• Journal of Biosystems Engineering
• /
• v.29 no.3
• /
• pp.207-216
• /
• 2004

This study was intended to investigate the characteristics of ride vibrations transmitted to tractor operator during rotary tillage and plowing operations. Seat accelerations of a 41 ps diesel tractor in rotary tillage and plowing were measured and evaluated as specified in the ISO 2631-1. Effects of working speed and tilling depth on ride vibration were investigated. The level of ride vibration was also evaluated in terms of health guidance caution zones. Some of the results of the study are as follows: 1. The level of ride vibration in plowing was about 4.3 times greater than in rotary tillage. 2. The effect of working speed in rotary tillage differs depending upon the tillage depth. The level of ride vibration was increased with the speed, but it decreased over a certain tillage depth. Fore and aft vibration was 2.2-2.7 times severer than horizontal and vertical vibrations. Dominant frequency band was 1-3.15 ㎐ in fore and aft, 1-3.15㎐ and 16-25㎐ in horizontal, and 16-25㎐ in vertical directions. 3. Plowing reduced the ride vibration by 42.8-50.2%. But its positive effect decreased as the plowing speed increased. In plowing operation, ride vibration was similar degrees in fore and aft, horizontal and vertical directions. The dominant frequency band in plowing operation was 1-2.5㎐ in fore and aft, 1-2.5㎐ in horizontal, and 1-8㎐ in vertical directions. 4. On a basis of daily work hours of 4, total level of ride vibrations in plowing operation is likely to be harmful to operator's health.

• Tribology and Lubricants
• /
• v.15 no.1
• /
• pp.83-89
• /
• 1999

The fretting wear behaviour of Zircaloy-4 tube used as the fuel rod cladding in PWR nuclear power plants has been investigated at the different test environment, in light water and in air as a function of slip amplitude, normal load, test duration and frequency. Zircaloy-4 tubes were used for both of oscillating and stationary specimens. A fretting wear tester was designed to be suitable for this fretting test. The wear volume and specific wear rate of Zircaloy-4 tube in water was greater than those in air under various slip amplitude. Delaminates and surface cracks were observed at low slip amplitude and high load of fretting test in water, but the traces of adhesion and plowing were observed at and above 200 Um. The water accelerates the wear of Zircaloy-4 tube at lower slip amplitude in fretting.

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.27 no.3
• /
• pp.209-218
• /
• 2007

This experiment was conducted to investigate effect of plowing frequency and sowing dates on the agronomic characteristics, feed value, weed yield and palatability of silage corn. Treatments were a basal treatment(C: May 5 seeding, plowing once, weeding control once), T1(May 12 seeding, plowing twice, weeding control 0 time), T2(May 19 seeding, plowing three times, weeding control 0 time, T3(May 26 seeding, plowing four times, weeding control 0 time) and T4(June 2 seeding, plowing five times, weeding control 0 time). The experiment was performed at the College of Life and Natural Sciences of Sangju University in Sangju in 2006. The plant height and ear height showed highly in order to C > T1 > T2 > T3 > T4 treatment, leaf length was the highest at T2 (96.0cm). Leaf width and number of dead leaf were the highest at C and T3 (11.2cm), C, C and T1 (4.6), respectively. Stem diameter was the highest at T3 as 31mm, while T2 was the lowest as 25mm (p<0.05). Ear circle showed highly in order of C > T1 > T4 > T3 > T4 (p<0.05), and tip filling degree was the highest at C treatment as 8.8, while T4 treatment was the lowest as 6.0 (p<0.05). The stem hardness and grain hardness were C < T1 < T2 < T3 < T4 (p<0.05). Stem saccharinity was T1(6.1%) was the highest, while T2(3.0%) was the lowest(P<0.05). Fresh yield of weed was the lowest at C treatment as 500 kg/ha, but T1 treatment was the highest as 44,100 kg/ha (p<0.05). Weed coverage rate showed highly in order of T1 > T2 > T3 > T4 > C treatment (p<0.05). Fresh yield of corn was the highest at C treatment as T3,550 kg/ha, but T4 treatment was the lowest as 65,500 kg/ha (p<0.05). Dry matter yield of corn showed highly in order of C(26,978 kg/ha) > T1(26,130 kg/ha) > T2(20,255 kg/ha) > T3(20,255 kg/ha) > T4(17,508 kg/ha) treatment (p<0.05). Crude protein content was T1(7.69%) > T4(7.42%) > T2(6.34%) > T3(5.99%) > C(5.91%) treatment (p<0.05), and Crude fat content showed highly in order of C (2.13%) > T1(2.04%) > T2(1.96%) > T3(1.95%) > T4(1.84%) treatment. Relative palatability of Holstein, Korean native goat and spotted deer was the highest at C treatment, but Korean native cattle was the highest at T1 treatment.

• Korean Journal of Agricultural Science
• /
• v.40 no.1
• /
• pp.53-59
• /
• 2013

Analysis of load data during field operations is highly important for optimum design of power drive lines for agricultural tractor. Objective of the paper was to analyze field load data using FFT to determine frequency and the energy levels of meaningful cyclic patterns. Rotary tillage, plowing, baling, and wrapping operations were selected as major field operations of agricultural tractor. An agricultural tractor with power measurement system was used. The tractor was equipped with strain-gauge sensors to measure torque of four driving axles and a PTO axle, speed sensors to measure rotational speed of the driving axles and an engine shaft, pressure sensors to measure pressure of hydraulic pumps, an I/O interface to acquire the sensor signals, and an embedded system to calculate power requirement. In rotary tillage, calculated frequency was decreased as travel speed increased. In baler operation, calculated frequency was increased as PTO speed was increased. The calculated peak frequency levels and expected levels were similar. Results of the study would provide information on power utilization patterns and on better design of power drive lines.

• Journal of Climate Change Research
• /
• v.9 no.4
• /
• pp.377-384
• /
• 2018

The chamber method is widely used for measuring methane emission from paddy rice fields. The closed static chamber has advantages of easy installation and removal in the field and low manufacturing cost. However, the manual chamber method requires a lot of labor and has a limited sampling time and frequency. To overcome the disadvantages of the manual chamber, the auto-chamber system is used for measuring methane emission. We compared the differences in methane flux between the auto-chamber and manual chamber. To investigate methane emissions by the two methods, a chamber was installed for each of the following treatments : control without rice straw (NA), spring plowing after autumn rice straw application (SPRA) and autumn plowing after autumn rice straw application (APRA). The total methane emission was lowest in the control and highest in APRA with both methods. There was no significant difference in total methane emission between the methods, but dynamic fluctuation in methane with temperature change was accurately measured in the auto-chamber. Measuring methane emission with an auto-chamber system is expected to reduce uncertainty and increase accuracy, accompanied by labor reduction.

• Journal of Ginseng Research
• /
• v.4 no.1
• /
• pp.104-120
• /
• 1980

The effects of temperature on transpiration, chlorophyll content, frequency and aperture of stomata, and leaf temperature of Panax ginseng were reviewed. Temperature changes of soil and air under spade roof were also reviewed. Growth responses of responses of ginseng plant at various temperature were assessed in relation to suseptibillity of ginseng plants. Reasonable management of ginseng fields was suggested based on the response of ginseng to various temperatures. Stomata frequency may be increased under high temperature during leaf$.$growing stage. Stomata aperture increased by high temperature but the increase of both frequency and aperture appears not enough for transpiration to overcome high temperature encountered during summer in most fields. Serial high temperature disorder, i.e high leaf temperature, chlorophyll loss, inhibition of photosynthesis, increased respiration and wilting might be alleviated by high humidity and abundant water supply to leaf. High air temperature which limits light transmission rate inside the shade roof, induces high soil temperature(optimum soil temperature 16∼18$^{\circ}C$) and both(especially the latter) are the principal factors to increase alternaria blight, anthracnose, early leaf fall, root rot and high missing rate of plant resulting in poor yield. High temperature disorder was lessen by abundant soil water(optimum 17∼21%) and could be decreased by lowering the content of availability of phosphorus and nitrogen in soil consequently resulting in less activity of microorganisms. Repeated plowing of fields during preparation seems to be effective for sterilization of pathogenic microoganisms by high soil temperature only on surface of soils. Low temperature damage appeared at thowing of soils and emergence stage of ginseng but reports were limited. Most limiting factor of yield appeared as physiological disorder and high pathogen activity due to high temperature during summer(about three months).

• Women's Health Nursing
• /
• v.7 no.4
• /
• pp.631-641
• /
• 2001

This study is to investigate women have pre menstruation discomfort, The period of this research was almost one month (from 25, August 2001 to 25, October 2001). The PAF (Premenstrual assessment form), which was made by Park, Myonng-Wha, used for this study. The confidence rate is Crombach's $\alpha$= .9773. Correcting research papers are analyzed by SPSS 7.5 program and normal feature of the subject is divided by frequency, percentage, mean, standard deviation, t-test and ANOVA. The results of this study are as follows; 1. The average age of the subjects is 26.47 age. 220 subjects(44.6%) have gastroenteric trouble like, enteritis, stomachache, laxity. 278 subjects usually have caffeine drink in routine life. 123 subjects(24.9%) have controlled their diet. The average age of the first plowing is 13.55 ages and distribution is between 10 years and 20 years. The average of the uncomfortable point is 2.84. The way to reduce the uncomfortable feeling on the menstruation is taking relax time. 2. All subjects have experienced pre menstruation discomfort, even the degree uncomfortable feeling is different. Through eighteenth categories on the research papers, average point 2.21 were calculated and many subjects have fatigue ($2.89{\pm}1.0614$) and normal physical uncomfortable ($2.84{\pm}1.0633$) and undercurrent water symptom and unsuitability ($2.45{\pm}0.9857$). 3. According to the result of this study, that shows statistical difference; age (F=2.56. p=.037). marriage (t=2.60, p=.009) the number of children(t=2.83, p=.005), stress level(F=13.03, p=.000) job(F=3.91, p=.020). monthly income(t=2.14. p=.032) uncomfortable degree on the menstruation (F=19.121, p=.000), use of contraceptive appliance or pill(t=-2.20, p=.043), schooling (F=3.30, p=.038). Further research is need to understand pie menstruation discomforts, the variables associated with them. And nursing intervention has to considered in program to reduces of pre-menstruation discomforts.