• Title/Summary/Keyword: Range of variation

Search Result 3,245, Processing Time 0.035 seconds

A Study on the Simulation Method of the Code Correlation Range (코드상관 거리측정센서의 시뮬레이션 기법 연구)

  • Kim, Ung-Sik;Kang, Byoung-Moo;Kim, Wan-Joo
    • Proceedings of the KIEE Conference
    • /
    • 1997.07b
    • /
    • pp.459-461
    • /
    • 1997
  • This paper describes a simulation method of the correlation-signal output, which has Doppler effect (variation of amplitude, phase, and frequency) caused by the moving-effect of target and encounter conditions. Using these results, we can develope and verify the algorithm of the signal processing parts of the code correlation range sensor with ease.

  • PDF

The Jumping Performance Strategy over 8 meters in National Long Jumpers through the Kinematic Variable Researches (멀리뛰기 8m 선수들의 운동학적 변인 조사를 통한 국내 멀리뛰기 선수들의 8m 뛰기 전략)

  • Ryu, Jae-Kyun
    • Korean Journal of Applied Biomechanics
    • /
    • v.15 no.2
    • /
    • pp.129-138
    • /
    • 2005
  • The purpose of this study was to investigate the techniques used by long jumpers who recorded over 8meters in 2002 Busan Asian Game and 2003 Daegu Universiade. The kinematic characteristics from the last three stride to takeoff at the takeoff board were analyzed such as velocities, heights and angles. The real-life three-dimensional coordinates of 20 body landmarks during each trial were collected using a Direct Linear Transformation procedure. The conclusion were as follows; 1. The height variation who recorded over 8 meters of center of gravity of the jumpers at the last stride was under 8cm. In order to record over 8meters the national long jumpers should have under 10cm height variation. 2. In the approach phase the horizontal velocity of the jumpers should reach to 10.5m/s in last three strides and 9.79m/s in touch down at take off board. 3. The horizontal velocity at take off board must have over 8.51m/s and the vertical velocity must have 3.75m/s simultaneously in order to record 8meters. 4. The forward body lean angle should have over 20degrees with pushing the take off board in forwarding movement. The appropriate body variation range ratio between take off and touch down should be 1.2 vs 1 and the trunk angle at touch down on the board should be close to the erect posture for higher body flight.

Dispersionless transmission line and the characterization using leaky circuit board for high speed and high density digital circuits (고속/고밀도 디지털 회로를 위한 기판을 이용하는 무왜곡 전송 구현 및 해석)

  • 이중호;윤상기;이해영
    • Journal of the Korean Institute of Telematics and Electronics D
    • /
    • v.35D no.8
    • /
    • pp.1-7
    • /
    • 1998
  • This paper reports a dispersion compensation technique to implement tje distortionless transmission line by satisfying the heaviside conditon. Because of the skin depth for aconductor, compensation condition is dependent on the freuqncy variation. For this reason, first, the resistance have been chaacterized in awide range of frequencies, and then found the effective conductivity of the substrate which satisfied the heaviside condition. The phase velocity and the characteristics impedance are prresented nearly constant over a wideband frequency range.

  • PDF

A Study on Improving Mass Production of the Radar Sensor Oscillator (레이더 센서용 발진기의 양산성 향상에 관한 연구)

  • Kim, Byung-Chul;Cho, Kyung-Rae;Lee, Jae-Buom;Kim, Dae-Hyung
    • Journal of the Korea Institute of Information and Communication Engineering
    • /
    • v.16 no.4
    • /
    • pp.669-676
    • /
    • 2012
  • In this paper, The method to improve the mass production method of the radar sensor is suggested by using the temperature compensation circuit which is composed with the thermister. The mass production became easier by decreasing the adjustment time for the exact oscillation frequency with the temperature compensation circuit that can support the proper gate bias voltage for the FET after the dielectric resonator is removed from the DRO(Dielectric Resonator Oscillator) of the radar sensor. Radar sensor with the proposed method has 15.67MHz oscillator frequency variation in the temperature range of $-20^{\circ}C-+55^{\circ}C$, 0.65dB magnitude variation, -105.47dBc phase noise characteristics at 1MHz which are better or similar temperature characteristics with the DRO whose oscillator frequency variation is 25MHz, magnitude variation is 0.42dB and phase noise is -107.40dBc in the same temperature range.

An experimental study on the viscosity of visco-elastic fluids (점탄성유체의 점성에 관한 실험적 연구)

  • 김춘식;이영호
    • Journal of Advanced Marine Engineering and Technology
    • /
    • v.6 no.2
    • /
    • pp.21-41
    • /
    • 1982
  • Viscosity, especially characteristic among various properties of visco-elastic fluids such as high polymer solutions, is affected mainly by temperature and concentration. Hence, it is important for fluid engineering to express, by some equations, how the fluid characteristics vary with the change of temperature and concentration and to analyze them to obtain consistent viscous characteristics. High polymer solutions, synthetic products of modern chemical industry, suggest many interesting investigations because they are typical visco-elastic materials. Experimentation was made to derive some useful fluid characteristic equations of SEPARAN-NP10 (polyacylamide) expressed by n (flow behavior index) and K' (consistency index) when it is given temperature and concentration variation. To measure viscosity, capillary viscometer was adopted and the range of experimentation is 0-2,000 P.P.M. in concentration and 15-55 .deg.C in temperature. The experimental results are summarized as follows: The flow behavior index n 1) has nearly constant results irrespective of temperature variation at same conentration and the results are shown in (Table. 4-4-3) 2) has following equation, regardless of temperature, for the variation of concentration. n=-1.0765*10$^{-4}$ P+0.9915 (P:P.P.M.) The consistency index K' 1) has different results for the variation of temperature at same concentration and the results are given in (Table.4-7-2) 2) has following equation for the variation of concentration at same temperature. log 10$^{4}$K' =6.4785*10$^{-4}$ P-1.0529 (P:P.P.M)

  • PDF

Polarization Scattering Property of Cascaded Polarization Controllers

  • Muga, Nelson J.;Ferreira, Mario F.;Pinto, Armando Nolasco
    • ETRI Journal
    • /
    • v.29 no.6
    • /
    • pp.838-840
    • /
    • 2007
  • The relation between the allowed range of variation of polarization controller wave-plates angles and the respective polarization scattering properties is investigated. It is demonstrated that a nearly uniform polarization scattering over the Poincare sphere is obtained using a concatenation of three polarization controllers with angles randomly changed between $-{\pi}$/4 and ${\pi}$/4. It is also shown that an improvement of the scattering properties is obtained if the configuration angles are allowed to change between $-{\pi}$/2 and ${\pi}$/2.

  • PDF

A Study on Ultrasonic Welding System Design (초음파 용접 시스템 설계에 관한 연구)

  • Hong, Jeng-Pyo;Jung, Seoung-Hwan;Won, Tae-Hyun;Kwon, Soon-Jae
    • Proceedings of the KIPE Conference
    • /
    • 2008.06a
    • /
    • pp.164-166
    • /
    • 2008
  • Ultrasonic welder joins with a horn and a booster for amplification of the mechanical displacement. This coupling generates other resonance points at a frequency range lower than the piezoelectric material's resonance frequency. Therefore, frequency variation range through PLL control was proposed in order to prevent reaction to these resonance points.

  • PDF

Occurrence of sea lice, Caligus undulatus Shen and Li, 1959 (Copepoda: Siphonostomatoida: Caligidae) in plankton samples collected from Korea

  • Moon, Seong Yong;Park, Jong Sick
    • Journal of Species Research
    • /
    • v.8 no.4
    • /
    • pp.365-372
    • /
    • 2019
  • We have conducted faunistic study of sea lice collected from marine plankton samples of western and southern coasts of Korea. These specimens were identified as Caligus undulatus Shen and Li, 1959, belonging to family Caligidae and order Siphonostomatoida with worldwide distribution. The range extension of C. undulatus is reported in addition to the previously known distributional range from the Northwest Pacific (China, Japan, and Korea), India, Brazil, and Mexico. This species can be distinguished from all previous reports with characteristics such as overall body proportions of both sexes, structure details of mouth appendages, armature of legs, and some variation in body size. The distributional range of C. undulatus is now given with its northern and south hemisphere limit being 40 to $10^{\circ}N$ in the Indo-Pacific and $30^{\circ}S$ in the Southwest Atlantic. This is the first record of its female occurring in Korea.

Effects of Vowel Differences on Laryngeal DDK (모음에 따른 후두 교호운동 특성)

  • Han, Ji-Yeon;Lee, Ok-Bun
    • MALSORI
    • /
    • v.68
    • /
    • pp.1-15
    • /
    • 2008
  • This study investigated the vowel effect on laryngeal DDK (L-DDK) in terms of rate, regularity, and range. Thirteen normal speakers participated in this experiment. Speakers were asked to repeat the vowels /a, e, i, o, u/ for vocal fold adduction DDK, and /ha, he, hi, ho, hul for vocal fold abduction DDK. Acoustic data was analyzed via Motor Speech Profile. There were 6 parameters: DDKavp and DDKavr for rate of L-DDK, DDKcvp and DDKjit for regulariry of L-DDK, and DDKavi and DDKcvi for range of L-DDK. Results of MANOVA and Fredman analysis showed no significant vowel effect on rate and regularity of L-DDK. MANOVA revealed significant effects of vowels and vocal fold ab/adduction on range of L-DDK. DDK peak intensity (DDKavi) in vowel /i/ production was lower than in vowels /a, e, o, u/. Variation of DDK peak intensity (DDKcvi) was significantly greater for /ha/ than for /a/ production. The implication of these findings on voice and speech pathology is discussed.

  • PDF

A 22kW Bidirectional Three-Phase Push-Pull Converter for Wide Voltage Range Application (넓은 입력 전압 범위를 갖는 20kW급 양방향 3상 푸쉬풀 컨버터)

  • Le, Tat-Thang;Jeong, Hyeonju;Kim, Seon-Ju;Choi, Sewan
    • Proceedings of the KIPE Conference
    • /
    • 2019.07a
    • /
    • pp.8-10
    • /
    • 2019
  • In this paper, a bidirectional three-phase push pull converter is analyzed for the high power, wide voltage range applications. From comparison analysis of two switching methods: PWM plus phase-shift (PPS) and dual-asymmetric PWM (DAPWM) with the effect of dead-time, the proposed hybrid control is aimed to reduce the circulating current under wide voltage range operation. Value of leakage inductance effect to the peak current value, current stress and conduction loss in facing the load variation. Trade-off between power range and slew rate of transformer current was analyzed for properly selecting value of the transformer leakage inductance. Experimental results from a 22-kW prototype are provided to validate the proposed concept.

  • PDF