• Journal of Power Electronics
• /
• v.18 no.5
• /
• pp.1347-1356
• /
• 2018

In a three-phase system, three-phase AC signals can be translated into two-phase DC signals through a coordinate transformation. Thus, the PI regulator can realize a zero steady-state error for the DC signals. In the control of a three-phase grid-connected inverter, the phase angle of grid is normally detected by a phase-locked loop (PLL) and takes part in a coordinate transformation. A novel control strategy for a three-phase grid-connected inverter with a frequency-locked loop (FLL) based on coordinate transformation is proposed in this paper. The inverter is controlled as a current supply. The grid angle, which takes part in the coordinate transformation, is replaced by a periodic linear changing angle from $-{\pi}$ to ${\pi}$. The changing angle has the same frequency but a different phase than the grid angle. The frequency of the changing angle tracks the grid frequency by the negative feedback of the reactive power, which forms a FLL. The control strategy applies to non-ideal grids and it is a lot simpler than the control strategies with a PLL that are applied to non-ideal grids. The structure of the FLL is established. The principle and advantages of the proposed control strategy are discussed. The theoretical analysis is confirmed by experimental results.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.10
• /
• pp.1-7
• /
• 2010

A new frequency offset estimation algorithm for chirp spread spectrum based on matched filter is proposed. Generally, the differential phase between successive symbols is used for the conventional frequency offset estimation algorithm. However, if the conventional frequency offset estimation algorithm is used for CSS, phase ambiguity arises because of long symbol duration and guard time. The phase ambiguity causes performance degradation of matched filter since the received signal is corrupted by the integer frequency offset. In this paper, we propose a new frequency offset estimation algorithm which separates integer and fractional frequency offset estimation for removing the phase ambiguity. The proposed algorithm estimates the integer frequency offset by using differential phase between matched filtering results of sub-chirps and successive symbols. Then, the fractional frequency offset is estimated by using the differential phase between successive symbols Simulation results show that the proposed algorithm well removes the phase ambiguity, and have almost same estimation performance compared with conventional one when there is not the phase ambiguity.

• Journal of Information Technology Services
• /
• v.13 no.1
• /
• pp.125-134
• /
• 2014

Device discovery for D2D (device-to-device) communication enables a device to discover other devices in order to initiate communication with them. Devices should perform the discovery phase using a small quantity of radio resource in a short time and be able to reduce the load of the base station. Legacy device discovery schemes have focused on discovering as many target devices as possible. However, it is not appropriate for peer-to-peer D2D communication scenario. Further, synchronization problems are an important issue for discovery signal transmission. This paper proposes a discovery method that one requesting device discovers a specific target for communication. Multiple antenna beamforming is employed for the synchronization between the base station and a target device. The proposal can reduce the load of the base station using the information that it already maintains and improve the reliability of the device discovery because two times of synchronizations using beamforming among the base station and devices can make the exact discovery of a target device with mobility possible.

• Proceedings of the Korean Society of Embryo Transfer Conference
• /
• 2002.11a
• /
• pp.116-116
• /
• 2002

Further development of reconstructed embryos may be dependent upon the synchronization of donor nucleus and recipient cytoplasm at cell fusion, To control the synchronization of donor and recipient cells, the enucleated MII arrested oocytes are artificially stimulated prior to embryo reconstruction. Destruction of cyclin B results in the exit of cells from M-phase of cell cycle. This study was designed to investigate the effects of single or combined stimulation affected cyclin B1 mRNA and protein levels in mouse oocytes. The oocyte activation was induced by 7% ethanol or 10$\mu\textrm{g}$/$m\ell$ Ca-ionophore without (single) or with (combined) 10$\mu\textrm{g}$/$m\ell$ cycloheximide. Competitive quantitative PCR for cyclin Bl mRNA and western blot analysis for cyclin B1 protein was preformed in mouse oocytes. Cyclin B1 mRNA level was significantly reduced in single (P<0.05) and combined (P<0.05) stimulation groups. However, this level did not change in non-activated group and increased in intact group. Cyclin B1 protein level was also significantly reduced in both single (P<0.05) and combined (P<0.05) stimulation groups. In conclusion, single and combined stimulation induces the degradation of cyclin B1 mRNA and protein after activation in enucleated mouse oocytes.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2001.10a
• /
• pp.307-310
• /
• 2001

In this paper we describe the design and implementation of uplink receiver for BWLL base station modem. The demodulator consists of digital down converter, matched filter and synchronization circuits. For symbol timing recovery we use Gardner algorithm. And we use forth power method and decision directed method for carrier frequency recovery and phase recovery, respectively. For the sake of performance analysis, we compare simulation results with the board implemented by FPGA which is APEX20KE series chip for Alter. The performance results show it works quite well up to the condition that a frequency offset equal to 4.7% of symbol rate.1

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.15 no.12
• /
• pp.1044-1052
• /
• 1990

We have investigated the digital bit synchronization problem in baseband communication receiver systems using the Gauss-Markov estimation technique which is equivalent to the weighted least square method. The realized bit synchronizer, including the data detector, processes the input signal two dimensionally into the transition phase and data level under the white Gaussian noise environment. We have confrmed the realiation of the bit synchronizer via computer simulation. In addition, we have compared and evaluated the estimation error performance of the proposed method with that of the conventional DTTL method and of the minimum likelihood method.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.10C
• /
• pp.980-986
• /
• 2002

In the fast data communication system, synchronized by a clock source, the loss of data will often occur due to several reasons as a differential routing path between data and clock, a differential propagation delay of components or an unstable phase of clock and data by external noise. In this paper, we describe the ASIC implementation of the data compensation circuit which can detect the data loss from above problems and recovery to original data with stable synchronization. Especially it supports a strong stability and a good BER in the communication system for fast data transfer as optic area. This circuit is implemented by Verilog HDL and available to the digital ASIC implementations related to fast data transfer.

• 한국정보통신설비학회:학술대회논문집
• /
• 2008.08a
• /
• pp.237-241
• /
• 2008

Femtocells are cellular access points that connect to a mobile operator's network using residential DSL or cable broadband connections. They have been developed to work with a range of different cellular standards including CDMA, GSM and UMTS. Like legacy base station, the frequency accuracy and phase alignment is necessary for ensuring the quality of service (QoS) for applications such as voice, real-time video, wireless hand-off, and data over a converged access medium at the femtocell. But, the GPS has some problem to be used at the femtocell, because it is difficult to set-up, depends on the satellite condition, and very expensive. So, some techniques are discussed to alternate with the legacy GPS system. NTP, PTP, Synchronous Ethernet use the ethernet to synchronize distributed clocks in packet networks. AGPS support reliable position information than the legacy GPS in poor signal conditions. But, These method also have some problems. So, hybrid timing method like A-GPS+PTP and TV+GPS was developed to make up the weak point of GPS. This paper introduces the each method and compare each other and y propose much better solution for timing synchronization at the Femtocell

• Journal of Power Electronics
• /
• v.18 no.1
• /
• pp.251-265
• /
• 2018

To enable a master-slave control independent microgrid system (MSCIMGS) to supply electricity continuously, the microgrid inverter should perform mode transfer between grid-connected and islanding operations. Transient oscillations should be reduced during transfer to effectively conduct a seamless mode transfer. This study uses a typical MSCIMGS as an example and improves the mode transfer strategy in three aspects: (1) adopts a status-tracking algorithm to improve the switching strategy of the outer loop, (2) uses the voltage magnitude and phase pre-synchronization algorithm to reduce transient shock at the time of grid connection, and (3) applies the hybrid-sensitivity $H_{\infty}$ robust controller instead of the current inner loop to improve the robustness of the controller. Simulations and experiments show that the proposed strategy is more practical than the traditional proportional-derivative control mode transfer and effective in reducing voltage and current oscillations during the transfer period.

• Journal of Electrical Engineering and Technology
• /
• v.12 no.5
• /
• pp.1754-1763
• /
• 2017

This paper analyses the characteristics of incomplete-journey double-circuit transmission lines on the same tower formed by single-circuit lines and double-circuit lines, and then presents a fault location algorithm based on identification of fault branch. With the relationship between the three-phase system and the double-circuit line system, a phase-mode transformation matrix for double-circuit lines can be derived. Based on the derived matrix, the double-circuit lines with faults can be decoupled, and then the fault location for an incomplete-journey double-circuit line is achieved by using modal components in the mode domain. The algorithm is divided into two steps. Firstly, the fault branch is identified by comparing the relationships of voltage amplitudes at the bonding point. Then the fault location, on the basis of the identification result, is calculated by using a two-terminal method, and only the fault distance of the actual fault branch can be obtained. There is no limit on synchronization of each terminal sampling data. The results of ATP-EMTP simulation show that the proposed algorithm can be applied within the entire line and can accurately locate faults in different fault types, fault resistances, and fault distances.