• Journal of Information Technology Services
• /
• v.15 no.4
• /
• pp.97-109
• /
• 2016

The rapid deployment of millions of mobile sensors and smart devices has resulted in high demand for opportunistic encounter-based networking. For the cooperative video surveillance of dashboard cameras in nearby vehicles, a fast and energy-efficient asynchronous neighbor discovery protocol is indispensable because a dashboard camera is an energy-hungry device after the vehicle's engine has turned off. In the existing asynchronous neighbor discovery protocols, all nodes always try to discover all neighbors. However, a dashboard camera needs to discover nearby dashboard cameras when an event is detected. In this paper, we propose a fast and energy-efficient asynchronous neighbor discovery protocol, which enables nodes : 1) to have different roles in neighbor discovery, 2) to discover neighbors within a search range, and 3) to report promptly the exact discovery result. The proposed protocol has two modes: periodic wake-up mode and active discovery mode. A node begins with the periodic wake-up mode to be discovered by other nodes, switches to the active discovery mode on receiving a neighbor discovery request, and returns to the periodic wake-up mode when the active discovery mode finishes. In the periodic wake-up mode, a node wakes up at multiples of number ${\alpha}$, where ${\alpha}$ is determined by the node's remaining battery power. In the active discovery mode, a node wakes up for consecutive ${\gamma}$ slots. Then, the node operating in the active discovery mode can discover all neighbors waking up at multiples of ${\beta}$ for ${\beta}{\leq}{\gamma}$ within ${\gamma}$ time slots. Since the proposed protocol assigns one half of the duty cycle to each mode, it consumes equal to or less energy than the existing protocols. A performance comparison shows that the proposed protocol outperforms the existing protocols in terms of discovery latency and energy consumption, where the frequency of neighbor discovery requests by car accidents is not constantly high.

• Journal of Broadcast Engineering
• /
• v.10 no.3
• /
• pp.401-412
• /
• 2005

We propose and design the algorithms of symbol timing recovery, carrier recovery, and equalization for the receiver of S-DMT cable modem, which supports more channels and better symmetric mutimedia services over HFC network. We evaluate the performance of the concatenated entire receiving system of 16QAM, 64QAM in the mixed noise channel of AWGN, ISI and impulse. The result of evaluation shows those algorithms work correctly and designed S-DMT receiver has good performance. We also verify the designed system has excellent immunity against impulse noise channel of practical Cable TV networks by the result of simulation with the parameters of impulse internal $\varepsilon$ and noise power $\gamma^{k}$.

• Quality Improvement in Health Care
• /
• v.5 no.1
• /
• pp.152-165
• /
• 1998

Background : In this paper patient outcomes research is going to be reviewed and described, to be compared with relevant studies, and to consider the application in Korea. Methods : We compiled and reviewed the articles and materials related to patient outcomes research especially by PORT(Patient Outcomes Research Team) and rearranged them for seeking the main point and comparing with relevant studies. Results : Patient outcomes research emphasizes patient outcomes as well as conventional clinical outcomes. It is prospective study observing effectiveness in real situation instead of efficacy in ideal condition. Patient outcomes research comprises of 6 fields ; literature review and meta-analysis, use of claims data, decision modeling, outcomes assessment, cost of care, dissemination of research findings. SAA(small-area variations analysis), appropriateness study and clinical practice guideline are connected with patient outcomes research. Conclusion : In view of the fact that current medical policy in Korea is shifting its focus from accessibility to the improvement in quality and cost containment, and is stressing patient-based research, patient outcomes research is one direction for which the medicine is accountable and assessable. Considering that the number of patient receiving medical treatment in Korea is higher than the West, patient outcomes research has competitive power as against the West.

• Journal of Satellite, Information and Communications
• /
• v.7 no.1
• /
• pp.39-47
• /
• 2012

Currently, most of the frequency spectrum resources are allocated and due to the lack of frequency, low frequency band, optimal for wireless communication environment is not used. Therefore, Cognitive Radio (CR) is a critical issue to solve the spectrum scarcity and to improve frequency spectrum utilization in wireless communication. In this paper, we implement data transmission and receive in a real CR system using the USRP(Universal Software Radio Peripheral) board and GNU Radio package of an open source development kit. Concretely, we detect the Primary User by spectrum sensing, and then we send Primary User information to the database. After receiving the information, because the database already sent optimal transmit power, bandwidth and channel information to CR equipment, CR can communicate without any interference to Primary User.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.4
• /
• pp.668-675
• /
• 2001

Recently, the performance of the commercial PCS(Personal Communication Service) system has been improved to the uppermost limit and ultimately the next generation mobile communication is to be realized by IMT-2000 (International Mobile Communication-2000) to provide multimedia services. Therefore, the new type receiving system is researched actively and one of the most important part in a receiver is direct conversion method. The direct conversion method is suitable for low power consumption, small size, MMIC, and low price, which is to be adopted to the next generation mobile communication systems. In this case, however, several problems occur due to DC-offset. The DC-offset suppresses amplification of the required signal because of the leakage signal of frequency synthesizer in the system. In this thesis, the removing method of DC-offset was considered. There are four removing techniques of DC-offset, which are AC-coupling, large capacitor, DC-feedback loop, and DC-free coding. Among these, the AC-coupling method is the most simplest method and the DC-feedback loop method has the best performance. Then, the performance of the AC-coupling method and DC-feedback loop method are evaluated by HP's ADS simulation tool. As a result, the AC-coupling method cannot be used to the digital communication systems due to data loss. On the other hand, it was confirmed that the DC-feedback loop method is suitable for the direct conversion receiver.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.8
• /
• pp.1597-1603
• /
• 2017

The incidence of fire in underground utility tunnel is lower than other fires, but the damage caused by fire can cause social loss due to social management paralysis as well as economic loss. Hereupon, this paper presents the results of an empirical test on the construction of the underground utility tunnel condition monitoring system using the leakage coaxial cable installed in the underground utility tunnel. For this reason, a verification test was conducted by connecting a inductive coupler 200 Mbps power line communication modem with insertion loss characteristics of $-6{\pm}2dB$ to the installed the leakage coaxial cable installed in the underground utility tunnel. As a result, We confirmed sending/receiving of IP cameras up to 500 m. Therefore, it is judged that it is possible to construct a condition monitoring system for underground utility tunnel by using the leakage coaxial cables installed in the underground utility tunnels without installing additional communication lines for data transmission.

• Tribology and Lubricants
• /
• v.31 no.6
• /
• pp.251-257
• /
• 2015

Heavy oil production is receiving significant attention because of increased demands for thermal power generation systems of the diesel engine and boilers. However, asphaltene, which is a heavy oil components (6-8 wt%), reduces the heat efficiency of the fuels owing to its agglomerated sludge of asphaltene during the burning process. Therefore, for hassle-free operation, we should develop asphaltene dispersants to suppress the formation of the sludge. We prepare variable salt-type polymeric dispersants using poly(isobutenyl succinic anhydride) and poly(amine) through both condensation esterification and acid-base neutralization reactions, which we subsequently evaluate for dispersing performance, using Turbiscan measurement. Total acid number (TAN) and total base number (TBN) of 75Lec-25SynDis.2 composed of lecithin and the prepared polymeric salt having the ratio of 3 : 1 are 18.9 and 33.7 mg KOH/g, respectively, which are comparable to those of the commercial dispersants (15.8 and 26.5 mg KOH/g). We determine the initial turbidity observed for 15 min of the polymeric dispersant was determined with transmittance (%), which can be calculated to separability number (SN). The SN value of 75Lec-25SynDis.2 is close to zero, which is superior to that of commercial dispersants and lecithin (0.015 and 0.017).

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.1
• /
• pp.25-32
• /
• 2008

This paper presents the reflection and transmission measurements conducted at the 60GHz suitable to provide a high speed wide band service. Mean received power and standard deviation are calculated and used to compare the characteristics of radio wave propagation to the various obstacles between transmitting and receiving antennas at the frequency. The results show that the transmitted signal strength by the steel door and copper plate are about 40dB lower than in free space, those by the rubber plate, glass and styroform are about 3dB lower than in free space. Also, the re(looted signal strengths at the 60 degree grazing angle show that in case by the partition is about 23dB lower, by the surface of a wall is about 6dB lower than by the copper plate. The presented results can be used for the design of 60 GHz picocell communication network that the reflected and transmitted waves affect to the service area.

• The Southeast Asian review
• /
• v.23 no.1
• /
• pp.169-194
• /
• 2013

A Korean writer, Yi Soonwon's The Face and a Thai writer, Win Lyovarin's Three Worlds of Rat Ekathet symbolize into literature the historical demonstration which occurred in Korea and Thailand. Comparing the characters in these two works, we come to the conclusion that the background in which people use violence strongly relates with their emotion. The character in The Face commit emotional violence in which receiving education and training and having jostled situation were sprouted as hostility. On the other hand, the characters in Three Worlds of Rat Ekathet show the difference in the sense that they feel a pleasant sensation when they use violence, intoxicated in the power of violence. One thing that two works have in common is that people committing a sin suffer from a guilty conscience and guilty fears when we see the way to treat them. It is how psychological punishment is made by their own. In The Face, the character suffers from psychological punishment in the fear that the other may be aware of his past record when we see the difference to deal with emotional violence. That who committed violence not to be able to open up honorably can never be free from the judgement of conscience out of the law and the sense of guilt continues for his life. However, emotional punishment made by a guilty conscience in Three Worlds of Rat Ekathet has the limited period if sinners make the process of purification which means not committing a fault again. The ultimate way of treating those who committed violence is to forgive them with love and is the process of purification to change violence into non-violence.

• Journal of the Korea Society for Simulation
• /
• v.25 no.3
• /
• pp.1-14
• /
• 2016

This paper proposes four general wireless gateway types, which are distinguished by their own processing ways to connect between a wireless sub-network of things and the mobile internet that links mobile network to internet step by step. In this paper, we also design general processing procedures of these four types using the state transition model. Gateways of each types were developed on the basis of the resulted state transition models and their performances were evaluated through several tests, analyzed, and compared each other. As the results of our evaluation, compared with the other types, the type, which combines both of a low-power Sleep-interrupt way and polling ways for receiving data or responses in all the waiting states of a gateway, shows the best performance in all of data transmission real-timeliness, data loss and energy consumption.