• Asian-Australasian Journal of Animal Sciences
• /
• 제3권3호
• /
• pp.225-229
• /
• 1990

Sixteen mature sheep were fed chaffed orchardgrass hay once a day. Jaw movement of the sheep was recorded for 24 hours before slaughter. Four sheep were slaughtered either prior to eating, 2, 8 or 16 hours after the commencement of eating to measure digesta pool size and particle size distribution in the reticulo-rumen. Eating time was restricted to 120 minutes. Rumination time and actual chewing time during rumination increased with time after the meal. Mean dry matter (DM) pool size before and 2 hours after the meal were 1.36 and 2.45 times of DM intake, respectively. The proportion of large particle (>1.18 mm; LP) in the DM ingested during the meal was caculated to be about 70%. The mean DM and LP pool sizes per DM intake and the mean proportion of LP in the DM pool decreased with time after the meal. There were close negative relationships between either DM or LP pool sizes per DM intake and the chewing activities either expressed as time spent rumination, actual chewing time during rumination or total actual chewing time(total of eating time and actual chewing time during rumination). The difference between DM intake and LP pool size were assumed to be LP degradation in the present experiment, and correlated positively with the chewing activities. A large proportion of the digesta load was comprised of small particles, in excess of the daily intake.

• 상하수도학회지
• /
• 제29권3호
• /
• pp.371-380
• /
• 2015

Particulate matters in a water distribution system are main causes of turbidity and discoloration of tap water. They could be removed by conventional or uni-directional flushing in a water distribution system. The behaviors and required flow velocity of particles are not well known for their flushing. A model water main and hydrant were made from transparent acrylic pipe of 30mm and 16mm in diameter, respectively. We analyzed the effect of flushing velocity, particle density, and particle diameter. We found that the existence of break-though velocities at which particles begin to be removed, and which are affected by their physical properties. The removal efficiencies seemed to be influenced by resuspension capabilities related to their upward movement from the bottom. Heavy particles like scale were hard to remove through upflow hydrant because the falling velocity, calculated using Stokes' law, was higher. Particle removal efficiencies of upward hydrant and downward drain showed minor differences. Additionally, the length between hydrant and control valve affected flushing efficiency because the particulate matters were trapped in this space by inertia and recirculating flow.

• Journal of Information Display
• /
• 제3권3호
• /
• pp.17-23
• /
• 2002

In this work we report methods of formation of three-dimensional structures of particles in a liquid crystal host. We found that, under the appropriate conditions, the particles are captured and dragged by the moving isotropic/nematic front during the phase transition process. This movement of the particles can be enhanced significantly or suppressed drastically with the influence of an electric field and/or with changing the conditions of the phase transition, such as the rate of cooling. As a result, a wide variety of particle structures can be obtained ranging from a fine-grained cellular structure to stripes of varying periods to a course-grained "root" structures. Changing the properties of the materials, such as the size and density of the particles and the surface anchoring of the liquid crystal at the particle surface, can also be used to control the morphology of the three-dimensional particle network and adjust the physical properties of the resulting dispersions. These particle structures may be used to affect the performance of LCD's much as polymers have been used in the past.

• 한국전기전자재료학회논문지
• /
• 제24권8호
• /
• pp.669-673
• /
• 2011

The charged particle type display is a kind of the reflectivity type display and shows an image by absorption and reflection of external light source, which has keep an image without additional electric power because of bistability. In this paper, we made a device whose cell gap is $56\;{\mu}m$ and also analyzed driving and memory characteristics by applied driving voltages. As a result, we found that the driving voltage and memory effect depend on q/m(charge to mass ratio) of charged particle. In this case of breakdown voltage, the devices showed degradation of reflectivity and memory effect due to irregular movement of overcharged particles. In addition, contrast ratio of the device varies with memory effect. Thus, we consider that device needs uniform q/m for improvement of electric and optical properties and memory effect.

• 한국언어정보학회지:언어와정보
• /
• 제18권1호
• /
• pp.33-52
• /
• 2014

This paper proposes a unified structural account of some instances of the English Modals and Semi-auxiliaries. The classification and the syntactic/structural description of the English Modal auxiliary verbs and verb-related elements have long been the center for many proposals in the history of generative syntax. According to van Gelderen (1993) and Lightfoot (2002), it was sometime around 1380 that the Tense-node (T) appeared in the phrasal structures of the English language, and the T-node is under which the English Modal auxiliaries occupy. Closely related is the existing evidence that English Modals were used as main verbs up to the early sixteenth century (Lightfoot 1991, Han 2000). This paper argues for a bi-clausal approach to English Modal auxiliaries with the infinitival particle 'to' such as 'ought to' 'used to' and 'dare (to)' 'need (to)', etc. and Semi-auxiliaries including 'be to' and 'have to'. More specifically, 'ought' in 'ought to' constructions, for instance, undergoes V-to-T movement within the matrix clause, just like 'HAVEAux' and all instances of 'BE', whereas 'to' occupies the T position of the embedded complement clause. By proposing the bi-clausal account, Radford's (2004, 2009) problems can be solved. Further, the historical motivation for the account takes a stance along with Norde (2009) and Brinton & Traugott (2005) in that Radford's (2004, 2009) syncretization of the two positions of the infinitival particle 'to' is no different from the 'boundary loss' in the process of Grammariticalization. This line of argument supports Krug's (2011), and in turn Bolinger's(1980) generalization on Auxiliaryhood, while providing a novel insight into Head movement of V-to-T in Present Day English.

• 한국전기전자재료학회논문지
• /
• 제33권5호
• /
• pp.386-392
• /
• 2020

In this study, the drift current characteristics of charged particles are analyzed for panels fabricated by varying the waveform biasing of the active particle loading method (APLM), which is a method driven by the electrophoretic principle of loading charged particles into a cell of a barrier rib-type electronic paper. We prepare 3 panels using APLM and 1 panel without APLM. The waveform of APLM uses square wave and ramp wave, and the step voltage wave is applied to the driving voltage. The drift currents measured from the square wave and ramp wave with the same period applied by APLM are 4.872 µC and 5.464 µC, respectively, and the ramp wave is shown to be relatively advantageous for loading charged particles that have a large q/m. The time-current curve results confirm that the abrupt movement of charged particles is occurring. When the step form wave signal with a short time of 1s is first applied, initial large movement of the charged particles is confirmed to occur in all samples, which is understood as the effect of applying the voltage necessary to remove the imaging force. The results of this study are expected to improve the loading of charged particles into the electronic paper cell, driven by the electrophoretic principle and optimization of the driving conditions.

• Tribology and Lubricants
• /
• 제40권2호
• /
• pp.61-66
• /
• 2024

Micro-plastics are synthetic high-differentiation chemicals of less than 5mm in size, and are deposited not only on the sea surface but also on the coast. If these micro-plastics are not properly separated from the sand, they can threaten marine ecosystems. Thus, in the present study, we aimed to apply cyclone separator to the micro-plastic retrieval in order to predict the movement of particles according to the formation of the cyclone separator by applying the centrifugal force of the particle in accordance with the rotational movement of the air. The cyclone separator has three shapes, the first one is a typical interconnected cyclone separator. The second is the horn form, except for the cylinder in a regular cyclone separator, and the third is a form that increases the horn's height twice in the second. The numerical analysis simulation of the Cyclone separator used the Fluent software package. The output speed of the Cyclone separator was 5 to 13m/s at 1m/s intervals. The simulated particles include sand, Styrofoam, PET, PP, and PU. Sand particles are assigned a fixed diameter of 2mm, while other particles have a diameter of 3mm. As a result of the analysis, the first form was not separated from plastic. The Styrofoam separation efficiency in the second showed its highest efficiency at 72.7% at 7m/s, and the efficiency decreased after 12m/s as the sand particles were mixed into the plastic attachment location. In the third form, the separation efficiency of Styrofoam at 12m/s was highest at 67.9%.

• Nuclear Engineering and Technology
• /
• 제56권2호
• /
• pp.575-600
• /
• 2024

During an earthquake on December 29th 2020, the Krško NPP automatically shutdown due to the trigger of the negative neutron flux rate signal on the power range nuclear instrumentation. From the time course of the detector signal, it can be concluded that the fluctuation in the detector signal may have been caused by the mechanical movement of the ex-core neutron detectors or the pressure vessel components rather than the actual change in reactor power. The objective of the analysis was to evaluate the sensitivity of the neutron flux at the ex-core detector position, if the detector is moved in the radial or axial direction. In addition, the effect of the core barrel movement and core inside the baffle movement in the radial direction were analysed. The analysis is complemented by the calculation of the thermal and total neutron flux gradient in radial, axial and azimuthal directions. The Monte Carlo particle transport code MCNP was used to study the changes in the response of the ex-core detector for the above-mentioned scenarios. Power and intermediate-range detectors were analysed separately, because they are designed differently, positioned at different locations, and have different response characteristics. It was found that the movement of the power range ex-core detector has a negligible effect on the value of the thermal neutron flux in the active part of the detector. However, the radial movement of the intermediate-range detector by 5 cm results in 7%-8% change in the thermal neutron flux in the active part of the intermediate-range detector. The analysis continued with an evaluation of the effects of moving the entire core barrel on the ex-core detector response. It was estimated that the 2 mm core barrel radial oscillation results in ~4% deviation in the power and intermediate-range detector signal. The movement of the reactor core inside baffle can contribute ~6% deviation in the ex-core neutron detector signal. The analysis showed that the mechanical movement of ex-core neutron detectors cannot explain the fluctuations in the ex-core detector signal. However, combined core barrel and reactor core inside baffle oscillations could be a probable reason for the observed fluctuations in the ex-core detector signal during an earthquake.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 춘계학술대회논문집D
• /
• pp.97-103
• /
• 2001

The effects of the electrohydrodynamic (EHD) flow and turbulent diffusion on the collection efficiency of a model ESP composed of the plates with a cavity were studied through numerical computation. The electric field and ion space charge density were calculated by the Poisson equation of the electrical potential and the current continuity equation. The EHD flow field was solved by the continuity and momentum equations of the gas phase including the electrical body force induced by the movement of ions under the electric field. The RNG $k-{\varepsilon}$ model was used to analyze the turbulent flow. The particle concentration distribution was calculated from the convective diffusion equation of the particle phase. As the ion space charge increased, the particulate collection efficiency increased because the electrical potential increased over the entire domain in the ESP. The collection efficiency decreased and then increased, i.e. had a minimum value, as the EHD circulating flow became stronger when the electrical migration velocity of the charged particle was low. However, the collection efficiency decreased with the stronger EHD flow when the electrical migration of the particle was higher relatively. The collection efficiency of the model ESP increased as the turbulent diffusivity of the particle increased when the electrical migration velocity of the particle was low. However, the collection efficiency decreased for increasing the turbulent diffusivity when the electrical migration of the particle was higher relatively.

• 한국게임학회 논문지
• /
• 제14권3호
• /
• pp.55-62
• /
• 2014

파티클 기반의 유체 시뮬레이션에서 파티클 들이 경계면에 부딪쳐 쇄파를 일으키는 경우 과도한 움직임으로 인해 자연스러운 흐름을 표현하기 어렵다. 파티클이 이동하는 시간 간격을 세분화하여 선형보간 함으로써 이 문제를 해결할 수 있다. 이렇게 하면 경계면에 모여 압력이 높아진 파티클 들의 가속도 벡터가 부드럽게 변한다. 하지만 보간을 하기위한 최소 샘플수가 높기 때문에 파티클 들이 점성을 가진 액체처럼 뭉치는 문제가 발생한다. 본 연구에서는 이 문제를 해결하기 가중치 보간 방식을 사용한다. 가중치 보간은 파티클의 현재 가속벡터와 이전 가속벡터에 서로 다른 가중치를 주며 차례로 더해 이동벡터를 구한다. 가중치 보간 방식을 쓰면 비슷한 흐름을 표현하는데 필요한 샘플수가 선형 보간 방식보다 적다. 그 결과로 점성을 가진 액체처럼 뭉치는 선형보간 방식의 문제점을 해결할 수 있다.