• Analytical Science and Technology
• /
• v.8 no.2
• /
• pp.167-170
• /
• 1995

A simple and rapid permanganate value test procedure for the estimation of COD, based on the photometric measurement of the remained permanganate after the color bleaching by oxygen demand organics during digestion, has been described. Optimized conditions were 1% NaOH, 0.6mM $KMnO_4$, with a closed reflux in the boiling water bath for 90 sec using sample size of 5mL.

• Analytical Science and Technology
• /
• v.8 no.3
• /
• pp.281-284
• /
• 1995

The effect of permanganate concentration and refluxing time on the test COD results were investigated, as a validation test of the revised procedure. The amended protocol involves the use of a more dilute(1/2.5) permanganate solution(0.010N) and a shorter(1/3) refluxing period(20 min). This revision resulted only 70% of the COD value determined by the old procedure with 8 somewhat improved precision(CV 4.6%${\rightarrow}$3.3%). The dominant factor that influences the decrease in the COD result is the oxidant concentration, being two thirds of the overall effect. The same results were obtained in the comparison test using seawater samples.

• Carbon letters
• /
• v.12 no.3
• /
• pp.167-170
• /
• 2011

Petroleum pitch-based activated carbons (ACs) were obtained in this work from a combination of pretreatment with different amounts of potassium permanganate ($KMnO_4$) and chemical activation with potassium hydroxide. The surface characteristics of the pitch after the $KMnO_4$ pretreatment were characterized by means of Fourier transform infrared spectroscopy (FT-IR). The structural characteristics of the pitch after the $KMnO_4$ pretreatment were determined by means of X-ray diffraction. The influence of the $KMnO_4$ treatment on the textural properties of the petroleum pitch-based ACs was investigated by means of $N_2$/77K adsorption isotherms. The investigation also involved the use of the Brunauer-Emmett-Teller equation and the Dubinin-Radushkevich method. The FT-IR results show that the pretreatment promotes the formation of surface oxygen functionalities and leads to an increase of the interplanar distance ($d_{002}$) of the functional groups induced between carbon layers. Moreover, the specific surface area of the pitch-based ACs increases in proportion to the amount of $KMnO_4$ pretreatment and reaches its highest value of 2334 $m^2$/g with 2 g of $KMnO_4$ because the surface oxygen groups of the pitch act as an active site during chemical activation.

• Journal of the Korean Chemical Society
• /
• v.48 no.2
• /
• pp.195-202
• /
• 2004

Micellar catalysis is an essential part of theoretical and experimental curricular. The sodium dodecylsulfate (SDS) catalyzed reaction between glycine and potassium permanganate in acidic medium is an ideal kinetic experiment for the secondary and undergraduate physical chemistry laboratory, to show the effect of micellar catalysis on rate of the reaction. The reaction is conducted both with and without SDS to observe the rate enhancement in the presence of surfactant. To show surfactant catalysis a plot between k and [SDS] is plotted. As surfactant catalysis is observed even before the critical micelle concentration of SDS, this pre-micellar catalysis can be understood in the light of positive co-operativity. The value of positive cooperative index (n) has been found to be 2.37. Further, dependence of the reaction rate on substrate and oxidant concentrations is also discussed. The reaction follows pseudo-first-order kinetics. The overall reaction is second order, with first-order dependence on both glycine and permanganate concentrations. The theory of surfactant catalysis is also discussed. With the conditions specified in the experiment, total reaction times are in 3~4 hours lab session, thus allowing several data sets to be acquired in a single laboratory period. Preparation of solutions and procedure is also given in detail.

• Nuclear Engineering and Technology
• /
• v.3 no.1
• /
• pp.9-13
• /
• 1971

The levels of strontium-90 in milk produced in Korea were determined during the past six years. Milk samples were collected from dairies and market shops in seoul area. Strontium-90 in milk was separated from calcium using fuming nitric acid and purified radiochemically. After seculear equilibrium was completed, the radioactivity of yttrium-90 was counted in a low background beta counting system. The determination of stable calcium in milk was also made by volu-metric method using 0. 1 N potassium permanganate solution. The highest value of 34.9 pCi $^{90}$ Sr/g-Ca was determined in August, 1966 and the lowest value was 7.5 pCi $^{90}$ Sr/g-Ca in August, 1967. From the result we can say that levels of strontium-90 are decreasing year after year and are far bellow the maximum permissible level recommended by International Committe on Radiation Protection.

• Nuclear Engineering and Technology
• /
• v.20 no.2
• /
• pp.105-111
• /
• 1988

The chemical effects resulting from the capture of the thermal neutron by manganese in various crystalline permanganates, that is, potassium permanganate ammonium permangante and barium permanganate, have been investigated. The effect of pH of solvent on the distribution of radioactive manganese chemical species, that is, cationic $^{56}$ Mn, $^{56}$ MnO$_2$ and $^{56}$ MnO$_4$$^{[-10]}$ produced in the permanganates by $^{55}$ Mn(n, ｒ) $^{56}$ Mn reaction was studied by using various adsorbents and ion-exchanger, that is, zeolite A-3, kaolinite, alumina, manganese dioxide and Dowex-50 The distribution of radioactive MnO$_4$$^{[-10]}$ in kaolinite and alumina has higher than that in other adsorbents and ion-exchanger at a representative pH value of 4, 7 and 9, respectively. The yield of radioactive MnO$_4$$^{[-10]}$ is higher at pH 4 End pH 9 than at pH 7. The thermal annealing behavior of recoil manganese atoms produced in the permanganates by $^{55}$ Mn(n, ｒ) $^{56}$ Mn reaction was also studied. The retention of MnO$_4$$^{[-10]}$ in the thermal annealing is increased as annealing temperature increases when it was treated at 10$0^{\circ}C$ and 13$0^{\circ}C$. The recoil effect of permanganates was explained by the hot zone model.

• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.14 no.1
• /
• pp.35-42
• /
• 2008

Twenty eight gas impermeable plastic films for food-contact application were collected in the domestic market and material and/or migration tests for overall migration, antioxidants, potassium permanganate consumption, heavy metal, and plasticizers were carried out. The average overall migration values for NY/PE or NY/LLDPE, PETP/PE, and PVDC packaging films obtained by using n-heptane as fatty food simulant were 7.6, 6.9 and 14.1 mg/L, respectively. These values were much lower than the limit values of 150 and 30 mg/L for polyethylene and polyvinylidene chloride prescribed in the Korea Food Code. In almost of the packaging materials tested, the antioxidants such as Irganox 1010, Irganox 1076 and Irgafos 168 were found. The migration test result showed that almost of all samples except PVDC film contained Irganox 1076 and Irgafos 168, while the maximum migration value of Irganox 1076 into n-heptane was found in the Ny/PE/LLDPE(15/25/50 ${\mu}m$) sample at the concentration of 216.9 ${\mu}g/g$. From the plastic packaging samples tested, plasticizers such as DEP, DPRP, DBP, DPP, BBP, DCHP, DEHP, DEHA and observed above the detection limit. Consumption amount of potassium permanganate was much lower than the limit value of 10 mg/L. In the material test for heavy metals, cadmium and lead were determined at the concentrations far below the limit value of 100 mg/kg. The migration test for cadmium and lead showed a lower value than the detection limit. Therefore, it can be concluded that the safety status of the plastic films tested met the requirement of limit values as prescribed for the material and migration tests of food packaging utensils, containers and packages of the Korea Food Code.

• Journal of Korean Society of Water and Wastewater
• /
• v.29 no.2
• /
• pp.211-222
• /
• 2015

This study focused on evaluating the efficiency of the removal of non-point source pollution by Daecheong Lake Juwon Stream constructed wetlands. The constructed wetland system is a surface flow type designed in the year 2007 for purifying eutrophic water of Daecheong Lake Juwon Stream. The value of conductivity, suspended solids(SS), chemical oxygen demand using a potassium permanganate($COD_{Mn}$), five-day biochemical oxygen demand($BOD_5$), total nitrogen(T-N), total phosphorous(T-P), and pH in inflow averaged 220.2, 2.46, 3.33, 1.34, 2.00, 0.04 mg/L and 7.24, respectively and in outflow averaged 227.9, 1.12, 3.34, 0.87, 1.16, 0.02 mg/L and 7.45, respectively. The average removal efficiency of constructed wetlands was 30 % for SS, 22 % for $BOD_5$, 45 % for T-N and 31 % for T-P. The removal rates of SS, $BOD_5$ and T-N in the spring, summer and autumn were higher than those in winter. The removal rate of T-P was not significant different in all seasons. The amounts of pollutants removal in the constructed wetlands were higher in the order of $3^{rd}$ < $2^{nd}$ < $1^{st}$ wetland for SS and T-P, $2^{nd}$ < $3^{rd}$ < $1^{st}$ wetland for $BOD_5$ and T-N. Therefore, our findings suggest that the constructed wetlands could well treat the eutrophic Daecheong Lake Juwon Stream waters.

• Applied Chemistry for Engineering
• /
• v.21 no.5
• /
• pp.590-592
• /
• 2010

Li-Mn spinel ($LiMn_2O_4$) is prepared by a hydrothermal process with K-Birnessite ($KMnO_4{\cdot}yH_2O$) as a precursor. The K-Birnessite obtained via a hydrothermal process with potassium permanganate [$KMnO_4$] and urea [$CO(NH_2)_2$] as starting materials are converted to Li-Mn spinel nanoparticles reacting with LiOH. The molar ratio of LiOH/K-Birnessite is adjusted in order to find the effect of the ratio on the structural, morphological and electrochemical performances of the Li-Mn spinel. X-ray diffraction (XRD) and field emission scanning electron microscopy (FE-SEM), energy-dispersive X-ray spectroscopy (EDS), and thermogravimetry (TG) are used to investigate the crystal structure and morphology of the samples. Galvanostatic charge and discharge are carried out to measure the capacity and rate capability of the Li-Mn spinel. The capacity shows a maximum value of $117\;mAhg^{-1}$ when the molar ratio of LiOH/K-Birnessite is 0.8 and decreases with the increase of the ratio. However the rate capability is improved with the increase of the ratio due to the reduction of the particle size.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.9 no.3
• /
• pp.169-175
• /
• 1976

A solvent extraction-atomic absorption spectrophotometry for determination of trace amount of cadmium, copper, lead and zinc and a flameless atomic absorption spectrophotometry for mercury in sea water were studied. The optimum pH range for solvent extraction was pH 4-7. A better solvent extraction efficiency was obtained with MIBK solvent than nitrobenzene, benzene, isoamylalcohol, n-buthylacetate. DDTC was more advantageous than APDC as chelating agent. The metals, chelated with DDTC and concentrated into MIBK by solvent extraction with a volume of $1\iota$ of sea water for cadmium, copper and lead, and 200m1 for zinc, were determined simultaneously by atomic absorption spectrophotometry. For mercury determination, 500ml of sea water was digested with permanganate-sulfuric acid and mercury( II ) was reduced by stannous chloride and aerated the solution with air pump until the absorbance reached a constant value. The precisions, in standard deviation, of these methods were 0.058ppb for cadmium, 0.084 ppb for copper, 0.44ppb for lead, 2.49ppb for zinc and 0.08 ppb for mercury. The sensitivities, expressed in $ppb/1\%$ absorption, were 0.058 ppb cadmium, 0. 15 ppb copper, 0.6 ppb lead, 1.2 ppb zinc and 0.01 ppb mercury respectively. No significant adsorption on the wall of polyethylene sample bottle occurred during 30 days of storing by acidification to pH 1.5 with nitric acid except zinc. Poor reproducibility was found for zinc with this method.