• 한국항해학회지
• /
• 제16권3호
• /
• pp.65-76
• /
• 1992

An algorithm to determine the optimum nominal value of geometrical and material parameters in divice modelling is proposed. The algorithm uses the yield and variance prediction formula and Monte-Carlo analysis. The performance specification of the noise figure must also be satisfied. In this paper, the total number of considered devices is 1000, and each parameter of geometrical and material parameters is generated randomly within the limits of ${\pm}3%$ of nominal value, and the distribution of 1000 geometrical and material parameters is gaussing distribution.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1987년도 전기.전자공학 학술대회 논문집(II)
• /
• pp.1619-1621
• /
• 1987

본 실험에서는 nonlinear product average 법을 사용하여 에너지만을 parameter로 써서 음성구간을 순차적으로 검출할수 있음을 보였다.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2006년도 6th International Meeting on Information Display
• /
• pp.759-762
• /
• 2006

A simple SPICE model for the description of the on-current of low-temperature poly-silicon thin film transistors is proposed. By employing constant mobility, $V_GS$ dependent alpha parameter, and exponential kink effect, very good agreements between the model and measurement were obtained.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2002년도 하계종합학술대회 논문집(2)
• /
• pp.49-52
• /
• 2002

A new method is developed to extract model parameters of SiGe HBT equivalent circuit including the base impedance and base-collector junction capacitance. Using this method, all resistances and capacitances of SiGe HBT are independently determined from measured S-parameters using two-port parameter formula. This method is proposed to reduce possible errors generated from global optimization process, and its accuracy has been verified by finding good agreements between measured and modeled current / power gain up to 18 GHz.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제10권2호
• /
• pp.160-164
• /
• 2010

The radio frequency (RF) model of SOI FinFETs with gate length of 40 nm is verified by using a 3-dimensional (3-D) device simulator. This paper shows the equivalent circuit model which can be used in the circuit analysis simulator. The RMS modeling error of Y-parameter was calculated to be only 0.3 %.

• 음성과학
• /
• 제1권
• /
• pp.285-293
• /
• 1997

This paper was constructed to investigate strange attractor in considering speech which is regarded as chaos in that the random signal appears in the deterministic raising system. This paper searches for the delay time from AR model power spectrum for constructing fit attractor for speech signal. As a result of applying Taken's embedding theory to the delay time, an exact correlation dimension solution is obtained. As a result of this consideration of speech, it is found that it has more speaker recognition characteristic parameter, and gains a large speaker discrimination recognition rate.

• 한국지능시스템학회:학술대회논문집
• /
• 한국퍼지및지능시스템학회 2006년도 추계학술대회 학술발표 논문집 제16권 제2호
• /
• pp.197-202
• /
• 2006

본 논문에서는 퍼지 신경회로망을 사용하여 영상에서 물체를 배경으로부터 추출해내는 방법을 제시하였다. 퍼지 신경회로망의 vigilance parameter를 조정하여 영상을 2개의 클래스로 분류하고, 물체 영역과 배경영역의 Cb와 Cr의 대표값을 추출하였다. 제안한 방법을 사용하여 물체색상의 위치 및 크기와 밝기에 상관없이 물체영역을 추출하였다.

• 설비공학논문집
• /
• 제16권12호
• /
• pp.1175-1182
• /
• 2004

Installations of vertical boreholes for the ground source heat pump system are expensive to install. One way to reduce the initial cost is to increase the specific heat extraction rate of borehole system. However, as the specific heat extraction rate increases the temperature of borehole fluid decreases with the resultant lower Coefficient Of Performance in Heating(COPH) of heat pump system. The purpose of this study is to provide the basic informations about the performance of heat pump system with the specific heat extraction rate and soil thermal properties such as thermal conductivity and temperature. It is shown that the specific heat extraction rate is the most important parameter for the ground source heat pump system. To obtain the reasonable COPH value (COPH > 3) the heat extraction rate should be about 25 W/m or less. Accurate measurements of soil thermal properties are also very important to design the system properly. The effects of borehole thermal resistances are also examined in this study.

• 한국재료학회지
• /
• 제34권5호
• /
• pp.247-253
• /
• 2024

The separation of zirconium and hafnium using tributyl phosphate (TBP)-Dodecane extractants in nitric acid medium was performed. Zirconium oxychloride, used as extraction feed, was obtained from the synthesis of Kalimantan zircon sand concentrate smelted using NaOH. The extraction process was carried out by dissolving chloride-based metals in nitric acid media in the presence of sodium nitrate using TBP-Dodecane as an extractant. Some of the extraction parameters carried out in this study include variations in organic phase and aqueous phase (O/A), variations in contact time, and variations in nitric acid concentration. Extraction was carried out using a mechanical shaker according to the parameter conditions. X-ray fluorescence (XRF) was used for elemental (Zr and Hf) composition analysis of the aqueous solution. The results showed that zirconium was separated from hafnium at optimum conditions with an organic/aqueous ratio of 1:5, contact time of 75 min, and an HNO₃ concentration of 7 M. The resulting separation factor of zirconium and hafnium using TBP-Dodecane was 14.4887.

• 한국정보과학회 언어공학연구회:학술대회논문집(한글 및 한국어 정보처리)
• /
• 한국정보과학회언어공학연구회 1989년도 한글날기념 학술대회 발표논문집
• /
• pp.142-147
• /
• 1989

필기체 문자는 인쇄체 문자와는 달리, 복잡한 변형이 따르므로, 인식 하는데 많은 문제점이 따른다. 그렇기 때문에 일반적인 필기체 인식에 있어서는 필기 자체에 대한 제한을 두어 변형을 적게한 문자를 인식 대상으로 삼고 있다. 이러한 문자는, 설정된 조건만 확실하게 만족한다면, 비교적 간단하게 인식 할 수 있다. 반면에, 자유 필기체 문자는, 제한 필기체 문자와는 달리 변형이 크기 때문에, 그 인식에는 많은 연구가 필요하다. 본 연구에서는, 자유 필기체 한글의 자모를 추출하는데 있어 두개의 parameter space method를 이용했다. 화상내에서의 혼합은, 기본적으로 5 개의 element ($\mid,\;\setminus,\;/,\;-,\;o$)로 구성되어 있고, 이 element를 정의하는데는 최소한 4 개의 parameter, 즉 element의 위치 [x, y], 크기 [1] 및 type [T] 등이 필요하다. 입력 화상에서 추출된 직선 및 원의 성분은 [x, y, l] 과 [x, y, T]의 2 개의 3-D parameter space 에 누적되고, parameter space 상에서의 병합 분할 과정을 거쳐, element 가 형성된다. 추출된 element 들은, parameter space 상에서의 방향성 및 상호 위치 관계에 의한 조합 형태로서, 미리 기술되어진 자모 모델과 비교되어 인식된다. 본 방법의 특정은, 문자의 크기에 무관하고, 해석방법에 의해서는, 끊어진 element나 불필요한 element 등의 왜곡된 element 들의 처리가 가능한 점, 4 차원 parameter space를 두개의 3 차원 parameter space로 분리, 처리시간과 기억용량의 절약을 기한점 등을 들 수 있다.