• 한국지반공학회논문집
• /
• 제19권1호
• /
• pp.143-150
• /
• 2003

과압밀점토의 응력-변형 거동에 중요한 영향을 미치는 변형률 속도에 관하여 다루었다. 본 연구에서는 응력경로 회전각, 과압밀비 그리고 접근길이를 포함한 응력이력과 재하속도 이력 및 재하속도를 포함한 시간이력을 변화시켜 압밀-배수 응력경로 삼축 실험을 수행하였다. 실험 결과 모든 영향인자에 대하여 시간이 증가할수록 변형률 속도 역시 증가하였다. 또한, 회전각의 정의에 따라 상이한 변형률 속도의 값을 보였고, 과압밀비와 재하속도가 증가할수록 변형률 속도 역시 증가하였다. 응력이력에서는 응력-변형 거동과 변형률 속도간의 상관성이 존재하였지만 시간이력에서는 응력-변형-변형률 속도의 상관성을 보이지 않았다.

• Computers and Concrete
• /
• 제33권5호
• /
• pp.519-533
• /
• 2024

Many materials including cementitious concrete-type materials undergo material property changes during high-rate loading. There is a wealth of research regarding this phenomenon for concrete in compression and tension. However, there is minimal knowledge about how mortar material used in concrete masonry unit (CMU) construction behaves in high-rate shear loading. A series of experiments was conducted to examine the bond strength of mortar bonded to CMU units under high-rate shear loading. A novel experimental setup using a shock tube and dynamic ram were used to load specially constructed shear triplets in a double lap shear configuration with no pre-compression. The Finite Element Method was leveraged in conjunction with data from the experimental investigation to establish if the shear bond between concrete masonry units and mortar exhibits any rate dependency. An increase in shear bond strength was observed when loaded at a high strain rate. This data indicates that the CMU-mortar bond exhibits a rate dependent strength change and illustrates the need for further study of the CMU-mortar interface characteristics at high strain rates.

• 한국수소및신에너지학회논문집
• /
• 제24권2호
• /
• pp.179-185
• /
• 2013

The behavior of surface film formation was greatly dependent on the speed of potential cycling. In $LiClO_4$ / EC + DEC, cyclic voltammetry results showed that the peaks originated from surface film formation on graphite electrode at the high charge-discharge rate was shifted to the lower potentials as the charge-discharge rate decrease. This indicates that surface films with different morphology and thickness were formed by different charge-discharge rate. Transmission electron microscopy (TEM) results indicated that the properties such as thickness and morphology of the surface film were greatly affected by the charge-discharge rate. Electrochemical impedance spectroscopy (EIS) showed that the resistance of surface film was affected by the speed of potential cycling. In addition, the charge transfer resistance was also dependent on the charge-discharge rate indicating that the charge transfer reaction was affected by the nature of surface film. TEM and EIS results suggested that the chemical property as well as the physical property of the surface film was affected by the charge-discharge rate.

• 한국소성가공학회:학술대회논문집
• /
• 한국소성가공학회 2005년도 추계학술대회 논문집
• /
• pp.148-151
• /
• 2005

This paper is concerned with the thermo-mechanical behavior and temperature dependent strain rate sensitivity of steel sheet for an auto-body. In order to Identify the temperature dependent strain rate sensitivity of SPRC35R and SPRC45E, uniaxial tension tests are performed with the variation of the strain rates from 0.001/sec to 200/sec, and the variation of environmental temperatures from $-40^{\circ}C\;to\;200^{\circ}C$. The thermo-mechanical response at the quasi-static state is obtained with the static tensile test and at the intermediate strain rate is from the high speed tensile test. The experimental results show that the strain rate sensitivity increases at low temperature and it decreases at high temperature. It means that as the strain rate getting increasing, the variation of flow stress is more sensitive on the temperature. The results also indicates that the material properties of SPRC35R is more depend on the changes of strain rates and temperature than those of SPRC45E.

• The Journal of Asian Finance, Economics and Business
• /
• 제8권1호
• /
• pp.1-6
• /
• 2021

This research examines the stock market index determinants and the prediction using the FFT curve fitting of the Jakarta Stock Exchange (JKSE) Composite Index during the COVID-19 pandemic. This paper has used daily data of Jakarta Stock Exchange (JKSE) Composite Index, interest rate, and exchange rate from 15 October 2019 to 15 September 2020, and a total of 224 observations, retrieved from Indonesia Stock Exchange (IDX), Indonesia Statistics Central Bureau and Observation & Research of Taxation. The study covers descriptive statistics, multicollinearity test, hypothesis tests, determination test, and prediction using FFT curve fitting. The results unveil four fresh and robust evidence. Partially, the interest rate has affected positively and significantly the stock market index. Partially, the exchange rate has affected negatively and significantly the stock market index. The F-test result, interest rate, and exchange rate have significantly affected the stock market index (JKSE) simultaneously. Furthermore, the FFT curve fitting has predicted that the stock market fluctuates and increases over time. The results have shown a strong influence of the independent variables and the dependent variable. The value of Adjusted R-Square is 0.719, which means that the independent variables have simultaneously impacted the dependent variable for 71.9%; other factors have influenced the remaining 28.1%.

• 열처리공학회지
• /
• 제30권6호
• /
• pp.258-263
• /
• 2017

The effect of cooling rate on the damping capacity of pure Mg was studied. Two Mg samples with different cooling rates were prepared by heat treatment at 873 K for 24 h, followed by water quenching and by furnace cooling to room temperature, respectively. The average grain sizes of the Mg samples were almost identical regardless of the cooling rate, but more twins were observed in the sample with faster cooling rate. The calculated vacancy fraction was higher in the fast cooling sample than the slow cooling one. It is noted that the fast cooling sample exhibited lower damping capacity both in the strain-amplitude independent and strain-amplitude dependent regions. Higher values of vacancy concentration and number density of twins in the fast cooling sample are considered to be responsible for the deteriorated damping capacity in the strain-amplitude independent and strain-amplitude dependent regions, respectively.

• The Korean Journal of Ecology
• /
• 제18권2호
• /
• pp.265-273
• /
• 1995

Net photosynthetic rate (Pn) of Quercus mongolica leaves was determined under the controlled O₃concentrations of 0, 20, 30, 40, 50 or 60 ppb at every 10 min for 7 hr. Under the fumigation of the different O₃concentrations the relative net photosynthetic rate (RNPR) of the leaves decreased rapidly until 1 hr and thereafter decreased slowly. At below 20 ppb O₃the decrease of the RNPR was scarce but at above 20 ppb O₃the RNPR was inversely proportional to O₃concentration on a logarithmic curve. The RNPR at 60 ppb O₃, for example, was reduced 30％ less than that without O₃. Under the different O₃concentrations fumigated for the short period of time the Pn dependent upon PPFD was depicted as saturation equation and Pn dependent upon temperature as quadratic equation. Results of this study suggest that short-term low O₃of less than 60 ppb concentration may lead to reductions of Pn in Q. mongolica leaves.

• 대한기계학회논문집B
• /
• 제21권6호
• /
• pp.773-778
• /
• 1997

The present study investigates the effect of the shear rate-dependent thermal conductivity of non-newtonian fluids on the heat transfer enhancement in a 2:1 rectangular duct flow. An axially-constant heat flux and a peripherally-constant temperature boundary conditions(H1) was adopted for a top-wall-heated configuration. The present numerical results of Nusselt numbers for SRDC(Separan) show heat transfer enhancement over those of SRIC. The Nusselt numbers increased linearly as Reynolds numbers increased. The heat transfer enhancement is due to an increased thermal conductivity near the wall, which is attributed to the shear rate-dependence.

• 한국표면공학회지
• /
• 제32권2호
• /
• pp.172-181
• /
• 1999

The effect of the DMAB concentration, temperature, deposition time, and stabilizer concentration on the precipitation reaction of the electroless nickel plating using dimethylamine borane (DMAB) as reducing agent was investigated to by the weight gain and electrochemical method. The deposition rate was dependent with DMAB concentration. The polarization resistance of the precipitation reaction was reduced with DMAB concentration. The precipitation reaction rate of Ni-B deposits was controlled by the oxidation rate of DMAB as the source of electron. The boron content of the deposit was constant at about 5.5wt%, even when DMAB concentration in the solution was increased. The effect of temperature and stabilizer ($Pb(NO_3)_2$) concentration on deposition rate was shown to have co-dependent behaviors.

• Bulletin of the Korean Chemical Society
• /
• 제13권4호
• /
• pp.398-404
• /
• 1992

We have investigated the kinetics of diffusion-influenced bimolecular reactions in which one reactant has an internal mode, called the gating mode, that activates or deactivates its reactivity intermittently. The rate law and an expression for the time-dependent rate coefficient have been obtained from the general formalism based on the hierarchy of kinetic equations involving reactant distribution functions. The analytic expression obtained for the steady-state reaction rate constant coincides with the one obtained by Szabo et al., who derived the expression by employing the conventional concentration-gradient approach. For the time-dependent reaction rate coefficient, we obtained for the first time an exact analytic expression in the Laplace domain which was then inverted numerically to give the time-domain results.