• The KSFM Journal of Fluid Machinery
• /
• v.14 no.3
• /
• pp.28-32
• /
• 2011

The inverter rotary compressor discharges refrigerant and compressor oil in air-conditioning systems. The compressor oil which discharged form compressor decreases the efficiency of heat exchanger and affects the compressor operation. Recently, several studies are in progress for reducing the compressor oil. Before the reduction of compressor oil discharge rate, the quantitative measurement and evaluation method are required. In order to cope with this requirement we have developed the measurement technic of oil discharge rate. The reliability assessment was carried out approximately 0.1% of the errors with compressor performance indicators. The acceptable errors were to ensure the reliability of measurement technic. In the experiment results at several conditions, The oil discharge rate of heating operation has been confirmed average 3.7 times more than cooling operation. In this study the evaluation method and the experimental results of oil discharge rate in air-conditioning systems are presented with various operating conditions.

• Journal of the Korean Institute of Gas
• /
• v.8 no.4 s.25
• /
• pp.15-22
• /
• 2004

This study has been carried out to improve the conditions of process operation through the adjustment to the flow rate and outlet pressure of LNG HP pump, one of the main process facilities, in LNG receiving terminal. We have determined optimum flow rate and applied it to the field operation by analyzing the field operating performance for all the HP pumps and the load of natural gas supply in seasonal using the ASPEN PLUS. As a results, we have get the electric cost saving for the HP pump operation and derived contribution to safety operation by reduced the LNG Process pressure.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.6 no.3
• /
• pp.29-34
• /
• 2003

This paper describes the effects of sewage amount, temperature, and years in operation on the infiltration rate of a sewage disposal system. The self-purifying sewage disposal system, which is typically used in rural areas, consists of reeds and fine gravel. Water plants are planted on the gravel bed which provides the habitat for microbes. The basic process is that the gravel bed filters incoming sewage. Thus this system requires the smooth flow of sewage through the gravel. However, the efficiency of the disposal system will be lowered if the gravel bed is clogged with sewage sludge. A three year study shows that infiltration rate slows down significantly until the 7th day, depending on the sewage amount and the temperature. After the 7th day, the infiltration rate remains almost constant. In addition, the infiltration rate decreases as the temperature falls. It also decreases as the number of years in operation increase. But there is no significant change in the infiltration rate after the 7th day, independent of the temperature, the sewage amount, and years in operation. In order to take advantage of high infiltration rate, which improves the efficiency of the disposal system in its early stages, having two gravel beds and using them alternatively will be efficient. This operation method is called intermittent load and makes the disposal system last longer. The water plant roots above the gravel bed make the effective filtration possible because they delay accumulation of the sewage sludge and stabilize the filtration ability.

• 제어로봇시스템학회:학술대회논문집
• /
• 2001.10a
• /
• pp.157.3-157
• /
• 2001

In this paper, the optimal maintenance scheduling for turbine with considering maintenance replacement rate was proposed in order to reduce the maintenance cost during the whole period of operation, meanwhile keeping current reliability of turbine. The proposed method is only based on a few limited available data with various factors relating to maintenance replacement and repair of turbine. The proposed method will be adopted by Kyushu Electric Power Co., Inc. from April in 2002 to determine the maintenance schedule of thermal power plants.

• Journal of KSNVE
• /
• v.9 no.1
• /
• pp.85-96
• /
• 1999

For ASME Code pumps in nuclear power plants, inservice test is required to assess the operational readiness in accordance with ASME code and related regulations. The objective of this study therefore, is to develop the technical background of the degradation of pump performances and conditions due to low flow rate operation. In addition. the detection techniques of pump operating conditions are to be developed to enhance the safety and economy of nuclear power plants. A test loop consisted of pump, motor. water tank, flow rate measurements and piping system with flow control devices was established for this study. Two typical pumps, 1-stage volute pump and 3-stage turbine pump, were selected and the test was performed upon two major point of views ; i.e., pump discharge pressure pulsations analysis and pump vibration spectrum analysis. From the test results, it is concluded that (1) the pump vibration affected by the natural frequency of operating pump is significant in the low frequency zone (around 1 Hz) : the vibration amplitude. especially. is an important factor during low flow rate operation. and shall be monitored to ensure that it is within the limit of ASME OM code Part 6, (2) the vibration frequency and pump discharge pressure are affected by vane pass frequency and running speed, (3) the wave phenomena due to the compressiblity of water is anticipated during low flow rate operation. and the pump system shall be designed to prevent it and. finally, (4) the technical background of the degradation of pump performances and conditions due to low flow rate operation is provided.

• Journal of the Korean Society of Safety
• /
• v.37 no.4
• /
• pp.20-27
• /
• 2022

This article aims to develop an algorithm that detects fire pump defects by analyzing the current signals of an induction motor, which are triggered by changes in the flow rate and pressure of multistage volute pumps that are used for fire services. The operational status of the pumps was categorized into three: first, normal operation; second, a defect that is caused by a change in the current value; and third, a defect occasioned by a change in current, pressure, and flow rate. When a fire pump was in normal operation, the motor's operating current was measured between 5.06 A and 6.9 A, the flow rate was estimated at 0-0.27 m³/min, and the pressure ranged from 0 to 0.47 MPa. In the event that a defect was caused by an abnormal current value in the motor, it was attributed to the pump's adherence. Furthermore, if there was no source of water, the defect was considered to have been induced by phase-loss operation, no-load operation, or run-stop operation, with the current value of each scenario being measured at > 52.8 A, < 4.13 A, > 45.15 A, and < 3.8 A, respectively, placing its overall range between 0 and 50 A. The sources of defects were detected based on an analysis of the flow rate, pressure, and current, which represent the following causes: air inflow into the casing, inadequate suction of water, and reverse-phase operation, respectively. Each cause entailed the following values: when air seeped into the casing, the pressure was measured at 0.24 MPa irrespective of changes in the flow rate; when there was inadequate suction of water, the pressure was recorded between 0 and 0.05 MPa despite changes in the flow rate; and when the power line's reverse-phase loss was the cause of the defect, the pressure was measured at 0.33 MPa for a flow rate of 0 L/min, and a higher flow rate decreased the pressure to nearly 0 MPa. The results of this study will enable engineers to develop a pump defect detection algorithm that is based on an analysis of current, and this algorithm will facilitate the execution of a program that will control a fire pump defect detection system.

• Proceedings of the KSRS Conference
• /
• v.1
• /
• pp.216-219
• /
• 2006

This paper analyzes on LHGS (LRIT/HRIT Generation Subsystem) processing timeline for COMS LHGS design. The LHGS shall transmit LRIT/HRIT (Low Rate Information Transmission/ High Rate Information Transmission) data to the users within 15 minutes after the end of the image acquisition. So, this paper performs experiment using MTSAT-1R LRIT/HRIT (11 days) and calculates minimum LHGS processing time. Only HRIT FD (Full Disk) image is considered in this paper because data size of HRIT FD image is the largest. As a result of experiment, COMS LHGS should be able to receive MI Level 1B product within 157 seconds at least.

• Clinics in Shoulder and Elbow
• /
• v.27 no.2
• /
• pp.160-168
• /
• 2024

Background: Recurrent anterior shoulder dislocation (RASD) in cases of seizure disorders (SDs) total 50%-80% of all SD-associated shoulder instabilities. Based on the extent of bone loss, treatment options include bony and soft-tissue reconstructions, arthroplasty, and arthrodesis. The primary objective of this paper was to review the treatment options for RASD in SDs. Methods: Several bibliographic databases were searched for RASD treatment options in SD patients. The demographic outcome measures, the failure rate (defined as the relative risk of recurrence of dislocation postoperation), and the postoperative seizure recurrence rate were recorded. Results: We pooled 171 cases (187 shoulders) from 11 studies. Of these, one, five, two, two, and one reports studied Bankart's operation with remplissage (27 cases/29 shoulders), the Latarjet procedure (106/118), bone block operation (21/23), arthroplasty (11/11), and arthrodesis (6/6), respectively, in treating SD-associated RASD. The relative risk of failure between SD and non-SD patients was 3.76 (1.36-10.38) after the Latarjet operation. The failure rates were 17% and 13% for Bankart's operation with remplissage and the Latarjet procedure in SD patients, respectively, but 0% each for bone block operation, arthroplasty, and arthrodesis. The total rate of seizure recurrence after operation was 33% of the pooled cases. Conclusions: SD recurrence in the postoperative period, the size of the bone block, and the muscular attachments to a small coracoid autograft are the determinants of failure among various reconstructive operations in SD-associated RASD.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.44 no.12
• /
• pp.1103-1111
• /
• 2016

Korea Astronomy and Space Science Institute (KASI) has been operating SLR (Satellite Laser Ranging) system with 2kHz repetition rate for satellite precise orbit and spin determination as well as space geodesy. But the SLR system was improved to be capable of laser ranging with high repetition rate, up to 10kHz by developing new operation software and novel range gate generator, called HSLR-10. The HSLR-10 will contribute to the accurate spin rate determination of geodetic satellites and geodetic research due to its largest repetition rate in the world. In this study, the development methodology and configuration of operation software are addressed, and its validation results are also presented.

• 한국노년학
• /
• v.31 no.4
• /
• pp.985-998
• /
• 2011

This study was conducted to understand current management status of 'day and night care' facilities and to explore the related factors with rates of operation of them. The nationwide mailing survey was conducted with structured questionnaires from July, 14, 2010 to July, 28, 2010. The subjects were 277 facilities (response rate 24.5%). Regarding the types of operating, 79.1% of faculties was run by cooperation, and 17.8% and 3.6% for individuals and national/public institutes respectively. The average of operation rate was 70.15%. National/public institutes showed higher in the rate of operation(79.08%) than 72.49% of cooperations and 57.78% of individuals. The number of manpower was not nearly different by the types of operating bodies, but the number of nurse was significantly different among them. The national/public institutions had 1.07 nurses while individual institutions have only 0.08. We found that facilities run by national/public institutes and founded before 2008 years showed higher rate of operation. In case of providing regular monitoring and evaluation services, and music program for patients showed higher rate of operation. In addition, the number of managers, social workers, and nurses increase the rate of operation. We suggest that quality management and monitoring program for the facilities which run by individuals or established after 2008 years would be developed. We also call for development of programs for facilitating utilization of 'day and night care' facilities such as expanding the family support.