• Applied Chemistry for Engineering
• /
• v.29 no.5
• /
• pp.489-496
• /
• 2018

Fuel cells are seen as eco-friendly energy resources that convert chemical energy into electrical energy. However, proton exchange membrane fuel cells (PEMFCs) have problems such as the use of expensive platinum catalysts for the reduction of conductivity under high temperature humidification conditions. Thus, an anion exchange membrane fuel cell (AEMFC) is attracting a great attention. Anion exchange fuel cells use non - Pt catalysts and have the advantage of better efficiency because of the lower activation energy of the oxygen reduction reaction. However, there are various problems to be solved including problems such as the electrode damage and reduction of ion conductivity by being exposed to the carbon dioxide. Therefore, this mini review proposes various solutions for different problems of anion exchange fuel cells through a wide range of research papers.

• Fire Science and Engineering
• /
• v.24 no.5
• /
• pp.128-135
• /
• 2010

In this study, a mixture fraction analysis was performed to investigate the characteristics of chemical species production in compartment fires burning hydrocarbon fuels such as methane, heptane, and toluene. A series of fire experiments was conducted in the ISO 9705 standard room, and gas species concentration and soot fraction were measured at two locations in the upper layer of the compartment. The mass fractions of measured chemical species, such as unburned hydrocarbons (UHC), carbon monoxide (CO), carbon dioxide ($CO_2$), oxygen ($O_2$), and soot were presented as a function of mixture fraction and compared with state relationships based on the idealized reaction of hydrocarbon fuels. The mixture fraction analysis made it possible to rearrange hundreds of species measurements, which were done under various fire conditions and at two locations of the upper layer, in term of the unified parameter, i.e. the mixture fraction. The results also showed that inclusion of soot in the mixture fraction calculation could improve the performance of analysis, especially for the sooty fuels such as heptane and toluene.

• Journal of the Korean Chemical Society
• /
• v.22 no.6
• /
• pp.396-402
• /
• 1978

MO theoretical studies on the conformation and the acid-catalyzed nucleophilic substitution of N-acetylpyperidone were carried out by EHT, CNDO/2 and the orbital mixing analytical methods. MO calculations show that the most preferred conformation is the half-chair, cis-trans form and the protonation occurs most readily on the acetyl carbonyl oxygen. These results were interpreted in terms of conjugative, electrostatic and steric effect. From orbital mixing analysis, we found also that the reactivity of protonated carbonyl carbon is greatly enhanced due to increase in positive charge (for charge controlled reaction) of the carbonyl carbon atom. Accordingly, the acetyl cleavage will be preferred in the nucleophilic substitution (acid-catalyzed hydrolysis) to the ring cleavage.

• Journal of the Korean Chemical Society
• /
• v.21 no.4
• /
• pp.284-292
• /
• 1977

Epoxy-methacrylate prepolymer was synthesized from methacrylic acid and a diglycidyl ether type low molecular weight epoxy resin, and the electron beam curing of the prepolymer was studied using styrene and polyethyleneglycol dimethacrylates as comonomers. The esterification was carried out quantitatively without any side reaction adding more than 250∼300ppm hydroquinone and less than $1{\%}$ (wt) triethanolamine by wt. of methacrylate acid, respectively. In the radiation curing under air atmosphere, the maximum gel fraction was observed at 10∼$30{\%}$ monomer contents. The rate of gel formation was decreased by the presence of unreacted epoxy group and acid in the prepolymer and increased with increasing degree of polymerization of polyethyleneglycol block in the dimethacrylates. Considerable oxygen effect in the curing, particularly when polyethyleneglycol dimethacrylate was used as a comonomer, was recognized through the differences of the product properties, though no remarkable differences were found in the rate of gel formation in air and nitrogen atmosphere.

• Journal of the Korean Chemical Society
• /
• v.35 no.6
• /
• pp.636-644
• /
• 1991

The cationic polymerization of substituted oxethanes which have pendant energetic groups such as methoxy, azido, and nitrato are investigated theoretically using the semiempirical MINDO/3, MNDO, and AM1 methods. The nucleophilicity and basicity of substituted oxethanes can be explained by the negative charge on oxygen atom of oxetanes. The reactivity of propagation in the polymerization of oxetanes can be represented by the positive charge on carbon atom and the low LUMO energy of active species of oxetanes. The reaction of the energetic cyclic oxonium ion forms to the open chain carbenium ion forms is expected by computational stability energy of the oxonium and carbenium ion (about 10~20 kcal/mole) favoring the carbenium ion. The relative equilibrium concentration of cyclic oxonium and open carbenium ions is found to be a major determinant of mechanism, owing to the rapid equilibrium of these cation forms and the expectation based on clauclation that the prepolymer propagation step SN1 mechanism will be at least as fast as that for SN2 mechanism.

• Journal of the Korean Chemical Society
• /
• v.38 no.4
• /
• pp.276-282
• /
• 1994

Perovskite-type mixed oxides LaBO$_3$(B = Mn, Fe, Co) were prepared by citrate sol-gel method in $air(850^{\circ}C$, 24h). The oxygen stoichiometries and structures of these oxides were determined by XRD and TPR results as followings; LaMnO$_{3.16}$(a = 5.507, c = 13.329 $\AA$, hexagonal), LaFeO$_{3.17}$(a = 5.554, b = 5.555, c = 7.863 $\AA$, orthorhomibic), LaCoO$_{3.0}$(a = 5.436, c = 13.095 $\AA$, hexagonal). The temperature programmed reduction(TPR) experiments in static 300 torr H$_2$ atmosphere shows that the reduction reaction of LaBO$_3$(B = Mn, Fe, Co) proceeds into two stages, and thermal stabilities of these oxides decreased in the order of LaMnO$_3$ > LaFeO$_3$ > LaCoO$_3$. According to the kinetic analysis the lowest activation energy was obtained for LaCoO$_3$.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.12
• /
• pp.3521-3526
• /
• 2014

A magnetic sonophotocatalyst $Fe_3O_4@SiO_2@TiO_2$ is synthesized for the enhanced biodegradability of organophosphate pesticide. The as-prepared catalysts were characterized using different techniques, such as X-ray diffraction (XRD) and transmission electron microscopy (TEM). The radial sonophotocatalytic activity of $Fe_3O_4@SiO_2@TiO_2$ nanocomposite was investigated, in which commercial dichlorvos (DDVP) was chosen as an object. The degradation efficiency was evaluated in terms of chemical oxygen demand (COD) and enhancement of biodegradability. The effect of different factors, such as reaction time, pH, the added amount of catalyst on $COD_{Cr}$ removal efficiency were investigated. The average $COD_{Cr}$ removal efficiency reached 63.13% after 240 min in 12 L sonophotocatalytic reactor (catalyst $0.2gL^{-1}$, pH 7.3). The synergistic effect occurs in the combined sonolysis and photocatalysis which is proved by the significant improvement in $COD_{Cr}$ removal efficiency compared with that of solo photocatalysis. Under this experimental condition, the $BOD_5/COD_{Cr}$ ratio rose from 0.131 to 0.411, showing a remarkable improvement in biodegradability. These results showed that sonophotocatalysis may be applied as pre-treatment of pesticide wastewater, and then for biological treatment. The synthesized magnetic nanocomposite had good photocatalytic performance and stability, as when it was used for the fifth time, the $COD_{Cr}$ removal efficiency was still about 62.38%.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2017.06a
• /
• pp.205-205
• /
• 2017

An excess soil water condition is one of the major problems for the field crops growing in paddy fields because of their poor drainage and less availability for oxygen uptake which leads to adversely affect the photosynthesis. Therefore, the current study was undertaken with aim to investigate the effects groundwater level on the photosynthetic response of soy bean (Urum), red bean (Arari), sesame (Geonbaek), perilla (Dayu) after the transplanting to the lysimeter to investigate the plant-water relation and their effect on photosynthesis. The chlorophyll content of the crops according to the humid conditions of the soy bean, sesame and the perilla was found to be 5%, 6.89 % and 13.7% higher than that of the groundwater treated at 40cm, respectively. On the other hand, the chlorophyll content of adzuki bean decreased 6.6% from the groundwater level of 40cm, and the sorghum decreased by 5.7%. As a result of investigating the Fv / Fm value of groundwater, the adzuki bean at 20cm above groundwater was lower than that of groundwater by 40cm immediately before flowering. The Fv / Fm value of soy bean and sesame at 40cm above groundwater were lowered by flowering under groundwater 20 cm and Fv / Fm value of sorghum is increased at 40 cm treatment immediately before flowering while the Fv / Fm values of the perilla had no significant difference in comparison to those at 20 cm and 40 cm of groundwater. In the case of chlorophyll fluorescence reaction, it is known that the when the absolute value is closer to 0.82, the stress is considered less. As a result of comparing the numerical values of the crops, it was found that the sorghum was the most stressed followed by adzuki bean and sesame, while the soy beans and perilla was found on the average, as they received less stress.

• Korean Journal of Environmental Agriculture
• /
• v.19 no.2
• /
• pp.154-159
• /
• 2000

This study was carried out to elucidate the symptom of leaf injury to ozone and to determine varietal difference to ozone injury in rice and soybean plant. Ozone was produced by electrostatic discharge in oxygen and was monitored by UV absorption ozone analyzer. The rice leaves were spotted red and rolling leaf edge, discolored to reddish brown or yellowish white in response to ozone, and the leaves that were severely stressed were withered from the tip of leaf. The soybean ones were also discolored to lemon yellow, yellow or dark brown. The leaf injury in both rice and soybean was clearly appeared at the reverse side of leaf and in lower leaves. Milyang 23 and Nonganbyeo among rice cultivars tested were resistant to ozone, but Chucheongbyeo was resistant to it. The ratio of leaf injury was increased and chlorophyll content was decreased as the extension of ozone exposure from 2 to 8 hours in rice. Keunolkong and Danyeopkong among soybean cultivars tested showed resistant reaction to ozone, but Kwangankong and Muhankong were susceptible to it. It was observed that the soybean plants grown for 45 days after seeding were severely damaged by ozone than those of other growth stages.

• Progress in Superconductivity
• /
• v.7 no.1
• /
• pp.92-96
• /
• 2005

YBCO thin films on metal substrates were prepared by the metal-organic deposition using trifluoroacetates (TFA-MOD). To compensate the loss of Ba element from the precursor films due to the reaction with $CeO_2$ cap layer, we have employed Ba-excessive precursor solutions of $YBa_{2+x}Cu_{3}O_{7-{\delta}}$ ($0{\le}x{\le}0.1$). The precursor solutions were dip-coated on the metal substrates with $CeO_2$ cap layer, initially heated up to $400^{\circ}C$, and finally fired at the various high temperatures for 2 h in a reduced oxygen atmosphere. With this approach, YBCO films possessing critical temperature over 85 K could be successfully prepared on the metal substrates. The highest $T_{c,zero}$ value of 86 K was obtained from the Ba-excessive YBCO film of x=0.005 in $YBa_{2+x}Cu_{3}O_{7-{\delta}}$ fired at $750^{\circ}C$ for 2 h. However, unexpected $T_c$ suppression even in Ba-excessive YBCO samples requires further identification.