• Journal of the Society of Naval Architects of Korea
• /
• v.42 no.4 s.142
• /
• pp.368-378
• /
• 2005

The effects of rotary oscillation on the unsteady laminar flow past a circular cylinder. are numerically investigated in the present study. The numerical solutions for the 20 Wavier-Stokes equation are obtained using a finite volume method Tn the framework of an overlapping grid system. The vortex formation behind a circular cylinder and the hydrodynamics of wake flows for different rotary oscillation conditions are analyzed from the results of numerical simulation. The lock-on region is defined as the region that the natural shedding frequency due to the Karmann Vortex shedding and the forcing frequency due to the forced oscillating a cylinder are nearly same, and the quasi-periodic states are observed around that region. At the intersection between lock-on and non-lock-on region the shedding frequency is bifurcated. After the bifurcation, one frequency fellows the forcing frequency($S_f$) and the other returns to the natural shedding frequency($St_0$). in the quasi-periodic states, the variation of magnitudes and relevant phase changes of $C_L$ with forcing phase are examined.

• Journal of Welding and Joining
• /
• v.31 no.3
• /
• pp.76-83
• /
• 2013

This study investigated the effect of bonding temperature and holding time on microstructures and mechanical properties of diffusion bonded joint of Haynes230. The diffusion bonds were performed at the temperature of 950, 1050, and $1150^{\circ}C$ for holding times of 30, 60, 120 and 240 minutes at a pressure of 4MPa under high vacuum condition. The amount of non-bonded area and void observed in the bonded interface decreased with increasing bonding temperature and holding time. Cr-rich precipitates at the linear interface region restrained grain migration at $950^{\circ}C$ and $1050^{\circ}C$. However, the grain migration was observed in spite of short holding time due to the dissolution of precipitates to base metal in the interface region at $1150^{\circ}C$. Three types of the fracture surface were observed after tensile test. The region where the coalesce and migration of grain occurred much showed high fracture load because of base metal fracture whereas the region where those did less due to the precipitates demonstrated low fracture load because of interface fracture. The expected fracture load could be derived with the value of fracture area of base metal ($A_{BF}$) and interface ($A_{IF}$), $Load=201A_{BF}+153A_{IF}$. Based on this equation, strength of base metal and interface fracture were calculated as 201MPa and 153MPa, respectively.

• Journal of Acupuncture Research
• /
• v.30 no.1
• /
• pp.71-80
• /
• 2013

Objectives : This study aimed to investigate the difference of abdominal skin temperature responses following moxibustion comparing stimulation method. Methods : Moxibustion was applied on the acupuncture points of $CV_4$, $CV_6$, $CV_{12}$. Thirty healthy men were randomly divided into two groups, one receiving a single moxibustion stimulation in three locations '$CV_4{\cdot}CV_6{\cdot}CV_{12}$'(n=15) and the other receiving triple moxibustion stimulations in one location '$CV_{12}$'(n=15) for 30 min. To obtain the skin temperature on abdominal region, a thermograph was used. Three arbitrary frames(the upper abdominal, lower abdominal, whole abdominal regions) were made to analyse skin temperature. Thermographic images were obtained at before and after the procedure of indirect moxibustion and 5, 10, 15, 20, 25, 30 min afterwards. Results : An increase in skin temperature on the three abdominal regions was observed following both one point and three points moxibustion administrations. Significant increase in skin temperature of the whole abdominal region was observed at 30 min after the procedure of three points moxibustion compared with one point moxibustion stimulation. A tendency of skin temperature changes over time was observed. Conclusions : In this study, skin temperature of lower abdominal region does not increase after triple moxibustion stimulations on $CV_{12}$. Administration of single moxibustion on $CV_4$, $CV_6$, $CV_{12}$ makes greater changes in skin temperature on the whole abdominal region than triple moxibustion on $CV_{12}$.

• Biomedical Science Letters
• /
• v.25 no.1
• /
• pp.40-53
• /
• 2019

Of the Acinetobacter spp., A. baumannii (genospecies 2) is the most clinically significant in terms of hospital-acquired infections worldwide. It is difficult to perform Acinetobacter-related taxonomy using phenotypic characteristics and routine laboratory methods owing to clusters of closely related species. The ability to accurately identify Acinetobacter spp. is clinically important because antimicrobial susceptibility and clinical relevance differs significantly among the different genospecies. Based on the medical importance of pathogenic Acinetobacter spp., the distribution and characterization of Acinetobacter spp. isolates from 123 clinical samples was determined in the current study using four typically applied bacterial identification methods; partial rpoB gene sequencing, amplified rRNA gene restriction analysis (ARDRA) of the intergenic transcribed spacer (ITS) region of the 16~23S rRNA, the $VITEK^{(R)}$ 2 system (an automated microbial identification system) and matrix-assisted laser desorption/ionization-time of flight mass spectrometry (MALDI-TOF MS). A. baumannii isolates (74.8%, 92/123) were the most common species, A. nosocomialis (10.6%, 13/123) and A. pittii isolates (7.5%, 9/123) were second and third most common strains of the A. calcoaceticus-A. baumannii (ACB) complex, respectively. A. soli (5.0%, 6/123) was the most common species of the non-ACB complex. RpoB gene sequencing and ARDRA of the ITS region were demonstrated to lead to more accurate species identification than the other methods of analysis used in this study. These results suggest that the use of rpoB genotyping and ARDRA of the ITS region is useful for the species-level identification of Acinetobacter isolates.

• Journal of Korean Society for Atmospheric Environment
• /
• v.25 no.5
• /
• pp.432-449
• /
• 2009

In this study, the effects of high-resolution land cover on the simulation of near-surface meteorological fields were evaluated in two different coastal regions using Weather Research and Forecasting (WRF) model. These analyses were performed using the middle classification land cover data upgraded by the Korean Ministry of Environment (KME). For the purpose of this study, two coastal areas were selected as follows: (1) the southwestern coastal (SWC) region characterized by complex shoreline and (2) the eastern coastal (EC) region described a high mountain and a simple coastline. The result showed that the application of high-resolution land cover were found to be notably distinguished between the SWC and EC regions. The land cover improvement has contributed to generate the realistic complex coastline and the distribution of small islands in the SWC region and the expansion of urban and built-up land along the sea front in the EC region, respectively. The model study indicated that the improvement of land cover caused a temperature change on wide areas of inland and nearby sea for the SWC region, and narrow areas along the coastal line for the EC region. These temperature variations in the two regions resulted in a decrease and an increase in land-breeze and sea-breeze intensity, respectively (especially the SWC region). Interestingly, the improvement of land cover can contribute large enough to change wind distributions over the sea in coastal areas.

• Journal of Environmental Science International
• /
• v.6 no.5
• /
• pp.437-449
• /
• 1997

To predict diffusion and movement of k pollutants In coastal urban region a numerical simulation shouts be consider atmospheric flow field with land-sea breeze, mountain-valley wand and urban effects. In this study we used Lagrangian [article dispersion method In the atmospheric flow field of Pusan coastal region to depict diffusion and movement of the Pollutants emoted from particular sources and employed two grid system, one for large scale calculating region with the coarse mesh grid (CMG) and the other for the small region with the One mesh 914 (FMG). It was found that the dispersion pattern of the pollutants followed local circulation system in coastal urban area and wale air pollutants exhausted from Sasang moved Into Baekyang and Jang moutain, air pollutants from Janglim moved into Hwameong-dong region.

• Journal of Oral Medicine and Pain
• /
• v.39 no.2
• /
• pp.55-62
• /
• 2014

Purpose: This study aims to evaluate the changes in soft tissue thickness of the masseteric region after injection of botulinum toxin type A (BTX-A). Methods: Twenty-four data acquired from medical records were classified into 4 groups: bruxer group that received masseter muscle injection only (M-B), bruxer group that received both masseter and temporalis muscle injections (MT-B), non-bruxer group that received masseter muscle injection only (M-NB) and non-bruxer group that received both masseter and temporalis muscle injections (MT-NB). Injection dose of BTX-A was 30 units for each masseter muscle and 20 units for each temporalis muscle. We measured the reduced thickness of the masseteric region before and after 12 weeks after injection using cone-beam computed tomography. Results: Among the patients that received both masseter and temporalis muscle injections, bruxer group showed a tendency to have more reduction in masseter muscle thickness than non-bruxer group. The difference in reduced thickness between M-B and MT-B tended to show greater than the difference between M-NB and MT-NB. Conclusions: In case of masseter hypertrothy patients with bruxism there was a tendency to show a difference in reduced thickness of soft tissue between the group that received both masseter and temporalis muscles injection and the group that received masseter muscle injection only hence a thorough inspection before the injection of BTX-A is condisered to be needed.

• Journal of Acupuncture Research
• /
• v.36 no.4
• /
• pp.264-271
• /
• 2019

Background: The purpose of this study was to redefine the location of acupoints in the lower abdomen by taking actual thoracic and abdominal measurements. Methods: Measurements of the length and height of the thorax, and both the upper and lower abdominal area were compared to standard values defined by the World Health Organization Western Pacific Region (WHO/WPRO), and medical text books such as Miraculous Pivot, and A-B Classic of Acupuncture and Moxibustion. These measurements were used to redefine the standard of 1 cun, and the cun value of the lower abdomen. Results: Of the 60 studies screened, all studies used the cun measurement system. Considerable variation in the localization of acupoints in the lower abdominal area were detected. The average measurement of a typical male lower abdomen was within 6.33 cun to 6.34 cun. From this data, 6.5 cun appears to be more accurate than the current standardized length of 5 cun. The standardized index values of the width of the 4 fingers, and the distance from the lateral prominence from the greater trochanter to the popliteal crease (Fm), appeared to apply to only males, as defined by the WHO/WPRO. Conclusion: Further studies on standardizing the index measurements for the lower abdominal area are necessary. For males, the more accurate standardized length of the lower abdomen was 6.5 cun, whereas for females, the measurement would typically be longer than 6.5 cun.

• Journal of Trauma and Injury
• /
• v.33 no.4
• /
• pp.242-247
• /
• 2020

Purpose: The purpose of this study was to determine the incidence and characteristics of associated injuries in patients with spine trauma. Methods: Data of 3,920 consecutive patients admitted to a regional trauma center during a 3-year period were analyzed retrospectively. Results: Of the 3,920 patients who were admitted to the trauma center during the 3-year study period, 389 (9.9%) had major spinal injuries. Among these 389 patients, 303 (77.9%) had associated injuries outside the spine. The most common body region of associated injuries was the extremities or pelvis (194 cases, 49.4%), followed by the chest (154 cases, 39.6%) and face (127 cases, 32.6%). Of these 303 patients, 149 (64%) had associated injuries that required surgical treatment such as laparotomy or internal fixation. Associated injuries were more common in patients with lumbar injuries (93.3%) or multiple spinal injuries (100%) than in those with lower cervical injuries (67.4%). There was a significant correlation between the location of the spinal injury and the body region of the associated injury. However, distant associated injuries were also common. Conclusions: Associated injuries were very common in spinal injury patients. Based on demographic groups, the trauma mechanism, and the location of spinal injury, an associated injury should be suspected until proven otherwise. Using a multidisciplinary and integrated approach to treat trauma victims is of the paramount importance.

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.45 no.2
• /
• pp.116-120
• /
• 2019

Clear cell odontogenic carcinoma (CCOC), a rare tumor in the head and neck region, displays comparable properties with other tumors clinically and pathologically. In consequence, an incorrect diagnosis may be established. A 51-year-old male patient who was admitted to the Department of Oral and Maxillofacial Surgery at Pusan National University Dental Hospital was initially diagnosed with ameloblastoma via incisional biopsy. However, the excised mass of the patient was observed to manifest histopathological characteristics of ameloblastic carcinoma. The lesion was ultimately diagnosed as clear cell odontogenic carcinoma by the Department of Oral Pathology of Pusan National Dental University. Therefore, segmental mandibulectomy and bilateral neck dissection were performed, followed by reconstruction with fibula free flap and reconstruction plate. Concomitant chemotherapy radiotherapy was not necessary. The patient has been followed up, and no recurrence has occurred 6 months after surgery.