• 한국환경과학회지
• /
• 제16권4호
• /
• pp.449-458
• /
• 2007

Research results for the pressure drop variance depending on operation conditions such as change of inlet concentration, pulse interval, and face velocity, etc., in a pulse air jet-type bag filter show that while at $3kg/cm^2$ whose pulse pressure is low, it is good to make an pulse interval longer in order to form the first layer, it may not be applicable to industry because of a rapid increase in pressure. In addition, the change of inlet concentration contributes more to the increase of pressure drop than the pulse interval does. In order to reduce operation costs by minimizing filter drag of a filter bag at pulse pressure $5kg/cm^2$, the dust concentration should be minimized, and when the inlet dust loading is a lower concentration, the pulse interval in the operation should be less than 70 sec, but when inlet dust loading is a higher concentration, the pulse interval should be below 30 sec. In particular, in the case that inlet dust loading is a higher concentration, a high-pressure distribution is observed regardless of pulse pressure. This is because dust is accumulated continuously in the filter bag and makes it thicker as filtration time increases, and thus the pulse interval should be set to below 30 sec. If the equipment is operated at 1m/min of face velocity, while pressure drop is low, the bag filter becomes larger and thus, its economics are very low due to a large initial investment. Therefore, a face velocity of around 1.5 m/min is considered to be the optimal operation condition. At 1.5 m/min considered to be the most economical face velocity, if the pulse interval increases, since the amount of variation in filter drag is large, depending on the amount of inlet dust loading, the operation may be possible at a lower concentration when the pulse interval is 70 sec. However, for a higher concentration, either face velocity or pulse interval should be reduced.

• 한국환경과학회지
• /
• 제23권12호
• /
• pp.2045-2056
• /
• 2014

In this study, pressure drop was measured in the pulse jet bag filter without venturi on which 16 numbers of filter bags (Ø$140{\times}850{\ell}$) are installed according to operation condition(filtration velocity, inlet dust concentration, pulse pressure, and pulse interval) using coke dust from steel mill. The obtained 180 pressure drop test data were used to predict pressure drop with multiple regression model so that pressure drop data can be used for effective operation condition and as basic data for economical design. The prediction results showed that when filtration velocity was increased by 1%, pressure drop was increased by 2.2% which indicated that filtration velocity among operation condition was attributed on the pressure drop the most. Pressure was dropped by 1.53% when pulse pressure was increased by 1% which also confirmed that pulse pressure was the major factor affecting on the pressure drop next to filtration velocity. Meanwhile, pressure drops were found increased by 0.3% and 0.37%, respectively when inlet dust concentration and pulse interval were increased by 1% implying that the effects of inlet dust concentration and pulse interval were less as compared with those changes of filtration velocity and pulse pressure. Therefore, the larger effect on the pressure drop the pulse jet bag filter was found in the order of filtration velocity($V_f$), pulse pressure($P_p$), inlet dust concentration($C_i$), pulse interval($P_i$). Also, the prediction result of filtration velocity, inlet dust concentration, pulse pressure, and pulse interval which showed the largest effect on the pressure drop indicated that stable operation can be executed with filtration velocity less than 1.5 m/min and inlet dust concentration less than $4g/m^3$. However, it was regarded that pulse pressure and pulse interval need to be adjusted when inlet dust concentration is higher than $4g/m^3$. When filtration velocity and pulse pressure were examined, operation was possible regardless of changes in pulse pressure if filtration velocity was at 1.5 m/min. If filtration velocity was increased to 2 m/min. operation would be possible only when pulse pressure was set at higher than $5.8kgf/cm^2$. Also, the prediction result of pressure drop with filtration velocity and pulse interval showed that operation with pulse interval less than 50 sec. should be carried out under filtration velocity at 1.5 m/min. While, pulse interval should be set at lower than 11 sec. if filtration velocity was set at 2 m/min. Under the conditions of filtration velocity lower than 1 m/min and high pulse pressure higher than $7kgf/cm^2$, though pressure drop would be less, in this case, economic feasibility would be low due to increased in installation and operation cost since scale of dust collection equipment becomes larger and life of filtration bag becomes shortened due to high pulse pressure.

• 한국음향학회지
• /
• 제37권3호
• /
• pp.139-146
• /
• 2018

단상태 소나는 음원의 송신시간과 반사파의 수신시간 정보를 이용하여 표적의 위치를 산출한다. 그러나 음원의 송신시간 정보를 수신센서와 공유하지 않는 비동기 양상태 소나 시스템에서는 표적의 위치를 산출하기 위해 수신센서에서 음원의 직접파(direct blast)를 탐지해야한다. 본 논문에서는 직접파에 대한 PRI(Pulse Repetition Interval)와 적응적인 임계치 추정을 통해 직접파 탐지를 수행하는 기법을 제안한다. 모의 신호 및 해상 실험 데이터를 이용하여 제안하는 기법의 성능을 분석하였고 그 결과 강한 배경소음 및 직접파와 유사한 다수의 표적 반사파가 존재하는 환경에서도 강인한 직접파 탐지 성능을 보여주었다.

• 한국환경과학회지
• /
• 제13권3호
• /
• pp.223-232
• /
• 2004

The change of pressure drop according to the change in the inlet concentration, pulse interval, and injection distance of pulse air jet type bag filters, and the effect of venturi installation are as follows. The pressure drop with the range of 30 to $50mmH_2O$ varies according to the injection distance with 30, 50, 70, 90sec and the inlet concentration of venture built-in fabric filters. For the lower concentration of 0.5g/㎥ and 1g/㎥, the pressure $drop(\DeltaP)$ was stable 60 to 90minutes after operation. For the higher concentration of 3g/㎥, as $\DeltaP$ continues to go up, pulse interval should be set shorter than 30 seconds. The pressure drop with the injection distance of 1l0mm, when inlet dust concentration is 0.5g/㎥ or 1g/㎥, is 1.3 to 2 lower than with the injection distance of 50, 160, and 220mm, which means that the inflow amount of the secondary air by the instant acceleration is large. The injection distance of 2g/㎥ and 3g/㎥ has the similar pressure distribution. The higher inlet concentration is, the more important pulse interval is than injection distance. The pressure drop has proved to be larger when inlet concentration is lower and injection distance closer, on condition that the venturi is installed. The change in the pressure drop was smallest when injection distance was 50mm, followed by 220mm, 160mm, and 110mm.

• 전자공학회논문지
• /
• 제53권7호
• /
• pp.85-91
• /
• 2016

레이더 시스템은 방사 신호의 탐지를 회피하기 위해 펄스 반복주기(PRI, Pulse Repetition Interval)와 PRI 패턴을 변조하고 있으며, 반대로 레이더 신호 탐지 시스템은 다양한 노력을 기울여 PRI와 PRI 패턴을 감지하려고 한다. 일반적으로 레이더 신호의 PRI 패턴을 검출하기 위해 펄스열의 도착시각에 대한 히스토그램 또는 자기 상관관계 기법으로 펄스 변조를 검출하고 있다. 본 논문에서는 유한 상태 머신 개념을 도입하여 펄스 반복주기를 검출하는 알고리즘을 제안한다. 이 알고리즘은 PRI 순서와 PRI 패턴을 찾을 수 있는 특징이 있다.

• 한국통신학회논문지
• /
• 제28권12C호
• /
• pp.1192-1199
• /
• 2003

본 논문에서는 다중경로 채널 환경에서 펄스 반복 빈도 (pulse repetition frequency, PRF)와 슬롯 시간이 UWB (ultra wide band) 무선 통신 시스템의 데이터 전송율 (throughput) 성능에 미치는 영향을 조사하고 이를 기반하여 유효 데이터 전송율이 최대화되도록 하는 PRF와 슬롯 시간을 이용한 전송율 제어를 제안한다. 최근에 UWB 시스템이 갖고 있는 장점으로 인하여 근거리 고속 무선 데이터 전송과 관련하여 관심이 고조되고 있다. UWB 시스템에서는 데이터 전송율을 결정짓는 파라미터로는 펄스를 반복하는 펄스 반복 회수와 펄스간의 간격을 결정짓는 슬롯 시간을 들 수 있다. AWGN이 존재하는 다중경로 채널 하에 있는 UWB 시스템은 펄스간의 간섭(inter-pulse interference, IPI)과 잡음에 의하여 시스템 성능이 저하된다. UWB 시스템은 이 두 파라미터의 조정을 통하여 시스템의 성능을 유지 또는 개선할 수 있다. 본 논문에서는 두 파라미터의 변화가 다양한 채널 환경에서 데이터 전송율에 미치는 영향을 모의실험을 통하여 관측하고 이를 기반하여 설계된 가변 전송율을 사용하는 것이 비가변적인 방법에 비하여 유효 데이터 전송율 측면에서 우수함을 모의실험을 통하여 검증하였다.

• 한국산업보건학회지
• /
• 제18권3호
• /
• pp.189-203
• /
• 2008

Cylindrical bag filter system with pulse jet cleaning has been the most common device to control particle laden exhaust gas from the various industrial processes. But, it has many shortcomings due to particle reattachment and frequent bag rupture. In recent years, rectangular type bag filter system has been developed to overcome the problems associated with the cylindrical system. However, not many studies about the rectangular system were not done, compared to the cylindrical system. In this study, the optimum pulse jet cleaning conditions were thus tested by the series of experiments. The factors tested in this study are pulse distance, pulse pressure, pulse duration, the number of holes for pulsing and bag materials. A single bag ($1,500mmL{\times}50mmW{\times}300mmH$) system and a multi-bags (3 bags in a row) were tested separately. The highest removal efficiency with a single bag system was found at the conditions with pulse distance of 10cm, pulse pressure of $3kg/cm^2$, pulse duration of 0.3s, pulse jet number of 6 and Polyester bag. With the multi-bags system, the best cleaning conditions were found at the bag interval of 20cm with the simultaneous pulsing and the bag interval of 15cm with the serial pulsing.

• 전력전자학회논문지
• /
• 제17권3호
• /
• pp.252-258
• /
• 2012

This paper studies the power line communication method with splitting of power transmission interval in the small DC power system using pulse width modulation. The method divides the entire interval for transmitting power and data into a power transmission interval where power is supplied to a load and a data transmission interval where power from the power supply to the load is disconnected. The circuit is designed for the implementation to separate the power line from the power supply and load. The results of tests show the feasibility of the proposed power line communication method.

• 한국환경과학회지
• /
• 제21권5호
• /
• pp.613-622
• /
• 2012

A pilot-scale pulse-jet bagfilter was designed, built and tested for the effects of four operating conditions (filtration velocity, inlet dust concentration, pulse pressure, and pulse interval time) on the total system pressure drop, using coke dust from a steel mill factory. Two models were used to predict the total pressure drop according to the operating conditions. These model parameters were estimated from the 180 experimental data points. The empirical model (EM) with filtration velocity, areal density, inlet dust concentration, pulse interval time and pulse pressure shows the best correlation coefficient (R=0.971) between experimental data and model predictions. The empirical model was used as it showed higher correlation coefficient (R=0.971) compared to that of the Multivariate linear regression(MLR) (R=0.961). The minimum pulse pressure predicted by empirical model (EM) was 5kg/$cm^2$.

• The Korean Journal of Physiology
• /
• 제24권2호
• /
• pp.377-388
• /
• 1990

Ca movements during the late plateau phase in rabbit atrium implicate Na-Ca exchange. In single atrial cells isolated from the rabbit the properties of the inward current of Na-Ca exchange were investigated using the whole cell voltage clamp technique. The inward currents were recorded during repolarization following brief 2 ms depolarizing pulse to +40 mV from a holding potential of -70 mV. Followings are the results obtained: 1) When stimulated every 30 sec, the inward currents were activated and reached peak values $6{\sim}12\;ms$ after the beginning of depolarizing pulse. The mean current amplitude was 342 pA/cell. 2) The current decayed spontaneously from the peak activation and the timecourse of the relaxation showed two different phases: fast and slow phase. 3) The recovery of the inward current was tested by paired pulse of various interval. The peak current recovered exponentialy with a time course similar to that of Ca current recovery. 4) Relaxation timecourse was also affected by pulse interval and time constant was reduced almost linearly according to the decrease of pulse interval between 30 sec and 1 sec. 5) The peak inward current was increased by long prepulse stimulation, Bay K, isoprenaline or c-AMP. 6) The relaxation time constant of the inward current was prolonged by Bay K or c-AMP, and shortened by isoprenaline. From the above results, it could be concluded that increase of the calcium current potentiates and prolongs intracellular calcium transients, while shortening of the timecourse by isoprenaline or short interval stimulations might be due to the facilitation of Ca uptake by SR.