• Asian-Australasian Journal of Animal Sciences
• /
• 제20권2호
• /
• pp.245-251
• /
• 2007

A total of 160 d-old male broiler chicks (Cobb) were brooded for three weeks and then maintained at $24{\pm}1^{\circ}C$. Commencing from d 21, chicks were assigned to one of four feeding regimens: (1) diet with 8% palm oil (PO), (2) diet with 8% soybean oil (SO), (3) diet without added fat (control), (4) a choice of PO, SO and control (CH). The diets were formulated to maintain a constant ratio of energy and protein. From d 28 to 41, all birds were exposed to $34{\pm}1^{\circ}C$. The PO, SO and CH birds had greater body weight than controls on d 42. The PO but not SO diet reduced mortality rate, body temperature and serum creatine kinase level of broiler chickens during heat exposure. Although the total intake of control, PO and SO diets was not significantly different during heat exposure, the CH birds had lower creatine kinase activity and mortality rate than those provided SO diet but not significantly different from the birds fed control and PO diets. The relative abdominal fat weight and breast intramuscular fat content percentage were significantly lower in the control birds than those of PO, SO and CH groups. There were no significant differences in both parameters among the three latter groups. These findings suggest that the uncertainty of how much dietary fat to put into diets for heat stressed broilers can be overcome by allowing them to select their own consumption.

• Membrane and Water Treatment
• /
• 제2권3호
• /
• pp.187-205
• /
• 2011

The electric transport of the mixture of hydrochloric and phosphoric acids through strong base (Neosepta ACM) and weak base (Selemion AAV) anion-exchange membranes was investigated. The instantaneous efficiency of HCl removal from the cathode solution, $CE_{Cl}$, with and without $H_3PO_4$ was determined. It was found that $CE_{Cl}$ was 0.8-0.9 if the number of moles of elementary charge passed through the system, $n_F$, did not exceed ca. 80% of the initial number of HCl moles in the cathode solution, $n_{Cl,ca,0}$. The retention efficiency of $H_3PO_4$ in that range was close to one. The transport of acid mixtures was satisfactorily described by a model based on the extended Nernst-Planck and Donnan equations for $n_F$ not exceeding $n_{Cl,ca,0}$. Among the tested model parameters, most important were: concentration of fixed charges, the porosity-tortuosity coefficient, and the partition coefficient of an undissociated form of $H_3PO_4$. For the both membranes, the obtained optimal values of fixed charge concentration, $\bar{c}_m$, were up to 40% lower than the literature values of $\bar{c}_m$ obtained from the equilibrium measurements. Regarding the $H_3PO_4$ equilibria, it was sufficient to consider $H_3PO_4$ as a monoprotic acid.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 추계학술대회 논문집 Vol.19
• /
• pp.241-242
• /
• 2006

In this work, the $LiFePO_4-LiCoO_2$ mixed cathode electrodes were prepared and their electrochemical performances were measured in different current density. The cell of $LiFePO_4-LiCoO_2$ observed two voltage plateau regions at 3.4 and 3.9V. The cell of $LiFePO_4-LiCoO_2$ (90:10 wt%) mixed cathode delivered a discharge capacity of ca. 139.8 mAh/g at a 0.2C rate. The capacity of the cell decreased with the current rate and a useful capacity of ca 85.7mAh/g was obtained at a 2C rate.

• 한국세라믹학회지
• /
• 제45권2호
• /
• pp.112-118
• /
• 2008

To prepare the high-capacity cathode material with improved electrochemical performances, nanoparticles of $C0_3(PO_4)_2$ were coated on the powder surface of $Li[Co_{0.1}Ni_{0.15}Li_{0.2}Mn_{0.55}]O_2$, which was already synthesized by simple combustion method. The coated powders after the heat treatment at >$700^{\circ}C$ surely showed well-structured crystalline property with nanoscale surface coating layer, which was consisted of $LiCOPO_4$ phase formed from the reaction bwtween $CO_3(PO_4)_2$ and lithium impurities. In addition, cycle performance was particularly improved by the $CO_3(PO_4)_2$-coating for the cathode material for lithium rechargeable batteries.

• Bulletin of the Korean Chemical Society
• /
• 제26권2호
• /
• pp.241-247
• /
• 2005

A series of proton conductive inorganic-organic hybrid membranes doped with phosphoric acid ($H_3PO_4$) and/or triethylphosphate (PO(OEt)$_3$) have been prepared by sol-gel process with 3-glycidoxypropyltrimethoxysilane (GPTMS), 3-aminopropyltriethoxysilane (APTES) and tetraethoxysilane (TEOS) as precursors. High proton conductivity of 3.0 ${\times}$ $10^{-3}$ S/cm with composition of 50TEOS-30GPTMS-20APTES-50$H_3PO_4$ was obtained at 120 ${^{\circ}C}$ under 50% relative humidity. Thermal stability of membrane was significantly enhanced by the presence of SiO$_2$ framework up to 250 ${^{\circ}C}$. XRD revealed that the gels are amorphous. IR spectra showed a good complexation of $H_3PO_4$ in the matrix. The conductivity under 75% relative humidity was significantly improved by addition of APTES due to the increase in concentration of defected site in hybrid matrix. The effect of PO(OEt)$_3$, humidifying time, and heat-treatment were also investigated. PO(OEt)$_3$ had no improvement on conductivity and conductivity increased with humidifying time, however, decreased with heating temperature.

• Bulletin of the Korean Chemical Society
• /
• 제32권2호
• /
• pp.536-540
• /
• 2011

This study reports the origin of the electrochemical improvement of $LiFePO_4$ when synthesized by wet milling using acetone without conventional carbon coating. The wet milled $LiFePO_4$ delivers 149 $mAhg^{-1}$ at 0.1 C, which is comparable to carbon coated $LiFePO_4$ and approximately 74% higher than that of dry milled $LiFePO_4$, suggesting that the wet milling process can increase the capacity in addition to conventional carbon coating methods. UV spectroscopy, elemental microanalysis, and evolved gas analysis are used to find the root cause of the capacity improvement during the mechanochemical reaction in acetone. The analytical results show that the improvement is attributed to the conductive residual carbon on the surface of the wet milled $LiFePO_4$ particles, which is produced by the reaction of $FeC_2O_4{\cdot}2H_2O$ with acetone during wet milling through oxygen deficiency in the precursor.

• Bulletin of the Korean Chemical Society
• /
• 제30권10호
• /
• pp.2223-2226
• /
• 2009

Pristine and sulfur-doped (LiFe$PO_{3.98}S_{0.03}$) lithium iron phosphates were synthesized by a sol-gel method. The XRD pattern of the prepared materials suggested an orthorhombic structure with a Pnma space group and an absence of impurities. The Li/LiFe$PO_4$ or LiFe$PO_{3.98}S_{0.03}$ cells were employed for cycling studies at various temperatures (25, 50 and $60\;{^{\circ}C}$). In all cases, the Li/LiFe$PO_{3.98}S_{0.03}$ cell showed an improved performance with a stable discharge behavior of ~155 mA$hg^{-1}$. Nevertheless, pristine LiFeP$O_4$ cells presented poor discharge behavior at elevated temperatures, especially $60\;{^{\circ}C}$.

• Bulletin of the Korean Chemical Society
• /
• 제25권8호
• /
• pp.1182-1188
• /
• 2004

Polydisperse oligo(PO-b-EO) allyl ether siloxane surfactants were synthesized by the hydrosilylation reaction of OMTS with Allyl-oligo(PO-b-EO) series. The surface tension of siloxane surfactants increased with increasing the EO chain length while it decreased with increasing the PO ratio. However, the sedimentation time of the aqueous solution showed opposite trend to the surface tension data. Both the surface tension and sedimentation time of the aqueous solution containing inorganic electrolyte gradually decreased as the content of inorganic electrolyte increased because of the surface arrangement of surfactant molecules. However, they increased with an increase of pH values due to the hydrolysis of the siloxane backbone. The $C_p$ values tended to increase with the increase in the EO chain length and decrease of the PO ratio. It seems that intermolecular interaction between PO/EO block copolymer and water affects the variation of transition temperature.

• 대한화학회지
• /
• 제40권1호
• /
• pp.1-10
• /
• 1996

Gibbs' adsorption isotherms을 이용하여, 계면에서 보조계면활성제 분자의 분자 면적과 계면장력거동에 미치는 ethylene oxide(EO)와 propylene oxide(PO)의 영향을 조사하였다. 일반식 $C_4H_9O(EO)m(PO)_nH$를 갖는 alcohol들의 보조계면활성제로서의 특성을 연구하였는데, 이 alcohol들은 일반적으로 사용되는 보조계면활성제에 비해서 분자량이 크며 계면활성 또한 큰 특성을 갖고있다. EO와PO의 몰수와 이들이 첨가된 상대적 순서는 물/기름 계면에서 alcohol 분자의 분자면적과 계면장력 특성에 큰 영향을 미치는 것을 알 수 있었으며, 다음의 결론을 얻었다. 1) PO는 EO에 비해서 계면흡착 효율은 낮으나, 계면장력 저하 능력은 더 크다. 2) 분자량은 같으나 구조가 다른 분자들, 즉 EO와PO의 첨가 순서만 다른 분자들의 경우는, 계면흡착 효율이 큰 (계면에서의 분자면적이 작은) 분자들이 계면장력 저하 능력이 더 크다. 3) 동일한 친유기에 EO나 PO가 많이 첨가될수록, 분자들의 계면에서의 분자면적은 커지나 계면장력 저하능력도 커진다.

• 한국전기전자재료학회논문지
• /
• 제19권6호
• /
• pp.519-523
• /
• 2006

$LiFePO_4$ has been received attention as a potential cathode material for the lithium secondary batteries. In our study, $LiFePO_4$ cathode active materials were synthesized by a solid-state reaction. It was modified by coating $TiO_2$ and carbon in order to enhance cyclic performance and electronic conductivity. $TiO_2$ and carbon coatings on $LiFePO_4$ materials enhanced the electronic conductivity and its charge/discharge capacity. For lithium polymer battery applications, $LiFePO_4$/solid polymer electrolyte (SPE)/Li and $LiFePO_{4}-TiO_{2}/SPE/Li$ cells were characterized by a cyclic voltammetry and charge/discharge cycling. The electrode with $LiFePO_{4}-carbon-TiO_{2}$ in PVDF-PC-EC-$LiClO_{4}$ electrolyte showed promising capacity of above 100 mAh/g at 1C rate.