• 전자공학회논문지A
• /
• 제30A권9호
• /
• pp.6-13
• /
• 1993

In is well-known that system performance in the high speed digital radio communication system is usually deteriorted due to the frequency selective fading distortion. In this paper, bit error rate(BER) performance by the reception phase error in cellular mobile communication systems is derived and analyzed. The system is modeled as a frequency selective fast Rayleigh fading channel corrupted by additive white gaussian noise(AWGN) and co-channel interference(CCI). Our numerical results show that for the 24KBaud(48Kb/s) $\pi$/4-DQPSK operated at carrier frequency 800 MHz and C/I<20 dB, the BER will be dominated by CCI if the vehicular speed is below 100 Km/h. The results show that performance, when reception phase error is below $\pi$/12, is deterioreted less than 3 dB, and that performance, when reception phase error is above $\pi$/12, is degraded over 3 dB.

• 전력전자학회논문지
• /
• 제5권6호
• /
• pp.544-551
• /
• 2000

In this paper, 3-phase hybrid series active power filter for compensate current harmonics, voltage drop and unbalanced voltage in the network presented. The proposed system is implemented with a space vector modulation voltage source inverter and a high pass filter connected in parallel to the power system. Here the load is six-pulses thyristor rectifier. The phase angle detected in order to generation reference voltage at load terminal is synchronized with the positive sequence component of the unbalanced source by using symmetrical component transformation. The proposed system has an function harmonic isolation between source and load, voltage regulation, and unbalance compensation. Therefore, what the power system is improved quality, the source current is maintained as a nearly sinusoidal waveform and the load voltage is regulated with a rated voltage regardless of the source variation condition. To verify the validity of the proposed compensating system, the computer simulation and experiment are carried out.

• 한국광학회지
• /
• 제3권4호
• /
• pp.239-243
• /
• 1992

KDP 결정에서 2차 고조파가 발생될 때와 질소기체에서 CARS신호가 발생될 때 나타나는 간섭현상을 조사하였다. 비선형 신호들의 위상차이를 주기 위하여 광학유리를 이용하여 제작된 위상변이장치와 고압기체셀을 사용하였으며 각 매질에 대한 가간섭길이를 측정하였다. 특정한 스톡스광의 파장에서 CARS신호가 상쇄간섭을 일으키도록 위상변이장치의 두께를 조정한 후, 넓은 파장영역에서 상쇄간섭된 질소 CARS 스펙트럼을 얻었다. 위상변이장치의 두께를 바꾸면서 상쇄간섭정도의 변화를 관찰하였다.

• ETRI Journal
• /
• 제28권2호
• /
• pp.231-234
• /
• 2006

The cancellation performance of a linearization loop is limited by the degree of an amplitude imbalance and a phase imbalance. A delay mismatch causes a phase variation as a function of frequency. Therefore, the cancellation performance and linearization bandwidth are limited by a delay mismatch. The expression for the effects of an amplitude imbalance, a phase imbalance, and a delay mismatch on the characteristics of a linearization loop is derived and analyzed. The simulation results are compared with the results obtained by means of using a commercial simulation tool and the exact agreement is reported. The derived equation could be used in designing a linearization loop and predicting the cancellation performance of the linearization loop usefully. Some useful characteristics, known from the simulation results obtained by using the derived equation, of a linearization loop for designing and implementing feedforward amplifiers are described in detail.

• 조명전기설비학회논문지
• /
• 제28권12호
• /
• pp.65-73
• /
• 2014

In this paper, the detection scheme of the voltage variation using a two difference voltage is proposed. The conventional sag detector is from a single-phase digital phase-locked loop (DPLL) that is based on a d-q transformation using an all-pass filter (APF). The APF generates a virtual q-axis voltage component with $90^{\circ}$ phase delay but the APF cannot generate the virtual q-axis voltage depending on the phase of the grid voltage. To overcome the problem, q-axis voltage component is generated from difference between the current and previous value of d-axis voltage component in the stationary reference frame. However, the difference voltage around the zero crossing is not enough to detect the voltage sag. Therefore, the new detection scheme using the two difference voltage which can detect the sag around the zero crossing voltage is proposed.

• 한국자동차공학회논문집
• /
• 제11권5호
• /
• pp.15-21
• /
• 2003

The liquid phase LPG injection engine is a new technology to make good use of LPG as a clean energy. However, it is difficult to precisely control air/fuel ratio in the system because of variation of fuel composition, change of temperature and flash boiling injection mechanism. This study newly suggests an injector control logic for liquid phase LPG injection systems. This logic compensates a number of effects such as variations of density, stoichiometric air/fuel ratio, injection delay time, injection pressure, release pressure which is formed by flash boiling of fuel at nozzle exit. This logic can precisely control air/fuel ratio with only two parameters of intake air flow rate and injection pressure without considering fuel composition, fuel temperature.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2001년도 전력전자학술대회 논문집
• /
• pp.231-234
• /
• 2001

The torque of SRM depends on phase current and the derivative of inductance. But the inductance of SRM is nonlinearly changed according to rotor position angle and phase current because of saturation in magnetic circuit. Therefore this has a concern in torque ripple and speed variation, and it is difficult to control the desired torque The torque of SRM depends on phase current and the derivative of inductance. But the inductance of SRM is nonlinearly changed according to rotor position angle and phase current because of saturation in magnetic circuit, and it is difficult to control the desired torque. This paper proposes an optimization control scheme by adjusting both the turn-on and turn-off angle according to high efficiency points which are simulated by GA-Neural Network, which is used to simulate the reasonable switching angle which is nonlinearly varied with rotor speed and load.

• Journal of the Korean Statistical Society
• /
• 제35권4호
• /
• pp.377-395
• /
• 2006

In this paper we have suggested a family of chain estimators of the population mean $\bar{Y}$ of a study variate y using two auxiliary variates in two phase (double) sampling assuming that the coefficient of variation of the second auxiliary variable is known. It is well known that chain estimators are traditionally formulated when the population mean $\bar{X}_1$ of one of the two auxiliary variables, say $x_1$, is not known but the population mean $\bar{X}_2$ of the other auxiliary variate $x_2$ is available and $x_1$ has higher degree of positive correlation with the study variate y than $x_2$ has with y, $x_2$ being closely related to $x_1$. Here the classes are constructed when the population mean $\bar{X}_1\;of\;X_1$ is not known and the coefficient of variation $C_{x2}\;of\;X_2$ is known instead of population mean $\bar{X}_2$. Asymptotic expressions for the bias and mean square error (MSE) of the suggested family have been obtained. An asymptotic optimum estimator (AOE) is also identified with its MSE formula. The optimum sample sizes of the preliminary and final samples have been derived under a linear cost function. An empirical study has been carried out to show the superiority of the constructed estimator over others.

• 한국정보통신학회논문지
• /
• 제16권4호
• /
• pp.669-676
• /
• 2012

본 논문에서는 써미스터를 이용한 온도보상회로를 이용하여 레이더 센서의 양산성을 향상시킬 수 있는 방안을 제시하였다. 레이더 센서에 사용되는 DRO(Dielectric Resonator Oscillator)의 유전체공진기를 제거한 후, FET의 게이트에 적절한 바이어스전압을 인가할 수 있는 온도보상회로를 이용하여 정확한 발진주파수를 조정하는데 필요한 시간을 절약함으로써 양산이 용이하도록 하였는데, 본 논문에서 제안한 방법으로 제작한 레이더 센서의 출력주파수는 $-20^{\circ}C-+55^{\circ}C$의 온도범위에서 15.67MHz의 변화량을 보였으며, 출력크기의 변화는 0.65dB, 위상잡음 특성은 1MHz에서 -105.47dBc로 같은 온도범위에서 25MHz의 출력주파수 변화, 0.42dB의 출력크기 변화, -107.40 dBc의 위상잡음 특성을 보이는 유전체공진기를 이용한 발진기보다 우수하거나 비슷한 특성을 나타내었다.

• Journal of Korean Society for Atmospheric Environment
• /
• 제22권E2호
• /
• pp.57-68
• /
• 2006

Four intensive seasonal sampling campaigns between October 1998 and October 1999 were undertaken at an urban site of Chongju, in which polyurethane foam (PUF) sampler was used to collect particulate- and vapor-phase polycyclic aromatic hydrocarbons (PAHs). The contribution to total (particulate+vapor) PAH concentration by the vapor phase component exceeded the particulate phase contribution by factor of ${\sim}2.6$. Summed concentrations of phenanthrene (30.9%), pyrene (16.6%), naphthalene (11.3%) and fluoranthene (11.0%) account for significant amounts of the vapor-phase, while chrysene (12.5%), benzo[b]fluoranthene (11.6%), indeno[123-cd]pyrene (9.9%), benzo[ghi]perylene (9.5%), benzo[k]fluoranthene (9.4%), pyrene (8.9%), and benzo[a]pyrene (8.3%) are found to be the most common PAH compounds in the particulate phase. The results from application of principal component analysis to particulate-phase PAH data demonstrate that a combination of PAH and $PM_{2.5}$ inorganic data is a more powerful tracer of emission sources than PAH species data alone. Particulate-phase PAH species were found to be associated predominantly with emissions from diesel engine vehicles and incineration.