• 한국해양공학회:학술대회논문집
• /
• 한국해양공학회 2001년도 춘계학술대회 논문집
• /
• pp.186-195
• /
• 2001

The purpose of this study is to develop the time-dependent, one-dimensional numerical model on the interaction between irregular waves and two-layer permeable coastal structures, by extending and modifying the numerical model PBREAK(Wurjanto and Kobayashi, 1992) which is applicable only to one-layer permeable coastal structures. The two-layer permeable coastal structure consists of two permeable underlayers with different permeable media resting on an impermeable slope and an armor layer covering the permeable underlayer. The numerical model of this study simulates the wave over rough permeable underlayer of arbitrary geometry as well as the waves inside two-permeable underlayers of arbitrary thickness for specified normally-incident irregular waves. The utility of the numerical model is founded from comparing with PBREAK and the four hydraulic model tests under irregular waves. The sensitivities of computed results according to typical parameters(porosity, stone diameter, horizontal width of the permeable underlayer) and major factors(friction factor of primary armor layer etc.) discussed.

• 한국환경과학회지
• /
• 제24권4호
• /
• pp.449-459
• /
• 2015

The depth of low permeable layer in Jeju Island was analyzed using the geologic columnar section data. The highest low permeable layer was found in center of Mt. Halla and the deepest area was in eastern part of Jeju Island. The study area, Seongsan watershed, is located in the eastern part of Jeju where the low permeable layer showing deep in a northward direction. Based on this analysis, the MODFLOW modeling was performed for groundwater flow of Seongsan watershed. The boundary of Seongsan watershed was set up as a no-flow and the modeling result showed the difference -0.26~0.62 m compared to the observed groundwater level. Meanwhile, MODFLOW model results considering low permeable layer showed -0.26~0.36 m differences compared to groundwater level and indicated more accurate than no-flow method result. Therefore, to interpret the groundwater flow over Seongsan watershed, comprehensive consideration including the low permeable layer distribution below the basalt layer is needed.

• 한국지반공학회논문집
• /
• 제33권12호
• /
• pp.75-80
• /
• 2017

도심 홍수 및 물순환 왜곡을 해결하기 위한 대표적 저영향개발기술 중 하나인 투수 블록포장이 포장시설로서 활발하게 적용되고 있다. 하지만 국내의 경우 설계법이 잘 정립되어있지 않고 국외에선 AASHTO 93 연성포장 설계법을 구조설계법으로 적용하고 있긴 하나 투수성 포장재료의 상대강도계수에 대한 정보가 부족하여 다양한 재료에 대한 설계적용이 어렵다는 단점이 있다. 이에 따라 본 연구에선 평판재하시험을 통해 투수 블록포장 재료의 상대강도계수를 산정하는 방법을 제시하고, 투수성 포장 실증현장에서 평판재하시험을 실시하여 이를 산정하였다. 산정된 개립도 골재와 투수 블록포장 표층의 상대강도계수는 전체적으로 기존의 값과 유사한 경향을 나타냈다. 본 연구에서 제시한 방법을 사용하여 향후 설계를 위한 투수 블록포장 재료의 상대강도계수를 산정할 수 있을 것으로 판단된다.

• 한국해양공학회지
• /
• 제20권6호
• /
• pp.35-40
• /
• 2006

In recent years, there's been strong demand for seawalls that havea gentle slope and permeability that serveswater affinity and disaster prevention from wave attack. The aim of this study is to examine wave transformation, including wave run-up that propagates on the coastal structures. A numerical model based on the weak nonlinear dispersive Boussinesq equation, together with the unsteady nonlinear Darcy law for fluid motion in permeable layer, is developed. The applicability of this numerical model is examined through Deguchi and Moriwaki's hydraulic model test on the permeable slopes. From this study, it is found that the proposed numerical model can predict wave transformation and run-up on the gentle slope with a permeable layer, but can't show accurate results for slopes steeper than about 1:10.

• 한국의류산업학회지
• /
• 제11권2호
• /
• pp.359-362
• /
• 2009

This study investigates the behavior of water vapor permeability of a layered system to find out a comfortable combination of a layered system for outdoor activities and examines the water vapor permeability of various types of outdoor clothing fabrics. The layered system includes the base layer such as sportswool and polyester/cotton fabrics, the middle layer such as single and double sided fleece fabrics, and the shell layer such as polyurethane-coated, PTFE-laminated and microfiber fabrics in this experiment. Results show that the layered system was applied, it was working together as a whole having some influence on each other layer, though every layer offered varying degree of water vapor permeability. Water vapor permeability of layered system exactly followed the same trend as the shell layer, which is all vapor permeable water repellent fabrics as a single layer. The rate of water vapor transfer through a layered system is mainly related to the type of vapor permeable water repellent fabrics used for the shell layer.

• 복합신소재구조학회 논문집
• /
• 제6권4호
• /
• pp.64-70
• /
• 2015

A rapid urbanization has increased the portion of paved layer that results in the change of water circulation system. This change leads to frequent events of flooding, drought, and urban heat island. To resolve these issues, permeable pavement system based on Low Impact Development (LID) concept is being applied to international urban areas. Therefore it is necessary to establish a rational design procedure for the permeable pavement system that reflects our environmental conditions. iDue to inherent characteristics of permeable pavement system, water infiltrates thorough the layers so it may reduce the bearing capacity of sub-layers. In this study, an effort was made to investigate the effectiveness of geogrid reinforced crushed stone subbase layer based on field experimental program along with a limited numerical analysis. It reveals that geogrid reinforced sections improve the bearing capacity by close to 20%. In addition, a light weight deflectomenter (LWDT) appears to be promising for the compaction quality control of crushed stone subbase layer in order to construct qualified permeable pavement systems.

• 한국해안·해양공학회논문집
• /
• 제21권2호
• /
• pp.127-135
• /
• 2009

Reid and Kajiura(1957)은 해저면에 무한한 깊이의 투수층이 존재할 경우에의 파의 감쇠율을 유도하였다. 본 연구에서는 유한한 깊이의 투수층이 존재할 경우에의 파의 감쇠율을 선형파이론을 이용하여 유도하였다. 그리고 이를 확장하여 해저면에 재질이 다른 2 층 또는 3 층의 투수층이 존재할 경우에 파의 감쇠율을 제시하였다. 다음으로 이를 완경사 방정식에 적용하여, 해저면에 투수층이 존재할 경우에의 파의 투과율을 계산하였으며, 1층 투수층이 존재할 경우의 수치계산결과를 Flaten and Rygg(1991)의 적분식 방법과 비교하여 검증하였다.

• 한국방재학회:학술대회논문집
• /
• 한국방재학회 2011년도 정기 학술발표대회
• /
• pp.91-91
• /
• 2011

The quality of the surface layer in concrete structures plays an important role in the durability of the concrete. The concrete factory products are made as they improve the appearance of the surface and compressive strength in need. A common criterion to judge the quality of concrete products frequently seen in our daily life appears to be "beauty" in terms of consistent shaping. However, as for most concrete curb in such areas where a large amount of anti-freezing agents(NaCl) and ice and snow melting agents(CaCl2) are spread over roads to ensure road safety during the winter season, since deterioration advances from the surface, scaling is seen on the surface concrete due to deterioration which combined freezing damage and salt damage. Especially, In cold northern districts, the spreading amount of deicing salts increases by regulation of studded tire use, and the scaling of the concrete products, the various parts of concrete structures for roads is increasing in recent years. In this study, L-shape concrete curb were targeted, the permeable form method with the commercial permeable sheet was applied to it and the improvements of the quality were examined. By the permeable form method, surface layers got strengthened, which prevented permeation of the deterioration factor from the outside, and the scaling resistance of the upper surface where the permeable sheet was applied improved exceedingly. It will be expected by applying the permeable form method to various concrete products that frost resistance improves and scaling damage decreases.

• 대한토목학회논문집
• /
• 제38권1호
• /
• pp.113-119
• /
• 2018

현재 국내에서는 도심지 및 주거지에 원활한 물순환 구조를 이루기 위해 저영향개발에 근거한 투수성 포장 시스템 구축에 대한 시도를 하고 있다. 본 연구는 투수성 아스팔트 포장 구조 설계를 위한 포장인자 구축 및 설계법을 제안하고자 한다. 선행 연구 분석 결과, 1993년 AASHTO 설계법이 적합한 것으로 확인 되었다. 본 연구에서는 투수성 아스팔트 포장 재료의 상대구조계수 같은 주요 설계인자를 선행연구 분석을 통해 정량적으로 산정하였으며, 1993년 AASHTO 설계법 및 국내국도설계기준을 적용한 투수성 포장 구조 설계 프로그램을 개발하였다. 본 연구에서 개발된 프로그램 및 한국형 도로 설계법 프로그램을 비교한 결과 다양한 교통량 및 노반 지지력 조건에서 합리적인 포장 설계 두께를 산정하는 것을 확인하였다.

• Corrosion Science and Technology
• /
• 제7권1호
• /
• pp.40-44
• /
• 2008

Passive metal forms an interfacial diffuse layer on the surface of passive film by its reaction with $H^+$ or $OH^-$ ions in solution depending on solution pH. There is a critical pH, called pH point of iso-selectivity ($pH_{pis}$) at which the nature of the diffuse layer is changed from the anion-permeable at pH<$pH_{pis}$ to the cation-permeable at pH>$pH_{pis}$. The $pH_{pis}$ for a passivated Fe was determined by examining the effects of pH on the thickness of passive film and on the dissolution reaction occurring on the passive film under a gavanostatic reduction in borate-phosphate buffer solutions at various pH of 7~11. The steady-state thickness of passive film formed on Fe showed the maximum at pH 8.5~9, and further the nature of film dissolution reaction was changed from a reaction producing $Fe^{3+}$ ion at $pH\leq8.5$ to that producing $FeO_2{^-}$ at $pH\geq9$, suggesting that the $pH_{pis}$ of Fe is about pH 8.5~9. In addition, the passive film formed at pH 8.5~9, $pH_{pis}$, was found to be the most protective with the lowest defect density as confirmed by the Mott-Schottky analysis. Pitting potential was decreased with increasing $Cl^-$ concentration at $pH\leq8.5$ due probably to the formation of anion permeable diffuse layer, but it was almost constant at $pH\geq9$ irrespective of $Cl^-$ concentration due primarily to the formation of cation permeable diffuse layer on the film, confirming again that $pH_{pis}$ of Fe is 8.5~9.