• 한국전자파학회논문지
• /
• 제9권1호
• /
• pp.98-107
• /
• 1998

FM-DS /SS 시스댐 구현을 위하여, 주입되는 신호에 동기하는 주입형 SO (Synchronous Oscillator)에 대하 여 해석하였다. 송신부에서는 FM의 RF 출력 신호와 DS /SS(Direct Sequence /Spread Spectrum)을 이용하 여 FM-DS /SS 변조 방식을 채택하였으며, 수신부에서는,SO를 수신부의 PN(Pusudo Noise) 클럭 동기를 위한 슬라이딩 상관기로 사용하여 FM-DS/SS의 복조를 위한 동기부로 이용하였다. 그 결과 수신주파수가 도플러와 같은 현상에서도 안정된 동기성능을 유지하였으며, FM-DS /SS의 시스템에 적용하여 PN 동기 및 동기 특성 을 입증하였다.

• 한국위성정보통신학회논문지
• /
• 제9권4호
• /
• pp.16-19
• /
• 2014

본 논문에서는 와이파이(WiFi) 도플러 주파수의 검파를 기반으로 무선랜 AP(Access Point)용 송신기와 수신기의 부반송파(subcarrier)비콘 방식을 설계한다. 이로서 WiFi-AP에서 도플러 주파수의 감지 및 검파를 위해 어레이(array) 안테나와 RF 빔을 추정함으로서 사람의 움직임과 침입탐지를 검출할 수 있다. 이러한 무선 탐지와 무선 동작인식을 기반으로 한 WiFi 도플러 주파수 검파방식과 적응형 비콘(beacon)의 시간영역신호를 조합하는 무선보안 서비스 설계방안을 제안하였다.

• Journal of electromagnetic engineering and science
• /
• 제16권4호
• /
• pp.232-234
• /
• 2016

In this paper, the power transfer efficiencies (PTEs) of magnetic resonance (MR) wireless power transmission (WPT) and radio frequency (RF) WPT are compared as a function of the distances between resonators (or antennas). The PTE of the C-loaded loop resonators during MR WPT was theoretically calculated and simulated at 6.78MHz, showing good agreement. The PTE of the patch antennas, whose area is the same as the C-loaded loop resonator during MR WPT, was theoretically calculated using the Friis equation and the equation by N. Shinohara and simulated at 5.8 GHz. The three results from the Friis equation, the equation by N. Shinohara, and from a full wave simulation are in strong agreement. The PTEs, when using the same size resonators and antennas are compared by considering the distance between the receiver and transmitter. The compared results show that the MR WPT PTE is higher than that of the RF WPT PTE when the distance (r) between the resonators (or antennas) is shorter. However, the RF WPT PTE is much higher than that of the MR WPT PTE when the distance (r) between the resonators (or antennas) is longer since the RF WPT PTE is proportional to $r^{-2}$ while the MR WPT PTE is proportional to $r^{-6}$.

• 한국항행학회논문지
• /
• 제13권4호
• /
• pp.503-508
• /
• 2009

본 논문에서는 특정인(장애인, 재활치료자, 고령자 등)들이 수월하게 컴퓨터를 사용 할 수 있도록 하기 위한 손동작 인식형 보조 입력장치를 설계하였다. 입력장치는 3차원 공간에서 손 동작 인식을 위해 자이로 센서를 사용하였고, 통신 대역은 무선 RF 2.4GHz 대역에서 신호를 송 수신 하도록 하였다. 제작된 보드는 자이로 모듈, RF 통신 모듈, MCU, USB 단자 등으로 구성되었다. 동작인식 실험결과, 마우스 기반의 커서 이동 및 프로그램 제어 등이 설계 규격대로 수행됨을 확인 하였다.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제2권2호
• /
• pp.147-155
• /
• 2002

This paper describes RF front-end transceiver chipset for the dual-mode operation of PCS-Korea and IMT-2000. The transceiver chipset has been implemented in a $0.25\mutextrm{m}$ single-poly five-metal CMOS technology. The receiver IC consists of a LNA and a down-mixer, and the transmitter IC integrates an up-mixer. Measurements show that the transceiver chipset covers the wide RF range from 1.8GHz for PCS-Korea to 2.1GHz for IMT-2000. The LNA has 2.8~3.1dB NF, 14~13dB gain and 5~4dBm IIP3. The down mixer has 15.5~16.0dB NF, 15~13dB power conversion gain and 2~0dBm IIP3. The up mixer has 0~2dB power conversion gain and 6~3dBm OIP3. With a single 3.0V power supply, the LNA, down-mixer, and up-mixer consume 6mA, 30mA, and 25mA, respectively.

• 한국마이크로전자및패키징학회:학술대회논문집
• /
• 한국마이크로전자및패키징학회 2003년도 기술심포지움 논문집
• /
• pp.205-207
• /
• 2003

본 논문에서는 고유전율 기판을 사유하여 성능은 뛰어나며, 사이즈가 작은 통합된 마이크로파 멀티 칩 필터의 설계를 제시하고자 한다. 다양한 유전체 기판은 유전성, 큐 인자, 온도 등에 의해 제품의 요구조건에 EK라 선택 될 수 있다. 이 논문에서는 5.8 GHz 송/수신기 모듈에 소요되며 유전상수(K=130)을 사용하여 대역 여파기(band pass filter)의 설계에 관한 연구를 나타내었다.

• 반도체디스플레이기술학회지
• /
• 제13권4호
• /
• pp.59-63
• /
• 2014

Previous studies have selected wireless power transmission system using 2.45 GHz of ISM band, but the researches for 5.8 GHz microwave wireless power transmission have been relatively rare. The 5.8 GHz has some advantages compared with 2.45 GHz. Those are smaller antenna and smaller integrated system for RFIC. In this paper, the 5.8 GHz wireless power transmission system was developed and transmission efficiency was measured according to the distance. A transmitter sent the amplified microwaves through an antenna amplified by a power amplifier of 1W for 5.8 GHz, and a receiver was converted to DC from RF through a RF-DC Converter. In the 1W 5.8GHz wireless power transmission system, the converted currents and voltages were measured to evaluate transmission efficiency at each distance where LED lights up to 1m. The RF-DC Converter is designed and fabricated by impedance matching using full-wave rectifier circuit. The transmission-efficiency of the system shows from 1.05% at 0cm to 0.095% at 100cm by distance.

• 융합신호처리학회논문지
• /
• 제3권1호
• /
• pp.27-32
• /
• 2002

본 논문에서 제안한 텔레미트리 시스템은 생체신호를 중거리로 전송하기 위한 RF 송신기와 전자파 간섭의 영향이 없는 광을 매체로한 수신기이다. 텔레미트리 시스템은 of 65$\times$125$\times$45mm크기이며, RF 송신부, 광 수신부와 생체신호 처리를 위한 CMOS 칩으로 구성되어 있다. 제안된 텔레메트리 장점은 전자파에 노출을 최소화하면서 중거리(50m) 텔레메트리가 가능하여, 자유로운 상태에서의 모니터링이 가능하다. 관측 시스템은 실시간 처리를 위해 dual-processor구조로 설계했다. 본 연구에서는 1 채널 360Hz, 16 Bits의 심전도 데이터를 1.42초 간격으로 실시간 웨이브렛 변환할 수 있었다.

• 제어로봇시스템학회논문지
• /
• 제13권10호
• /
• pp.1025-1031
• /
• 2007

GPS is widely used for positioning applications and attitude of a vehicle can be found also with multiple antennas. However, extremely weak signal level prevents GPS from indoor operation. DR with accelerometers and gyros and landmark based localization method used for indoor applications increase complexity and cost. In this paper, a simple but very efficient ultrasound based attitude determination system which determines both position and attitude in WSN is given. The range between transmitter and receivers are measured using the arrival time difference between ultrasound and RF signal. The 3 dimensional positions can be found using more than 3 range measurements. Furthermore, if more than 2 transmitters are used, the attitude can be determined using the baseline vectors obtained by differencing transmitter and receiver positions. The prototype system is implemented to evaluate the performance of the proposed method. In addition, an error analysis shows the relation between the attitude error and basel me length, quality of measurement and orientation of a vehicle. The static and dynamic experiments performed by micro mobile robot shows accurate position with less than 1.5cm error and attitude with less than 1 degree error can be obtained continuously with 20cm baseline. It is expected that these results can be adapted without modification to indoor applications such as home cleaning robot and autonomous wheelchair maneuvering.

• 전기학회논문지
• /
• 제59권11호
• /
• pp.2043-2047
• /
• 2010

This study is to solve problems of depletion of RF bandwidth frequency, confusion possibility, security that current wireless communications system have and is to confirm possibility of applying next generation network. To solve problems of current wireless communications system, visible light communications system for power line communications using ATmega16 Microcontroller is was realized and receiver property was analyzed. PLC exclusive chip APLC-485MA, Microcontroller ATmega16, 5pi bulb type LED and high flux LED, visible light receiving sensor LLS08-A1 were used for transmitter and receiver. Performance was analyzed by designed program and an oscilloscope. It was showed average 20% improved receiver rate rather than bulb type LED in the case of high flux LED through voltage change rate on communication distance and LED type of distance between 10 to 50 cm. The blue LED showed the best performance among measured LED types with above 10% of voltage decreasing rate. But As it gradually becomes more distant, the precise date was difficult to obtain due to weak light. To overcome these sort of problems, specific values such as changing conditions and efficiency value relevant to light emitting parts and visible light receiving sensor should be calculated and continuous study and improvements should also be accomplished for the better communications condition.