• Proceedings of the PSK Conference
• /
• 2003.10b
• /
• pp.118.1-118.1
• /
• 2003

SS cream and its revised formula, CJ-4001 is topical Chinese herbal drugs for premature ejaculation. To evaluate the genotoxic potentials of these drugs, micronucleus test using Acridine orange (AO) staining method was performed. Acridine orange (AO) staining is adopted in OECD guideline 474 and widely used in micronucleus test. In dose range finding study, no mouse was dead at 2000 mg/kg using single treatment subcutaneously. Therefore, 3 dose levels were chosen at 500, 1000, 2000 mg/kg. (omitted)

• Journal of Yeungnam Medical Science
• /
• v.8 no.2
• /
• pp.158-163
• /
• 1991

It is evident that an elevation of airway albumin excreation rate without clinical proteinuria strongly predicts a later progression on diabetic renal disease. So we studied the correation between Microalbumin checkly RIA & Mitral-Test$^{(R)}$. We collected urine between 08 : 00 h and 08 : 00 h next day and then checked microalbuminuria by radioimmunoassay method and Mitral-Test$^{(R)}$ The results are as follows : 1. There was significant correation between microalbuminuria checked by RIA & Micral-Test$^{(R)}$ 2. There was poor correations between diabetes duration or HV-A1c and maximal change in albumin excreation rate. 3. So we conclued that Micral-Test$^{(R)}$ can be used in laboratory instead of RIA.

• Journal of Periodontal and Implant Science
• /
• v.32 no.3
• /
• pp.655-664
• /
• 2002

The purpose of this study was to observe the degree of surface obliteration of dentinal tubule using Gluma(R) desensitizer and MS coat(R) with 15 specimens made out of 15 extracted lower incisors. They were divided into Root planning group(control), Gluma(R) desensitizer group(test I ) and MS coat(R) group(test II). Degree of Obliteration was examined under the scanning electron microscope(${\times}$2000). The following results were obtained: 1. In the root planning group(control), the complete open of dentinal tubule surface was accounted for 73.8%, the partial obliteration for 17.2% and the complete obliteration for 9.0%. 2. In the Gluma(R) desensitizer group (test I), the complete open of dentinal tubule surface was accounted for 23.6%, the partial obliteration for 42.8% and the complete obliteration for 33.6%. 3. In the MS coat(R) group (test II), the complete open of dentinal tubule surface was accounted for 19.2%, the partial obliteration for 45.6% and the complete obliteration for 35.2%. 4. The average number of open dentinal tubules in the control was significantly higher than in the test I and II (P<0.05), but there were no statistically significant differences between the test I and II. 5. The average number of the partially obliterated and the completely blocked dentinal tubules in the control was significantly lower than the test I and II(P<0.05), but there were no statistically significant differences between the test I and II. The results of this study suggest that Gluma(R) desensitizer and MS coat(R) is significantly effective on dentinal tubule obliteration, therefore they were effective on hypersensitivity caused by periodontal treatment

• Journal of the Korean Society of Safety
• /
• v.27 no.3
• /
• pp.9-14
• /
• 2012

The objectives of this study were to compare the results of HSL (Health and Safety Laboratory) ramp test with perceived sense of slip onto the several different floor surfaces under contaminated conditions. There are a variety of approaches from biomechanical measurements to psychophysical test and human perception. However, controversies over these approaches still remain. Some widely accepted methods need to be improved. AHP (Analytic Hierarchy Process) was used to evaluate the perception of slipperiness of seven different floor surfaces under the contaminated condition with glycerol solution. Twelve subjects worn same footwear and walked with self-selected step and cadence along the test floors. The angle of inclination obtained for water wet condition using 5 l/min with HSL ramp test was compared to perception of slipperiness. The surface roughness ($R_z$) related very well both AHP (r=0.95) and ramp test (r=0.92). The high significant correlation (r=0.90) was found between AHP and HSL ramp test.The HSL ramp test values (Coefficient of Friction, COF) according to subjective evaluation were divided into two categories. There were high correlations between test results (subjective evaluation, HSL ramp test) and surface roughness in Rz. Perception rating obtained with AHP showed a high correlation with COF obtained with HSL ramp test.

• Journal of the Korean Society for Industrial and Applied Mathematics
• /
• v.12 no.2
• /
• pp.109-118
• /
• 2008

We present a new version of the first return time test for pseudorandomness. Let $R_n$ be the first return time of initial n-block with overlapping. An algorithm to calculate the probability distribution of the first return time $R_n$ for each starting block is presented and used to test pseudorandom number generators. The standard Z-test for log $R_n$ is applied to test the pseudorandom number generators.

• Proceedings of the KIEE Conference
• /
• 1995.07a
• /
• pp.98-100
• /
• 1995

This paper deals with development of high torque and high accurate stepping motor and control system which is adopted heavy equipment engine speed control. In the process of development, only pure domestic technics is involved, all the parts are supplied in domestic industries, and successfully accomplished to mass production. In order to confirm product liability, circumferential test,such as vibration test impact test,thermal test,and field test are thoroughly fulfilled.

• Korean Journal of Clinical Laboratory Science
• /
• v.36 no.2
• /
• pp.137-143
• /
• 2004

Erythrocyte sedimentation rate(ESR) measurements were performed in a total of 191 blood samples from patients below a hematocrit of 35% by both the Test-1(SIRE Analytical Systems, Udine, Italy) and the Westergren method, endorsed as the reference method for ESR by the International Council for Standardization in Hematology(ICSH). The corrected Westergren ESR values were also obtained applying the formula of Fabry (corrected ESR = ESR measured x 15/55-Hct). Linear regression analysis showed a close correlation (r=0.85) between the two methods both before and after ESR correction in total samples. There was no significant correlation difference between two methods in both two groups with hemoglobin $${\geq_-}9g/dl$$ and <9g/dl before and after ESR correction (r=0.873, r=0.827 respectively before correction and r=0.867, r=0.830 respectively after correction). Also, for two groups with hematocrit $${\geq_-}24%$$ and <24%, no significant difference was observed (r=0.859, r=0.792 respectively before correction and r=0.782, r=0.842 respectively after correction). However, for samples with <60mm of Westergren ESR before correction, a better correlation coefficient was obtained than samples with $${\geq_-}60mm$$(r=0.701, r=0.541 respectively). In corrected Westergren ESR, also samples that were obtained with <40mm showed better correlation than samples with $${\geq_-}40mm$$ (r=0.690, r=0.347 respectively). In conclusion, we found a good correlation between Test-1 and Westergren measurements in patients with anemia but an expert group discussion is required to solve discrepancy between two methods in blood samples with very high ESR.

• Journal of Internet Computing and Services
• /
• v.19 no.2
• /
• pp.43-48
• /
• 2018

Various artifacts that are produced as software R&D project progresses contain research plan, research report, software requirements and design descriptions, etc. When conducting a software R&D project, it is necessary to confirm that the developed system has implemented its research requirements well. However, various research results make it difficult to design appropriate tests. So, there is a practical need for us to comprehensively handle the planning, execution, and reporting of software test for finding and verifying information related to the research. In this paper, we propose a useful method for software test process in R&D project which supports model based software testing. The proposed method supports automation of test design and generation of test data by explicitly separating each step of System Under Test (SUT). The method utilizes the various models representing the control flow of the function to extract the information necessary for testing the system. And it supports a systematic testing process based on TMMi and ISO 29119. Finally, we show the validity of the method by implementing a prototype with basic functionality to generate test data from software behavioral models.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.20 no.6
• /
• pp.844-852
• /
• 2017

Since guided weapon is high-cost and one-shot device which is non-reusable, it requires a lot of resources to prove required accuracy as a part of reliability demonstration. Once a test for proving accuracy rate of guided missile fails, it causes an additional cost and delay of schedule. This study introduces an equation for proper sample size and plan for guided-missile accuracy rate test in order to minimize the risk of test failure. Proper sample size for the test is derived by considering the reliability growth. Furthermore, each task for accuracy rate test is defined according to the development step. Therefore, this study can contribute to reduce sample size for accuracy rate test in order to meet the reliability requirement and assure transparency in the test process.

• Physical Therapy Korea
• /
• v.28 no.3
• /
• pp.208-214
• /
• 2021

Background: The CKCUES test evaluates the functional performance of the shoulder joint. The CKCUES test scores CKC exercises of the upper limbs to examine shoulder stability. Although the CKCUES test provides quantitative data on functional ability and performance, no study has determined the relationship between CKCUES scores and SA and TB muscle strength. Objects: The objective of this study is to determine the relationship between the CKCUES test scores and the strength of the SA and TB muscles in the CKCUES and unilateral CKCUES tests. Methods: Sixty-six healthy male volunteers participated in the study. A Smart KEMA strength sensor measured SA and TB muscle strength. Two parallel lines on the floor indicated the initial hand placement to start CKCUES tests. For 15 seconds, the subject raises one hand and reaches over to touch the supporting hand, then returns to the starting position. Results: The correlation between the CKCUES test scores and the strength of the SA was strong (r = 0.650, p < 0.001), and the TB was moderate (r = 0.438, p < 0.001). The correlation between the unilateral CKCUES test and the strength of the SA of the supporting side was strong (r = 0.605, p < 0.001), and swing side was strong (r = 0.681, p < 0.001). The correlation between the unilateral CKCUES test and the strength of the TB of the supporting side was moderate (r = 0.409, p < 0.001), and swing side was moderate (r = 0.482, p < 0.001). Conclusion: Our study showed that the CKCUES test had a strong association with isometric strength of SA and moderate association with that of TB. These findings suggest that the CKCUES test can evaluate the function of the SA. Moreover, the unilateral CKCUES test can evaluate unilateral shoulder function.