• Korean Journal of Materials Research
• /
• v.26 no.4
• /
• pp.200-206
• /
• 2016

This study was carried out to investigate the effect of W substitution on the precipitation behavior of ${\chi}$ and ${\sigma}$ phases in super duplex stainless steel. The ${\chi}$ phase was precipitated at the interface of ferrite / austenite phases and inside the ferrite phase at the initial stage of aging. With an increase in the aging time, the volume fraction of the ${\chi}$ phase increased, and then decreased with the transformation from the ${\chi}$ phase to the ${\sigma}$ phase. The ${\sigma}$ phase was precipitated later than the ${\chi}$ phase, and the volume fraction of x phase increased with the increase in the aging time. The ferrite phase was decomposed into the new austenite (${\gamma}2$) and ${\sigma}$ phases by aging treatment. The decomposition of the ferrite phase into the ${\gamma}2$ and ${\sigma}$ phases was retarded by W substitution for Mo. The volume fraction of the ${\chi}$ phase increased and that of the ${\sigma}$ phase decreased due to W substitution. The ${\chi}$ and ${\sigma}$ phases were intermetallic compounds, which had lower nickel concentration, and higher chromium, molybdenum, and tungsten concentrations. The ${\chi}$ phase has higher molybdenum and tungsten concentrations than those of the ${\sigma}$ phase. The amounts of chromium and nickel in the ${\chi}$ and ${\sigma}$ phases did not change, but these phases have higher concentrations of molybdenum and tungsten due to W substitution for Mo.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.8
• /
• pp.1805-1810
• /
• 2014

The phase noise spectrum distribution for remote controller using the BPSK mode and low data rate of 50 kbps was designed and proposed in this paper. In case of applying the BPSK that transmission performance is superior to FSK method, the performance degradations due to phase noise are generated. To minimize the phase noise effect, it is important to dispatch the digital signal in channel environment with required phase noise characteristics. To provide the terminal design technique and the proper channel environment with required phase noise characteristics, the phase noise spectrum distribution was designed for required phase noise characteristics. By analyzing the phase noise effects for damping factor and noise bandwidth of the carrier recovery circuit, the phase noise spectrum design that consider the damping factor and noise bandwidth was performed. Based on the IESS-308 standards, also, the phase noise effects was analyzed. The phase noise spectrum design techniques and phase noise spectrum that is suitable to remote controller were proposed.

• Proceedings of the KSME Conference
• /
• 2007.05b
• /
• pp.2273-2278
• /
• 2007

Brazed Plate Heat Exchanger (BPHE) is a type of compact plate heat exchanger with parallel corrugated plates which are brazed together in series. Each plate hascorrugation called herringbone pattern. Inside a BPHE, hot fluid and cold fluid alternate its flow direction to establish counter current flow configuration. Two-phase flow heat transfer and pressure drop of R-22 in BPHE were experimentally measured in this study. In the present experiments, single-phase region and two-phase region coexist in a BPHE. Therefore, the inside of a BPHE have to be divided into single phase region and two phase region and analyzed accordingly. The results from the single phase flow analysis are then extended to the two phase flow analysis to correlate the condensation and evaporation heat transfer and pressure drop for the refrigerant R-22 in the BPHEs. Previous models for two- phase friction factor have been compared with the present experimental results.

• Korean Journal of Microbiology
• /
• v.9 no.4
• /
• pp.169-174
• /
• 1971

Ultrastructural observations of mycelial and tissue phase with dimorphic fungal pathogen Coccidioides immitis were studied by electron microscopy of thin sections. 1. In mycelial phase of C.immitis contains normal cell components such as nucleus, mitochondria, endoplamsic reticulum, intracytoplasmic membrane system, cell wall and cell membrane as observed in the other encaryotic cells. 2. In tissue phase of C. immitis was larger than mycelial phase in cell size and observed much more vacuoles than mycelial phase. 3. In the contrast of mycelial phase of C. immitis, the tissue phase of cells were observed fibril form of capsular layer.

• Journal of the Korean Ceramic Society
• /
• v.35 no.4
• /
• pp.413-419
• /
• 1998

${\beta}$-silicon carbides with yttrium aluminum garnet of 2,5,10 mol% were prepared by a liquid--phase sint-ering and the microstructural evolution and phase transformation were investigated during sintering as functions of liquid-phase amount and sintering time. The rate of grain growth decreases with the addition of the amount of yttrium aluminum garnet (YAG) in the SiC starting powder however the apparent density and the aspect ratio of grains in sintered body increase. The phase transformation from ${\beta}$-SiC to ${\alpha}$-SiC were dependent on the liquid-phase amount and sintering time.

• Journal of Electrical Engineering and Technology
• /
• v.8 no.5
• /
• pp.1086-1095
• /
• 2013

The main issue of parallel three-phase boost converters is reduction of the low- and high frequency circulating currents. Most present technologies concentrate on low frequency circulating current because the circulating current controller cannot mitigate the high frequency circulating current. In this paper, analytical approach of three-phase coupled inductor applied to parallel system becomes an important objective to effectively reduce the low- and high frequency circulating currents. The characteristics of three-phase coupled inductor based on a structure and voltage equations are mathematically derived. The modified voltage equations are then applied to parallel three-phase boost converters to develop averaged models in stationary coordinates and rotating coordinates. Based on the averaged modeling approach, design of the circulating current controller is presented. Simulation and experimental results demonstrate the effectiveness of the analysis and modeling for the parallel three-phase boost converters using three-phase coupled inductor.

• 제어로봇시스템학회:학술대회논문집
• /
• 2005.06a
• /
• pp.233-236
• /
• 2005

Phase noise in a phase-locked-loop (PLL) is unwanted and unavoidable. It is a main concern in oscillation system especially PLL. The phase noise is derived in term of power spectrum density by using a reliable phase noise model. There are four noise sources being considered in this paper, which are generated by reference oscillator, voltage controlled oscillator, filter, and main divider. The major concern for this paper is the noise from the filter. Two types of second order low pass filter are used in the PLL system. Applying the mathematical phase noise model, the output noises are compared. The total noise from the passive filter is lower than the active filter at the offset frequency range between 1 Hz to 33 kHz.

• Applied Microscopy
• /
• v.45 no.2
• /
• pp.58-62
• /
• 2015

Formation of an icosahedral phase in the bulk glass forming $Ti_{40}Zr_{29}Be_{14}Cu_9Ni_8$ alloy during crystallization from amorphous phase and solidification from melt is investigated. The icosahedral phase with a size of 10 to 15 nm forms as a thermodynamically stable phase at intermediate temperature during the transformation from amorphous to crystalline phases such as Laves and ${\beta}$-(Ti-Zr) phases, indicating that the existence of the icosahedral cluster in the undercooled liquid. On the other hand, the icosahedral phase forms as a primary solidification phase even though the Laves phase is stable at high temperature, which is can be explained based on the high nucleation rate of icosahedral phase relative to that of competing crystalline Laves phase due to lower interfacial energy between icosahedral and liquid phases.

• Journal of information and communication convergence engineering
• /
• v.13 no.4
• /
• pp.280-285
• /
• 2015

Double random phase encryption (DRPE) is one of the well-known optical encryption techniques, and many techniques with DRPE have been developed for information security. However, most of these techniques may not solve the fundamental security problem caused by using fixed phase masks for DRPE. Therefore, in this paper, we propose a key phase mask updating scheme for DRPE to improve its security, where a spatial light modulator (SLM) is used to implement key phase mask updating. In the proposed scheme, updated key data are obtained by using previous image data and the first phase mask used in encryption. The SLM with the updated key is used as the second phase mask for encryption. We provide a detailed description of the method of encryption and decryption for a DRPE system using the proposed key updating scheme, and simulation results are also shown to verify that the proposed key updating scheme can enhance the security of the original DRPE.

• Journal of Advanced Marine Engineering and Technology
• /
• v.31 no.8
• /
• pp.983-989
• /
• 2007

This paper decribes multi-phase BLDC motor with a minimum torque pulsation among BLDC motor used for electric propulsion system. Multi-phase BLDC motor has characteristic that phase of stator has more than 3-phase. This paper is modeling two type of BLDC motor, one has 3-phase and the other has 7-phase, and it shows simulation of them comparing its characteristics. As a result of simulation, the 7-phase BLDC motor shows better performance in terms of torque pulsation. It is also found that the torque pulsation is reduced further by increasing the number of phase.