• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1992.05a
• /
• pp.50-53
• /
• 1992

The GaP crystals are growth by Synthesis Solute Diffusion(SSD) method and its properties are investigated. Etch pits density along vertical direction of ingot is increased from 3.8${\times}$10$^4$cm$\^$-2/ of first freeze to 2.3${\times}$10$\^$5/cm$\^$-2/ of last freeze part. The carrier concentration and mobilities are measured to 197.49$\textrm{cm}^2$/V. sec and 6.75${\times}$10$\^$15/cm$\^$-3/ at room temperature. The temperature dependence of optical energy gap is empilically fitted to E$\_$g/(T)=2.3383-(6.082${\times}$10$\^$-4/T${\times}$/(373.096+T)[eV]. Photo-luminescence spectra measured at low temperature are consist with sharp line-spectra near band-gap energy and radiative recombination between shallow Si-donor to Zn-acceptor and its phonon reprica, and broad emission. The infrared absorption in GaP is cause to phonon coupling modes of TO, LO, LA, TA$_1$, TA$_2$and vibration modes of Ga$_2$O, Si-donor and Zn-acceptor, respectively.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07a
• /
• pp.24-27
• /
• 2004

ZnS nanoparticles were synthesized and doped with $Pr^{3+}\;and\;Mn^{2+}$. Photoluminescence(PL) peaks were observed at 430 nm for pure ZnS, 585 nm for $Mn^{2+}-doped$ ZnS, and at around 430, 460, 480, 495 nm for ZnS nanoparticles doped with $Pr^{3+}$, respectively. For co-doped sample, both characteristics of doping with each element were exhibited. Optical annealing through UV irradiation was carried out in the two atmospheres; air and vacuum. The increases of the luminescence intensity was more considerable in the air, which is attributed to the photo-induced oxidation. In the case of co-doped sample the change of the emission color was observed by UV annealing.

• Korean Journal of Materials Research
• /
• v.9 no.6
• /
• pp.564-568
• /
• 1999

The 8-hydroxyquinoline Zinc(Znq2) were prepared successfully from zinc chloride and zinc acetate as two kinds of starting material. The organic electroluminescent devices(ELDs) were fabricated by the structure of ITO/TPD/Znq2/Al with N-N'-diphenyl-N-N'-bis(3-methylphenyl)-1,1'-biphenyl-4,4'-diamine(TPD) which acts hole trasporting layer and bis(8-oxyquinolino) zinc(II)(Znq2) which acts as emission and electron transporting layer. EL efficiency of Znq2 prepared by heating was investigated. The 570nm of main emission peak which is yellowich green was investigated by photo luminesence(PL) and this results shows that electro luminescence(EL) is from Znq2. The V-J curve shows that carrier injection were investigated from 4V. Maximum luminance and luminance efficiency were 1600cd/$\m^2$, 0.9lm/W. From this results, the Znq2 can be one of the useful organic EL material.

• Journal of Powder Materials
• /
• v.28 no.1
• /
• pp.44-50
• /
• 2021

Zinc selenide (ZnSe) nanoparticles were synthesized in aqueous solution using glutathione (GSH) as a ligand. The influence of the ligand content, reaction temperature, and hydroxyl ion concentration (pH) on the fabrication of the ZnSe particles was investigated. The optical properties of the synthesized ZnSe particles were characterized using various analytical techniques. The nanoparticles absorbed UV-vis light in the range of 350-400 nm, which is shorter than the absorption wavelength of bulk ZnSe particles (460 nm). The lowest ligand concentration for achieving good light absorption and emission properties was 0.6 mmol. The reaction temperature had an impact on the emission properties; photoluminescence spectroscopic analysis showed that the photo-discharge characteristics were greatly enhanced at high temperatures. These discharge characteristics were also affected by the hydroxyl ion concentration in solution; at pH 13, sound emission characteristics were observed, even at a low temperature of 25℃. The manufactured nanoparticles showed excellent light absorption and emission properties, suggesting the possibility of fabricating ZnSe QDs in aqueous solutions at low temperatures.

• Korean Journal of Materials Research
• /
• v.32 no.6
• /
• pp.307-312
• /
• 2022

Metal halide perovskite (MHP) nanocrystals (NCs) have emerged as promising materials for various optoelectronic applications including photovoltaics, light-emitting devices, and photodetectors because of their high absorption coefficient, high diffusion length, and photoluminescence quantum yield. However, understanding the morphological evolution of the MHP NCs as well as their controlled assembly into optoelectronic devices is still challenging and will require further investigation of the colloidal chemistry. In this study, we found that the amount of n-octylamine (the capping agent) plays a crucial role in inducing further growth of the MHP NCs into one-dimensional nanowires during the aging process. In addition, we demonstrate that the dielectrophoresis process can permit self-alignment of the MHP nanowires with uniform distribution and orientation on interdigitated electrodes. A strong light-matter interaction in the MHP NWs array was observed under UV illumination, indicating the photo-induced activation of their luminescence and electrical current in the self-aligned MHP nanowire arrays.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.422.1-422.1
• /
• 2016

Graphene quantum dots (GQDs), a new kind of carbon-based photo luminescent nanomaterial from chemically modified graphene oxide (CMGO) or chemically modified graphene (CMG), has attracted extensive research attention in the last few years due to its outstanding chemical, optical and electrical properties. To further extended its potential applications as optoelectronic devices, solar cells, bio and bio-sensors and so on, intensive research efforts have been devoted to the CMG. However, the CMG, a suspension of aqueous, have problematic since they are prone to agglomeration after drying a solvent. In this study, we synthesized the GQDs from graphite and deposited on silicon substrate by kinetic spray. The photo luminescent properties of deposited GQD films were analyzed and compared with initial GQDs suspension. In addition, its carbon properties were investigated with GQDs solution properties. The properties of deposited GQD films by kinetic spray were similar to that of the GQDs suspension in water. We could provide a pathway for silicon-based silicon based device applications. Finally, the well-adjusted GQD films with photo luminescence effects will show Energy-Down-Shift layer effects on silicon solar cells. The GQD layers deposited at nozzle scan speeds of 40, 30, 20, and 10 mm/s were evaluated after they were used to fabricate crystalline-silicon solar cells; the results indicate that GQDs play an important role in increasing the optical absorptivity of the cells. The short-circuit current density (Jsc) was enhanced by about 2.94 % (0.9 mA/cm2) at 30 mm/s. Compared to a reference device without a GQD energy-down-shift layer, the PCE of p-type silicon solar cells was improved by 2.7% (0.4 percentage points).

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.29 no.4
• /
• pp.179-186
• /
• 2019

In this study, we investigated the structural properties of $Ga_2O_3$ thin films and the photo-electrical properties of metal-semiconductor-metal (MSM) photodetectors deposited by Ti/Au electrodes. $Ga_2O_3$ thin films were grown at different temperatures using metal organic chemical vapor deposition (MOCVD). The crystal phase of $Ga_2O_3$ changed from ${\varepsilon}$-phase to ${\beta}$-phase depending on the growth temperature. The crystal structure of ${\varepsilon}-Ga_2O_3$ was confirmed by X-ray diffraction (XRD) analysis and the formation mechanism of crystal structure was discussed by scanning electron microscopy (SEM) images. From the results of current-voltage (I-V) and time-dependent photoresponse characteristics under the illumination of external lights, we confirmed that the MSM photodetector fabricated by ${\varepsilon}-Ga_2O_3$ showed much better photocurrent characteristics in the 266 nm UV range than in the visible range.

• Journal of the Korean Vacuum Society
• /
• v.20 no.4
• /
• pp.288-293
• /
• 2011

We investigated the effects of piezoelectric field on the electro-absorption characteristics in InGaN/GaN multiple-quantum well (MQW) green light emitting diodes (LED). Double crystal X-ray diffraction measurement was performed to study the crystalline property and indium (In) composition in the MQW active layer. To measure the electro-luminescence and electro-reflectance (ER) spectroscopy, we fabricated the $1{\times}1\;mm^2$ large-area green LED chip. The piezoelectric field inside the LED structure was evaluated from the Vcomp in active layer by the ER spectra. Finally, we analyzed the electro-absorption characteristics of the green LED by using the photo-current spectroscopy.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.40 no.11
• /
• pp.1569-1574
• /
• 2011

In this study, the identification of the irradiated seafood cooking drips from Hizikia fusiformis, Enteroctopus dofleini and Thunnus thynnus was conducted. The physical detection methods used included photo-stimulated luminescence (PSL) and thermoluminescence (TL), and the chemical detection methods were hydrocarbons analysis. In the PSL study, all seafood cooking drip samples showed 260~510 photon counts; thus, the PSL method could not be used for the detection of irradiated seafood cooking drips. The TL method could be used for the detection of irradiated H. fusiformis and E. dofleini cooking drips. In both cooking drips, the shapes of the glow curves indicated a specific peak at 150$^{\circ}C$~250$^{\circ}C$, which made it possible to identify the irradiated samples. The hydrocarbons derived by gamma irradiation of T. thynnus cooking drip were not detected due to low concentration and inconsistent content of fatty acids in the untreated T. thynnus cooking drip.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.340-341
• /
• 2013

양자점(Quantum dots; QDs)은 단전자 트랜지스터, 레이저, 발광다이오드, 적외선 검출기와 같은 고효율 광전소자 응용을 위해 활발한 연구가 진행되고 있다. II-VI 족 화합물 반도체는 III-V 족 화합물 반도체와 비교했을 때 더 큰 엑시톤 결합에너지(exciton binding energy)를 가지는 우수한 특성을 보이고 있으며 이러한 성질을 가지는 II-VI 족 화합물 반도체 중에서도 넓은 에너지 갭을 가지는 CdTe 양자점은 녹색 영역대의 광전자 소자로서 활용되고 있다. 기존의 CdTe/ZnTe 양자점을 성장하기 위해 ZnTe와 격자부정합이 적은 GaAs 기판을 이용한 연구가 주를 이룬 반면 Si기판을 이용한 연구는 미흡하다. 하지만 Si 기판은 GaAs 기판에 비해 값이 싸고, 여러 분야에 응용이 가능하며 대량생산이 가능하다는 이점을 가지고 있어 초고속, 초고효율 반도체 광전소자의 제작을 가능케 할 것으로 기대된다. 또한 양자점의 고효율 광전소자에 응용을 위해서는 Si 기판 위에 양자점의 크기를 효율적으로 조절하는 연구 뿐 아니라 양자점의 크기에 따른 운반자 동역학에 대한 연구도 중요하다. 본 연구에선 분자선 에피 성장법(Molecular Beam Epitaxy; MBE)과 원자층 교대 성장법(Atomic Layer Epitaxy; ALE)을 이용하여 Si 기판 위에 성장한 CdTe/ZnTe 양자점의 크기에 따른 광학적 특성을 연구하였다. 저온 광 루미네센스(PhotoLuminescence; PL) 측정 결과 양자점의 크기가 증가함에 따라 더 낮은 에너지영역으로 피크가 이동하는 것을 확인하였다. 그리고 온도 의존 광루미네센스 측정 결과 양자점의 크기가 증가함에 따라 열적 활성화 에너지가 증가하는 것을 관찰하였는데, 이는 양자점의 운반자 구속효과가 증가하였기 때문이다. 또한 시분해 광루미네센스 측정 결과 CdTe/ZnTe 양자점의 크기가 증가함에 따라 소멸 시간이 긴 값을 갖는 것을 관찰하였는데, 이는 양자점의 크기가 증가함에 따라 엑시톤 진동 세기가 감소하였기 때문이다. 이와 같은 결과 Si 기판 위에 성장한 CdTe/ZnTe 양자점의 크기에 따른 열적 활성화 에너지와 운반자 동역학에 대해 이해 할 수 있었다.