• 한국연소학회지
• /
• 제11권4호
• /
• pp.22-26
• /
• 2006

To meet the environmental requirements, Doosan Heavy Industries & Construction Co., Ltd. (Doosan) had developed low NOx pulverized coal burner and it was applied to boiler retrofit project, 130 ton/hr coal fired cogeneration boiler, in 2003. NOx emissionand unburned carbon (UBC) in fly ash were measured during the commissioning tests. In this paper, the operation results of low NOx pulverized coal burner installed in 130 ton/hr coal fired boiler are presented. Burners emitted 160 ppm (@6 % $O_2$ basis) NOx and 3 % UBC with Chinacoal containing 0.86 % fuel nitrogen. And also it was shown that NOx emission rate of low NOx pulverized coal burner is linearly increased with fuel-nitrogen fraction of coal.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2004년도 추계학술대회
• /
• pp.1751-1755
• /
• 2004

Increasing environmental pressures to reduce NOx emission are being placed on coal-fired boilers. To meet the environmental requirements, Doosan Heavy Industries & Construction Co., Ltd.(Doosan) has developed low NOx pulverized coal burner. Low NOx pulverized coal burner has already delivered, and it's combustion performance was evaluated to the NOx and Unburned Carbon(UBC) during the commissioning tests. The test results are shown that the strong relationship is existed between NOx and OFA flow rate, and also fuel-N fraction of coal has effected on NOx emission.

• 한국환경과학회지
• /
• 제27권5호
• /
• pp.309-317
• /
• 2018

In this study, a laser sheet technique and PLIF (Planar laser-induced fluorescence) are applied to a laboratory-scale pulverized coal burner of the open type, and the spatial relationship of the pulverized coal particle zone and the combustion reaction zone is examined by simultaneous measurement of Mie scattering and OH-LIF images. It is found that this technique can be used to investigate the spatial relationship of the combustion reaction zone and pulverized-coal particles in turbulent pulverized-coal flames without disturbing the combustion reaction field. In the upstream region, the combustion reaction occurs only in the periphery of the clusters where high-temperature burned gas of the methane pilot flame is entrained and oxygen supply is sufficient. In the downstream region, however, combustion reaction can be seen also within clusters of pulverized-coal particles, since the temperature of pulverized-coal particles rises, and the mixing with emitted volatile matter and ambient air is promoted.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2012년도 제45회 KOSCO SYMPOSIUM 초록집
• /
• pp.15-16
• /
• 2012

The present study aims to investigate quantitatively the hydrodynamic effect on combustion process of pulverized coal particles in large scale combustion chamber using computational analysis, with a general purpose computational fluid dynamics code. Burner hydrodynamics include swirl and turbulence intensity from the burner. To understand the phenomena which are difficult to observe how flow has influence on the combustion process, comparative effect of combustion related coal properties and hydrodynamics is evaluated on flame formation and development in burner flames.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2001년도 제23회 KOSCO SYMPOSIUM 논문집
• /
• pp.153-160
• /
• 2001

The combustion test used DTF was performed to obtain the characteristics of NOx emission and reduction. In this test, major factor of NOx emission was a stoichiometric air ratio. At the onset of combustion to be rich oxygen, NOx was produced rapidly. Optimum condition for NOx reduction was formed under about AR:0.7 in the combustion test of Alaska coal. Investigations were undertaken with 200KW(th) test combustor. In combustion test, the major variables were coal feed ratio of center/outer, stoichiometric air ratio at the onset of combustion. The lowest NOx emission, 182ppm(6% O2 base), was achieved at about AR:0.6 of the first combustion stage with low NOx burner. Also, unburned carbon content of char collected in this combustion condition was about 1wt%.

• 한국연소학회지
• /
• 제11권2호
• /
• pp.1-6
• /
• 2006

This report presents a study of the development of an advanced coal nozzle used in burners to reduce unburned carbon (UBC) in a tangential coal-fired boiler. To understand the mechanism of UBC reduction, experiments using conventional burners were carried out to evaluate the effects of air injection velocity, coal fineness and over fired air (OFA) on combustion efficiency. It was confirmed that ignition of pulverized coal particles close to the burner is helpful toward the complete burn of residual carbon in fly ash. These efforts indicated the additional results that UBC was strongly dependent on the primary air velocity and coal fineness; especially that UBC dramatically decreased when the weight fraction of pulverized coal under $75{\mu}m$ was over 85 %. New coal nozzles, modified from conventional nozzles, were prepared and tested to improve the combustion efficiency. Some of these nozzles offered relatively lower unburned carbon than those of conventional burners and are referred to as HPFS (High Performance Flame Stability) coal nozzles.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2014년도 제49회 KOSCO SYMPOSIUM 초록집
• /
• pp.1-4
• /
• 2014

The present work focuses on the analysis of the pulverized coal combustion aerodynamics of the dual swirl burner by the control of the swirl-modes such as the outer swirl intensity (OSI). The detailed structure of pulverized coal swirling flames with swirl-mode was studied experimentally by particle image velocimetry and local flame colors based on $OH^*$, $CH^*$, and ${C_2}^*$ radicals. For all co-swirling conditions, the internal recirculation zone (IRZ) was observed near the inner shear layer with respect to the processing vortex core structure. Furthermore, a co-rotating vortex in the outer shear layer and the exhaust tube vortex (ETV) along the central axis were observed. The intensity of $CH^*$ signal was higher with small coal particle size, conversely, the size of the distribution of the $CH^*$ signal becomes larger. Therefore, the control of the aerodynamics with changing swirl intensities may play an important role in improving both environmental and combustion performances.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 1998년도 제17회 KOSCI SYMPOSIUM 논문집
• /
• pp.79-84
• /
• 1998

In this paper we show design and operation of 1MWth pulverized coal combustion test facility. The test facility is consists of coal feeding system, furnace and flue gas treatment system. The furnace is equipped with a top-fired burner in order to avoid influence of gravity on the coal particles. There are two part of vertical(VP) and horizontal pass(HP) at furnace. We can measure temperature and species of coal flames in vertical pass. Also, there is horizontally arranged section where investigation regarding corrosion and deposit formation will be carried out. The burner of combustor was externally air staging burner(EASB) type made by IFRF. The pulverized high bituminous(Blair athol) coal from Australia was used as fuel, and the particle size less than 80 ${\mu}m$ was 83.4%. Overall excess air ratio was 1.2.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 1997년도 제15회 KOSCO SYMPOSIUM 논문집
• /
• pp.103-112
• /
• 1997

In the combustion of the pulverized coal compared with that of liquid fuel or gaseous fuel, serious pollutants such as ash, $NO_x$ and $SO_x$ are released to surroundings. The objective of this study is the reduction of such pollutants in the combustion process. The modeling of cyclone combustor which uses the method of two stage combustion was carried out. The main burner length, scattering angle and air/fuel ratio were considered as parameters. The results show that the shorter the main burner length is, the less the amounts of coals which exit the combustor directly are, but the scattered input of coal is required anyway in order to collect all ashes. It is recommended that the shorter the main burner length is, the less the scattering angle is. And in the case of the scattered input compared with no scattering, the temperature in the combustor is more uniform and the amount of volatile is more reduced.

• 대한환경공학회지
• /
• 제32권12호
• /
• pp.1111-1118
• /
• 2010

비접촉법으로 유동장이나 온도, 화학종 농도의 계측이 가능한 레이저 응용 계측기술은 연소 메카니즘의 해명뿐만 아니라 수치해석 결과의 정당성을 입증하는 수단으로 최근 주목받고 있다. 본 연구에서는 레이저 도플러 유속계와 쉐도우 도플러 입자 분석계를 이용하여 난류 미분탄 화염 내 입자거동에 대하여 관찰하였다. 버너는 여러 광학계측을 용이하게 하기 위하여 대기개방형으로 하였으며, 실험실 규모의 안정된 난류 미분탄화염이 형성 가능한 소형 모델버너를 제작 하였다. 그 결과 미분탄 입자의 평균입경은 연소과정이 진행함에 따라 증가하는 경향을 나타내었다. 이러한 원인은 다수의 소입경의 미분탄 입자가 휘발분을 방출하여 연소반응에 의해 소실되기 때문이다. 또한 화염 중심부에서 미분탄 입자의 속도장은 입경의 크기에 크게 의존하지 않지만, 화염 외주부에서의 미분탄 입자의 속도장은 입경에 크게 의존하고 있음을 알 수 있다.