• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.41 no.11
• /
• pp.921-930
• /
• 2013

Satrec Initiative successfully developed and verified a high-resolution electro-optical camera system, EOS-D Ver.1.0. We designed this system to give improved spatial and radiometric resolution compared with EOS-C series systems. The thermal control subsystem (TCS) of the EOS-D Ver.1.0 uses heaters to meet the opto-mechanical requirements during in-orbit operation and uses different thermal coatings and multi-layer insulation (MLI) blankets to minimize the heater power consumption. Also, we designed and verified a refocusing mechanism to compensate the misalignment caused by moisture desorption from the metering structure. We verified the design margin and workmanship by conducting the qualification level thermal vacuum test. We also performed the verification of thermal math model (TMM) by comparing with thermal balance test results. As a result, we concluded that it faithfully represents the thermal characteristics of the EOS-D Ver.1.0.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.8 no.2
• /
• pp.195-204
• /
• 2004

A series of constant creep and repeated creep tests are performed to investigate the behavior of visco-elasto-plastic materials of chemical grouted sands. In the result of constant creep test, the material exhibits three types of shear strain : elastic, plastic, viscoelastic. The elastic, plastic and viscoelastic strains are linear, i.e., the strains are proportional to the stresses for loading. Good agreement is found between the predicted viscoelastic and test results by the power law and the generalized model. In the repeated creep test, the instantaneous recoverable strain is time-independent and the magnitude of accumulated plastic strain increases with number of cycles. Also it is seen that the accumulated plastic strains are approximately proportional to stress. There are no significant differences between test results predicted values for first cycle, and the differences increase relatively insignificantly with number of cycles.

• Journal of the Korean Geotechnical Society
• /
• v.17 no.6
• /
• pp.149-162
• /
• 2001

Longitudinal cracks have occurred on the crest of dams soon after their construction of two earth-rocfill dams located in Samlangjin. They are a pair of pumped storage dams constructed for generation of electrical power. The upper dam and lower dam are subjected to the variation of water level more than 10m once in a day alteratively. This paper deals with the finding of possible causes for longitudinal cracks about upper dam. The dominant cause was considered to be due to fluctuation of water load, for which numerical analysis was carried out using the hyperbolic model. In order to obtain parameters necessary to the analysis, a series of triaxial tests was performed for both core and rock material. Also dynamic triaxial test was performed to obtain dynamic properties of soils, which could be used as input data to simulate frequent variation of stress change due to the water fluctuation. It was known from the numerical analysis that the confining pressure of upper 4m from the top of the crest become negative after repeating of water load, meaning that tension cracks occurred in the top portion of the crest. The depth of longitudinal cracks has been investigated by digging test pit on the crest. This results agree with the field observation.

• Computational Structural Engineering
• /
• v.5 no.3
• /
• pp.119-126
• /
• 1992

Most civil engineering structures such as bridges, power plants, and offshore platforms are apt to suffer structural damages over their service lives caused by adverse loadings, such as earthquakes, wind and wave forces. Accumulation of structural damages over a long period of time might cause catastrophic structural failure. Therefore, a methodology for monitoring the structural integrity is essential for assuring the safety of the existing structures. A method for the damage assessment of structures by the second order inverse modal perturbation technique is presented in this paper. Perturbation equation consists of a matrix equation involving matrices of structural changes(stiffness and mass matrix changes) and matrices of modal property changes(natural frequency and mode shape changes). The damages of a structure are represented as changes in the stiffness matrix. In this study, a second order perturbation equation is formulated for the damage assessment of structures, and solved by an iterative procedure. The effectiveness of the proposed method has been investigated through a series of example analysis. The estimated results for the structural damage indicated that the present method yields resonable estimates for the structural changes.

• Research in Community and Public Health Nursing
• /
• v.13 no.2
• /
• pp.216-229
• /
• 2002

Objectives: This study was conducted to investigate the effects of a self growth program through MBTI on interpersonal relationships, and the career identity of nursing college students. Methods: A randomized controlled pre-post test experimental design was used for this study. The 24 nursing students were randomly assigned into two groups: 12 for the experimental group, and 12 for the control group. The subjects were junior nursing students, who were randomly selected from an undergraduate nursing program at K university located in Daegu, Korea. The data was collected from March 18 to April 1, 2002. The MBTI self growth program used in this study was based on the one developed by Shim and Kim (1997). The 12 experimental group students received the group self growth program through MBTI for 15 hours, while the 12 control group students received no treatment, except a series of tests. The Korean version MBTI test used in this study was developed and verified for reliability and validity by Kim and Sim (1990). Change in inter-personal relationships was measured using the Relationship Change Scale developed by Schlein and Guerney (1971), and modified by Lee and Mun (1982). Career identity was measured using the My Vocational Situation developed by Holland. Daiger and Power (1980), and revised by Kim (1997). The data were analyzed with the SPSS Win 10.0 program, through which the 2 test, t-test, and Repeated measures ANOVA were examined. Results: 1) The first hypothesis, 'the experimental group that received the self growth program through MBTI will obtain a higher interpersonal relationship score than the control group', was supported (F=5.295. p=.031. Interaction: p=.000). 2) The second hypothesis, 'the experimental group that received the self growth program through MBTI will obtain a higher career identity score than the control group', was supported (F=28.575, p=.000, Interaction: p=.000). Conclusion: The results showed that the ready planned self growth program through MBTI had positive effects on improving the interpersonal relationships, and the career identity of nursing college students.

• The KIPS Transactions:PartC
• /
• v.12C no.4 s.100
• /
• pp.535-542
• /
• 2005

This paper proposes an on-demand ad hoc routing protocol, Node Density Based Routing (NDBR), which enhances the routing performance applying a new method to establish alternate patlis. It is important to reserve alternate paths for the route from source to destination in mobile ad hoc networks that are susceptible to failure due to the movement or the power exhaustion of mobile nodes. NDBR aims to establish a route that contains more alternate paths toward the destination by involving intermediate nodes with relatively more adjacent nodes in a possible route, and introduces a new routing criterion called 'node density.' This approach can localize the effects of route failures, and reduce control traffic overhead and route reconfiguration time by enhancing the reachability to the destination node without source-initiated route re-discoveries at route failures. This paper describes the route setup procedure using node density and the route re-configuration procedures employing alternate path information at the intermediate nodes. We show the performance of our routing schemes through a series of simulations using the Network Simulator 2 (ns-2).

• International Journal of Highway Engineering
• /
• v.16 no.5
• /
• pp.59-66
• /
• 2014

PURPOSES : This study is to predict the Sound Pressure Level(SPL) obtained from the Noble Close ProXimity(NCPX) method by using the Extended Kalman Filter Algorithm employing the taylor series and Linear Regression Analysis based on the least square method. The objective of utilizing EKF Algorithm is to consider stochastically the effect of error because the Regression analysis is not the method for the statical approach. METHODS : For measuring the friction noise between the surface and vehicle's tire, NCPX method was used. With NCPX method, SPL can be obtained using the frequency analysis such as Discrete Fourier Transform(DFT), Fast Fourier Transform(FFT) and Constant Percentage Bandwidth(CPB) Analysis. In this research, CPB analysis was only conducted for deriving A-weighted SPL from the sound power level in terms of frequencies. EKF Algorithm and Regression analysis were performed for estimating the SPL regarding the vehicle velocities. RESULTS : The study has shown that the results related to the coefficient of determination and RMSE from EKF Algorithm have been improved by comparing to Regression analysis. CONCLUSIONS : The more the vehicle is fast, the more the SPL must be high. But in the results of EKF Algorithm, SPLs are irregular. The reason of that is the EKF algorithm can be reflected by the error covariance from the measurements.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.5 no.4
• /
• pp.318-328
• /
• 1993

A series of long wave measurements was made in the region of Shikotan Island (the South Kuril Islands) during 1990-1992: 7 bottom pressure stations were installed in 5 bays and inlets of Shikotan and 3 precise microbarographs were situated at the shore. The observations were taken in order to monitor tsunami waves, estimate resonance features of coastal topography, and investigate seiche generation mechanism. It was found that forced long waves dominate in the motions with periods exceeding 2 hours, freely propagating long waves prevail at periods of 30-120 min and eigen-oscillations of bays (seiches) are the predominant type of long waves at periods less than 30 min. The Helmholtz mode with period 30 min in Krabovaya Bay and 18.5 min in Malokurilskaya Bay is the most important type of wave motion in the inner Shikotan basins. There is a good correlation between passages of atmospheric disturbances and generation of seiches near the coast of Shikotan Island. In particular, jumps in atmospheric pressure excite seiches in different bays simultaneously, in each one with the corresponding dominant period. The atmospheric spectra were remarkably smooth and stable, and could be described by a $\omega$$^{-2}$26/ power law.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.22 no.1
• /
• pp.148-156
• /
• 2014

The objective of this study is to compare NOx emissions from light duty diesel vehicles measured from on-road tests that conducted under various driving routes and seasonal conditions. We measured real-driving NOx emissions using PEMS, portable emissions measurement system, under the urban, rural and motorway road traffic conditions. On-road tests were repeated at summer, fall and winter season. The accumulated driving distance is more than 1,200 km per each vehicle. Route average NOx emission factors were compared among nine route-season combinations. The emission characteristics of each combinations were investigated using time series mass emission rates and vehicle operation-based emission rates and activities, which is based on U.S. EPA's MOVES model. Most concerned route-season combination is "urban road condition at summer", which shows two to eleven times higher NOx emissions than other combinations. The emission rates and activities under low speed operating conditions should be managed in order to reduce urban-summer NOx. From a NOx control strategy perspective, the exhaust gas recirculation, EGR, is observed to be properly operated under wide range of vehicle driving conditions in Euro-5 vehicles, even if the air conditioner turns on. In high power demanding conditions, the effect of overspeeding could be more critical than that of air conditioner activation.

• Transactions of the Korean Society of Pressure Vessels and Piping
• /
• v.16 no.1
• /
• pp.110-116
• /
• 2020

As the management plan for domestic spent nuclear fuel is delayed, the storage of the operating nuclear power plant is approaching saturation, and the Kori 1 Unit that has reached its end of operation life is preparing for the dismantling plan. The first stage of dismantling is the transfer of spent nuclear fuel stored in storage at plants. The spent fuel management process leads to temporary storage, interim storage, reprocessing and permanent disposal. In this paper, the technical issues to be considered when transporting spent fuel in this process are summarized. The spent fuels are treated as high-level radioactive waste and strictly managed according to international regulations. A series of integrity tests are performed to demonstrate that spent fuel can be safely stored for decades in a dry environment before being transferred to an intermediate storage facility. The safety of spent fuel transport container must be demonstrated under normal transport conditions and virtual accident conditions. IAEA international standards are commonly applied to the design of transport containers, licensing regulations and transport regulations worldwide. In addition, each country operates a physical protection system to reduce and respond to the threat of radioactive terrorism.