• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.11 no.1
• /
• pp.1-9
• /
• 1999

For roughened annular pipes with diameter ratios of 0.26, 0.39, and 0.56 and with Reynolds numbers ranging 13,000 to 67,000, friction factor, autocorrelation coefficients, power spectral density functions, and integral length scales for each flow condition using X-type hot wire anemometry system are experimentally investigated. Distributions of these quantities show that the times which the streamwise autocorrelation coefficients become zero first increase with decreasing the radius ratios of concentric annuli and Reynolds numbers, however the power spectra density functions increase with increasing the radius ratios and Reynolds number.

• Journal of IKEEE
• /
• v.17 no.4
• /
• pp.559-563
• /
• 2013

This paper analytically proves the equivalence between two main oscillator phase noise theories, which are based on the ISF, and Floquet vector, respectively. For this purpose, this study obtains the power spectral density matrix from the ISF-based phase noise theory. As a result, one can prove that the power spectral density matrix obtained from the ISF-based phase noise theory is essentially equivalent to the power spectral density matrix presented by the Floquet vector-based phase noise theory, which manifests the equivalence of the two main theories. This study is intended to provide deeper insight into the relations between the two main theories.

• Wind and Structures
• /
• v.9 no.5
• /
• pp.387-396
• /
• 2006

This paper presents the wind characteristics of Typhoon Dujuan as measured at a 50 m guyed mast in Hong Kong. The basic wind speed, wind direction and turbulent intensity are studied at two measurement levels of the structure. The power spectral density of the typhoon is compared with the von Karman prediction, and the coherence between wind speeds at the two measurement levels is found to This paper presents the wind characteristics of Typhoon Dujuan as measured at a 50 m guyed mast in Hong Kong. The basic wind speed, wind direction and turbulent intensity are studied at two measurement levels of the structure. The power spectral density of the typhoon is compared with the von Karman prediction, and the coherence between wind speeds at the two measurement levels is found to compare with Davenport's prediction. The effect of typhoon Dujuan on the response of the structure will be discussed in a companion paper (Law, et al. 2006).with Davenport's prediction. The effect of typhoon Dujuan on the response of the structure will be discussed in a companion paper (Law, et al. 2006).

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.5
• /
• pp.917-922
• /
• 2009

This paper presents a technique to generate road surface profiles in a spatial domain using a power spectral density function. A single track power spectral density function is proposed to describe a road surface profile, which is also applicable for multi-track vehicle response analysis. The roads in lateral direction makes the relation between the coherence of the lateral tracks. The derived road surfaces are compared to ISO(International Organization for Standardization) standards. Generated road profiles are in good agreements with the target road PSD shape and measured coherence relation.

• ETRI Journal
• /
• v.33 no.2
• /
• pp.279-282
• /
• 2011

Coexistence analysis is extremely important in examining the possibility for spectrum sharing between orthogonal frequency-division multiplexing (OFDM)-based international mobile telecommunications (IMT)-Advanced and other wireless services. In this letter, a new closed form method is derived based on power spectral density analysis in order to analyze the coexistence of OFDM-based IMT-Advanced systems and broadcasting frequency modulation (FM) systems. The proposed method evaluates more exact interference power of IMT-Advanced systems in FM broadcasting systems than the advanced minimum coupling loss (A-MCL) method. Numerical results show that the interference power is 1.3 dB and 3 dB less than that obtained using the A-MCL method at cochannel and adjacent channel, respectively. This reduces the minimum separation distance between the two systems, which eventually saves spectrum resources.

• Journal of Biomedical Engineering Research
• /
• v.30 no.4
• /
• pp.327-332
• /
• 2009

In this paper, new index was developed to estimate the depth of anesthesia during general anesthesia using EEG. Analysis of the power spectral density(PSD) of EEG was used to develop new parameters because EEG signal tends to have slow wave during anesthesia. Classifier for index creator was developed by using SEF, BDR and BTR parameters, which are calculated by power spectral density. EEG data were obtained from 7 patients (ASA I, II) during general anesthesia with Sevoflurane. The anesthetic depth evaluation indexes ranged from 0 to 100. The average were $86.05{\pm}10.1$, $36.98{\pm}20.2$, $15.33{\pm}13.6$, $50.87{\pm}16.5$ and $87.72{\pm}11.7$ for the states of pre-operation, induction of anesthesia, operation, awaked and post-operation, respectively. The results show that while the depth of anesthesia was evaluated, more accurate information can be provided for anesthetician.

• Journal of the Korean earth science society
• /
• v.33 no.5
• /
• pp.395-400
• /
• 2012

One of the main problems concerning the shallow seismic survey is how to generate high frequency signals with large amplitudes using small seismic sources. If one could focus the seismic energy in the direction of the survey line, it will be much helpful in identifying the first break. In this research, we have used hammer as an impulsive source and compared the signal powers generated by different shapes of the hammer plates: circular, square, and rectangular. The experiment was conducted by calculating the power spectral density function to compare the frequency spectrum and signal power. In the direction perpendicular to the long side of the rectangular plate, the largest seismic energy with the highest frequency was achieved even with the same weights of hammer plates. Our conclusion is that it is more efficient to use a rectangular plate than a circular (or square) one when conducting a 2-D shallow seismic survey.

• Journal of Biomedical Engineering Research
• /
• v.6 no.1
• /
• pp.19-30
• /
• 1985

This paper describes the EMG signals in frequency domain using power spectral density, The changes in the moan frequency can represent the energy distribution which results from changing in load before and during fatigue. Most of EMG signal power spectrum is located between 10 and 200Hz. Shifts of the high-energy regions of the power spectra can be inferred from the changes in the mean frequency. If the load is increased without fatigue-ocurring, the high frequency regions have more energy than the low frequency regions. And if load is increased during fatigue, the low frequency regions have more energy than the high frequency regions.

• Journal of Electrical Engineering and Technology
• /
• v.9 no.4
• /
• pp.1343-1348
• /
• 2014

The low frequency noise in Silicon Nanowire Field Effect Transistors is analyzed by characterizing the gate electrode dependence on various geometrical parameters. It shows that gate electrodes have a strong impact in the flicker noise of Silicon Nanowire Field effect transistors. Optimization of gate electrode was done by comparing different performance metrics such a DIBL, SS, $I_{on}/I_{off}$ and fringing capacitance using TCAD simulations. Molybdenum based gate electrode showed significant improvement in terms of high drive current, Low DIBL and high $I_{on}/I_{off}$. The noise power sepctral density is reduced by characterizing the device at higher frequencies. Silicon Nanowire with Si3N4 spacer decreases the drain current spectral density which interms reduces the fringing fields there by decreasing the flicker noise.

• Wind and Structures
• /
• v.5 no.2_3_4
• /
• pp.209-226
• /
• 2002

When predicting unsteady flow and pressure fields around a structure in a turbulent boundary layer by Large Eddy Simulation (LES), velocity fluctuations of turbulence (inflow turbulence), which reproduce statistical characteristics of the turbulent boundary layer, must be given at the inflow boundary. However, research has just started on development of a method for generating inflow turbulence that satisfies the prescribed turbulence statistics, and many issues still remain to be resolved. In our previous study, we proposed a method for generating inflow turbulence and confirmed its applicability by LES of an isotropic turbulence. In this study, the generation method was applied to a turbulent boundary layer developed over a flat plate, and the reproducibility of turbulence statistics predicted by LES computation was examined. Statistical characteristics of a turbulent boundary layer developed over a flat plate were investigated by a wind tunnel test for modeling the cross-spectral density matrix for use as targets of inflow turbulence generation for LES computation. Furthermore, we investigated how the degree of correspondence of the cross-spectral density matrix of the generated inflow turbulence with the target cross-spectral density matrix estimated by the wind tunnel test influenced the LES results for the turbulent boundary layer. The results of this study confirmed that the reproduction of cross-spectra of the normal components of the inflow turbulence generation is very important in reproducing power spectra, spatial correlation and turbulence statistics of wind velocity in LES.