveness of each process, possible effects on environment caused by the volume reduction process, and possible recycled products. The methods include thermal, solvent, far infrared and mechanical compaction. Comparison in this paper is made mostly in qualitative manner. The focus in this study is concentrated on summarizing and comparing existing methods of volume reduction for wasted EPS foam.