• 전기학회논문지
• /
• 제58권10호
• /
• pp.2064-2070
• /
• 2009

According to recent researches, apparent power in a non-sinusoidal single phase system can be represented with geometric algebra. In this paper, the geometric algebra is applied to apparent power defined in a multi-line system having transmission lines with frequency-dependency under non-sinusoidal conditions.

• 한국전자파학회논문지
• /
• 제13권9호
• /
• pp.924-931
• /
• 2002

본 논문에서, 기존의 λ/4 전원 전송선로의 접지면에 아령 모양의 DGS(Defected Ground Structure)를 추가한 새로운 형태의 λ/4 전원 전송선로를 제안하였다. DGS A/4 전원 전송선로는 높은 특성 임피던스 값을 유지하면서, 기존의 전원 선로보다 폭은 더 넓어지고 길이는 더 짧아졌다. 제안된 전원 선로가 신호 전송선로에 부착되면, 2차 고조파 성분뿐만 아니라 3차 고조파 성분 역시 감쇄시킬 수 있다. 증폭기에서 고조파 감쇄 특성을 갖는다면, 효율과 선형성이 개선되어진다. 제안된 전원 선로는 IMT-2000 기지국 송신 대역 전력 증폭기에 적용하였다. 본 논문에서는 제안된 새로운 DGS 구조 λ/4 전원 선로를 이용한 전력 증폭기의 검증을 위해, DGS 시뮬레이션과 실험 결과들을 제시하였다. 실험 결과, 기존의 구조에 비해 3차 고조파 성분은 26.5 dB 감쇄되었고, 효율은 약 9.1% 정도 향상되었으며, 3차 혼변조 왜곡 특성은 4.5 dB 개선되었다.

• Journal of Electrical Engineering and Technology
• /
• 제8권6호
• /
• pp.1305-1309
• /
• 2013

The application of the superconducting fault current limiter (SFCL) in a power distribution system is expected to contribute the voltage-sag suppression of the bus line as well as the fault-current reduction of the fault line. However, the application effects of the SFCL on the voltage sag of the bus line including the fault current are dependent on its application location in a power distribution system. In this paper, we investigated the fault current limiting and the voltage sag suppressing characteristics of the SFCL due to its application location such as the outgoing point of the feeder, the bus line, the neutral line and the 2nd side of the main transformer in a power distribution system, and analyzed the trace variations of the bus-voltage and fault-feeder current. The simulated power distribution system, which was composed of the universal power source, two transformers with the parallel connection and the impedance load banks connected with the 2nd side of the transformer through the power transmission lines, was constructed and the short-circuit tests for the constructed system were carried out. Through the analysis on the short-circuit tests for the simulated power distribution system with the SFCLs applied into its representative locations, the effects from the SFCL's application on the power distribution system were discussed from the viewpoints of both the suppression of the bus-voltage sag and the reduction of the fault current.

• 전기학회논문지
• /
• 제63권10호
• /
• pp.1364-1370
• /
• 2014

Power system fault analysis has been based on symmetrical component method, which describes power system elements by positive, negative and zero sequence impedance. Obtaining accurate line impedances as possible are very important for estimating fault current magnitude and setting distance relay accurately. Especially, accurate calculation of zero sequence impedance is important because most of transmission line faults are line-to-ground faults, not balanced three-phase fault. Since KEPCO has started measuring of transmission line impedance at 2005, it has been revealed that the measured and calculated line impedances are well agreed within reasonable accuracy. In case of underground transmission lines, however, large discrepancies in zero sequence impedance were observed occasionally. Since zero sequence impedance is an important input data for distance relay to locate faulted point correctly, it is urgently required to analyze, detect and consider countermeasures to the source of these discrepancies. In this paper, development of pre/post processor to ATP (Alternative Transient Program) version of EMTP (Electro-Magnetic Transient Program) for sequence impedance calculation was described. With the developed processor ATP-cable, effects of ground resistance and ECC (Earth Continuity Conductor) on sequence impedance were analyzed.

• 한국산학기술학회논문지
• /
• 제19권11호
• /
• pp.224-229
• /
• 2018

우리나라는 급격한 경제발전으로 전력소비량이 크게 증가하고 있으며, 원활한 전력의 공급을 위해 많은 송전탑 및 송전선이 설치되고 있다. 고압 송전선은 주로 알루미늄 연선으로 제작되며, 전선을 느슨하게 가선하여 약간의 처짐이 유지되도록 하고 있다. 처짐의 정도는 공사의 품질과 전선의 수명에 많은 영향을 끼치게 되는데 시간이 지날수록 전선의 무게나 주변 환경적 요인으로 수축과 팽창이 반복적으로 일어나므로 송전선의 관리를 위해 주기적인 모니터링이 필수적이다. 본 연구에서는 3D 레이저 스캐닝 기술을 활용하여 송전선에 대한 모니터링을 수행하였다. 연구대상지의 송전선에 대한 데이터를 취득하고, 자료처리를 통해 송전선에 대한 포인트클라우드 형태의 3차원 공간정보를 추출하였다. 송전선에 대한 3차원 공간정보를 활용하여 송전선의 길이와 처짐량을 산출하였으며, 주변 장애물들과의 이격거리를 효과적으로 산출할 수 있었다. 연구를 통해 송전선 관리를 위한 3D 레이저 스캐닝 기술의 활용성을 제시할 수 있었으며, 향후 추가적인 연구를 통해 3D 레이저 스캐닝 기술이 적용된 송전선 모니터링 방안이 개발된다면 송전선 관리의 효율성 증대에 크게 기여할 것이다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 춘계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.488-490
• /
• 2001

A dispered power system means a little bit of small power generation equipment located near the power-damend areas. Due to no power supply line, such a power source is very favorable for the decrease in loss of electric power supply, in comparison to the giantly focused power source, Because of small power source, this power source also corresponds promptly to the variation of power demend. On the basis of energy saving, environmental reservation, and utilization of natural or unused energy, solar power plants can be introduced into the residence section of cities and small water or wind-power plants near the urban areas. In case of Korea, some wind farm have been introduced into Cheju island, Condensed introduction of several small power sources into an used distribution line may, however, result in a big problem, it is, therefore, necessary that protective-cooporative plans between power quality and distribution line should be introduced for efficient utilization of KEPCO distribution system.

• ETRI Journal
• /
• 제35권3호
• /
• pp.554-557
• /
• 2013

This letter presents a power amplifier (PA) with an on-chip power detector for 2.4-GHz wireless local area network application. The power detector consists of a clamp circuit, a diode detector, and a coupled line directional coupler. A series inductor for an output matching network in the PA is combined with a through line of the coupler, which reduces the coupling level. Therefore, the coupler employs a metamaterial-based transformer configuration to increase coupling. The amount of coupling is increased by 2.5 dB in the 1:1 symmetric transformer structure and by 4.5 dB from two metamaterial units along the coupled line.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 C
• /
• pp.1158-1160
• /
• 1999

This paper proposes a SSSC(Static Synchronous Series Compensator) power flow model to be incorporated into power flow calculation for the steady state analysis of the power system. SSSC provides controllable compensating voltage, which is in quadrature with the line current, over an capacitive and an inductive range, independently of the magnitude of the line current. This SSSC model is obtained from the injection model for series connected VSC(Voltage Source Converter) by adding a constraint that the injected voltage should be in quadrature with the line current. In this paper the static model is implemented into the continuation power-flow (CPF) program. It is shown that SSSC has its intrinsic superiority over TCSC in controllable power flow range.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2008년도 제39회 하계학술대회
• /
• pp.1947-1948
• /
• 2008

This paper presents the implementation of Power Line Communication(PLC) module which can reduce standby-power consumption. The suggested PLC module consists of PLC modem, coupling circuit, ZCP(Zero-Cross Point) Circuit and main SMPS control relay. The test results under power line communication test-bed used home appliance show the 77% saving of standby-power.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 추계학술대회 논문집 전력기술부문
• /
• pp.47-49
• /
• 2002

Recently, the power system has a trend of a sustaining growth in electric power demand with large-sized formation. In this situation, current states can be definitely comprehended to operate security and economic power system. Also, corrective actions must be performed for the violation of bus voltage and line overload. In the security and economy with on-line, It is desirable that the situations of violation are promptly removed to operate power system effectively. This paper deals with the development of application, Kangyang Steel Works' Power System Guidance System, for voltage and overload correction on base case using Generator-Voltage Sensitivity List(GVSL) and Generator Shifter Factor List(GSFL). Also, to show the superiority and economical efficiency of the proposed application, we simulate the Kangyang Steel Works' Power System.