• Korean Journal of Microbiology
• /
• v.26 no.1
• /
• pp.37-43
• /
• 1988

This research was focused on investigation of the condition for protoplast formation and regeneration of protoplast fusion between Saccharomyces cerevisiae which has fermentation ability and Candida cariosilignicola which can grow at high temperature and utilize methanol. The results obtained were as follows; The highest production was collected in exponential growth phase. Ninety-nine% protoplast formation of C. cariosilignicola was obtained in glycin-NaOH buffer (pH10.0) containing Zymolyase 0.5mg/ml at $35^{\circ}C$ for 1hr incubation. The highest regeneration was produced when protoplast wuwpension containing 0.5% soft agar in buffered 50mM $CaCl_{2}$ was poured as a soft overlay onto 2% agar plates. Equal amuont of protoplast suspension of two strains was mixed and centrifuged. The subsequent pellet was added to 2ml of 35% polyethylene glycol (MW 4,000) containing 50mM $CaCl_{2}$, and incubated at $30^{\circ}C$ for 10min. Then 0.1ml of the suspension of aggregated protoplast was immediately covered with minimal medium and incubated at $40^{\circ}C$ for 5-7 days. As results, $SC_{1}$, $SC_{2}$, and $SC_{3}$ fusants were obtained. The physiological characteristics of fusants produced by protoplast fusion were; $SC_{1}$, and $SC_{2}$ utilized maltose, galactose, methanol, potassium nitrate. $SC_{3}$ utilized all the above materials except galactose.

• Proceedings of the KIEE Conference
• /
• 2005.07c
• /
• pp.2109-2111
• /
• 2005

The effect of arc like streamer discharge is investigated on the hydrogen generation in the plasma reactor with multineedle - plate electrode geometry and SDR (Plasma reactor using the surface discharge). An additive of the two type (the saw type and the pellet type) was placed under the water surface to investigate the effect of the water surface conditions. The experimental results are compared in case of the reactor with and without an additive on the water surface. The generation of arc streamer discharge is more powerful with increasing applied voltage in the saw type. The maximum hydrogen Production concentration is about 4300 ppm at 74W in the SDR with additive of the saw type. Also, the Energy yield of the SDR (28990 g/kWh, 4300ppm, 74W) is higher than of the multineedle - plate electrode geometry (20892g/kWh, 3300ppm, 77W).

• Korean Chemical Engineering Research
• /
• v.59 no.3
• /
• pp.467-479
• /
• 2021

Abstract: A kinetic model was developed for the dehydration of ethanol to ethylene based on two parallel reaction pathways. Kinetic parameters were estimated by fitting experimental data of powder catalysts in a lab-scale test, and the effectiveness factor was determined using data from pellet-type catalysts in bench-scale experiments. The developed model was used to design a multitubular fixed-bed reactor (MTR) and an adiabatic reactor (AR) at a 10 ton per day scale. The two different reactor types resulted in different process configurations: the MTR consumed the ethanol completely and did not produce the reaction intermediate, diethyl ether (DEE), resulting in simple separation trains at the expense of high equipment cost for the reactor, whereas the AR required azeotropic distillation and cryogenic distillation to recycle the unreacted ethanol and to separate the undesired DEE, respectively. Quantitative analysis based on the equipment and annual energy costs showed that, despite high equipment cost of the reactor, the MTR process had the advantages of high productivity and simple separation trains, whereas the use of additional separation trains in the AR process increased both the total equipment cost and the annual energy cost per unit production rate.

• Journal of Hydrogen and New Energy
• /
• v.32 no.6
• /
• pp.464-469
• /
• 2021

A reforming catalyst for hydrogen production from ammonia is being studied. Non-novel metal based Ni catalysts for use in ammonia reforming processes are being developed. In this study, the ammonia reforming characteristics according to Ni content of the alumina pellet supported catalyst in the mid-temperature region were investigated under different space velocity. 20 Ni and 3,000 h^-1 showed the best catalytic activity with ammonia conversion of 63% among all conditions.

• Nuclear Engineering and Technology
• /
• v.55 no.6
• /
• pp.2206-2214
• /
• 2023

The existing wet reconversion processes for the recovery of scraps generated in manufacturing of nuclear fuel are complex and require several unit operation steps. In this study, it is attempted to simplify the recovery process of high-quality fuel-grade UO₂ powder. A novel wet reconversion process for uranyl nitrate hexahydrate solution is suggested by using a newly developed pulsed fluidized bed reactor, and the resultant chemical characteristics are evaluated for the intermediate ammonium uranate hydrate product and subsequently converted UO₂ powder, as well as the compliance with nuclear fuel specifications and advantages over existing wet processes. The UO₂ powder obtained by the suggested process improved fuel pellet properties compared to those derived from the existing wet conversion processes. Powder performance tests revealed that the produced UO₂ powder satisfies all specifications required for fuel pellets, including the sintered density, increase in re-sintered density, and grain size. Therefore, the processes described herein can aid realizing a simplified manufacturing process for nuclear-grade UO₂ powders that can be used for nuclear power generation.

• Journal of the Korean Wood Science and Technology
• /
• v.52 no.4
• /
• pp.363-374
• /
• 2024

Nyamplung (Calophyllum inophyllum L.) seeds, which account for 40% of the fruit, have been used as a raw material for biofuels, and the seed shells remaining after their extraction are wasted. In this study, we investigated the potential of waste Nyamplung seed shells in the form of pellets as a biomass energy resource. A completely randomized research design was implemented to evaluate the effects of torrefaction and heat treatment on the quality of produced pellets. Two observed treatments, namely, particle size (0.18-0.25, 0.25-0.43, and 0.43-0.84 mm) and torrefaction temperature (200℃, 225℃, and 250℃), were investigated. Our results showed that the calorific value of torrefied Nyamplung seed-shell pellets ranged from 4,245.60 to 4,528.00 cal/g, fulfilling the Indonesia Nasional Standard (≥ 4,000 cal/g). The quality of pellets were the best when produced from raw materials with a particle size of 0.18-0.25 mm and torrefaction temperature of 225℃. Thus, we concluded that waste Nyamplung seed shells are a good raw material for the production of pellets.

• Proceedings of the Korean Aquaculture Society Conference
• /
• 2003.10a
• /
• pp.17-18
• /
• 2003

Although flounder is one of the most important marine fish for aquaculture in Korea, feeding the flounder in commercial farms depends mainly on moist pellet in which over 70% frozen fishes (e.g. frozen horse mackerel) are incorporated in its formulation. Therefore, for further expansion of flounder farming, it is essential to employ practical formulated feeds that can support reasonable growth. Development of nutritionally balanced and cost-effective feeds is dependant on the information about nutritional requirement and feed utilization of the species. Nutrient and energy source in feed are needed for the growth and maintenance of fish. Protein is probably the most important nutrient affecting fish growth and feed cost. Therefore, it is essential to determine the optimum dietary protein level for the growth of fish, both its high proportion in the feed and because it is the main factor in determining feed cost. Dietary energy level is also critical because protein source in the feed is utilized as an energy source when the feed deficient in energy is fed to fish, whereas when the feed excess in energy is fed to fish, feed consumption decreased and resulted in growth reduction due to lack of other necessary nutrients for normal growth. Improper dietary protein, energy levels and/or their ratio will lead to an increase of fish production cost and deterioration of water quality resulting from wasted feed; thus, they are important in formulating commercial feed. Dietary lipids play important roles in providing energy and essential fatty acid for normal growth and survival of fish. Although carbohydrates are not essential nutrients for carnivorous fish, these compounds play important roles as a low-cost energy source for protein sparing and also as a feed binder. Nutrition researches for flounder have identified its requirements of protein, lipid and essential fatty acid, vitamin, and minerals for normal growth. Other studies have also been carried out to investigate the utilization of the protein, lipid and carbohydrate sources. Based on these nutritional information obtained, practical feed formulations have been studied for improve aquaculture production of flounder. The results of the researches on utilization of dietary protein, lipid and carbohydrate by flounder are discussed in this review.

• Journal of Hydrogen and New Energy
• /
• v.21 no.6
• /
• pp.500-506
• /
• 2010

The metal monolith catalyst coated with 15wt% Ni/$MgAl_2O_4$ is applied to the natural gas steam reforming for hydrogen production. To address the improvement of adherence between metal monolith and catalyst coating layer, the pre-calcination temperature as well as the coating conditions of $Al_2O_3$ sol are optimized. When the Fe-Cr alloy monolith is pre-calcined at $900^{\circ}C$ for 6 h, $Al_2O_3$ layer was formed uniformly on the entire surface of the metal substrate. It is seen that the formation of $Al_2O_3$ layer on the monolith surface is essential for the uniform coating of $Al_2O_3$ sol onto the monolith substrate. The monolith catalyst coated with 10wt% $Al_2O_3$ sol shows high $CH_4$ conversion and good thermal stability as compared with the monolith catalyst without $Al_2O_3$ sol coating under severe reaction conditions with high GHSV of 30,000 $h^{-1}$ at $700^{\circ}C$. In addition, the metal monolith catalyst shows higher catalytic activity and better thermal conductivity than 15wt% Ni/$MgAl_2O_4$ pellet catalyst.

• Korean Journal of Food Science and Technology
• /
• v.20 no.5
• /
• pp.724-731
• /
• 1988

For a study on the production of ${\gamma}-linolenic$ acid(GLA) by microorganisms, fifteen strains of Mucorales obtained from culture stocks and ten isolate strains were compared in their cell growth, lipid content, fatty acid composition and pellet size formed in shake flask culture. Among the fungi examined, the isolated fungus, designated as FB-354, was found to be the most suitable one for the production of GLA mainly due to its high contents of lipid, 29.9% of dry cell weight and GLA, 16.8% of the total fatty acids. The strain FB-354 was tentatively identified as Mucor sp. on the basis of morphological characteristics. Fungal oil produced by Mucor sp. FB-354 was fractionated into 81.1% of neutral lipid, 7.2% of glycolipid, and 11.8% of phospholipid. Although the GLA content in the phospholipid fraction was as high as 21.4%, most of the GLA was found in the neutral lipid fraction.

• Proceedings of the Korea Society of Poultry Science Conference
• /
• 2001.11a
• /
• pp.58-60
• /
• 2001

Two experiments were conducted to study the effects of nutrient level and feeding method of split diets for a.m. and p.m. on laying hen performance. In both studies, ISA Brown layers were kept in laying hen cages and treatments were represented by three or four replicates each containing 25 or 34 birds. In Experiment 1, the control group(C) was fed a conventional single diet throughout the day and split diet groups(T1, T2 and T3) were offered high energy/protein - low Ca diet and low energy/protein - high Ca diets in a.m. and p.m., respectively. In split diet groups, ME and CP consumption, and feed cost required per day and per kg egg mass were significantly reduced(P＜0.05) compared to C group, while the hen-day egg production, average egg weight and daily feed intake were not different among treatments. In the second study, C and T1 groups were fed the diets same to the C and T2 groups in Experiment 1, respectively. And T2 group was fed the diet mixed with the split diets for a.m. in mash and p.m. in pellet used in T1 group. In T1 and T2 groups, daily feed intake and average egg weight were significantly reduced(P＜0.05), while the hen-day egg production was not influenced by the feeding system. Daily ME and CP consumption, and feed cost were reduced(P＜0.05) in T1 and T2, while the ME, CP and feed cost required per kg egg mass were not different to the C group. In both study, eggshell qualities were improved(P＜0.05) by split diet feeding. It was concluded the feed and nutrients consumption, feed cost per day or per kg egg mass could be spared by introducing split diets for a.m. and p.m., and the feeding method of mixed diet of split diets was also convenient and effective for sparing feed cost and improvement of eggshell quality.