• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.51 no.9
• /
• pp.449-454
• /
• 2002

A rectangular straight microchannel, integrated with the resistance temperature detectors(RTDs) for temperature sensing and a micro-heater for generating the Temperature gradient along the channel, was fabricated. Its dimension is 57${\mu}{\textrm}{m}$(H)$\times$200${\mu}{\textrm}{m}$(W)$\times$48,050${\mu}{\textrm}{m}$(L), and RTDs were placed at the inner-channel wall. Si wafer was used as a substrate. For the fabrication of RTDs, 5300$\AA$ thick Pt/Ti layer was sputtered on a Pyrex glass wafer. Finally, the glass wafer was bonded with Si wafer by anodic bonding, so that the RTDs are located inside the microchannel. Temperature coefficient of resistance(TCR) values of the fabricated Pt-RTDs were 2800~2950ppm$^{\circ}C$ and the variation of TCR value In the range of O~10$0^{\circ}C$ was less than 0.3％. Therefore, it was proved that the fabricated Pt-RTDs without annealing were excellent as temperature sensors. The temperature distribution in the microchannel was investigated as a function of mass flow rate and heating power. The temperature increase rate diminished with decreasing the applied power and increasing the mass flow rate. It was confirmed from the comparison with the simulation results that the temperature measured inside the microchannel is more accurate than measuring the temperature measured at the outer wall. The proposed temperature sensing method and microchannel are expected to be useful in microfluidics researches.

• Journal of Power Electronics
• /
• v.15 no.2
• /
• pp.555-566
• /
• 2015

A TRIAC dimming LED driver that can control the brightness of LED arrays for a wide range of source voltage variations is proposed in this paper. Unlike conventional PWM LED drivers, the proposed LED driver adopts a TRIAC switch, which inherently guarantees zero current switching and has been proven to be quite reliable over its long lifetime. Unlike previous TRIAC type LED drivers, the proposed LED driver is composed of an LC input filter and a variable switched capacitance, which is modulated by the TRIAC turn-on timing. Thus, the LED power regulation and dimming control, which are done by a volume resistor in the same way as the conventional TRIAC dimmers, can be simultaneously performed by the TRIAC control circuit. Because the proposed LED driver has high efficiency and a long lifetime with a high power factor (PF) and low total harmonic distortion (THD) characteristics, it is quite adequate for industrial lighting applications such as streets, factories, parking garages, and emergency stairs. A simple step-down capacitive power supply circuit composed of passive components only is also proposed, which is quite useful for providing DC power from an AC source without a bulky and heavy transformer. A prototype 60 W LED driver was implemented by the proposed design procedure and verified by simulation and experimental results, where the efficiency, PF, and THD are 92%, 0.94, and 6.3%, respectively. The LED power variation is well mitigated to below ${\pm}2%$ for 190 V < $V_s$ < 250 V by using the proposed simple control circuit.

• Proceedings of the KIEE Conference
• /
• 2007.07a
• /
• pp.1275-1276
• /
• 2007

For fabrication of $BaTiO_3$ system Ferroelectric thick films, (Ba,Sr,Ca)$TiO_3$ (BSCT) powders, prepared by using the alkoxide-based sol-gel method, were doped $MnCO_3$ as acceptor and $Dy_{2}O_{3}$ as donor. $MnCO_3$ and $Dy_{2}O_{3}$-doped (Ba,Sr,Ca)$TiO_3$ thick films were fabricated by screen printing techniques on high purity alumina substrates. The structure and dielectric properties were investigated with variation of $Dy_{2}O_{3}$ amount. As a result of the differential thermal analysis(DTA), exothermic peak was observed at around $670^{\circ}C$ due to the formation of the polycrystalline perovskite phase. All the BSCT thick films, sintered at $1420^{\circ}C$ for 2h, showed the typical XRD patterns of perovskite polycrystalline structure and no pyrochlore phase was observed. The average grain size and thickness of specimens no doped with $Dy_{2}O_{3}$ was 1.32mm, 52mm, respectively. The relative dielectric constant decreased and dielectric loss increased with increasing amount of $Dy_{2}O_{3}$ dopant, the values of the BSCT thick films no doped with $Dy_{2}O_{3}$ were 4043 and 0.4% at 1 kHz, respectively. The relative dielectric constant gradually decreased in the measured frequency range from 0.1 to 100 kHz

• Applied Chemistry for Engineering
• /
• v.19 no.3
• /
• pp.264-269
• /
• 2008

For the synthesis of lead chromate pigments, we investigated the characteristics of particle growth with reacting conditions in the synthetic process, the effect of additives, and its micro-capsulation. The more tiny and uniform dispersion particles could be obtained at a lower pH and diluter intial concentration. The variation range of average pigment size was increased with the agitating speed. The pigment size could be controlled by adding aluminum sulfate as an additive, which maintained the optimum particle dispersion. It was found that the optimum micro-capsulation conditions were pH 9~10 and above $90^{\circ}C$ during the micro-capsulation of lead chromate pigment, and below 0.5% humidity after micro-capsulation.

• Journal of Aerospace System Engineering
• /
• v.13 no.3
• /
• pp.56-63
• /
• 2019

Performance analyses were performed on a propeller developed for use in a PAV (Personal Air Vehicle) under 600 kg Maximum Take-Off Weight (MTOW). The actuator disc theory and CFD analyses were used to estimate the hovering time with regards to MTOW variation for a given battery weight. The interference induced power factor kint was introduced to account for the effect of flow interference between the propellers and to estimate the performance of counter-rotating propellers. The Maximum Figure of Merit (FM) value of the propeller pitch was determined and the design RPM range for the required power inversely obtained from the CFD results. Previous research indicate that the flight time of large multi-copter is limited by the available battery energy density. Similarly, the propeller pitch settings and spacing are important factors in reducing the kint value.

• The Korean journal of sports medicine
• /
• v.36 no.4
• /
• pp.214-220
• /
• 2018

Purpose: The purpose of this research is to study changes in pituitary hormone in anterior lobe and thyroid hormone before, after, and during recovery time in severe 100 km ultramarathon. Methods: Healthy middle-aged runners (age, $52.0{\pm}4.8$ years) participated in the test. Grade exercise test is done, and then blood is taken from those participants before and after completing 100 km ultramarathon at the intervals of 24 hours (1 day), 72 hours (3 days), and 120 hours (5 days) to analyze their luteinizing hormone (LH), follicle-stimulating hormone (FSH), thyroid stimulating hormone (TSH), triiodothyronine (T3), thyroxine (T4), and free thyroxine (Free T4). Results: For LH, it decreased more significantly at 100 km than pre-race. However, after 1 day result increased more than that of 100 km. At 3 days, it was significantly higher than pre-race and 100 km, recovering at 5 days. In terms of FSH, it decreased at 100 km, 1 day, and 3 days more than pre-race but recovered at 5 days. TSH was higher at 1 day and 5 days compared to pre-race. T3 was only higher at 100 km than pre-race. T4 was higher till 5 days at 100 km than pre-race. Free T4 increased more significantly at 100 km than pre-race. Conclusion: In terms of severe long distance running, LH and FSH which belong to hormone from anterior lobe as well as T3, T4, and Free T4 which belong to thyroid hormone showed their variation within the standard range. However, TSH showed abnormal increase from enhanced concentration of blood after marathon becoming hyper-activation even during the recovery period.

• Journal of Astronomy and Space Sciences
• /
• v.38 no.2
• /
• pp.135-143
• /
• 2021

We report, for the first time, the afternoon (i.e., from noon to sunset time) observations of the northern mid-latitude E-region field-aligned irregularities (FAIs) made by the very high frequency (VHF) coherent backscatter radar operated continuously since 29 December 2009 at Daejeon (36.18°N, 127.14°E, 26.7°N dip latitude) in South Korea. We present the statistical characteristics of the mid-latitude afternoon E-region FAIs based on the continuous radar observations. Echo signal-to-noise ratio (SNR) of the afternoon E-region FAIs is found to be as high as 35 dB, mostly occurring around 100-135 km altitudes. Most spectral widths of the afternoon echoes are close to zero, indicating that the irregularities during the afternoon time are not related to turbulent plasma motions. The occurrence of afternoon E-regional FAI is observed with significant seasonal variation, with a maximum in summer and a minimum in winter. Furthermore, to investigate the afternoon E-region FAIs-Sporadic E (E_s) relationship, the FAIs have also been compared with E_s parameters based on observations made from an ionosonde located at Icheon (37.14°N, 127.54°E, 27.7°N dip latitude), which is 100 km north of Daejeon. The virtual height of E_s (h'E_s) is mainly in the height range of 105 km to 110 km, which is 5 km to 10 km greater than the bottom of the FAI. There is no relationship between the FAI SNR and the highest frequencies (f_tE_s) (or blanket frequencies (f_bE_s)). SNR of FAIs, however, is found to be related well with (f_tE_s-f_bE_s).

• Analytical Science and Technology
• /
• v.18 no.2
• /
• pp.147-153
• /
• 2005

Benzophenone (BP) which is one of endocrine disrupting chemicals is suspected to contaminate waters (river, lake and industrial drainage) and soils (ground soil and sediment). Analytical method for determination of BP in soil and water was developed by gas chromatography/mass spectrometry. Water sample (100 mL) was extracted with n-hexane, and soil (10 g) was extracted with methanol and n-hexane. Recovery for BP was >71.4% in water and 86.5-94.7% in soil with coefficient variation of less than 19.8%. Calibration curves showed a good linearity ($r^2$ >0.998). In water, soil and sediment collected at nation-wide sites, BP was detected at 5 sites among 43 water sites at the concentration range of 30-200 ng/L. No BP was found in the soil and sediment samples. It is suggested that this method will be useful to the determination of BP in the environmental matrices such as waters, soils and sediments in minute quantities.

• Korean Journal of Materials Research
• /
• v.14 no.1
• /
• pp.67-72
• /
• 2004

The glass-forming conditions are investigated in the $K_2$O-CaO-$SiO_2$ $-P_2$$O_{5}$ system with 10~65 mole% of$ P_2$$O_{5}$. Thermal properties and dissolution properties were investigated according to variation of the SiO and KO contents in selected compositions. The glass formation condition was determined when $K_2$O/$P_2$$O_{5}$ mole ratio 0~0.24, $SiO_2$/($SiO_2$+$P_2$$O_{5}$ ) mole ratio 0～0.29, and CaO/$P_2$$O_{5}$ mole ratio 0~1.00. In the result of the thermal properties, the glass transition temperature($T_{g}$) and softening temperature($T_{s}$ ) were gradually shifted to the lower temperature range with increase of $K_2$O contents. The maximum value of the chemical durability was shown in $K_2$$PO_2$$O_{5}$ mole ratio 0.17 when the $SiO_2$ contents were changed, and $K_2$O was fixed at 10 mole%. Hence the change of the $K_2$O/$P_2$$O_{5}$ mole ratio was found that a new main factor of the chemical durability.

• The KIPS Transactions:PartB
• /
• v.15B no.4
• /
• pp.365-374
• /
• 2008

In this paper, we propose a model to enrich an ontology by incrementally extending the relations through variations of patterns. In order to generalize initial patterns, combinations of features are considered as candidate patterns. The candidate patterns are used to extract relations from Wikipedia, which are sorted out according to reliability based on corpus frequency. Selected patterns then are used to extract relations, while extracted relations are again used to extend the patterns of the relation. Through making variations of patterns in incremental enrichment process, the range of pattern selection is broaden and refined, which can increase coverage and accuracy of relations extracted. In the experiments with single-feature based pattern models, we observe that the features of lexical, headword, and hypernym provide reliable information, while POS and syntactic features provide general information that is useful for enrichment of relations. Based on observations on the feature types that are appropriate for each syntactic unit type, we propose a pattern model based on the composition of features as our ongoing work.