• International Area Studies Review
• /
• v.21 no.1
• /
• pp.281-301
• /
• 2017

This article examines the way of the functionality of policy instruments for the development of renewable energy through the case of the wind power. The general barrier of the renewable energy development is considered to be the economic barrier. However the principal issue is the political barrier without the broad cooperation between the host government and the firm. Maintaining the long-term competitive advantage requires the shift of not only the strategy following the external circumstance but also the internal capacity development to utilize resources. Thus the comparative case study of Sri Lanka and Germany proposes the analysis of the supply-push and demand-pull policy with five patterns on the development of wind power in order to suggest how the functionality of policy instruments must be served to foster the wind power.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.19 no.1
• /
• pp.61-74
• /
• 2021

A paradigm shift in the government's energy policy was reflected in its declaration of early closure of old nuclear plants as well as cancellation of plans for the construction of new plants. To this end, unit 1 of Kori Nuclear Power Plant was permanently shut down and is set for decommission. Based on these changes, the off-site transport of spent fuels from nuclear power plants has become a critical issue. The purpose of this study is to develop an optimized method for transportation of spent fuels from Kori Nuclear Power Plant's units 1, 2, 3, and 4 to an assumed interim storage facility by simulating the scenarios using the Flexsim software, which is widely used in logistics and manufacturing applications. The results of the simulation suggest that the optimized transport methods may contribute to the development of delivery schedule of spent fuels in the near future. Furthermore, these methods can be applied to decommissioning plan of nuclear power plants.

• Current Optics and Photonics
• /
• v.7 no.6
• /
• pp.708-713
• /
• 2023

A robust all-fiber nonlinear amplifying loop-mirror-based mode-locked femtosecond laser is demonstrated. Power-dependent nonlinear phase shift in a Sagnac loop enables stable and power-efficient mode-locking working as an artificial saturable absorber. The pump power is adjusted to achieve the lowest intensity noise for stable long-term operation. The minimum pump power for mode-locking is 180 mW, and the optimal pump power is 300 mW. The lowest integrated root-mean-square relative intensity noise of a free-running mode-locked laser is 0.009% [integration bandwidth: 1 Hz-10 MHz]. The long-term repetition-rate instability of a free-running mode-locked laser is 10^-7 over 1,000 s averaging time. The repetition-rate phase noise scaled at 10-GHz carrier is -122 dBc/Hz at 10 kHz Fourier frequency. The demonstrated method can be applied as a seed source in high-precision real-time mid-infrared molecular spectroscopy.

• Journal of Advanced Navigation Technology
• /
• v.28 no.2
• /
• pp.250-253
• /
• 2024

This paper proposes a low-power waveform for a long-range air-to-air data link. In the case of an air-to-air data link, data communication is performed in the air and high Doppler shift may occur depending on the flight speed, so a waveform based on the non-coherent method is suitable. In addition, since it is mounted on an aircraft, it must have low power characteristics. This paper proposes a waveform that combines a modulation technique based on frequency modulation and pulse position modulation that can turn on/off the transmission signal. As a result of the performance analysis, it was shown that the performance was suitable for air-to-air operation while showing low power characteristics.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.2
• /
• pp.769-780
• /
• 2018

This paper presents an analysis of the power gain under partial shading conditions (PSC) when the partial shade loss is being compensated in photovoltaic(PV) system. To analyze the power gain, our study divides the mismatch loss into partial shade loss and operating point loss. Partial shade loss is defined as the power difference between a normal string and a partially shaded string at the maximum power point (MPP). Operating point loss is defined as the power loss due to the operating point shift while following the MPP of the PV array. Partial shading in a PV system affects the maximum power point tracking (MPPT) control by creating multiple MPPs, which causes mismatch losses. Several MPPT algorithms have been suggested to solve the multiple MPP problems. Among these, mismatch compensation algorithms require additional power to compensate for the mismatch loss; however, these algorithms do not consider the gain or loss between the input power required for compensation and the increased output power obtained after compensation. This paper analyzes the power gain resulting from the partial shade loss compensation under PSC, using the V-P curve of the PV system, and verifies that power gain existence by simulation and experiment.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.21 no.3
• /
• pp.66-72
• /
• 1984

In this paper, the error rate performance of L-level amplitude shift keying (ASK), M-ary phase shift keying (PSK) and amplitude phase keying (APK) systems have been studied in the presence of interference and noise. Using the derived error probability equations, the error rate performance of each L-level ASK and M-ary PSK system has been evaluated in terms of carrier-to-noise power ratio (CNR), carrier-to-interferer power ratio (CIR), and envelope distribution of interferer. These results are combined and then the error rate performance of APK signal has been found. Finally, the error rate performance is compared and discussed.

• Journal of Biosystems Engineering
• /
• v.29 no.5 s.106
• /
• pp.395-406
• /
• 2004

Most of tractors in the world have manual gear transmission, and some of small tractors have hydrostatic trans-mission(HST). Since the HST is expensive and has low power efficiency, it is being used for only small garden tractors. The continuously variable transmission(CVT) is an alternative to the HST or power-shift gear transmissions. The driver of the CVT tractor doesn't have to operate a shift lever since the CVT controller automatically controls the speed of tractor. Thus, it is much easier to operate the CVT tractor. For the easy and stable control of the CVT tractor, an appropriate control algorithm should be developed and the dynamic modeling should be carried out before making the prototype of CVT controller. This study was conducted to develop a simulation model of the CVT control system needed to develop a PID control algorithm. The simulation model consisted of variator dynamics, hydraulic system and control computer. And the simulation model was verified by experiment. The results obtained in this study can be utilized in the design of CVT tractors for practical use, but a lot of field tests and improvement of softwares would be necessary.

• 한국HCI학회:학술대회논문집
• /
• 2009.02a
• /
• pp.542-546
• /
• 2009

This paper introduces a Mixed-Reality based Software technology in Smart-Phone Environment. The field of Mixed-Reality in mobile environment is relatively young. but Cause to develop Mobile infra and improvement of mobile device, open-platform mobile OS, the request extended This paper suggest the method for Marker Detection and Marker Tracking method. This method is the one of some kind of a base-technology in Mixed Reality. this method is to effect to location and registration. This paper suggest the method in low CPU computing power. Using a deformable searching area, the method improve computing power. and Using a Cam-shift algorithm, we suggest a calibration free method.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.2 no.2
• /
• pp.19-28
• /
• 1997

A simple AC complex circuit analysis for LCL type series resonant converter with phase shift control is proposed. Based on these analyses, a set of characteristic curves which allows a optimal design procedure for this converter is shown, without increasing the volt-ampere rating of tank circuit. Especially, inverter output peak current can be minimized in both full load and partial load conditions. The presented design considerations can make the load range wide from full loads to light loads achieving turn-on with zero voltage switching (ZVS) operation. The simulation and experimental results show the effectiveness of the proposed design algorithms.

• Journal of Astronomy and Space Sciences
• /
• v.27 no.3
• /
• pp.221-230
• /
• 2010

A 4+12+16 amplitude phase shift keying (APSK) modulation outperforms other 32-APSK modulations in a nonlinear additive white Gaussian noise (AWGN) channel because of its intrinsic robustness against AM/AM and AM/PM distortions caused by the nonlinear characteristics of a high-power amplifier. Thus, this modulation scheme has been adopted in the digital video broadcasting-satellite2 European standard. And it has been considered for high rate transmission of telemetry data on deep space communications in consultative committee for space data systems which provides a forum for discussion of common problems in the development and operation of space data systems. In this paper, we present an improved bits-to-symbol mapping scheme with a better bit error rate for a 4+12+16 APSK signal in a nonlinear AWGN channel and propose a simple signal detection algorithm for the 4+12+16 APSK from the presented bit mapping.