• Journal of the Korean Society for Heat Treatment
• /
• v.24 no.3
• /
• pp.144-148
• /
• 2011

Change in damping capacity with strain amplitude was studied in Mg-Al-Si alloy in as-cast, solution-treated and aged states, respectively. The as-cast microstructure of the alloy is characterized by eutectic ${\beta}$($Mg_{17}Al_{12}$) phase and Chinese script type $Mg_2Si$ particles. The solution treatment dissolved the ${\beta}$ phase into the matrix, while the aging treatment resulted in the distribution of continuous and discontinuous type ${\beta}$ precipitates. The solution-treated microstructure showed better damping capacity than as-cast and aged microstructures both in strain-dependent and strain-independent damping regions. The decrease in second-phase particles which weakens the strong pinning points on dislocations and distribution of solute atoms in the matrix, would be responsible for the enhanced damping capacity after solution treatment.

• The Journal of the Acoustical Society of Korea
• /
• v.24 no.3E
• /
• pp.109-114
• /
• 2005

In this paper, we present a phase coherent all-digital transceiver for underwater acoustic communication, which allows the system to reduce complexity and increase robustness in time variant underwater environments. It is designed in the digital domain except for transducers and amplifiers and implemented by using a multiple digital signal processors (DSPs) system. For phase coherent reception, conventional systems employed phase-locked loop (PLL) and delay-locked loop (DLL) for synchronization, but this paper suggests a frame synchronization scheme based on the quadrature receiver structure without using phase information. We show experimental results in the underwater anechoic basin at MOERI. The results show that the adaptive equalizer compensates frame synchronization error and the correction capability is dependent on the length of equalizer.

• Transactions of the Society of Information Storage Systems
• /
• v.2 no.3
• /
• pp.196-200
• /
• 2006

We are developing a phase change etching technology using an inorganic photoresist of GeSbTe film which is the recording material of the phase change disc. A selective etching phenomenon between amorphous and crystalline states can be utilized with an alkaline etchant. Phase-change pits could be formed using this technique, in which the etching selectivity is strongly dependent on the concentration of the etchant. The degree of etching was investigated by the transmittance between crystalline and amorphous films after the wet-etching. The pits patterned on the disc could be observed by AFM after wet-etching.

• Phonetics and Speech Sciences
• /
• v.3 no.1
• /
• pp.87-94
• /
• 2011

The decision directed (DD) approach is widely used to determine a priori SNR from noisy speech signals. In conventional speech enhancement systems with a DD approach, a priori SNR is estimated by using only the magnitude components and consequently follows a posteriori SNR with one frame delay. We propose a phase-dependent two-step a priori SNR estimator based on the minimum mean square error (MMSE) in the log-mel spectral domain so that we can consider both magnitude and phase information, and it can overcome the performance degradation caused by one frame delay. From the experimental results, the proposed estimator is shown to improve the output SNR of enhanced speech signals by 2.3 dB compared to the conventional DD approach-based system.

• Proceedings of the KIEE Conference
• /
• 2001.10a
• /
• pp.48-50
• /
• 2001

This paper presents the switching angle and the 1/2-phase hybrid exciting method to minimize torque ripple in the 6/4 Switched Reluctance Motor (SRM). The inductance in SRM is dependent on rotor position and current. Therefore, the inductance profile is expressed as an approximate function based on FEM data. And then, the dynamic characteristics are simulated by Matlab simulink using the derived inductance function. The torque ripple resulting from single phase exciting and 1/2-phase hybrid exciting is compared.

• Proceedings of the KOR-KST Conference
• /
• 2002.02a
• /
• pp.143-159
• /
• 2002

The performance of two single-barrier three-phase actuated control systems at diamond interchanges was evaluated for various traffic conditions. To emulate the actuated signal control, hardware-in-the-loop system combined with CORSIM simulation program was used. Two performance measures, average delay and total stops, were used for the evaluation process. Results showed that the two three-phase systems gave similar performance in terms of average delay, but not stops. The delay performance of each phasing system was generally dependent on the traffic pattern and ramp spacing. The total stops decreased as the spacing increased, and it was the most sensitive variable that can differentiate between the two three-phase systems. It was also shown that the hardware-in-the-loop control could provide a good method to overcome the limitations of current simulation technology.

• Journal of Korean Society of Water and Wastewater
• /
• v.12 no.4
• /
• pp.33-42
• /
• 1998

The optimum design and preliminary cost estimations of air stripping towers ASTs with granular activated carbon adsorption (GAC) systems as the off-gas treatment were done and compared to liquid-phase GAC system. The optimum design and preliminary cost estimations were done for either single or multicomponent systems. A computer program was developed for this study. 15 single compounds and their multicomponent systems were studies. Even with off-gas treatment, AST was generally a less expensive process for treatment of volatile organics than liquid-phase GAC system. Treatment costs of small systems were sensitive to system capacity. Accumulative effect of treatment costs was found in multicomponent systems. The cost of a multicomponent system was highly dependent on the least strippable component in ASTs even with gas-phase GAC or the least adsorbable component in liquid-phase GAC system.

• Nano
• /
• v.13 no.10
• /
• pp.1850114.1-1850114.7
• /
• 2018

Here we report an optimized hot-injection method and a phase transfer strategy for the synthesis of water-soluble $CuInS_2$ QDs with desired properties. The structure and morphology studies demonstrate that the resulting QDs are $CuInS_2$ tetragonal phase with well-defined facets. It is also found that the crystal size gradually increases with the increase of reaction temperature, while the surface of QDs with pre- and post-phase transfer is functionalized with hydrophobic and hydrophilic ligands, respectively. Spectroscopy measurements reveal the size-dependent optical properties of $CuInS_2$ QDs, demonstrating the quantum confinement effect in this system.

• Advances in nano research
• /
• v.7 no.5
• /
• pp.325-335
• /
• 2019

In the present study, nonlocal strain gradient theory (NSGT) is developed for wave propagation of functionally graded (FG) nanoscale plate in the thermal environment by considering the porosity effect. $Si_3N_4$ as ceramic phase and SUS304 as metal phase are regarded to be constitutive material of FG nanoplate. The porosity effect is taken into account on the basis of the newly extended method which considers coupling influence between Young's modulus and mass density. The motion relation is derived by applying Hamilton's principle. NSGT is implemented in order to account for small size effect. Wave frequency and phase velocity are obtained by solving the problem via an analytical method. The effects of different parameters such as porosity coefficient, gradient index, wave number, scale factor and temperature change on phase velocity and wave frequency of FG porous nanoplate have been examined and been presented in a group of illustrations.

• Proceedings of the SCSK Conference
• /
• 1999.10a
• /
• pp.65-74
• /
• 1999

We have studied the stability of W/O high internal phase emulsions(HIPE) containing water, cetyl dimethicone copolyol and oils varying magnesium sulfate in the range 0 to 0.5wt% and oil polarities, respectively. The rheological consistency was mainly destroyed by the coalescence of the deformed water droplets. The greater the increase of concentrated modulus was, the less coalescence occurred and the more consistent the concentrated emulsions were. The increasing pattern of complex modulus versus volume fraction has been explained with the resistance to coalescence of the deformed interfacial film of water droplets in concentrated W/O emulsion. The stability is dependent on: (i) the choice of the oil is important, the requirements coincide with the requirements for the formation of the rigid liquid crystalline phases :5; and (ii) addition of salts the aqueous phase opposes the instability due to coalescence:. Increasing the salt concentration increases the refractive index of the aqueous phase. It lowers the difference in the refractive index between the oil and aqueous phases. This decreases the attraction between the water domains, thus increasing the stability.