• Bulletin of the Korean Chemical Society
• /
• 제16권5호
• /
• pp.398-400
• /
• 1995

Selective oxidation of cyclohexane in acetone solution has been studied using iron catalysts with hydrogen peroxide in-situ produced by palladium catalyst. Iron tetraphenylporphyrin chloride shows the highest activity among the tested chlorides and porphyrin complexes of some metals of the first transiton series. Iron chloride and iron tetraphenylporphyrin chloride were supported on four kinds of 4-vinylpyridine copolymer with styrene or divinyl-benzene. Nitrogen 1s photoelectron spectra give the evidence that pyridyl nitrogens of the 4-vinyl pyridine copolymer act as ligands to bind iron species. The copolymer with styrene is the most efficient support for the binding because its solubility in catalyst preparation solvent (methylene chloride) gives the pyridyl group advantage to contact with the iron catalysts. However, better catalytic activity per iron atom could be obtained with a rigid crosslinked polymer due to active site isolation.

• Bulletin of the Korean Chemical Society
• /
• 제27권3호
• /
• pp.423-425
• /
• 2006

• Bulletin of the Korean Chemical Society
• /
• 제25권4호
• /
• pp.441-442
• /
• 2004

• Bulletin of the Korean Chemical Society
• /
• 제27권11호
• /
• pp.1727-1728
• /
• 2006

• Bulletin of the Korean Chemical Society
• /
• 제28권4호
• /
• pp.675-678
• /
• 2007

• 한국재료학회:학술대회논문집
• /
• 한국재료학회 2000년도 추계학술발표강연 및 논문개요집
• /
• pp.162-162
• /
• 2000

• 한국대기환경학회지
• /
• 제14권4호
• /
• pp.313-320
• /
• 1998

The most desirable diesel oxidation catalyst (DOC) should have the properties of oxidibing CO and HC effectively at low exhaust gas temperature while minimizing the formation of sulfate at high exhaust gas temperature. Precious metals such as platinum and palladium have been known to be sufficiently active for oxidizing CO and HC and also to have high activity for the oxidation of sulfur dioxide (SO2) to sulfor trioxide (SO3). There is a need to develop a highly selective catalyst which can promote the oxidation of CO and HC efficiently, but, on the other hand, suppress the oxidation of SO2. One approach to solve this problem is to load a base metal such as vanadium in Pt-based catalyst to suppress sulfate formation. In this study, a Pt-V catalyst was prepared by impregnating platinum and vanadium onto a Ti-Si wash coated catalyst in a laboratory reactor by changing the formulations and reaction temperatures.

• 한국물환경학회지
• /
• 제34권6호
• /
• pp.621-631
• /
• 2018

In this study, catalyst was made through incipient wetness method using palladium (Pd) as noble metal, indium (In) as secondary metal, and montmorillonite (MK10) and Al pillared montmorillonite (Al-MK10) as supporters. The nitrate reduction rate of the catalysts was measured by batch experiments where H2 gas was used as reducing agent and formic acid as pH controller. Transmission electron microscopy (TEM) equipped with energy dispersive spectroscopy (EDS) and X-ray photoelectron spectroscopy (XPS) were all used to determine the elemental distribution of Pd, In, Al, and Si on catalysts. It was observed that Al pillaring increased the Al/Si elemental composition ratio and point of zero charge of MK10, but decreased its BET specific surface area and pore volume. The nitrate reduction rate of Al-MK10 Pd/In was 2.0 ~ 2.5 times higher than that of MK10 Pd/In using artificial groundwater (GW) in ambient temperature and pressure. Nitrate reduction rates in GW were 1.2 ~ 1.7 times lower than those in distilled deionized water (DDW). Nitrate reduction rates in acidic conditions were higher than those in neutral condition in both GW and DDW. The amount of produced NH3-N over degraded NO3- at acid conditions was lower than that of neutral condition. Even though the leaching of Pd after reaction was measured in DDW it was not detected when both Al-MK10 Pd/In and MK10 Pd/In were used in GW. The modification of montmorillonite as a supporter significantly increased the reductive catalytic activities of nitrates. However, the ratio of producing ammonia by-products to degraded nitrates in ambient temperature and pressure was similar.

• 대한화학회지
• /
• 제37권10호
• /
• pp.903-909
• /
• 1993

팔라듐(0, II)-포스핀계 착물을 촉매로 하여 crotonic acid, methacrylic acid 및 3-butenoic acid 같은 불포화가크복실산의 카르보닐화 고리반응에서 생성가능한 물질의 구조를 확인하고, 그 반응메카니즘을 MM2 와 EHMO 계산에 의해서 추정하였다. 이 반응은 ${\pi}$ -착물을 거쳐 금속 함유 고리화합물을 만든 다음 산화성 첨가반응과 환원성 제거반응이 일어나 진행된다. ${\pi}$ -착물을 안정화시키는 crotonic acid, methacrylic acid 등은 카르보닐화 고리반응이 진행되지 않고, 3-butenoic acid는 무수카르복실산 유도체로서 glutaric anhydride와 3-methylsuccinic anhydride 및 이중결합이 자리옮김된 crotonic acid가 얻어졌다.

• 폴리머
• /
• 제28권3호
• /
• pp.245-252
• /
• 2004

5-헥실-2-노보넨 (HNB)과 5-메틸에스터-2-노보넨 (MES-NB)을 양이온 ${\eta}^3$-알릴 팔라듐 촉매인 [(${\eta}^3$-allyl) palladium(tricyclohexylphosphine) trifluoroacetate]와 리튬계 조촉매 [lithium tetrakis(pentafluorophenyl( borate${\cdor}$2.5etherate]를 사용하여 비닐 부가형의 폴리노보넨 공중합체를 합성하였다. 에스터기를 과량 함유한 폴리노보넨을 제조하기 위한 최적 중합 조건을 조사하기 위하여 여러가지 중합조건에 따른 분자량변화와 수율의 변화를 알아보았다. 팔라듐 촉매의 함량이 많을수록 수득율은 증가하는 한편, 분자량은 감소하였으며, 리튬조촉매의 함량은 많을수록 분자량과 수득율이 동시에 증가하였다. 사슬이동체를 이용하여 분자량을 조절할 수 있었고, 사슬이동제의 길이가 긴 1-데센과 1-옥텐이 1-헥센보다 분자량을 더 감소시키는 역할을 하였다. 한편 사슬이동제의 양은 수율에 큰 영향을 미치지 않았다. HNB/MES-NB(투입비 40/60 mol%)의 공종합체의 $^1$H-NMR 과 GPC 분석으로부터, 실제 에스터 함유량으 약 25mol%인 고분자량 (M$_{w}$ : 270,000)의 폴리노보넨 공중합체가 얻어짐을 알 수 있었다.