• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.7A
• /
• pp.712-718
• /
• 2004

We report 1.6 Tb/s (160${\times}$10 Gb/s) WDM transmission over 2,000 km of single mode fiber using distributed hybrid(distributed Raman amplifier＋Erbium-doped fiber amplifier) optical amplifiers. After transmission over 2,000 km of single mode fiber, average optical signal to noise ratios of C/L-band were 20.5 dB, 21.9 dB, respectively. The minimum Q-factors of each band were 14.65 dB (BER=5.8e-8) in C-band, 13.75 dB (BER=5.0e-7) in L-band without forward error correction. We performed 1.6 Tb/s error-free transmission over 2,000 km of single mode fiber using Reed-Solomon (255, 239) forward error correction code.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.10A
• /
• pp.1015-1022
• /
• 2007

In this paper, dual-band digital codec for UHF(Ultra High Frequency) and MW(Micro Wave) is proposed for an RFID reader system. Most RFID systems have been supported only one protocol. But, There are many protocols of each bandwidth. Especially, UHF bandwidth which is widely used on the globe consists of A,B,C type, and more standards will be established. Recently, Since an interest about mobile RFID system is increasing, the RFID system with more than one protocol will be need. Therefore, this paper suggests a dual-band digital codec with UHF and MW bands for an RFID reader system. Standards used in this system are 18000-6C and 18000-4 standards. The digital codec is synthesize by the Quartus II compiler. Target device is EPC20Q240C8 which is family of CycloneII. Main Clock is 19.2MHz and elements of FPGA which is used for the system is 18,752.

• Journal of Forest and Environmental Science
• /
• v.8 no.1
• /
• pp.51-66
• /
• 1992

This study was carried out to investigate the micromorphology of vessel wall sculpture such as shape of perforation plate, perforation rim, steepness of perforation plate, occurrence of vestured pit, warty layer and ray-vessel pitting on 13 species of Fagaceae in Korea. The results were summarized as follows ; 1. In the species examined, all sample species except Fagus crenata var. multinervis have simple perforation plate. But Fagus crenata var. multinervis has simple and scalariform perforation plate (it was called to combination perforation plate) in a tree stem. 2. The shapes of perforation rim could be classified into five types; Type A without tail, Type B with small tail on both sides, Type C with long tail on both sides, Type D with tail only one side and Type E with the very short interval between perforations. Among five types, Type Band C have higer frequency of distribution than the others. 3. The steepness of perforation plate measured was about 20 degree on pore zone and 43 degree on outside parts of pore zone. 4. Species with vestured pit were Q. aliena, Q, dentata, Q. variabilis, Fagus crenata var. multinervis, Castanopsis cuspidata var sieboldii, Q. acuta, Q. stenophylla, and Q. glauca. But the extent of vesturing was very slight and vestured pits were observed mainly in ray-vessel pit of some vessel elements. 5. Species with warty layer on the inner surface wall of all vessel elements were Q. acuta, Q. stenophylla, Q. glauca, Fagus crenata var. multinervis and species with warty layer of some vessel elements were Q. aliena, Q, dentata, Q. variabilis, Castanopsis cuspidata var. sieboldii. 6. Species with palisade ray-vessel pit were Q. acuta, Q. stenophylla, Q. glauca, Castanea crenata, Castanea bungeana, Q. aliena, Q. serrata, Q. mongolica, and species with scalariform ray-vessel pit was Fagus crenata var. multinervis and species with oval ray-vessel pit were Q, dentata, Castanopsis cuspidata var sieboldii.

• Korean Journal of Optics and Photonics
• /
• v.6 no.3
• /
• pp.245-256
• /
• 1995

Rugate filters of inhomogeneous refractive index were designed using the Fourier transform and the effect of reflectance, stop bandwidth, optical thickness, and Q function on the rugate filter was investigated. An iterative correction process using a merit function was employed to fit an initial design to the target spectrum. Three Q functions derived by Sossi, Bovard, and Fabricius, respectively, were compared in terms of the number of iteration, merit function, and optimum optical thickness. The result shows that after a number of iterations the Q functions by Bovard and Fabricius produce high rejection rugate filters closer to the target spectrum than the Sossi's Q function and the optimal optical thickness is determined by the stop-band width of the rugate filter. ilter.

• Journal of Environmental Science International
• /
• v.27 no.4
• /
• pp.275-279
• /
• 2018

Water status of intact plants has been optically estimated by measuring reflectance at the wavelengths 1,450 nm and 1,900 nm based on their signal strengths. Although another water band at 970 nm is considered to have very small signals, the band apparently lies within the detection range of inexpensive spectrometer and plain charge-coupled device (CCD) camera used in wild fire studies. However measurement of the reflectance at 970 nm has been rarely applied to estimate the water status of dead plant materials such as fallen branch, twig, and leaf. To test the possibility of applying water reflectance at 970 nm to estimate the water content (WC) in leaf litter, the reflectance in various WC values were measured in the leaf litter of three Quercus species (Q aliena, Q aliena, Q mongolica, and Quercus variabilis). The results showed that the WC in the leaf litter can be determined by reflectance water index (WI) in the three Quercus species ($WC=1,450{\times}WI-1,378.8$, r=0.865). However, there was no interaction effect in the relationship between WI and WC among the litter of the three Quercus species.

• Journal of electromagnetic engineering and science
• /
• v.14 no.2
• /
• pp.47-53
• /
• 2014

This paper presents a high gain and high harmonic rejection low-noise amplifier (LNA) for software-defined radio receiver. This LNA exploits the high quality factor (Q) series resonance technique. High Q series resonance can amplify the in-band signal voltage and attenuate the out-band signals. This is achieved by a source impedance transformation. This technique does not consume power and can easily support multiband operation. The chip is fabricated in a $0.13-{\mu}m$ CMOS. It supports four bands (640, 710, 830, and 1,070MHz). The measured forward gain ($S_{21}$) is between 12.1 and 17.4 dB and the noise figure is between 2.7 and 3.3 dB. The IIP3 measures between -5.7 and -10.8 dBm, and the third harmonic rejection ratios are more than 30 dB. The LNA consumes 9.6 mW from a 1.2-V supply.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.35C no.8
• /
• pp.42-51
• /
• 1998

An 8th-order elliptic low-pass filter with cutoff frequency of 3.13kHz is presented. The design procedure is based on teh 1/s impedance transformation which is applied to a minimum capacitor LC ladder network.The tranformed network is implemented with resistors and high Q frequency-dependent negative resistors (FDNR's). The high Q FDNR is realized with two transadmittance amplifiers. Detailed SPICE simulations show that the iflter has pass-band ripple of 0.18dB, stop-band attenuation over 100dB, cutoff frequency of 3.13 khz, and cutoff frequency temperature coefficient of 8.5ppm/.deg. C at supply voltage of .+-.5V.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.55 no.4
• /
• pp.172-177
• /
• 2006

During normal machine operation, partial discharge(PD) tests were performed with partial discharge analyzer(PDA) in two hydrogenerators. Six cable couplers were installed in circuit ring bus and endwinding of three phases. PDA showed that the normalized quantity number(NQN) and the partial discharge magnitude$(Q_m)$ were very low in hydrogenerator #1 and #2, respectively. The trend analyses of NQN and $Q_m$ value are available for monitoring of the insulation condition in hydrogenerator stator windings. The insulation condition of stator winding can be assessed. Discharge at conductor surface was discovered in B phase(C2 coupler) of hydrogenerator #1. Internal discharges were generated in A and C phases(C2 coupler) of hydrogenerator #1 and in A, Band C phases(C1 and C2 couplers) of hydrogenerator #2. Slot discharges occurred in A, Band C phases(C1 coupler) of hydrogenerator #1. The stator windings of two hydrogenerators were in good condition.

• The Bulletin of The Korean Astronomical Society
• /
• v.36 no.2
• /
• pp.128.1-128.1
• /
• 2011

We present the results of the first simultaneous dual-frequency VLBI observation with KVN (Korean VLBI Network). The KVN has a unique multi-frequency receiving system performing simultaneous observations at four frequencies, such as 22, 43, 86, and 129 GHz, in order to calibrate the atmospheric phase fluctuations, which cause a severe degradation of an interferometric coherence in mm-VLBI regime. In order to test the multi-frequency phase referencing capability of KVN, we observe the bright continuum VLBI source, NRAO 150 at two different frequencies of 21.7 (K band) and 43.4 (Q band) GHz simultaneously. The VLBI fringe phases at K and Q bands show a tight correlation of phase behaviors and the results of phase referencing (residual phase, coherence etc) are promising for achieving excellent phase referencing observations with KVN. The KVN will be able to open new perspectives in the multi-frequency study of VLBI.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.08a
• /
• pp.319-319
• /
• 2011

KSTAR ICRF 안테나 장치에서 외곽 플라즈마 밀도분포는 고주파 출력이 내부로 전달되는 효율을 위해 중요하게 다루어 진다. 따라서 1.5T의 자기장에서 플라즈마에 간섭없이 0~$10^{14}/cm^3$의 외곽 플라즈마 밀도분포를 측정할 수 있는 Q-band 대역의 x-mode 반사계가 필요 하였다. 헬리콘 플라즈마는 $10^{13}/cm^3$ 이상의 높은 플라즈마 밀도를 수 kW 이내의 rf power와, 수 MHz 대역의 고주파원을 사용하여 높은 에너지 효율로 얻을 수 있다. 이때 높은 플라즈마 밀도는 외곽 플라즈마 밀도 와 비슷하여 제작한 반사계를 테스트 할 수 있다. 본 연구에서는 x-mode microwave 반사계를 제작하고, 1kW rf power와 10MHz 고주파원으로 헬리콘 플라즈마를 생성하여 정전 탐침으로 진단하였고, 반사계의 Q-band대역의 주파수를 가변 하여 반사되어 나오는 마이크로파의 beat 주파수를 통해 밀도 분포를 얻어서 정전탐침과 비교 분석하였다.