• Journal of Power Electronics
• /
• 제16권1호
• /
• pp.38-47
• /
• 2016

This paper presents DG based droop controlled parallel inverter systems with virtual impedance considering the unequal resistive-inductive combined line impedance condition. This causes a reactive power sharing error and dynamic performance degradation. Each of these drawbacks can be solved by adding the feedforward term of each line impedance voltage drop or injecting the virtual inductor. However, if the line impedances are high enough because of the long distance between the DG and the PCC or if the capacity of the system is large so that the output current is very large, this leads to a high virtual inductor voltage drop which causes reductions of the output voltage and power. Therefore, the line impedance voltage drops and the virtual inductor and resistor voltage drop compensation methods have been considered to solve these problems. The proposed method has been verified in comparison with the conventional droop method through PSIM simulation and low-scale experimental results.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1998년도 Proceedings ICPE 98 1998 International Conference on Power Electronics
• /
• pp.176-181
• /
• 1998

The parallel inverter is popularly used because of its fault-tolerance capability, high-current outputs at constant voltages and system modularity. The conventional parallel inverter usually employs active and reactive power control of frequency and voltage droop control. However, these approaches have the disadvantages that the response time of parallel inverter control is slow against load and system parameter variation to calculate active, reactive power, frequency and voltage. This paper describes a novel control scheme for power equalization in parallel-connected inverter. The proposed scheme has a fast power balance control response, a simplicity of implementation, and inherent peak current limiting capability since it employees an instantaneous current/voltage control with output voltage and current balance and output voltage regulation. A design procedure for the proposed parallel inverter controller is presented. Furthermore, the proposed control scheme is verified through the experiment in various cases such as the system parameter variation, the control parameter variation and the nonlinear load condition.

• Journal of KIEE
• /
• 제10권1호
• /
• pp.35-42
• /
• 2000

An equivalent load sharing control based on the frequency and voltage droop concept for parallel operation of two three-phase Uninterruptible Power Supply (UPS) systems with no control interconnection lines is presented in this paper. First of all, due to the use of active power and reactive power as control variables, the characteristics of output powers according to amplitude and phase differences between output voltages of two UPS systems are analyzed. Secondly, simulation results under different line impedance demonstrate the feasibility of the wireless parallel operation control. Finally, experiments are presented to verify the theoretical discussion with two three-phase 20kVA UPS systems employed TMS320C32, a kind of real time digital signal processor (DSP).

• Journal of Power Electronics
• /
• 제13권3호
• /
• pp.479-486
• /
• 2013

This paper presents a control strategy for distributed systems, which can be used in islanded microgrids. The control strategy is based on the droop method, which uses locally measured feedback to achieve load current sharing. Instead of the traditional droop method, an improved one is implemented. A virtual inductor in the synchronous frame for three-phase inverters is proposed to deal with the coupling of the frequency and the amplitude related to the active and reactive power. Compared with the traditional virtual inductor, the proposed virtual inductor is not affected by high frequency noises because it avoids differential calculations. A model is given for the distributed generation system, which is beneficial for the design of the droop coefficients and the value of the virtual inductor. The effectiveness of the proposed control strategy is verified by simulation and experiment results.

• 한국컴퓨터정보학회논문지
• /
• 제28권12호
• /
• pp.221-229
• /
• 2023

최근 전력 계통에 인공 관성, 감쇠, 블랙스타트 기능, 독립 운전 기능 등을 제공할 수 있어 많은 주목을 받고 있는 Grid-forming(GFM) 컨버터는 저전압 Microgrids(MG)에서 낮은 라인 임피던스의 X/R 비율과 작지 않은 전력각으로 인한 유효전력과 무효전력 간의 커플링 현상이 발생한다. 이러한 전력 커플링 현상은 GFM 컨버터의 안정성 및 성능 저하 문제, 부정확한 전력 공유 문제, 제어 파라미터 설계 문제를 유발하고 있다. 따라서 본 논문은 GFM 컨버터와 관련된 제어 방법뿐만 아니라 전력 디커플링 방법에 대한 검토 연구로서, 유망 제어 방법을 소개하고 전력 디커플링 방법에 대한 비판적 검토를 통하여 향후 연구 활동의 접근성을 높이고자 하였다. 이에 따라 전력디커플링 방법 연구를 위해 향후 연구자들이 쉽게 접근할 수 있어 분산 발전원 확대에 기여할 수 있을 것이다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1989년도 추계학술대회 논문집 학회본부
• /
• pp.291-295
• /
• 1989

The conventional Optimized Injection Method is a good control technique but can't be applied to 3-phase a.e. line. In this paper, a new technique, Time-sharing Method based on basic principle of conventional Optimized Injection Method is introduced to hold the independence of each phase, and the structure of power circuit is improved to realize the new control method. By this scheme it is possible to simplify the control circuit and power circuit. The characteristic of the new control method are investigated and compared with conventional Optimized Injection Method by computer simulation.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2001년도 전력전자학술대회 논문집
• /
• pp.501-505
• /
• 2001

The parallel operation system of UPS is used to increase reliability of power source at critical load. But parallel UPS system has a few defects, impedance is different from each other and circulating current occurs between UPSs, due to line impedance and parameter variation, though controlled by the same synchronization signal. According to such characteristic of parallel UPS, balanced load-sharing control is the most important technique in parallel UPS operation. In this paper, a novel power deviation compensation algorithm is proposed. it is composed of voltage controller to compensate power deviation that be calculated by using active and reactive current deviation between inverters on synchronous d-q reference frame.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 하계학술대회 논문집 F
• /
• pp.2048-2050
• /
• 1998

An uninterruptible power supply(UPS) with parallel operation is used to increase the power capacity of the system or to secure higher reliability at critical loads. In the parallel operating system composed of the multiple UPSs, load-sharing, i.e. current balance control between them is key technique. Because of its low impedance and quick response characteristics, inverter output current changes very rapidly and thereby easily researches an overload condition. The difference between total load current divided by number of operating inverters and its own current is detected as unbalanced current. Then frequency and voltage are controlled to minimize the active component and the reactive component. A good performance of the proposed load-sharing technique is verified by experiments in the parallel operating system with two 40kVA UPSs.

• 전력전자학회논문지
• /
• 제6권1호
• /
• pp.107-113
• /
• 2001

본 논문에서는 3-레벨 PWM 인버터식 STATCOM의 동특성 해석과 직류측 상.하단 캐패시터 전압의 분균등을 보상하기 위한 제어 시스템을 설계하여 시뮬레이션과 축소모형 실험에 의한 성능 해석에 관하여 기술하였다. STATCOM과 전력 계통을 등가회로로 표현하여 회로 방정식을 유도하고 수리모형을 도출하여 전체 회로의 동적 특성을 분석하고, 고안된 제어 시스템의 성능해석은 Marlab을 이용한 시뮬에리션과 축소모형 실험을 통해 검증하였는데, 검증결과 고안된 제어시스템은 무효전력 보상과 직류측 상.하단 캐패시터 전압의 불균등을 해소하는 우수한 성능을 갖는 것을 확인하였다.

• KIEE International Transactions on Power Engineering
• /
• 제5A권1호
• /
• pp.79-84
• /
• 2005

In many countries, the electric power industry is undergoing significant changes known as deregulation and restructuring. These alterations introduce competition in generation and retail and require open access to the transmission network. The competition of the electric power industry causes many issues to surface. Among them, unbundling of the transmission service is probably the most complicated as it is a single and integrated sector and the transmission revenue requirement must be allocated to market participants in a fair way. In these situations, it is valuable to research the methodologies to allocate transmission usage. The power tracing method offers useful information such as which generators supply a particular load or how much each generator (load) uses a particular transmission line. With this information, we can allocate required transmission revenue to market participants. Recently, several algorithms were proposed for tracing power flow but there is no dominant power tracing method. This paper proposes a power tracing method based on graph theory and complex-current distribution. For practicability, the proposed method for transmission usage allocation is applied to IEEE 30 buses and compared with the method proposed by Felix F.Wu.