• 대한전기학회논문지:시스템및제어부문D
• /
• 제51권2호
• /
• pp.78-85
• /
• 2002

We introduce a rotational decision-directed joint algorithm of blind equalization coupled with carrier recovery for 32-QAM demodulation with high symbol rate. The proposed carrier recovery, which we call a rotational decision-directed carrier recovery(RDDCR), removes the residual phase difference by rotating the decision boundary for the kth received symbol by the frequency detector output of the (k-1)th received symbol. Since the RDDCR includes the function of PLL loop filter by rotating the decision boundary, it gives a simpler demodulator structure. The rotational decision-directed blind equalization(RDDBE) with the rotated decision boundary based on the Stop-and-Go Algorithm(SGA) operated during tracking the frequency offset by the RDDCR and removes intersymbol interference due to multipaths and channel noise. Test results show that symbol error rate of $10^{-3}$ is obtained before the forward error correction when SNR equals 15dB with 150KHz of carrier frequency offset and two multipaths, which is the channel condition for 32-QAM receiver.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 추계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.204-206
• /
• 2002

For small capacity rectifier circuits such as these for consumer electronics and appliances. capacitor input type rectifier circuits are generally used Consequently. various harmonics generated within the power system become a serious Problem. Various studies of this effect have been presented previously. However. most of these employ switching devices, such as FETs and the like. The absence of switching devices makes systems more tolerant to over -load, and brings low radio noise benefits. We propose a power factor correction scheme using a LC resonant in commercial frequency without switching devices. In this method. It makes a sinusoidal wave by widening conduction period using the current resonance in commercial frequency. Hence, the harmonic characteristics can be significantly improved. where the lower order harmonics. such as the fifth and seventh orders are much reduced. The result are confirmed by the theoretical and expermental implementations.

• 대한방사선기술학회지:방사선기술과학
• /
• 제30권3호
• /
• pp.251-257
• /
• 2007

디지털 MTF의 정확도를 결정하는 요소로는 정확한 엣지 각도의 결정, 합성 ESF 또는 합성 LSF을 작성을 위한 재 샘플링, 스무징, 커브핏팅 등을 들 수가 있다. 본 실험에서는 Edge를 이용한 MTF커브 핏팅방법을 구현하였고, 슬릿법에 의한 MTF산출결과와 비교하였다. 실험결과 공간주파수 2.0 LP/mm 근방까지의 저주파수영역에서는 엣지법이 높은 수치를 나타내며 2.0 LP/mm 이상의 주파수 영역에서는 MTF값이 역전이 되어 슬릿법이 더욱 높은 값을 나타내었다. 이는 Cunningham의 보고와 완전히 일치한다.

• 에너지공학
• /
• 제9권3호
• /
• pp.261-268
• /
• 2000

A heat transfer correlation to predict the vaporization of a water droplet in highly superheated steam during a loss-of-coolant accident(LOCA) of a nuclear power plant is provided. Vaporization of liquid fuel or water droplets in superheated air or steam and subsequent interface heat transfer between a liquid droplet and superheated gas is typically correlated by way of a Nusselt number as a function of Reynolds number, Prantl number, and in some cases including mass transfer number. Presently available correlations and experimental data of the evaporation of liquid droplets in air or steam are analyzed and a new Nusselt number correlation is proposed taking Schmidt number into consideration in order to account for binary diffusion of the vapor as well, Nu$\_$f/(1+B)$\^$0.7/=2+0.53Sc$\_$f/$\^$-1/5/Re$\_$M/$\^$$\sfrac{1}{2}$/Pr$\_$f/$\^$$\sfrac{1}{3}$/ for which properties are evaluated at film condition except the density of Reynolds number evaluated at ambient condition. Diverse correlations for various combinations of liquid and gas species are put into single equation. The blowing correction factor of (1+B)$\^$0.7/ is confirmed appropriate, and a criterion to distinguish so-called high- and low-temperature condition of ambient gas is set forth.

• 전자통신동향분석
• /
• 제35권2호
• /
• pp.79-88
• /
• 2020

Quantum computing is regarded as one of the revolutionary computing technologies, and has attracted considerable attention in various fields, such as finance, chemistry, and medicine. One of the promising candidates to realize fault tolerant quantum computing is quantum dot qubits, due to their expectation of high scalability. In this study, we briefly introduce the international tendencies for quantum dot quantum computing. First, the current status of quantum dot gate operations is summarized. In most systems, over 99% of single qubit gate operation is realized, and controlled-not and controlled-phase gates as 2-qubit entangling gates are demonstrated in quantum dots. Second, several approaches to expand the number of qubits are introduced, such as 1D and 2D arrays and long-range interaction. Finally, the current quantum dot systems are evaluated for conducting quantum computing in terms of their number of qubits and gate accuracies. Quantum dot quantum computing is expected to implement scalable quantum computing. In the noisy intermediate-scale quantum era, quantum computing will expand its applications, enabling upcoming questions such as a fault-tolerant quantum computing architecture and error correction scheme to be addressed.

• ETRI Journal
• /
• 제41권6호
• /
• pp.715-730
• /
• 2019

We propose a switched beam-forming antenna that satisfies not only ultra-wideband characteristics but also beam-forming in the WLAN frequency band using an ultra-wideband antenna and passive parasitic elements applying a broadband optimal reactance load algorithm. We design a power and phase estimation function and an error correction function by re-analyzing and normalizing all the components of the parasitic array using control system engineering. The proposed antenna is compared with an antenna with a pin diode and reactance load value, respectively. The pin diode is located between the passive parasitic elements and ground plane. An antenna beam can be formed in eight directions according to the pin diode ON (reflector)/OFF (director) state. The antenna with a reactance load value achieves a better VSWR and gain than the antenna with a pin diode. We confirm that a beam is formed in eight directions owing to the RF switch operation, and the measured peak gain is 7 dBi at 2.45 GHz and 10 dBi at 5.8 GHz.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 심포지엄 논문집 정보 및 제어부문
• /
• pp.129-130
• /
• 2007

Self servo track writing(SSTW)은 servo track writer(STW)를 이용하지 않고 hard disk drive의 내부 VCM을 이용하여 servo track을 기록하는 방식이다. SSTW는 이전 servo track을 상대적인 reference로 하여 기록하게 되므로 초기에 발생된 error와 외부의 disturbance의 영향으로 error는 급속하게 증가된다. 이것을 radial error propagation 이라 한다. 본 논문에서는 radial error propagation을 억제하기 위한 correction signal을 설계하고 servo writing 과정에서 발생하는 disturbance의 영향을 제거하기 위하여 disturbance observer(DOB)를 add-on type으로 구성하여 tracking 제어기를 설계하였다. 또한 DOB를 적용한 경우와 유사한 gain margin, phase margin과 sensitivity function을 갖는 제어기를 설계하여 그 성능을 비교하였다. 제안된 방식은 radial error propagation을 억제 하였을 뿐만 아니라 disturbance의 최소화하여 쓰여진 track의 DC track spacing과 AC track Squeeze가 개선된 것을 모의실험을 통하여 검증하였다.

• Steel and Composite Structures
• /
• 제28권1호
• /
• pp.99-110
• /
• 2018

In this paper, a new size-dependent quasi-3D plate theory is presented for wave dispersion analysis of functionally graded nanoplates while resting on an elastic foundation and under the hygrothermaal environment. This quasi-3D plate theory considers both thickness stretching influences and shear deformation with the variations of displacements in the thickness direction as a parabolic function. Moreover, the stress-free boundary conditions on both sides of the plate are satisfied without using a shear correction factor. This theory includes five independent unknowns with results in only five governing equations. Size effects are obtained via a higher-order nonlocal strain gradient theory of elasticity. A variational approach is adopted to owning the governing equations employing Hamilton's principle. Solving analytically via Fourier series, these equations gives wave frequencies and phase velocities as a function of wave numbers. The validity of the present results is examined by comparing them with those of the known data in the literature. Parametric studies are conducted for material composition, size dependency, two parametric elastic foundation, temperature and moisture differences, and wave number. Some conclusions are drawn from the parametric studies with respect to the wave characteristics.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2007년도 동계학술발표대회 논문집
• /
• pp.191-196
• /
• 2007

This paper presents the measuring technique for local heat transfer coefficients using a copper sensor in a rod bundle with mixing vanes. A copper sensor consists of a cartridge heater and four pieces of thermocouple. The Heater is located at the center of the copper sensor and thermocouples measure the surface temperature of the copper sensor. Unheated copper sensor and heated copper sensor are able to measure the local heat transfer coefficient at the position where the heated copper sensor is installed. However the entire region of a rod bundle is actually not heated, the decay of local heat transfer coefficients measured represents overestimated value rather than an actual value. The calibration curve for local heat transfer coefficients is presented using the correction factor calculated by CFD.

• 한국해양공학회:학술대회논문집
• /
• 한국해양공학회 2003년도 춘계학술대회 논문집
• /
• pp.319-323
• /
• 2003

In this paper, we propose a hybrid transceiver for underwater acoustic communication, which allows the system to reduce complexity and increase robustness in time variant underwater channel environments. It is designed in the digital domain except for amplifiers and implemented by using a multiple digital signal processors (DSPs) system. The digital modulation technique is quadrature phase shift keying (QPSK) and frame synchronization is an energy (non-coherent) detection scheme based on the quadrature receiver structure. DSP implementation is based on block data parallel architecture (BDPA). We shaw experimental results in th? underwater anechoic basin at KRISO. The results indicate that the frame synchronization is performed without PLL. Also, we shaw that the adaptive equalizer can compensate frame synchronization error and the correction capability is dependent on the length of equalizer.