• 한국항행학회논문지
• /
• 제12권6호
• /
• pp.646-652
• /
• 2008

오늘날, 선박은 스마트 선박 또는 디지털 선박으로 발전되고 있다. 전력선 통신은 기존의 전력선을 이용하는 통신 시스템으로, 전력선 통신을 장비와 모니터링 전송 수단으로 사용하는 것은 선박에서의 시스템 설계에 있어서 효율적인 방법이다. 본 논문에서는 선박에서의 PLC기반 RFID모니터링 시스템을 구현하였다. 제안된 시스템은 선박에서의 RFID Tag Data를 통하여 승객, 선원 그리고 중요한 화물의 움직임을 모니터링 할 수 있다.

• 드라이브 ㆍ 컨트롤
• /
• 제14권2호
• /
• pp.1-8
• /
• 2017

The spool displacement of a directional control valve can be considered as the standard signal for the measurement of its bandwidth frequency. When the spool displacement is not available, the metering-orifice system is suggested in this study as an alternative way to measure the - 3 dB amplitude-ratio bandwidth frequency of the hydraulic directional-control valve. The amplitude ratio of the metering-orifice pressure can be adjusted to equal that of the spool displacement through the controlling of the metering-orifice opening area. A series of experiments were conducted to verify the effectiveness of the metering-orifice system. The metering orifice was confirmed as adequate for the measurement of the - 3 dB amplitude-ratio bandwidth frequency.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 하계학술대회 논문집 C
• /
• pp.1674-1676
• /
• 2002

In this paper, High Frequency PD measuring system using directional coupler sensors(DCS) is introduced. Especially the principles of the DCS and characteristics of the system are introduced. Evaluation of this system was carried by an adoption to the test circuit of 345kV XLPE $2000mm^2$ cable and EB-A, EB-G, PIJ, PNJ. In the test a PD measurement was carried out without shieldroom and under the on-line state and in the high frequency range at the remote site from the test object. The test result was satisfactory and this is due to the use of DCS and using a high frequency range and specific filter for radio and TV signal and low pass. This system can be used to the test of a new construction of cable and accessories and measuring of long-term deterioration of cable and accessories. And this will bring us the reliability of a power transmission.

• 한국전자파학회논문지
• /
• 제15권6호
• /
• pp.573-578
• /
• 2004

전기 기폭장치(EED, electroexplosive device)는 브리지 와이어, 추진제, 리드 핀 및 금속관으로 구성되었고, 기폭신호가 인가되면 브리지와이어의 발열에 의해 추진제를 점화시킨다. 또한 고출력 통신기나 레이더에서 방사되는 전자파에 의해 EED는 예기치 않은 기폭이 발생할 수 있어, EED에 대한 EMC 설계 및 시험관련 군사규격서를 제정하여 적용하고 있다. 본 논문은 항공기에 대한 전기체 EMC 시험평가를 수행할 때, 항공기에 설치 된 EED 대신에 사용할 기폭용 퓨즈의 RF 감도 특성을 기술하였다 RF 기폭수준은 전송선로 이론을 활용하여 예측하였고, 군사규격서에 규정된 DC 감도와 RE 감도를 측정하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 E
• /
• pp.2268-2270
• /
• 1999

The underground transmission line have been consistently developed to increase its voltage level for satisfying the customer's demand through supplying the high reliability power. The underground XLPE cable and its accessories of 500kV level have been already developed internationally, but the XLPE cable have been installed 154kV level in Korea up to now. Thus, our company has developed 230kV XLPE cable and its accessory in 1998 for preparing 345kV level system in Korea and being qualified as international cable maker of developing oversea markets. In this paper, newly our developed 230kV system will be introduced using the type test result according to IEC 840 and additional specification.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2008년도 하계학술대회 논문집 Vol.9
• /
• pp.292-292
• /
• 2008

The superconducting fault current limiter(SFCL) can be used to limit fault current level in electrical transmission line and power system. Up to now, there are several kinds of SFCL that have proposed and it is expects that they will be applied to appropriated position considering their own properties; initial fault current limiting instant and the current limiting characteristics. In this paper, we investigated the initial fault current limiting instant and the amplitude of initial fault current in the resistive type, the flux-lock type, the flux-coupling type and the transformer type SFCL. Experiment results show that the initial fault current limiting instant and the amplitude of initial fault current of the SFCLs are dependant on the ratio of inductance of primary and secondary coils.

• 대한전기학회논문지
• /
• 제43권7호
• /
• pp.1206-1213
• /
• 1994

This paper presents the operation principle and design rule of the Rogowski coil which can measure the transient current and describes the calibration and application experimental results for performance evaluation. It is obtained that the response curves of the Robowski coil with the turns of 300 and the passive integrator to sinusoidal input give a good linearity up to the frequency of 500 [kHz] and the current measurement system gaving the Rogowski coil is the frequency bandwidth of 40 [Hz]~700 [kHz]. As an application experiment for the fabricated modeling power transmission line, the impulse current, which limitates the direct lightning return stroke to overhead ground wire, is measured by the Rogowski coil and its fast Fourier transformation is carried out. The equivalent circuit of the Rogowski coil considering the stray capacitances is proposed, and the theoretical analysis is in good agreement with the measurement results. Also, it is found that for high frequency domain the stray capacitance such as a distributed capacitance to the shield and the capacitance between windings of coil should be considered in designing the Rogowski coils since the resonance originates from the stray capacitance and the self-inductance of the Rogowski coil.

• ETRI Journal
• /
• 제39권5호
• /
• pp.746-755
• /
• 2017

In this paper, an electrostatic discharge (ESD) protection circuit is designed for use as a 12 V power clamp by using a parasitic-diode-triggered silicon controlled rectifier. The breakdown voltage and trigger voltage ($V_t$) of the proposed ESD protection circuit are improved by varying the length between the n-well and the p-well, and by adding $n^+/p^+$ floating regions. Moreover, the holding voltage ($V_h$) is improved by using segmented technology. The proposed circuit was fabricated using a $0.18-{\mu}m$ bipolar-CMOS-DMOS process with a width of $100{\mu}m$. The electrical characteristics and robustness of the proposed ESD circuit were analyzed using transmission line pulse measurements and an ESD pulse generator. The electrical characteristics of the proposed circuit were also analyzed at high temperature (300 K to 500 K) to verify thermal performance. After optimization, the $V_t$ of the proposed circuit increased from 14 V to 27.8 V, and $V_h$ increased from 5.3 V to 13.6 V. The proposed circuit exhibited good robustness characteristics, enduring human-body-model surges at 7.4 kV and machine-model surges at 450 V.

• 대한기계학회논문집
• /
• 제13권4호
• /
• pp.697-702
• /
• 1989

본 연구에서는 도체의 접속 금구류의 도전 열특성을 규명하기 위한 연구의 일환으로 접속 금구류 중 접속 슬리브커넥터의 적절한 허용 전류, 통전시에 발생하는 승온 특성 및 전기 저항 특성 등을 실험적으로 구하고 접속 금구류의 설계에 필요한 도전 열특성을 실험적으로 규명하는 것을 목적으로 한다.

• 대한전기학회논문지:전력기술부문A
• /
• 제55권5호
• /
• pp.202-213
• /
• 2006

This paper presents a new approach for optimal dispatch of energy and frequency regulation reserve considering contingency in a competitive electricity market. It is necessary to introduce the reserve market with the spot energy market for operating efficiently and obtaining the security of the electricity market. However, the reserve market is closely connected with the energy market since the energy and reserve are produced from the same resources. Thus, it is inevitable to co-optimize the energy and ancillary service for efficient operation of energy and ancillary service market. Therefore, this paper proposes a new method for optimal dispatch of energy and frequency regulation reserve considering n-1 contingency of generator and transmission line using constraints and sensitivity based on AC power flow To verify the effectiveness of the proposed method, the numerical studies have been performed for 5-bus sample system and modified IEEE 14-bus system.